Study guide
Portable Warning Triangles: Carriage, Placement, and AS 3790
VicRoads Heavy Vehicle Knowledge Test — Rigid KT4
Track your progress as you read
Finished sections get a check mark.
1 Victorian Road Rules — Driver Obligations
Speed Limits for Heavy Vehicles in Victoria Zero BAC and Roadside Drug Testing for Heavy Vehicle Drivers Seatbelts, Parking Restrictions, and Night-Time Clearance Lighting Railway Crossing Procedures for Buses and Heavy Vehicles
2 Victorian Road Rules — Road Situations and Chain of Responsibility
Portable Warning Triangles: Carriage, Placement, and AS 3790 Following Distances, Lane Changes, and Turn Procedures for Long Vehicles Chain of Responsibility, Weighbridge Stops, and Enforcement Powers
3 Heavy Vehicle Law, Dimensions, and Access
Heavy Vehicle Licence Classes and Transmission Restrictions Mass and Dimension Limits for Rigid Vehicles Heavy Vehicle Road Signs, Access Restrictions, and Oversize/Overmass Permits
4 Vehicle Inspections and Roadworthiness
Pre-Operational Daily Checks: Cabin, Engine, Tyres, Brakes, and Lights Air Brake vs Hydraulic Brake System Checks and After-Departure Inspection Defect Identification, Roadworthiness Obligations, and Regular Mechanical Inspections
5 Vehicle Control, Braking, and Gear Selection
Double-Clutching and Gear Selection for Non-Synchromesh Gearboxes Braking Systems, Brake Fade, Stopping Distances, and Air Brake Delay Off-Tracking, Rollover Risk, Crash Avoidance Space, and Skid Correction
6 Load Restraint and Load Rules
6.1 Load Restraint Performance Standards 6.2 Tie-down vs Direct Restraint Methods 6.3 Load Placement, Distribution, Overhang Limits, and Load Security Checks
7 Fatigue Management and Work Diary
Standard Hours, BFM, AFM and ACH: Work/Rest Options and Fatigue-Regulated Vehicles National Driver Work Diary: Requirements, Completion, Record-Keeping, and Fatigue Prevention
8 Coupling and Combination Vehicle Rules
Coupling and Uncoupling: Procedures, Air Lines, Trailer Park Brake, Roll-Away Confirmation, and HC Licence Threshold
Portable Warning Triangles: Carriage, Placement, and AS 3790
Key Takeaways Explain This Topic AI
A vehicle with a GVM over 12 tonnes must carry at least three portable warning triangles (Road Safety Road Rules r. 226); the handbook says they must comply with AS 3790.
At 80 km/h or more, if the vehicle is not visible for 300 m, place one triangle 200–250 m behind, one 200–250 m in front and one beside the vehicle or fallen load.
Under 80 km/h, if the vehicle is not visible for 200 m, use the same three positions at 50–150 m behind and in front, plus one beside.
On a one-way or divided road no triangle goes in front: the second goes between the vehicle and the rear triangle. A painted median does not make a road divided.
Failing to carry, produce or correctly place the triangles is an offence under Victoria's Road Safety Road Rules (3 penalty units).
Last updated: October 2026
Portable Warning Triangles: Carriage, Placement, and AS 3790
Quick Answer: In Victoria a vehicle with a Gross Vehicle Mass (GVM) over 12 tonnes must carry at least three portable warning triangles (Road Safety Road Rules r. 226). If it stops on a road, or its load falls onto a road, and it cannot be seen for a set distance in all directions, the driver must put out all three (r. 227). On a road with a speed limit of 80 km/h or more (not visible for 300 m ): one triangle 200–250 m behind , one 200–250 m in front , and one beside the vehicle or fallen load. On a road under 80 km/h (not visible for 200 m ): the same pattern at 50–150 m . On a one-way or divided road the front triangle goes instead between the vehicle and the rear triangle.
Why Triangles Matter
A broken-down heavy vehicle on a high-speed road is a dangerous obstacle. A car travelling at 100 km/h covers roughly 28 metres per second — a driver who spots your truck only 100 metres away has under four seconds to react and stop. Triangles give approaching drivers time to slow down, change lanes, or stop safely. They are a legal requirement under Victoria's Road Safety Road Rules 2017 , rules 226 and 227, and a core duty for any HR licence holder.
Carriage Requirements
How many triangles must you carry?
