Study guide
Heavy Vehicle Licence Classes and Transmission Restrictions
VicRoads Heavy Vehicle Knowledge Test — Rigid KT4
Track your progress as you read
Finished sections get a check mark.
1 Victorian Road Rules — Driver Obligations
Speed Limits for Heavy Vehicles in Victoria Zero BAC and Roadside Drug Testing for Heavy Vehicle Drivers Seatbelts, Parking Restrictions, and Night-Time Clearance Lighting Railway Crossing Procedures for Buses and Heavy Vehicles
2 Victorian Road Rules — Road Situations and Chain of Responsibility
Portable Warning Triangles: Carriage, Placement, and AS 3790 Following Distances, Lane Changes, and Turn Procedures for Long Vehicles Chain of Responsibility, Weighbridge Stops, and Enforcement Powers
3 Heavy Vehicle Law, Dimensions, and Access
Heavy Vehicle Licence Classes and Transmission Restrictions Mass and Dimension Limits for Rigid Vehicles Heavy Vehicle Road Signs, Access Restrictions, and Oversize/Overmass Permits
4 Vehicle Inspections and Roadworthiness
Pre-Operational Daily Checks: Cabin, Engine, Tyres, Brakes, and Lights Air Brake vs Hydraulic Brake System Checks and After-Departure Inspection Defect Identification, Roadworthiness Obligations, and Regular Mechanical Inspections
5 Vehicle Control, Braking, and Gear Selection
Double-Clutching and Gear Selection for Non-Synchromesh Gearboxes Braking Systems, Brake Fade, Stopping Distances, and Air Brake Delay Off-Tracking, Rollover Risk, Crash Avoidance Space, and Skid Correction
6 Load Restraint and Load Rules
6.1 Load Restraint Performance Standards 6.2 Tie-down vs Direct Restraint Methods 6.3 Load Placement, Distribution, Overhang Limits, and Load Security Checks
7 Fatigue Management and Work Diary
Standard Hours, BFM, AFM and ACH: Work/Rest Options and Fatigue-Regulated Vehicles National Driver Work Diary: Requirements, Completion, Record-Keeping, and Fatigue Prevention
8 Coupling and Combination Vehicle Rules
Coupling and Uncoupling: Procedures, Air Lines, Trailer Park Brake, Roll-Away Confirmation, and HC Licence Threshold
Heavy Vehicle Licence Classes and Transmission Restrictions
Key Takeaways Explain This Topic AI
Victorian heavy vehicle licences run LR → MR → HR → HC → MC, and each class also covers every lower class.
MR is GVM over 8 t with no more than 2 axles; HR is GVM over 8 t with 3 or more axles. HR may tow one trailer (not a semi-trailer) up to 9 t GVM; a heavier trailer needs HC.
The B condition is applied when you are tested in a synchromesh vehicle (or get an automatic heavy licence while holding a manual car licence) and limits you to synchromesh or automatic heavy vehicles.
To remove the B condition you must be re-tested in a vehicle fitted with a non-synchromesh (constant-mesh) transmission.
You need a current Victorian car licence and an Australian car licence held for at least 24 months for HR (12 months for LR or MR); P1 and P2 holders may apply once the holding period is met.
Last updated: October 2026
The Victorian heavy vehicle licence ladder
Victoria issues five heavy vehicle licence categories — LR, MR, HR, HC and MC — and they are recognised throughout Australia. You need one to drive a truck or bus with a Gross Vehicle Mass (GVM) greater than 4.5 tonnes , or a bus that seats more than 12 adults. Each class authorises the vehicles of the lower classes plus its own, so the class on your licence card is the upper limit of what you may drive. The rigid classes are decided by GVM and number of axles ; the combination classes by the trailer.
Remember that GVM is the maximum loaded mass the manufacturer specifies (or VicRoads records), not the empty (tare) mass or what the truck weighs today.
