Study guide

10.3 Thunderstorms, Fronts and Fog

CASA Remote Pilot Licence RePL

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 About the RePL Exam 1.2 How to Use This Guide & Build a Study Plan

2 RPA Air Law: Regulatory Framework & Standard Operating Conditions

2.1 CASR Part 101 and the Manual of Standards 2.2 Standard Operating Conditions (SOC) 2.3 The 120 m (400 ft) AGL Height Limit 2.4 VLOS, Daylight, Visibility and the One-RPA Rule

3 RPA Air Law: Licensing, Categories & Approvals

3.1 RePL vs ReOC: Pilot Licence vs Operator Certificate 3.2 Excluded Categories and Operator Accreditation 3.3 RPA Weight Categories and Registration 3.4 Operating Beyond the SOC: Approvals and the ReB1

4 Basic Aviation Knowledge (RBAK)

4.1 Direction, Wind Velocity and Aviation Time 4.2 Units of Measurement: Height, Altitude and Elevation 4.3 Aerodynamics: Lift, Drag, Thrust, Weight and Energy 4.4 Weight and Balance: Terms and Limits 4.5 Propellers and Rotors 4.6 Axes, Attitude and Flight Control Principles 4.7 The Remote Pilot Station

5 RPAS Systems: Platforms, C2 Link & Power

5.1 Multirotor vs Fixed-Wing Characteristics 5.2 Command-and-Control Link and Failsafes 5.3 Lithium-Polymer Battery Management and Safety

6 RPAS Systems: Sensors, Payload & Preflight

6.1 GNSS, Compass, IMU and Geofencing 6.2 Payload, Centre of Gravity and Pre-Flight Checks 6.3 Automated Flight Management Systems (RAFM)

7 Electrical & Electronic Systems (REES)

7.1 Electrical Terms and RPAS Electrical Components 7.2 Electric Motors, Kv and Current Draw 7.3 Battery Types, Specifications and Dangerous Goods 7.4 Charging, Discharging, Balancing and Battery Limitations 7.5 Radio Waves, Frequency Bands and Propagation 7.6 GPS Components, Errors and Electromagnetic Hazards

8 Multirotor Aerodynamics & Performance (RBKM)

8.1 Multirotor Airframe and Component Layout 8.2 Rotor Aerodynamics: Blade Design, Thrust, Drag and Torque 8.3 Hovering: Ground Effect, Recirculation and Translational Lift 8.4 Multirotor Flight Controls, Stabilisation and GPS Hold 8.5 Motor Failure, Rotor Direction and Abnormal Aerodynamics 8.6 Weight, Power, Wind and Climb Performance 8.7 Descent, Vortex Ring State and Landing

9 Navigation & Charts

9.1 Chart Fundamentals: Latitude, Longitude, Variation and Distance 9.2 Visual Terminal Charts and Visual Navigation Charts 9.3 Airspace Classes, Control Zones and CTA Steps 9.4 Restricted, Danger and Prohibited Areas and Obstacles 9.5 NOTAMs, the AIP and Chart Currency

10 Meteorology

10.1 Wind, Sea Breezes and Local Effects 10.2 Turbulence, Orographic Effects and Terrain 10.3 Thunderstorms, Fronts and Fog 10.4 Density Altitude, METAR/TAF and BoM Forecasts 10.5 Weather Observations: Reading the Sky and the Site

11 Human Factors

11.1 IMSAFE, Fatigue and Complacency 11.2 Situational Awareness, Fixation and External Pressure 11.3 Alcohol, Drugs and Crew Resource Management 11.4 Vision, Visual Limitations and Illusions 11.5 Stress and Stress Management 11.6 Threat and Error Management

12 Radio & AROC

12.1 Phonetic Alphabet, Phraseology and CTAF 12.2 The 121.5 MHz Emergency Frequency, Transponder Codes and the AROC

13 Risk & Operational Procedures

13.1 Job Safety Assessment, Risk Assessment and the Hierarchy of Controls 13.2 Site Survey, Bystander Management, Emergencies and Giving Way

14 Operations, Airworthiness & Reporting (RKOP)

14.1 Remote Pilot Responsibilities, Crew Briefing and Ground Operations 14.2 Operational, Remote Pilot and Technical Logs 14.3 Airworthiness, Serviceability and Defect Reporting 14.4 Role Equipment, Sensors and Payload Implications 14.5 Accident and Incident Reporting to the ATSB 14.6 Abnormal Operations, Fail-Safes and Flight Termination 14.7 Operating Near Aerodromes and Above 400 ft AGL

10.3 Thunderstorms, Fronts and Fog

Key Takeaways Explain This Topic AI

A thunderstorm is a cumulonimbus (CB) cloud with strong updrafts and downdrafts, microbursts, lightning, and severe turbulence; a remote pilot must never operate near or beneath a CB, and a good rule is to maintain at least 10 nm (20 km) separation from any convective cell.

A microburst is an intense, localised downdraft from a convective cell that produces a radial outflow of strong wind and shear at the surface; it can exceed any RPA's wind limit within seconds and is one of the most lethal hazards to a small aircraft on approach.

A cold front brings a sharp wind shift, a squall line, and brief intense weather; a warm front brings gradual deterioration over a wider area. Avoid operations near or just behind a front.

Fog forms when air cools to its dew point (the temperature-dew-point spread narrows to near zero); radiation fog forms on clear nights with light wind over cooling ground, and advection fog forms when moist air moves over a cooler surface.

