Study guide

Speed Limits for Heavy Vehicles in Victoria

VicRoads Heavy Vehicle Knowledge Test — Rigid KT4

Track your progress as you read

Finished sections get a check mark.

1 Victorian Road Rules — Driver Obligations

Speed Limits for Heavy Vehicles in Victoria Zero BAC and Roadside Drug Testing for Heavy Vehicle Drivers Seatbelts, Parking Restrictions, and Night-Time Clearance Lighting Railway Crossing Procedures for Buses and Heavy Vehicles

2 Victorian Road Rules — Road Situations and Chain of Responsibility

Portable Warning Triangles: Carriage, Placement, and AS 3790 Following Distances, Lane Changes, and Turn Procedures for Long Vehicles Chain of Responsibility, Weighbridge Stops, and Enforcement Powers

3 Heavy Vehicle Law, Dimensions, and Access

Heavy Vehicle Licence Classes and Transmission Restrictions Mass and Dimension Limits for Rigid Vehicles Heavy Vehicle Road Signs, Access Restrictions, and Oversize/Overmass Permits

4 Vehicle Inspections and Roadworthiness

Pre-Operational Daily Checks: Cabin, Engine, Tyres, Brakes, and Lights Air Brake vs Hydraulic Brake System Checks and After-Departure Inspection Defect Identification, Roadworthiness Obligations, and Regular Mechanical Inspections

5 Vehicle Control, Braking, and Gear Selection

Double-Clutching and Gear Selection for Non-Synchromesh Gearboxes Braking Systems, Brake Fade, Stopping Distances, and Air Brake Delay Off-Tracking, Rollover Risk, Crash Avoidance Space, and Skid Correction

6 Load Restraint and Load Rules

6.1 Load Restraint Performance Standards 6.2 Tie-down vs Direct Restraint Methods 6.3 Load Placement, Distribution, Overhang Limits, and Load Security Checks

7 Fatigue Management and Work Diary

Standard Hours, BFM, AFM and ACH: Work/Rest Options and Fatigue-Regulated Vehicles National Driver Work Diary: Requirements, Completion, Record-Keeping, and Fatigue Prevention

8 Coupling and Combination Vehicle Rules

Coupling and Uncoupling: Procedures, Air Lines, Trailer Park Brake, Roll-Away Confirmation, and HC Licence Threshold

Speed Limits for Heavy Vehicles in Victoria

Key Takeaways Explain This Topic AI

Transport Victoria and the handbook say heavy vehicles must not travel faster than 100 km/h anywhere in Victoria, even where a sign shows 110 km/h.

The default urban speed limit in built-up areas is 50 km/h unless a sign says otherwise; the default rural (non-built-up) default is 100 km/h.

Victoria's 40 km/h limits apply in signed shopping strips and school zones during signed times, and when passing a stationary or slow-moving police, emergency or roadside assistance vehicle showing flashing lights.

Roadwork zones carry signed temporary limits that override all defaults and must be obeyed even when no workers are visible.

Driving a heavy vehicle faster than 100 km/h is an offence even on a road signed 110 km/h; a lower posted limit still applies.

Last updated: October 2026

The 100 km/h Heavy Vehicle Cap

Transport Victoria and the Victorian Bus & Truck Drivers' Handbook state the rule plainly: a heavy vehicle must not travel faster than 100 km/h anywhere in Victoria, even where a speed sign shows 110 km/h (for example on parts of the Hume Freeway). The legal detail is rule 21(2) of Victoria's Road Safety Road Rules 2017: where a sign shows more than 100 km/h, the limit is 100 km/h for a bus with a GVM over 5 tonnes, a prime mover with a GCM over 22 tonnes, or any other vehicle with a GVM over 12 tonnes. A heavy rigid truck reading a 110 km/h sign on the Calder Freeway must hold its speed at or below 100 km/h.

