Study guide

1.2 Queensland Motorcycle Licensing Pathway: Q-Ride, Q-SAFE and the HPT

Queensland Motorcycle Knowledge Test Exam

Track your progress as you read

Finished sections get a check mark.

1 Exam Overview & Queensland Licensing Pathway

1.1 Queensland Motorcycle Knowledge Test: Format, Eligibility and Logistics 1.2 Queensland Motorcycle Licensing Pathway: Q-Ride, Q-SAFE and the HPT 1.3 A Source-Based Study Plan and the Numbers That Cause Errors

2 Queensland Motorcycle Learner Rules & Restrictions

2.1 Learner Supervision, Supervisor Qualifications and the Sidecar Exception 2.2 L Plates, Licence Carriage and Learner Operating Conditions 2.3 Zero BAC, Roadside Drug Testing and Impairment Consequences

3 The Learner Approved Motorcycle Scheme (LAMS) & Equipment

3.1 LAMS Eligibility: Capacity Bands, the Official List and Vehicle Verification 3.2 LAMS Exclusions, Allowable Modifications and Proof of Approval 3.3 Passengers, Sidecars, Loads, Animals and Towing

4 Special Motorcycle Road Rules & Offences

4.1 Lane Filtering and Edge Filtering: Two Different Queensland Rules 4.2 Mobile Phones, Licence-Based Restrictions and Rider Distraction 4.3 Demerit Points, Licence Sanctions and Motorcycle Offences

5 Protective Gear & Pre-Ride Bike Preparation

5.1 Approved Motorcycle Helmets: Standards, Fit and Care 5.2 Protective Clothing, Weather Protection and Visibility 5.3 Motorcycle Controls, Pre-Ride Checks and Maintenance

6 Roadcraft, Hazard Perception & Space Management

6.1 Queensland Roadcraft: Look, Slow Down, Move Away and 12–6–3 6.2 Crash-Avoidance Space, Vision and Stopped Buffers 6.3 Lane Positioning: Space, Surface and Sight 6.4 Rain, Night, Wind, Wildlife and Fatigue

7 Motorcycle Dynamics: Cornering, Braking & Surface Hazards

7.1 Riding Curves: Look, Slow Down and Move Away 7.2 Steering: Direct Steering, Countersteering and Look–Push–Go 7.3 Braking: Set Up and Squeeze, Both Brakes and Emergency Stops 7.4 Surface Hazards and Mechanical Problems While Riding

8 Queensland Road Rules, Speed Limits & Intersections

8.1 Speed Limits, School Zones, Shared Zones and Roadworks 8.2 Giving Way at Crossroads, T-Intersections, Signs and Driveways 8.3 Roundabouts: Giving Way, Lanes and Signals 8.4 Traffic Lights, Signs and Road Markings

9 Road Sharing, Overtaking & Crash Procedures

9.1 Pedestrians, Cyclists, Crossings and Shared Zones 9.2 Heavy Vehicles, Merging, Overtaking and Group Riding 9.3 Crash Duties, Emergency First Aid and Returning to Riding

1.2 Queensland Motorcycle Licensing Pathway: Q-Ride, Q-SAFE and the HPT

Key Takeaways Explain This Topic AI

Queensland motorcycle licences progress from RE learner to RE provisional or open and then to unrestricted R.

The pre-learner course has 34 modules over at least 2 days; the RE course has 15 modules over at least 1 day; the R course has 7 modules over half a day.

A standard RE learner must be held for at least 90 days; a pre-learner exemption normally makes that period at least 1 year.

The motorcycle hazard perception test may be taken while holding the RE learner licence and has no separate tenure requirement, but it must be passed before the RE course or Q-SAFE test.

Q-SAFE is available as an alternative only for eligible people living outside a 100-kilometre radius of a Q-Ride training area.

