Study guide

14.6 Abnormal Operations, Fail-Safes and Flight Termination

CASA Remote Pilot Licence RePL

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 About the RePL Exam 1.2 How to Use This Guide & Build a Study Plan

2 RPA Air Law: Regulatory Framework & Standard Operating Conditions

2.1 CASR Part 101 and the Manual of Standards 2.2 Standard Operating Conditions (SOC) 2.3 The 120 m (400 ft) AGL Height Limit 2.4 VLOS, Daylight, Visibility and the One-RPA Rule

3 RPA Air Law: Licensing, Categories & Approvals

3.1 RePL vs ReOC: Pilot Licence vs Operator Certificate 3.2 Excluded Categories and Operator Accreditation 3.3 RPA Weight Categories and Registration 3.4 Operating Beyond the SOC: Approvals and the ReB1

4 Basic Aviation Knowledge (RBAK)

4.1 Direction, Wind Velocity and Aviation Time 4.2 Units of Measurement: Height, Altitude and Elevation 4.3 Aerodynamics: Lift, Drag, Thrust, Weight and Energy 4.4 Weight and Balance: Terms and Limits 4.5 Propellers and Rotors 4.6 Axes, Attitude and Flight Control Principles 4.7 The Remote Pilot Station

5 RPAS Systems: Platforms, C2 Link & Power

5.1 Multirotor vs Fixed-Wing Characteristics 5.2 Command-and-Control Link and Failsafes 5.3 Lithium-Polymer Battery Management and Safety

6 RPAS Systems: Sensors, Payload & Preflight

6.1 GNSS, Compass, IMU and Geofencing 6.2 Payload, Centre of Gravity and Pre-Flight Checks 6.3 Automated Flight Management Systems (RAFM)

7 Electrical & Electronic Systems (REES)

7.1 Electrical Terms and RPAS Electrical Components 7.2 Electric Motors, Kv and Current Draw 7.3 Battery Types, Specifications and Dangerous Goods 7.4 Charging, Discharging, Balancing and Battery Limitations 7.5 Radio Waves, Frequency Bands and Propagation 7.6 GPS Components, Errors and Electromagnetic Hazards

8 Multirotor Aerodynamics & Performance (RBKM)

8.1 Multirotor Airframe and Component Layout 8.2 Rotor Aerodynamics: Blade Design, Thrust, Drag and Torque 8.3 Hovering: Ground Effect, Recirculation and Translational Lift 8.4 Multirotor Flight Controls, Stabilisation and GPS Hold 8.5 Motor Failure, Rotor Direction and Abnormal Aerodynamics 8.6 Weight, Power, Wind and Climb Performance 8.7 Descent, Vortex Ring State and Landing

9 Navigation & Charts

9.1 Chart Fundamentals: Latitude, Longitude, Variation and Distance 9.2 Visual Terminal Charts and Visual Navigation Charts 9.3 Airspace Classes, Control Zones and CTA Steps 9.4 Restricted, Danger and Prohibited Areas and Obstacles 9.5 NOTAMs, the AIP and Chart Currency

10 Meteorology

10.1 Wind, Sea Breezes and Local Effects 10.2 Turbulence, Orographic Effects and Terrain 10.3 Thunderstorms, Fronts and Fog 10.4 Density Altitude, METAR/TAF and BoM Forecasts 10.5 Weather Observations: Reading the Sky and the Site

11 Human Factors

11.1 IMSAFE, Fatigue and Complacency 11.2 Situational Awareness, Fixation and External Pressure 11.3 Alcohol, Drugs and Crew Resource Management 11.4 Vision, Visual Limitations and Illusions 11.5 Stress and Stress Management 11.6 Threat and Error Management

12 Radio & AROC

12.1 Phonetic Alphabet, Phraseology and CTAF 12.2 The 121.5 MHz Emergency Frequency, Transponder Codes and the AROC

13 Risk & Operational Procedures

13.1 Job Safety Assessment, Risk Assessment and the Hierarchy of Controls 13.2 Site Survey, Bystander Management, Emergencies and Giving Way

