6.2 Cargo, Trailers, and Three-Wheeled Motorcycles

Alberta Class 6 Motorcycle Knowledge Test Exam

Track your progress as you read

Finished sections get a check mark.

1 Class 6 Licensing and Test Process

1.1 The Class 6 Licensing Pathway 1.2 Learning Rider Supervision and Restrictions 1.3 Class 6 Road Test and GDL Restrictions

2 Protective Gear and Rider Fitness

2.1 Helmet Safety Standards and Laws 2.2 Protective Clothing and Riding Gear 2.3 Rider Fitness and Impairment Rules

3 Motorcycle Controls and Maintenance

3.1 Primary Controls and Gauges 3.2 Friction Zone and Basic Handling 3.3 Pre-Trip Inspections and Maintenance

4 Lane Position, Visibility, and Traffic Risk

4.1 Lane Positioning and Visibility 4.2 Space Cushions and Following Distances 4.3 Intersections, Passing, and Signs

5 Braking, Curves, Surfaces, and Emergencies

5.1 Steering and Cornering Techniques 5.2 Braking and Emergency Swerving 5.3 Road Hazards and Mechanical Emergencies

6 Passengers, Cargo, Trailers, Sidecars, and Group Riding

6.1 Carrying Passengers 6.2 Cargo, Trailers, and Three-Wheeled Motorcycles 6.3 Group Riding Formations and Tactics

6.2 Cargo, Trailers, and Three-Wheeled Motorcycles

Key Takeaways Explain This Topic AI

Pack heavy cargo low and centered to maintain a low center of gravity and prevent pulling to one side.

Towing a trailer significantly increases stopping distances; maintain a 4-second gap and begin braking early.

Trailer tongue weight should be about 10% of the loaded trailer to prevent fishtailing or losing front-wheel steering.

Testing on a three-wheeled motorcycle (trike or sidecar) restricts your Alberta Class 6 licence to three-wheeled vehicles only.

Three-wheelers do not countersteer; they use direct steering, and sidecar rigs handle asymmetrically in turns.

Last updated: July 2026

Cargo, Trailers, and Three-Wheeled Motorcycles

Carrying cargo, towing a trailer, or operating a three-wheeled motorcycle (such as a trike or a motorcycle with a sidecar) changes the fundamental principles of motorcycle dynamics. Each of these modifications alters weight distribution, steering, and braking. Under the Alberta Traffic Safety Act, riders must understand the legal constraints and safety techniques required to manage these configurations.

Carrying Cargo on a Two-Wheeled Motorcycle

Loading cargo onto a motorcycle changes the vehicle's center of gravity and handling. Proper distribution and securing of the load are critical to prevent crashes.

Keep the Weight Low : Place heavy items as low as possible. This means packing heavy items at the bottom of saddlebags rather than in a top trunk or tank bag. A high center of gravity makes the motorcycle top-heavy, making it difficult to balance at low speeds and slow to respond in turns.

Keep the Weight Centered : Distribute the weight evenly between both sides of the motorcycle. If you have unequal loads in your left and right saddlebags, the motorcycle will pull to the heavier side, making steering unpredictable. Place cargo directly over or slightly forward of the rear axle; loading cargo too far behind the rear axle can lift the front wheel, reducing steering traction and causing dangerous head-shake (wobble).

Secure the Load : Use high-quality straps, bungee cords, or cargo nets to secure your items. Loose cargo can shift during acceleration, braking, or cornering, throwing off your balance. Ensure that no straps or cargo items are dangling, as they can become entangled in the chain, belt, rear wheel, or brake assembly, causing an immediate crash.

Do Not Block Equipment : Never pack cargo in a way that blocks your headlight, tail lamp, license plate, or turn signals. Ensure the load does not interfere with your ability to reach the handlebars, foot controls, or obscure your view in the mirrors.

Gross Vehicle Weight Rating (GVWR) : Always check the owner's manual to find the motorcycle's GVWR. This is the maximum total weight (including motorcycle, fluids, rider, passenger, and cargo) that the vehicle can safely carry. Exceeding this limit strains the engine, transmission, brakes, tires, and frame.

