Study guide
9.2 Traffic Lights, Arrows and Lane Discipline
NSW Heavy Vehicle Knowledge Test Exam
Track your progress as you read
Finished sections get a check mark.
1 NSW Heavy Vehicle Licensing, Qualifications & Pathways
1.1 Heavy Vehicle Licence Classes and Progression Pathways 1.2 Transmission Restrictions, Assessments, and Driver Qualifications 1.3 HVKT Test Structure, Delivery, and Exam Day Logistics
2 Driver Health, Alcohol and Drugs, and Roadside Testing
2.1 Alcohol Limits, Breath Testing and Drink-Driving Sanctions 2.2 Roadside Drug Testing and Prescribed Medications 2.3 Driver Health, Medical Conditions, and Commercial Fitness Standards
3 Fatigue Management, Heavy Vehicle National Law, and Work Diaries
3.1 Fatigue Science, Warning Signs, and Risk Factors 3.2 Standard Hours Work and Rest Limits 3.3 Basic Fatigue Management (BFM) and Advanced Fatigue Management (AFM) 3.4 National Driver Work Diary Rules and Record-Keeping
4 Low-Risk Driving, Spatial Management, and Maneuvering
4.1 Crash Avoidance Space, Scanning, and Following Distances 4.2 Speed Management, Braking Distances, and Rollover Prevention 4.3 Off-Tracking, Turning Sweeps, and Safe Reversing
5 NSW Heavy Vehicle Road Rules, Signs, and Infrastructure
5.1 "Do Not Overtake Turning Vehicle" Rules and Multi-Lane Turns 5.2 Heavy Vehicle Road Signs, Lane Restrictions, and Low Gear Descents 5.3 Level Crossings, Portable Warning Triangles, and Heavy Vehicle Parking
6 Vehicle Roadworthiness, Inspections, and Braking Systems
6.1 Pre-Departure Daily Safety Inspections 6.2 Air Brake Systems, Pressures, and Low-Air Warnings 6.3 Brake Fade, Auxiliary Retarders, and Non-Synchromesh Transmissions 6.4 Heavy Vehicle Defect Notices and Compliance Inspections
7 Vehicle Mass, Dimension Limits, and General vs Restricted Access
7.1 Statutory Mass Limits and Axle Weight Distribution 7.2 Statutory Dimension Limits and Overhang Regulations 7.3 Restricted Access Vehicles (RAVs), PBS, and Oversize/Overmass Permits
8 Combination Vehicles, Coupling, and Load Restraint
8.1 Coupling and Uncoupling Procedures for Combination Vehicles 8.2 Combination Vehicle Dynamics, Air Lines, and Roll-Away Prevention 8.3 National Load Restraint Guide Standards and Restraint Methods
9 NSW Road Rules: Signs, Signals and Lane Discipline
9.1 Traffic Signs: Regulatory, Warning and Heavy-Vehicle Signs 9.2 Traffic Lights, Arrows and Lane Discipline 9.3 Intersections, Give Way, Stop Signs and Roundabouts
10 Sharing the Road with Vulnerable Road Users
10.1 Pedestrians, Children, School and Rail Crossings 10.2 Bicycle Riders, Motorcyclists, Horses and Sharing the Road 10.3 Seat Belts, Restraints and Getting In and Out Safely
11 Offences, Enforcement and Test Integrity
11.1 Negligent and Dangerous Driving, Overtaking and Road Works 11.2 Speed Limits, Speed Limiters and Speeding Penalties 11.3 Vehicle Monitors, Noise, Emissions and Test Integrity
9.2 Traffic Lights, Arrows and Lane Discipline
Key Takeaways Explain This Topic AI
A green light is permission to proceed only if there is room for your whole vehicle on the far side; a long combination must judge the far-side gap against its full length, not against the cab.
Yellow means stop before the lights unless you are so close that stopping would require sudden braking, and a red arrow prohibits the turn regardless of how empty the road is.
On a multi-lane road with a speed limit of more than 80 km/h you must drive in the left lane unless overtaking, and a truck over 4.5 tonnes GVM must move into a marked trucks lane and stay there until a sign ends the restriction.
Bus lanes are reserved for public buses seating more than eight adults including the driver and used to carry passengers for hire or reward, and a bus facing a showing B signal proceeds as it would on a green.
A vehicle over 7.5 metres long may turn from the lane next to the left-hand lane, and double unbroken dividing lines may only be crossed to enter or leave a driveway or property when it is safe.
Last updated: August 2026
9.2 Traffic Lights, Arrows and Lane Discipline
Quick Summary / Key Rule: Traffic lights, arrows and lane rules make up roughly one question in twelve in the published pool, and virtually all of them are Road User Handbook material. The rules are simple; the traps come from heavy-vehicle length. A truck that "just fits" through on a yellow will still be in the intersection when the light goes red.