At least three portable warning triangles in any vehicle with a GVM over 12 tonnes , including a rigid HR vehicle, whether loaded or empty. The requirement attaches to the vehicle's GVM, not the load.
The handbook says warning triangles must comply with Australian Standard AS 3790 . The Road Safety Road Rules also require a type approved under r. 407(g) that shows a clear red warning light, or a red reflection of a vehicle's headlights at night, visible from 200 metres. The handbook's emergency equipment list says "at least three, two-faced portable warning triangles".
You must produce the triangles for inspection when a police officer or authorised person directs you to (r. 226(2)).
Triangles must be in good condition — faded, cracked, or non-reflective triangles do not do their job. Inspect them in your daily pre-start check.
When must you place triangles?
Rule 227 applies to a driver whose vehicle has a GVM over 12 tonnes. You must use the triangles when you stop on a road , or some or all of your load falls onto a road , and the vehicle is not visible from that place for at least:
300 metres in all directions, where the speed limit is 80 km/h or more ; or
200 metres in all directions, where the speed limit is less than 80 km/h .
For this rule a road includes its shoulder. Typical triggers are breakdowns, tyre failures, load shifts and crashes. A stop at a rest area or truck bay off the road does not trigger the rule.
Placement Distances
- Road speed limit Visibility trigger Behind In front (two-way undivided road) Third triangle
- 80 km/h or more Not visible for 300 m in all directions 200–250 m 200–250 m Beside the vehicle or fallen load
- Under 80 km/h Not visible for 200 m in all directions 50–150 m 50–150 m Beside the vehicle or fallen load
- One-way and divided roads
On a one-way road or a divided road , three triangles are still needed, but none goes in front: the second triangle is placed between the vehicle (or fallen load) and the rear triangle , and the third still goes beside it. A road with only a painted median is not a divided road for this rule (r. 227(7)), so on a painted-median road you still place one in front.
Worked Example: Breakdown on a 100 km/h Two-Lane Highway
You are driving a 22-tonne HR rigid truck on a country highway with one lane each way and no median, speed limit 100 km/h , and a rear axle bearing fails just past a crest. You pull onto the shoulder and stop. Traffic coming over the crest cannot see you from 300 m.
Switch on hazard lights immediately.
The limit is 80 km/h or more and the truck is not visible for 300 m, so all three triangles are required.
Walk back along the shoulder, keeping off the live traffic lane, and place one triangle 200–250 m behind the truck, facing approaching traffic.
Place one triangle 200–250 m in front of the truck, because the road is two-way and undivided.
Place the third triangle beside the truck where it gives the best warning of its position.
Stay well clear of the traffic lane and call for assistance.
Worked Example: Breakdown on a 60 km/h Road Around a Bend
Your 15-tonne truck loses drive on a road signed 60 km/h , just around a blind bend, so it cannot be seen from 200 m. Because the limit is under 80 km/h and the 200 m visibility trigger is met, place all three triangles: one 50–150 m behind , one 50–150 m in front (unless the road is one-way or divided), and one beside the truck.
Common Exam Traps
Trap 1: "Two triangles are enough on a freeway." Wrong — when the rule applies, three are used. On a divided freeway the front one moves behind, between the truck and the rear triangle.
Trap 2: "Under 80 km/h one triangle is enough." Wrong — when the vehicle is not visible for 200 m, the rule needs three : behind, in front (or between on a one-way or divided road) and beside, at 50–150 m.
Trap 3: "Triangles are only required when loaded." No — carriage depends on GVM over 12 tonnes , not on the load. An empty HR rigid still carries them.
Trap 4: "A painted median makes it a divided road." No — a road whose median is only painted lines is not a divided road for r. 227, so the front triangle is still needed.
Trap 5: "You can skip triangles if hazard lights are on." No — hazard lights do not replace triangles when r. 227 requires them.
Inspection and Maintenance
Check triangles in your daily pre-start : confirm three are present, clean, undamaged, and reflective.
Replace faded or cracked triangles.
Store them where they will not be damaged by load movement or weather.
If you drop a triangle on the road while placing it, do not chase it into live traffic; wait for a gap.
Victorian Enforcement
Victoria Police and authorised officers can direct you to produce your triangles. Failing to carry three triangles, failing to produce them, and failing to place them as r. 227 requires are each offences with a penalty of 3 penalty units . Under Chain of Responsibility, an operator who fails to supply the triangles its drivers need can also breach its own duty.