Last updated: September 2026

Queensland Motorcycle Licensing Pathway

Queensland uses two motorcycle licence classes. Class RE is restricted to learner-approved motorcycles. Class R is unrestricted. A new rider progresses through an RE learner licence, an RE provisional, probationary or open licence, and then an R licence. The type—provisional, probationary or open—usually follows the person’s underlying driver-licence type.

Step 1: qualify for and complete pre-learner training

An applicant for an RE learner licence must hold a current provisional, probationary or open licence and have held a car licence for at least 1 year in the past 5 years. The normal pathway begins with the Q-Ride pre-learner course , delivered by a TMR-approved Q-Ride registered service provider. Current TMR course information specifies 34 modules over a minimum of 2 days . It is an off-road course combining theory, demonstrations, coaching and practice in protective gear, motorcycle controls, curves, controlled braking and roadcraft.

A person who lives outside a 100-kilometre radius of a Q-Ride training area may apply to TMR for a pre-learner exemption. It is not an automatic rural exemption. If granted and accepted, it normally requires the resulting learner licence to be held for at least 1 year rather than the standard period.

Step 2: pass the knowledge test and receive RE learner authority

After course completion or an approved exemption is recorded, the applicant passes the 30-question motorcycle knowledge test with at least 27 correct. A competency declaration or online notification is not itself a licence. The person must have the RE learner authority issued or added before learning on a road.

While learning, the rider must use a LAMS-approved motorcycle, display the rear L plate, have zero BAC, carry the licence, wear an approved helmet, avoid lane and edge filtering and ride under the direction of a qualified supervisor. The standard minimum learner period is 90 days . TMR’s older guide describes this as three months, but the current learner page uses 90 days; use the current wording when planning eligibility.

Step 3: pass the motorcycle hazard perception test

The online motorcycle hazard perception test (HPT) presents situations from a rider’s perspective and assesses recognition of hazards and the timing of safe responses. TMR says a candidate must hold the learner motorcycle licence. There is no separate HPT tenure requirement . It may therefore be completed during the learner period, but it must be passed before the candidate undertakes the restricted RE course or the Q-SAFE RE riding test.

Do not confuse “must hold the learner licence for 90 days before upgrading” with “must wait 90 days before taking the HPT.” They are different requirements.

Step 4: move to an RE provisional, probationary or open licence

After the applicable learner tenure and HPT are complete, the normal path is the Q-Ride restricted (RE) course . TMR lists 15 modules delivered over a minimum of 1 day , divided between off-road and on-road activities. The course develops the skills and judgement needed for unsupervised riding.

Q-SAFE is a practical riding test conducted by a Queensland Government examiner. It is not a freely interchangeable choice for every candidate: TMR permits it as an alternative when the applicant lives outside a 100-kilometre radius of a Q-Ride training area. Avoid unsupported claims about a fixed route, automatic instant-fail rules or how popular either route is.

An RE provisional or open holder may ride a LAMS motorcycle without supervision. P1 and P2 riders display the appropriate rear P plate. For the first year of holding RE provisional or open, the rider has a zero-alcohol limit and may not carry either a pillion passenger or a passenger in a sidecar.

Step 5: progress from RE to R

The normal minimum RE provisional or open tenure before progressing to R is 2 years . The rider then completes the Q-Ride unrestricted (R) course or, if eligible by location, a Q-SAFE R test. TMR describes the R course as 7 modules delivered over half a day , primarily on road. An R licence permits an unrestricted motorcycle and permits a passenger immediately, subject to the ordinary passenger rules.

The pathway is therefore:

  • meet the underlying licence-history requirement;
  • complete the pre-learner course or receive an exemption;
  • pass the knowledge test and obtain RE learner authority;
  • practise under supervision for the applicable tenure and pass the HPT;
  • complete the RE course or eligible Q-SAFE test; and

after the required RE tenure, complete the R course or eligible Q-SAFE test.

Always check TMR before booking because course availability, fees and administrative methods can change even when the core licensing sequence remains the same.