The Signal Sequence and What Each Colour Requires
Signal What you must do
Green You may proceed if the way ahead is clear. Green is permission, never an instruction to enter a blocked intersection.
Yellow (amber) Stop before the lights , unless you are so close that stopping would require sudden or dangerous braking.
Yellow while you are already in the intersection Continue through and clear the intersection.
Red Stop and wait behind the stop line until the green shows.
Red arrow You must not turn in that direction, even at 3 am with no other traffic in sight .
Green arrow You may proceed only in the direction of the arrow.
Flashing yellow (signals out of order) Proceed with caution and give way as if the signals were not there.
Temporary signals at roadworks Must be obeyed exactly as permanent signals; stop at the "Stop here on red signal" sign.
The two rules a long vehicle gets wrong
Do not enter an intersection you cannot clear. If the road beyond is choked with vehicles travelling in the same direction, you must wait until there is room for your vehicle on the far side before you enter, even on a green light. This applies to a green light for going straight ahead and to a green light for turning left. In a 19-metre articulated vehicle you must judge the far-side gap against your whole combination , not against the cab.
A green light is not a right of way over pedestrians. A driver turning left or right must give way to pedestrians crossing the road being entered.
Red arrow with a "Left turn on red permitted after stopping" sign
Where this sign is displayed at an intersection with traffic lights, on a red light you must first stop , then turn left only if it is safe to do so. The stop is not optional and the give-way obligation is absolute.
- Lane Discipline
- Keeping left
On a multi-lane road with a speed limit of more than 80 km/h , you must drive in the left lane unless you are overtaking . The same rule is signposted on many two-lane freeways. For a heavy vehicle this is reinforced by two extra rules:
A truck over 4.5 tonnes GVM must move into a lane marked with a trucks lane sign , and must stay there at all times until a sign indicates the end of the restriction .
Only vehicles with a GVM greater than 4.5 tonnes may use a lane marked with a trucks lane sign — it is not a general slow-vehicle lane.
Bus lanes and bus-only lanes
Bus lanes and bus-only lanes are marked by signs or by lane markings. They may be used by public buses constructed principally to carry people, equipped to seat more than eight adults including the driver, and used to carry passengers for hire or reward or in the course of trade or business . A freight truck is not entitled to use a bus lane.
The B signal
Bus-only lanes at signalised intersections often carry a separate "B" signal . If you are driving a bus in a bus-only lane and you come to a B signal that is showing, you go through the intersection as you would on a normal green signal — the B signal is the bus equivalent of the green, released early to give buses a head start.
Priority for buses
In a built-up area , other drivers should give way to a bus displaying a give way sign when the bus is in front of them and is about to enter or proceed in the line of traffic. The bus driver is still required to obey the road rules when entering the traffic — the sign creates a courtesy priority, not an unconditional right of way. Buses cannot park at bus stops, but may wait at one before starting a regular passenger service.
Turning from the correct lane
Right turns must be made from the far right-hand lane , or from any other lane that has an arrow marked on the roadway permitting a right turn.
Where you turn right from one of two right-turn-only lanes , you still indicate right for the whole manoeuvre.
A long vehicle exception matters here: you may make a turn from the lane next to the left-hand lane when you are driving a vehicle over 7.5 metres long , because the vehicle physically cannot complete the turn from the kerb lane.
Lines on the road
Double unbroken dividing lines: you may cross them to enter or leave a driveway or property, if it is safe to do so . You may not cross them to overtake.
Unbroken lane lines: crossing one to change lanes is an offence, and it is one of the specific examples of negligent driving in the official pool.
Changing lanes is permitted only when it is safe to do so , and you must signal.
Merging
Where two lanes merge into one , the vehicle that has to cross a lane line gives way .
Entering a motorway , watch for a gap and increase your speed to merge safely with the traffic already on the motorway. Merging slowly from an on-ramp in a heavy vehicle forces the through traffic to brake and is a common cause of freeway crashes.
Emergency Vehicles and Trams
If you hear a siren , take whatever action is safely necessary to make way for the emergency vehicle — generally move to the left and let it pass.
At an intersection where a light rail vehicle is about to enter, wait until the intersection is clear .
Where police or a traffic controller are directing traffic, always follow their instructions , even if that contradicts the signals or signs.
Common Exam Traps
⚠️ "The light is green so I can enter." — Only if there is room for your whole vehicle on the far side.
⚠️ "It's 3 am and the road is empty, so I can turn on the red arrow." — No. A red arrow prohibits the turn regardless of traffic.
⚠️ "Yellow means speed up to clear." — No. Yellow means stop, unless stopping would require sudden braking.
⚠️ "A truck can use a bus lane if it is empty." — No. Bus lanes are for public buses as defined above.
⚠️ "I can cross double unbroken lines to get around a slow vehicle." — No. The only permitted crossing is to enter or leave a driveway or property, safely.