Study guide

Seatbelts, Parking Restrictions, and Night-Time Clearance Lighting

VicRoads Heavy Vehicle Knowledge Test — Rigid KT4

Track your progress as you read

Finished sections get a check mark.

1 Victorian Road Rules — Driver Obligations

Speed Limits for Heavy Vehicles in Victoria Zero BAC and Roadside Drug Testing for Heavy Vehicle Drivers Seatbelts, Parking Restrictions, and Night-Time Clearance Lighting Railway Crossing Procedures for Buses and Heavy Vehicles

2 Victorian Road Rules — Road Situations and Chain of Responsibility

Portable Warning Triangles: Carriage, Placement, and AS 3790 Following Distances, Lane Changes, and Turn Procedures for Long Vehicles Chain of Responsibility, Weighbridge Stops, and Enforcement Powers

3 Heavy Vehicle Law, Dimensions, and Access

Heavy Vehicle Licence Classes and Transmission Restrictions Mass and Dimension Limits for Rigid Vehicles Heavy Vehicle Road Signs, Access Restrictions, and Oversize/Overmass Permits

4 Vehicle Inspections and Roadworthiness

Pre-Operational Daily Checks: Cabin, Engine, Tyres, Brakes, and Lights Air Brake vs Hydraulic Brake System Checks and After-Departure Inspection Defect Identification, Roadworthiness Obligations, and Regular Mechanical Inspections

5 Vehicle Control, Braking, and Gear Selection

Double-Clutching and Gear Selection for Non-Synchromesh Gearboxes Braking Systems, Brake Fade, Stopping Distances, and Air Brake Delay Off-Tracking, Rollover Risk, Crash Avoidance Space, and Skid Correction

6 Load Restraint and Load Rules

6.1 Load Restraint Performance Standards 6.2 Tie-down vs Direct Restraint Methods 6.3 Load Placement, Distribution, Overhang Limits, and Load Security Checks

7 Fatigue Management and Work Diary

Standard Hours, BFM, AFM and ACH: Work/Rest Options and Fatigue-Regulated Vehicles National Driver Work Diary: Requirements, Completion, Record-Keeping, and Fatigue Prevention

8 Coupling and Combination Vehicle Rules

Coupling and Uncoupling: Procedures, Air Lines, Trailer Park Brake, Roll-Away Confirmation, and HC Licence Threshold

Seatbelts, Parking Restrictions, and Night-Time Clearance Lighting

Key Takeaways Explain This Topic AI

All occupants of a heavy vehicle must wear a seatbelt where one is fitted; the driver is responsible for ensuring passengers under 16 are belted.

A heavy vehicle (over 4.5 t GVM) or long vehicle (7.5 m or longer) must not stop on a road in a built-up area for more than 1 hour, unless signs or the council permit it or the driver is picking up or dropping off goods (r. 200).

A vehicle 2.2 metres wide or wider that stops on a road at night must have its clearance and side marker lights operating (Road Safety Road Rules r. 220).

Parking a heavy vehicle on a verge, nature strip, or footpath is prohibited unless a sign permits it.

Headlights must be on at night or in hazardous conditions; hazard lights are for temporary stops only.

Last updated: October 2026

Seatbelt Requirements

Under the Victorian Road Safety Road Rules, every occupant of a motor vehicle must wear a seatbelt where one is fitted. For a heavy rigid truck, this includes the driver and any co-driver or passenger travelling in the cabin. The driver is responsible for ensuring that passengers under 16 years of age are wearing a seatbelt; adult passengers are personally liable for their own non-compliance, but the driver still commits an offence by carrying an unbelted passenger where the seat is fitted with a belt.

Seatbelts must be in good working order. A frayed, cut, or non-retracting belt is a defect that can draw an on-the-spot defect notice and pull the truck off the road. A driver who modifies or removes a fitted seatbelt commits an offence. The only exemptions are medical conditions certified in writing by a medical practitioner and certain vintage vehicles not originally fitted with belts — neither exemption applies to a modern heavy rigid truck.

Co-Driver and Sleeper Cabin Rules

In a two-up operation, the off-duty co-driver is still an occupant of the vehicle and must wear a seatbelt when seated in the front seat. A co-driver resting in a sleeper cabin is not required to wear a seatbelt while lying down (a sleeper is not a seating position), but must belt up before moving to the front seat. The driver must not move the vehicle while an unrestrained occupant is in the cabin seating area.

Parking Restrictions for Heavy Vehicles

Victoria restricts on-street parking of heavy vehicles to limit obstruction and preserve local amenity. Two main rules apply.

The 1-Hour Rule

Under rule 200 of the Road Safety Road Rules, the driver of a heavy vehicle (GVM over 4.5 tonnes ) OR a long vehicle ( 7.5 metres or longer , including any load or projection) must not stop on a length of road in a built-up area for longer than 1 hour , unless a sign or the council permits it, or (for a vehicle other than a bus) the driver is dropping off or picking up goods the whole time. The 1-hour clock starts when the vehicle stops; moving it to a different parking spot on the same length of road does not reset the time. The rule is enforced by local council parking officers and Victoria Police.

