Study guide

8.3 Roundabouts: Giving Way, Lanes and Signals

Queensland Motorcycle Knowledge Test Exam

Track your progress as you read

Finished sections get a check mark.

1 Exam Overview & Queensland Licensing Pathway

1.1 Queensland Motorcycle Knowledge Test: Format, Eligibility and Logistics 1.2 Queensland Motorcycle Licensing Pathway: Q-Ride, Q-SAFE and the HPT 1.3 A Source-Based Study Plan and the Numbers That Cause Errors

2 Queensland Motorcycle Learner Rules & Restrictions

2.1 Learner Supervision, Supervisor Qualifications and the Sidecar Exception 2.2 L Plates, Licence Carriage and Learner Operating Conditions 2.3 Zero BAC, Roadside Drug Testing and Impairment Consequences

3 The Learner Approved Motorcycle Scheme (LAMS) & Equipment

3.1 LAMS Eligibility: Capacity Bands, the Official List and Vehicle Verification 3.2 LAMS Exclusions, Allowable Modifications and Proof of Approval 3.3 Passengers, Sidecars, Loads, Animals and Towing

4 Special Motorcycle Road Rules & Offences

4.1 Lane Filtering and Edge Filtering: Two Different Queensland Rules 4.2 Mobile Phones, Licence-Based Restrictions and Rider Distraction 4.3 Demerit Points, Licence Sanctions and Motorcycle Offences

5 Protective Gear & Pre-Ride Bike Preparation

5.1 Approved Motorcycle Helmets: Standards, Fit and Care 5.2 Protective Clothing, Weather Protection and Visibility 5.3 Motorcycle Controls, Pre-Ride Checks and Maintenance

6 Roadcraft, Hazard Perception & Space Management

6.1 Queensland Roadcraft: Look, Slow Down, Move Away and 12–6–3 6.2 Crash-Avoidance Space, Vision and Stopped Buffers 6.3 Lane Positioning: Space, Surface and Sight 6.4 Rain, Night, Wind, Wildlife and Fatigue

7 Motorcycle Dynamics: Cornering, Braking & Surface Hazards

7.1 Riding Curves: Look, Slow Down and Move Away 7.2 Steering: Direct Steering, Countersteering and Look–Push–Go 7.3 Braking: Set Up and Squeeze, Both Brakes and Emergency Stops 7.4 Surface Hazards and Mechanical Problems While Riding

8 Queensland Road Rules, Speed Limits & Intersections

8.1 Speed Limits, School Zones, Shared Zones and Roadworks 8.2 Giving Way at Crossroads, T-Intersections, Signs and Driveways 8.3 Roundabouts: Giving Way, Lanes and Signals 8.4 Traffic Lights, Signs and Road Markings

9 Road Sharing, Overtaking & Crash Procedures

9.1 Pedestrians, Cyclists, Crossings and Shared Zones 9.2 Heavy Vehicles, Merging, Overtaking and Group Riding 9.3 Crash Duties, Emergency First Aid and Returning to Riding

8.3 Roundabouts: Giving Way, Lanes and Signals

Key Takeaways Explain This Topic AI

A rider entering a roundabout gives way to every vehicle already in it, not merely a vehicle approaching from the right.

Follow lane arrows and signs; unless they say otherwise, use the left lane for left, either permitted lane for straight and the right lane for right or U-turn.

Signal left for a first-exit left turn and right for a right turn or U-turn; no approach signal is normally required for straight.

Signal left before leaving the roundabout when practicable and stop the signal after exit.

Avoid travelling beside a long vehicle through a roundabout because its turning path and blind spots may occupy another lane.

Last updated: September 2026

Roundabouts: Giving Way, Lanes and Signals

The entry rule is simple but often misstated: a driver entering a roundabout must give way to any vehicle already in the roundabout . It is not a “give way to the right” rule. A vehicle already circulating can approach from another position after a multi-lane movement, and its presence—not its compass direction—creates the duty.

Approach and entry

Read the roundabout sign, lane arrows and destination signs early. Check mirrors, reduce speed and select the correct lane before reaching the give-way line. Scan every circulating lane, bicycle movements, pedestrians near exits and vehicles whose indicators may be late or wrong.

Enter only when the gap allows the motorcycle to join without affecting another vehicle’s crash-avoidance space. Legal priority never makes a small gap safe.

Lane selection

Traffic-lane arrows and signs control. When no marking says otherwise, the general pattern is:

  • left / first exit: approach in the left lane or left line of traffic;
  • straight / halfway around: use a lane permitted by arrows—commonly either lane on a two-lane approach; and

right or U-turn / more than halfway: approach in the right lane or right line of traffic.

Remain in the selected lane through the roundabout unless making a lawful lane change. A lane change requires sufficient warning, a mirror and head check, and giving way to traffic in the destination lane. Do not cut from an inside lane across a vehicle in an outer lane to reach the exit.

Signals

For a first-exit left turn, signal left on approach and keep signalling through the exit. For straight ahead, do not normally signal on approach. For a right turn or U-turn, signal right on approach and continue while circulating until preparing to leave.

When leaving a roundabout, signal left if practicable , starting after passing the exit immediately before the intended exit. Very small roundabouts may make an exit signal impracticable, but the rider should signal whenever it can be done. Cancel the signal after leaving.

Indicators communicate intention; they do not create priority. Continue to observe and give way.

Motorcycle position and surface

Use the lane position that balances space, surface and sight. Buffer a vehicle waiting to enter, but do not move into another circulating lane. Look for diesel, oil, gravel and wet markings, especially near give-way lines and tight turns. Reduce speed before lean and keep control inputs smooth.

Avoid filtering in or through a roundabout unless every condition of the lane-filtering rule is met; a dedicated turning lane cannot be used for filtering. For a learner or provisional rider, filtering is prohibited everywhere.

Heavy vehicles

Long vehicles may use more than one lane to turn and their rear wheels can cut across the inside of the path. A vehicle displaying “Do Not Overtake Turning Vehicle” has special turning rights in the stated circumstances. Never place the motorcycle beside it in a roundabout or on the side toward which it is turning. Stay back where the driver can see the motorcycle and allow the whole combination to clear.

Examples

Straight ahead on a marked two-lane approach: choose a lane whose arrow permits straight. Give way to all circulating vehicles. Enter and remain in that lane, then indicate left after the prior exit if practicable.

Right turn: use the right lane unless markings permit another. Signal right, give way and enter the matching circulatory lane. After passing the exit before yours, signal left and leave from the lawful lane.

Vehicle already in the far circulating lane: do not enter merely because it appears left of the motorcycle or is not “coming from the right.” It is in the roundabout, so give way if the paths may conflict.

Exam traps

“Give way only to vehicles on the right” is wrong.

A right indicator on a circulating vehicle is useful information, not a guarantee.

The lane table yields to actual arrows and signs.

An exit signal is required when practicable.

A motorcycle’s narrow width does not permit it to share a circulatory lane unsafely.

Approach slowly enough to read, decide and stop.

If an emergency vehicle approaches, do not stop on the roundabout unless necessary to avoid a collision. Continue to a safe exit, then comply with the emergency-vehicle rule. If an exit is blocked, do not enter simply because the entry gap is open; wait behind the give-way line so the motorcycle does not stop across a circulating lane or pedestrian path.