14 Operations, Airworthiness & Reporting (RKOP)

14.1 Remote Pilot Responsibilities, Crew Briefing and Ground Operations 14.2 Operational, Remote Pilot and Technical Logs 14.3 Airworthiness, Serviceability and Defect Reporting 14.4 Role Equipment, Sensors and Payload Implications 14.5 Accident and Incident Reporting to the ATSB 14.6 Abnormal Operations, Fail-Safes and Flight Termination 14.7 Operating Near Aerodromes and Above 400 ft AGL

14.6 Abnormal Operations, Fail-Safes and Flight Termination

Key Takeaways Explain This Topic AI

Motor failure, control-link loss, remote pilot station failure, fire and bird strike are the five abnormal situations Schedule 4 names.

Fail-safe options include return to home, a regain-link holding pattern, flight to a predetermined holding point, parachute deployment, immediate landing and flight termination.

Failsafe behaviour must be configured before flight, because once the link is lost no command can be sent.

Carbon fibre containment matters after a crash: shattered carbon produces sharp fragments and fine airborne dust that require gloves, care and controlled clean-up.

Last updated: August 2026

Abnormal Becomes Emergency When It Is Not Managed

AC 101-01 puts it plainly: even the best designed, manufactured and maintained RPA will suffer failures, and abnormal operations that are not properly managed readily become emergencies . The difference between the two is almost always preparation — the procedure was known, the option was pre-configured, and the site had been surveyed for somewhere to put the aircraft down.

CASA expects a ReOC holder's documented practices and procedures to identify the relevant emergency procedures, with type-specific procedures where they are needed, and expects the mission plan to detail emergency procedures where the standard ones cannot be achieved for a particular task. Most manufacturers publish emergency checklists — read yours before you need it.

The failures AC 101-01 lists for planning are: engine or propeller failure, loss of data link, loss of control, failure of navigation equipment such as loss of GPS, and airframe damage.

Motor or Engine Failure, by Circumstance

Schedule 4 topic 6(a) asks about motor failure in five specific circumstances, and the right answer differs in each.

Circumstance Considerations

Immediately after launch Low altitude, low energy, and the crew is close by. Prioritise getting the aircraft away from people even at the cost of the airframe. A quadcopter will not recover; steer it clear and let it down

On approach to landing Similar low-energy case, but the landing area is usually already clear. Continue the descent to the cleared area if possible

In controlled airspace under ATC control Advise ATC immediately. The aircraft's uncontrolled descent is a hazard to other traffic and ATC needs to know where it is going

In a built-up area The highest-consequence case. Steer for the largest clear area available — a road is worse than a park, a park is worse than a river. Reduce power once clear of people to lower impact energy

In the vicinity of bystanders Move the aircraft away from people first, using whatever roll and pitch authority remains. Avoid yaw inputs, which accelerate the departure

Across all five the priority order is constant: people first, then property, then the aircraft.

Control Link Failure

AC 101-01 requires that the RPAS data link be continuously and automatically monitored in flight, with a real-time warning displayed to the remote pilot on failure. It also distinguishes intermittent loss of signal — and programmed periods of outage — from a genuine total loss, with the parameters for each pre-determined by the manufacturer and documented in the operations manual.

On a genuine lost control data link the pilot should:

Advise air traffic services (where applicable) and any aircraft in the vicinity if the RPA is likely to pose a hazard.

Execute the recovery procedures — which means letting the pre-configured failsafe run while positioning yourself and the crew appropriately.

The pilot cannot select a failsafe after the link is lost. This is the single most important point in the topic: failsafe behaviour must be configured before flight , because once the uplink is gone there is no way to send a command.

Remote Pilot Station Failure

A ground-station failure is the mirror image of a link failure — the aircraft is fine, but the pilot has lost the means to command it. Causes include a flat or overheated tablet, a controller battery failure, an app crash, or a damaged antenna lead.