The handbook explains why: heavy vehicles take longer to stop, and crashes involving them are more likely to cause severe injury than crashes involving only cars. Examiners test the 100 km/h figure and the fact that it applies even when the sign says 110 km/h.

Built-up Areas: The 50 km/h Default

Where there are buildings next to the road or street lighting at regular intervals and no speed sign, the default urban speed limit is 50 km/h . Outside a built-up area the default is 100 km/h. The 50 km/h default is the one most drivers underestimate — it is not posted on every street, it simply applies by default. A heavy rigid driver turning off a signed 80 km/h arterial into a local street with no speed sign must drop immediately to 50 km/h, not assume a higher limit.

40 km/h Zones: Shops, Schools, and Emergency Scenes

Victoria uses 40 km/h as a safety speed for vulnerable-road-user zones. The main 40 km/h situations are:

Zone type Trigger How it is signed

Shared/Activity centre Strip shopping precincts on local roads 40 km/h signs at precinct entry, sometimes electronic

School zone Signed roads near schools during school-day times 40 km/h electronic signs that flash during arrival/departure windows

Emergency scene Passing a stationary or slow-moving police, emergency, enforcement, escort, incident response or roadside assistance vehicle showing flashing blue, red, magenta or yellow lights No faster than 40 km/h while passing (Road Safety Road Rules r. 79A); no separate speed sign required

Roadwork (short-term) Roadside workers with signs Temporary 40 km/h sign on a frame or electronic board

School zone times in Victoria are typically 8:00-9:30 am and 2:30-4:00 pm on school days, but the only reliable trigger is the flashing 40 km/h sign — if it is flashing, you are at 40 km/h, holidays or not.

Roadwork Zones

Roadwork zones carry a signed temporary speed limit that overrides every default. A 60 km/h or 40 km/h temporary sign inside an orange work-zone frame is law, not a suggestion, and Victoria Police and Transport Safety Services (TSS) enforce it whether or not workers are present. The common trap is the off-peak driver who sees cones but no workers and assumes the temporary limit is advisory — it is not. The temporary limit is set for worker safety and for the changed road geometry (narrow lanes, sharp edge drops, loose surface), not only for moving machinery.

Worked Speed Scenarios

Road Posted car limit HR truck (15 t GVM) limit Why

Hume Freeway, rural 110 km/h 100 km/h Heavy vehicles must not exceed 100 km/h (r. 21(2) covers a vehicle over 12 t GVM)

Calder Freeway, rural 110 km/h 100 km/h Same cap

Princes Highway, built-up Warrnambool 60 km/h 60 km/h Posted sign governs; 100 km/h cap not in play below 100 km/h

  • Local street, inner Melbourne, no sign (none) 50 km/h Built-up default 50 km/h
  • School zone at 8:15 am, flashing 40 sign 60 km/h 40 km/h Flashing school zone overrides posted 60 km/h
  • Roadworks on Western Ring Road 100 km/h 40 km/h Temporary signed roadwork limit overrides all defaults
  • The Legal Thresholds Behind the Rule

The handbook's "any heavy vehicle" wording is the safe rule to apply. Rule 21(2) is where the numbers sit: the 100 km/h limit on a road signed above 100 km/h applies to a bus over 5 t GVM, a prime mover over 22 t GCM, and any other vehicle over 12 t GVM. A permit or notice for an oversize or overmass vehicle can set a lower limit still.

Common Exam Traps

A sign reading 110 km/h does not mean 110 km/h for a heavy rigid. Heavy vehicles must not exceed 100 km/h anywhere in Victoria.

A 40 km/h school zone flashing at 3:15 pm on the last day of term still applies — the flashing sign is the law, not the school calendar.

You must not pass a stationary or slow-moving police, emergency or roadside assistance vehicle showing flashing lights at more than 40 km/h, even if you cannot see workers or police.

Roadwork limits stay in force even when no workers are visible; they exist for narrowed lanes and loose surface as well as for machinery.

The 50 km/h built-up default applies where there is no sign — do not assume a higher limit on an unsigned local street.