The threshold is "over 4.5 t GVM or 7.5 m or longer", not both. A long but light truck and a short but heavy truck both fall under the 1-hour rule.

Nature Strips, Footpaths, and Verge Parking

Parking a heavy vehicle on a nature strip, footpath, or verge is prohibited unless a sign expressly permits it. This is the most commonly issued infringement in suburban streets and applies regardless of vehicle size. A heavy rigid truck partially parked with wheels on a nature strip to keep the roadway clear is still committing an offence — the offence is the placement on the nature strip, not the obstruction of traffic.

Other Parking Prohibitions

A heavy vehicle must not park within:

1 metre of a fire hydrant, fire hydrant indicator or fire plug indicator (r. 194)

10 metres from the nearest point of an intersecting road at an intersection without traffic lights, or 20 metres where there are traffic lights (r. 170)

20 metres before and 10 metres after a bus stop sign (r. 195)

When parallel parking outside marked bays, leave at least 1 metre to the vehicles in front and behind.

Double parking, parking against the flow of traffic, and stopping on a level crossing or within 20 m before or after the nearest rail (r. 175) are separately prohibited.

Night-Time Clearance Lighting for Wide Vehicles

Under rule 220 of Victoria's Road Safety Road Rules, a driver must not stop on a road at night unless, for a vehicle 2.2 metres wide or wider , the vehicle's clearance and side marker lights are operating effectively and clearly visible (other vehicles show parking lights). The rule does not apply where the road has street lighting and the vehicle is visible for at least 200 metres in all directions. The lamps themselves are required by the vehicle standards.

Specifications

Front clearance lamps : white or yellow, fitted at the widest part of the vehicle facing forward, visible from the front

Rear clearance lamps : red, fitted at the widest part of the vehicle facing rearward, visible from the rear

Side marker lamps : yellow (front half of vehicle) and red (rear half), spaced along the side at intervals not exceeding specified distances

Reflex reflectors : matching colour to the lamps, fitted to mark the extremities of width and length

The 2.2 m width threshold is important because the general maximum width for a heavy vehicle without an overdimension permit is 2.5 metres . Most loaded heavy rigid trucks are between 2.4 and 2.5 m wide and therefore above the 2.2 m clearance lamp threshold — this rule bites on the majority of rigid trucks, not only the unusual ones.

Worked Lighting Scenario

Vehicle Width Day Night

HR truck, 2.45 m wide, stopped on the road 2.45 m No clearance lamps required Clearance and side marker lights operating (2.2 m or wider)

HR truck, 2.10 m wide, stopped on the road 2.10 m No clearance lamps required Parking lights operating (under 2.2 m)

Oversize load, 3.0 m wide, with permit 3.0 m Oversize signs, flags, and (for some classes) pilot vehicles required Clearance lamps plus oversize lighting as per the permit

Other Lighting and Visibility Rules

Headlights must be on at night, in fog, or in hazardous weather reducing visibility (e.g. heavy rain, smoke). High beam must be dipped within 200 m of an oncoming vehicle and within 200 m when following another vehicle.

Hazard lights (four-way flashers) are for temporary stops where the vehicle is a hazard to others — breakdown, slow-moving works vehicle, or queued traffic. They are not a substitute for parking legally.

Rear number plate light must illuminate the plate so it is readable at 20 m at night.

Reflective side markings (conspicuity tape) are required on most heavy vehicles over 12t GVM; check the relevant Australian Design Rule for the vehicle's date of manufacture.

Worked Parking Scenario

Scenario Lawful? Why

HR driver parks on a residential street at 9:00 am, moves the truck 50 m forward at 10:00 am, parks again No — 1-hour rule breach The 1-hour rule applies to a length of road; moving the truck within the same length does not reset the clock

HR driver parks half on the road and half on the nature strip in a residential street No — nature strip offence Parking on a nature strip or footpath is prohibited unless a sign permits it, regardless of vehicle size

HR truck, 2.45 m wide, parked on an unlit roadside at night without clearance lamps No — lighting offence A vehicle 2.2 m wide or wider that stops on a road at night must have its clearance and side marker lights operating (r. 220)

HR driver parked within 1 m of a fire hydrant No — hydrant offence Stopping within 1 m of a fire hydrant is prohibited regardless of vehicle size (r. 194)

Common Exam Traps

The 1-hour rule threshold is "over 4.5 t GVM or 7.5 m or longer" — either condition triggers the rule, not both.

Moving a truck a short distance within the same length of road does not reset the 1-hour clock; the rule is about on-street presence in a built-up area, not the parking bay.

A nature strip is part of the road reserve; parking on it is an offence unless a sign permits it, even when done to keep the roadway clear.

The 2.2 m threshold in r. 220 is below the 2.5 m general width limit, so most rigid trucks stopped on an unlit road at night need their clearance and side marker lights on — do not assume your truck is under the threshold because it is "only 2.45 m wide".

Hazard lights are not a parking exemption; they identify a temporary hazard such as a breakdown or a slow-moving works vehicle.

A driver must wear a seatbelt at all times the vehicle is moving, and an off-duty co-driver must belt up before moving to the front seat.