Towing a Trailer with a Motorcycle

Towing a trailer behind a motorcycle is legal in Alberta, but it requires extreme caution and specialized equipment. A trailer adds significant rolling resistance, wind drag, and pushing force under braking.

Hitch and Tongue Weight : The trailer hitch must be securely attached to the motorcycle's frame (never to the swingarm or rear axle). The tongue weight—the downward force exerted by the trailer coupler on the hitch—should be approximately 10% of the total loaded trailer weight. Too little tongue weight causes the trailer to fishtail (sway), while too much tongue weight lifts the front wheel of the motorcycle, compromising steering control.

Braking Distance : A trailer will push the motorcycle forward during deceleration. This significantly increases your stopping distance. You must increase your following distance to at least 4 seconds and begin braking much earlier than usual. Apply both brakes smoothly to prevent the trailer from jackknifing.

Turning and Cornering : When towing, you must take wider turns to prevent the trailer wheels from clipping curbs, potholes, or obstacles. The trailer does not lean with the motorcycle; instead, the trailer's weight pushes against the rear of the motorcycle, which can cause the rear tire to slide out if you corner too quickly.

Wind Stability : Large trucks, passing vehicles, and natural crosswinds will exert a strong force on the trailer, which is transmitted directly to the motorcycle. Maintain a firm grip on the handlebars and be prepared to make minor steering corrections.

Three-Wheeled Motorcycles (Trikes) and Sidecars

Operating a three-wheeled motorcycle (trike) or a motorcycle with a sidecar requires a completely different skill set from riding a two-wheeled motorcycle.

Alberta Licensing Rules

In Alberta, if you take your Class 6 road test on a three-wheeled motorcycle or a motorcycle with a sidecar, your Class 6 licence will be restricted. You will receive a restriction code on your physical licence that limits you to operating three-wheeled motorcycles only. To operate a two-wheeled motorcycle, you must pass the road test on a standard two-wheeled motorcycle.

Steering and Handling Dynamics

Standard motorcycles steer through countersteering (pushing the handlebar in the direction of the turn at speeds above 15-20 km/h). Three-wheeled vehicles and sidecar rigs do not lean, and therefore countersteering does not work. Instead, they use direct steering:

To turn left, you must physically turn the handlebars to the left.

To turn right, you must physically turn the handlebars to the right.

Sidecar Turning Dynamics

Because a sidecar is asymmetrical (the third wheel is only on one side, typically the right), the rig handles differently depending on the direction of the turn:

Turning Toward the Sidecar (Right Turns) : When turning right, centrifugal force pushes the weight of the motorcycle toward the left. This can cause the sidecar wheel to lift off the ground, a phenomenon known as "flying the sidecar." To prevent this, riders must slow down before the turn and lean their body weight toward the sidecar (to the right).

Turning Away from the Sidecar (Left Turns) : When turning left, centrifugal force pushes the weight toward the right (the sidecar). This stabilizes the sidecar wheel but can cause the rear wheel of the motorcycle to lift if the turn is taken too fast. The rider must slow down and lean their body weight to the left.

Acceleration and Braking : Acceleration causes the motorcycle to pull toward the sidecar (due to the drag of the sidecar). Braking causes the rig to pull away from the sidecar (to the left) because the motorcycle has more braking power than the sidecar wheel. Riders must compensate by steering slightly in the opposite direction.

Comparing Two-Wheeled vs. Three-Wheeled Handling

Feature Conventional Two-Wheeler Three-Wheeler / Sidecar

Steering Method Countersteering (push left, lean left, go left) Direct steering (turn left, stay upright, go left)

Turning Stability Balanced by leaning into the turn Balanced by rider body weight shifting; prone to wheel lift

Braking and Tracking In-line; straight tracking under braking Asymmetrical; pulls left or right depending on brake force

Slippery Surfaces High risk of slide-out and tipping Low risk of tipping, but steering traction can be lost

Licensing Restriction None; covers two- and three-wheelers Restricted to three-wheeled vehicles only if tested on one