Last updated: August 2026

Thunderstorms

A thunderstorm is a convective cloud system that has grown into a cumulonimbus (CB) — a towering cloud with strong updrafts on the building side and strong downdrafts and precipitation on the mature side. A mature CB contains almost every hazard an aircraft can encounter, concentrated in one cell.

Hazards Inside and Near a CB

Severe turbulence — updrafts can exceed 3,000 ft/min; downdrafts can exceed 2,000 ft/min. Any of these exceeds a small RPA's capability by an order of magnitude.

Microbursts — intense, localised downdrafts (1-2 km across) that hit the surface and spread outward as a radial outflow. A microburst can produce a 30-50 kt wind shear within seconds and is one of the most lethal hazards to any aircraft near the ground.

Lightning — a direct strike can damage or destroy a small RPA's electronics; a near-strike can induce currents in the airframe. Lightning also signals that the cell is mature and violent.

Hail — can damage rotors, gimbal, and airframe.

Heavy rain — reduces visibility and can load the airframe with water, increasing mass.

Icing — supercooled water in the upper parts of the CB can coat the airframe; less relevant for most low-level RPA work but possible in mature cells.

The Never-Near Rule

For a remote pilot the guidance is absolute: never operate near, beneath, or within a cumulonimbus . A practical separation minimum used by many RPA operators is 10 nautical miles (nm), about 20 km , from any visible CB cell, and more if the cell is moving toward the operating area. If a CB is visible and building within that distance, land and secure the aircraft .

A CB does not need to be directly overhead to be dangerous. A mature cell 5 km away can drop a microburst onto an otherwise clear operating site with no warning, and the outflow from a dying cell can produce a wall of gusty wind that reaches the site well before any rain does.

Fronts

A front is the boundary between two air masses of different temperature and humidity. The two types a remote pilot most often encounters are:

Cold Front

A cold front is the leading edge of a colder, denser air mass that pushes under a warmer air mass and lifts it sharply. The lift is intense and concentrated, so a cold front is marked by:

A squall line — a line of thunderstorms or heavy showers just ahead of or along the front.

A sharp wind shift — typically a veering (clockwise) change of 30-60° as the front passes, often gusty.

Brief, intense weather — heavy rain, reduced visibility, turbulence, then rapid clearing behind the front.

A temperature drop behind the front.

For RPA operations a cold front is a do-not-fly event within roughly an hour either side of the passage. The squall line can arrive before the surface front; the wind shift can flip a light headwind into a strong crosswind in minutes.

Warm Front

A warm front is the leading edge of a warmer air mass that slides over a retreating colder one. The lift is gentler and spread over a wider area, so a warm front brings:

Gradual deterioration — lowering cloud base, thickening cloud, slowly reducing visibility, and eventually rain or drizzle over a wide area ahead of the front.

A wind shift that is smaller and slower than with a cold front.

A temperature rise after passage.

Warm fronts are less violent than cold fronts but can still produce low cloud and poor visibility that make a visual RPA operation unsafe. The lesson is the same: avoid operations near or behind a front until the air mass has settled.

Using the Forecast

The Bureau of Meteorology (BoM) aviation forecasts (TAF, area forecast) indicate expected frontal passage times. A remote pilot should check the forecast for the planned operating window and treat a forecast frontal passage within the window as a no-go.

Fog

Fog is cloud at ground level — suspended water droplets that reduce visibility below 1,000 m (and often to a few hundred metres). For a visual-line-of-sight RPA operation fog is an immediate no-go: it removes both visibility and the ability to maintain visual contact with the aircraft.

How Fog Forms

Fog forms when air cools to its dew point — the temperature at which the air becomes saturated and water vapour begins to condense. The gap between the air temperature and the dew point is the temperature-dew-point spread :

When the spread is large (e.g., T 25°C, DP 10°C), the air is dry and fog is unlikely.

When the spread is small and falling (e.g., T 16°C, DP 14°C, with evening cooling forecast), fog risk rises.

When the spread reaches about 0°C , fog is likely if there is enough condensation nucleus and light wind.

Two Fog Types

Radiation fog — forms on a clear night with light wind (2-5 kt). The ground radiates heat to space and cools; the air in contact with the ground cools to its dew point. Calm conditions let the fog stay shallow; light wind mixes the cooled air through a deeper layer and produces a thicker fog. Common inland and in valleys; typically burns off after sunrise.

Advection fog — forms when warm, moist air moves over a cooler surface (e.g., moist tropical air flowing over cooler southern waters in winter, or moist air flowing over cold ground). Can persist day and night and is common along the southern Australian coast.

Reading the Spread as a Fog Predictor

A METAR reports temperature and dew point, for example T 16/14 . The spread here is 2°C. If sunset is approaching, the wind is light, and the sky is clear, the spread will narrow further as the ground cools; fog is a real risk within a few hours . The decision is to finish the operation well before dusk and not plan a return at first light without re-checking the temperature-dew-point spread.

  • Observation Spread Fog risk
  • T 22 / DP 8 14°C Very low
  • T 16 / DP 14 2°C, falling High (if clear sky, light wind)
  • T 14 / DP 14 0°C Fog likely or forming

Key habit: before any early-morning or late-evening operation, check the temperature-dew-point spread in the latest METAR and the BoM forecast. A small, falling spread is a fog warning.