Class Full name Vehicles in the class (Transport Victoria) Also authorises
LR Light Rigid GVM more than 4.5 t but not more than 8 t; or a bus seating more than 12 adults (including the driver) with a GVM not more than 8 t Car; a car or LR vehicle towing a single trailer with GVM not more than 9 t
MR Medium Rigid GVM more than 8 t with no more than 2 axles Everything LR covers; an MR vehicle towing a single trailer (not a semi-trailer) with GVM not more than 9 t
HR Heavy Rigid GVM more than 8 t with 3 or more axles ; also an articulated bus Everything MR covers; a prime mover not towing a trailer; an HR vehicle towing a single trailer (not a semi-trailer) with GVM not more than 9 t
HC Heavy Combination A prime mover with a single semi-trailer over 9 t GVM, or a rigid vehicle towing a trailer over 9 t GVM Everything HR covers
MC Multi Combination Any motor vehicle or combination other than a motorcycle (B-doubles, road trains) Everything
Two thresholds deserve special attention. MR and HR are split by axles, not by a mass ceiling : a two-axle rigid truck with a GVM over 8 tonnes is MR however heavy it is, and a rigid with three or more axles and a GVM over 8 tonnes is HR. HC turns on the trailer : a prime mover with a semi-trailer over 9 t GVM, or a rigid vehicle towing a trailer over 9 t GVM, needs HC.
What an HR licence authorises
The Victorian HR licence — the one this study guide prepares you for — authorises:
Any heavy rigid vehicle : a motor vehicle with GVM over 8 t and three or more axles (the typical three-axle rigid truck or tipper), and an articulated bus.
A prime mover that is not towing a trailer.
Any MR vehicle (GVM over 8 t, no more than two axles), any LR vehicle and any car .
An HR vehicle towing a single trailer, other than a semi-trailer , with a GVM not more than 9 t (for example a small dog trailer).
What HR does not authorise: a combination with a trailer over 9 t GVM (that is HC), towing a semi-trailer, and any B-double, road train or other multi-combination (MC).
The B condition: synchromesh restriction
Heavy vehicle gearboxes come in two broad families relevant to the Victorian test: synchromesh (and automatic transmissions), where gear engagement is smoothed by synchronisers so you can shift with a single clutch movement, and non-synchromesh (constant-mesh or "crash box", including "Road Ranger" gearboxes), where the driver must match engine speed to road speed to engage gears without grinding.
Transport Victoria says that if you were tested in a vehicle fitted with a synchromesh transmission , a synchromesh (B) condition is placed on your licence and you may only drive heavy vehicles with a synchromesh or automatic transmission. If you get an automatic heavy vehicle licence while holding a manual car licence, the B condition also applies. A licence holder who already has a heavy vehicle licence without a B restriction does not have one imposed.
To remove the B condition you must be re-tested in a vehicle fitted with a non-synchromesh transmission, booked through an accredited provider. There is no knowledge-test-only path to removing it. Many employers prefer unrestricted drivers because constant-mesh gearboxes are still found in older trucks, so removing the B condition can broaden your employability.
Prerequisites and the upgrade path
To get a heavy vehicle licence in Victoria you need to:
Hold a current Victorian car licence . Probationary P1 and P2 licence holders may apply once the minimum holding period is met.
Meet the holding period : an Australian car licence held for at least 12 months for LR or MR, or at least 24 months for HR. Periods of suspension or disqualification do not count.
Pass an eyesight test and meet the national medical standards for private and commercial vehicle drivers.
Pass the heavy vehicle knowledge test — a written test based on the Victorian Bus & Truck Drivers' Handbook. Transport Victoria does not publish a statewide question count or pass mark.
Pass the off-road and on-road assessments with an accredited provider. The HR assessment vehicle must be a rigid vehicle (not an unladen prime mover) with at least three axles and a GVM of at least 15 tonnes (or one of the other listed HR assessment vehicles, such as a three-axle articulated bus).
Transport Victoria says the heavy vehicle knowledge test must be passed when you apply for a heavy vehicle licence for the first time . An MR holder who later upgrades to HR therefore needs the HR practical assessments, not a second knowledge test. A car licence holder with 24 months' history can go straight to HR without holding LR or MR first.
Why the class ladder matters in the test
The Victorian knowledge test asks which class authorises which vehicle, what the GVM and axle boundaries are, and what the B condition means. Memorise the GVM thresholds ( 4.5 t and 8 t ), the axle split ( 2 axles = MR, 3 or more = HR ), and the trailer threshold ( trailer GVM over 9 t = HC ). Know that the class on your card covers all lower classes — but never any class above it, and never a non-synchromesh vehicle if the B condition is present.