Mitigations are all pre-flight: charged spare controller and display, the display shaded and with background apps disabled, a known procedure for restoring the app (many aircraft will hold position or fly the failsafe while the app restarts), and a second controller in dual-operator setups. If restoration is not achievable, the aircraft will run its link-loss failsafe — which is another reason to have set it correctly.

Fire, Bird Strike and Airframe Damage

Fire in flight or on the ground. Lithium fires are self-sustaining, burn extremely hot, and cannot be extinguished by smothering. Practical response:

In flight — land immediately, well clear of people, vegetation and structures. Do not attempt to return to the launch point if that route crosses anything flammable or populated.

On the ground — do not attempt to pick the aircraft up. Keep people back, call emergency services for anything beyond a small isolated fire, and let it burn out in a controlled area if it is safe to do so. A dry-powder or purpose-designed lithium extinguisher, or copious water to cool surrounding material, are the practical tools; water will not stop the cell reaction but does cool adjacent cells and surroundings.

Carry a fire plan on any job in dry vegetation, and check total fire ban conditions before flying in summer.

Bird attack. Raptors treat multirotors as rivals or prey. Descend and move away from the territory; do not attempt to out-climb or out-manoeuvre the bird. After any strike, land and inspect — a damaged propeller or a bent motor shaft is a serviceability matter and a technical log entry.

Airframe damage in flight. Symptoms are new vibration, an asymmetric handling feel, or a change in acoustic signature. Land at the nearest safe site, gently, without aggressive attitude changes.

Fail-Safe Options

Schedule 4 topic 7 lists the fail-safe systems and emergency actions a remote pilot should know.

Fail-safe What it does When it is the right choice

Return to home (RTH) Climbs to a set altitude, flies to the recorded home point, lands or hovers The default for open terrain with a clear return path. Requires GNSS lock, a recorded home point, sufficient battery, and an RTH altitude above every obstacle en route

Regain-link holding pattern Holds or orbits while attempting to re-establish the link Where a brief dropout is likely and the aircraft is over safe ground

Fly to a predetermined holding point Proceeds to a pre-programmed safe location Complex sites where "home" is not the safest destination

Emergency parachute deployment Deploys a recovery chute to reduce descent energy Larger aircraft, and operations near people where a ballistic descent is unacceptable

Immediate landing Descends in place Over water, over a populated return path, or where returning is riskier than landing now

Flight termination Deliberately ends the flight, cutting power Where continued flight presents a greater hazard than an immediate uncontrolled descent

Flight termination deserves particular care. AC 101-01 notes that termination procedures for controlled-airspace operations should be developed by the ReOC holder, executed by the remote pilot, and agreed with the air navigation service provider before the operation , with the loss-of-link flight profile, termination capabilities and RPA performance under termination all briefed. It also states that RPA should not be operated within controlled airspace without an operable flight failsafe system , such as one providing automated recovery to a predetermined recovery area.

Choosing the failsafe for the site

The setting is a site decision, not a default. Over open farmland, RTH is usually right. Over water, immediate landing means losing the aircraft — so RTH is better. Over a crowd on the far side of the return path, RTH flies the aircraft over people and immediate landing is safer. Set it deliberately, as part of the pre-flight, for the site you are actually at.

Carbon Fibre Containment

Schedule 4 topic 7(g) names carbon fibre containment in the event of a crash , and it is a genuine and under-appreciated hazard.

Carbon fibre composite does not deform like metal — it shatters. A crashed airframe produces:

Sharp splinters that penetrate skin easily and are difficult to see or remove.

Fine airborne dust that is a respiratory and eye irritant.

Electrically conductive fragments , which can short exposed electrical equipment.

The response at a crash site: wear gloves and, if the debris field is dusty or fragmented, eye protection and a mask . Keep bystanders back. Contain fragments rather than sweeping them into the air — dampen the area if practical and bag the debris. Collect all of it: fragments left in a paddock injure livestock, and fragments left on a worksite are a hazard to everyone who follows. Then photograph, preserve the logs, and start the reporting process.