Study guide

12.1 Phonetic Alphabet, Phraseology and CTAF

CASA Remote Pilot Licence RePL

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 About the RePL Exam 1.2 How to Use This Guide & Build a Study Plan

2 RPA Air Law: Regulatory Framework & Standard Operating Conditions

2.1 CASR Part 101 and the Manual of Standards 2.2 Standard Operating Conditions (SOC) 2.3 The 120 m (400 ft) AGL Height Limit 2.4 VLOS, Daylight, Visibility and the One-RPA Rule

3 RPA Air Law: Licensing, Categories & Approvals

3.1 RePL vs ReOC: Pilot Licence vs Operator Certificate 3.2 Excluded Categories and Operator Accreditation 3.3 RPA Weight Categories and Registration 3.4 Operating Beyond the SOC: Approvals and the ReB1

4 Basic Aviation Knowledge (RBAK)

4.1 Direction, Wind Velocity and Aviation Time 4.2 Units of Measurement: Height, Altitude and Elevation 4.3 Aerodynamics: Lift, Drag, Thrust, Weight and Energy 4.4 Weight and Balance: Terms and Limits 4.5 Propellers and Rotors 4.6 Axes, Attitude and Flight Control Principles 4.7 The Remote Pilot Station

5 RPAS Systems: Platforms, C2 Link & Power

5.1 Multirotor vs Fixed-Wing Characteristics 5.2 Command-and-Control Link and Failsafes 5.3 Lithium-Polymer Battery Management and Safety

6 RPAS Systems: Sensors, Payload & Preflight

6.1 GNSS, Compass, IMU and Geofencing 6.2 Payload, Centre of Gravity and Pre-Flight Checks 6.3 Automated Flight Management Systems (RAFM)

7 Electrical & Electronic Systems (REES)

7.1 Electrical Terms and RPAS Electrical Components 7.2 Electric Motors, Kv and Current Draw 7.3 Battery Types, Specifications and Dangerous Goods 7.4 Charging, Discharging, Balancing and Battery Limitations 7.5 Radio Waves, Frequency Bands and Propagation 7.6 GPS Components, Errors and Electromagnetic Hazards

8 Multirotor Aerodynamics & Performance (RBKM)

8.1 Multirotor Airframe and Component Layout 8.2 Rotor Aerodynamics: Blade Design, Thrust, Drag and Torque 8.3 Hovering: Ground Effect, Recirculation and Translational Lift 8.4 Multirotor Flight Controls, Stabilisation and GPS Hold 8.5 Motor Failure, Rotor Direction and Abnormal Aerodynamics 8.6 Weight, Power, Wind and Climb Performance 8.7 Descent, Vortex Ring State and Landing

9 Navigation & Charts

9.1 Chart Fundamentals: Latitude, Longitude, Variation and Distance 9.2 Visual Terminal Charts and Visual Navigation Charts 9.3 Airspace Classes, Control Zones and CTA Steps 9.4 Restricted, Danger and Prohibited Areas and Obstacles 9.5 NOTAMs, the AIP and Chart Currency

10 Meteorology

10.1 Wind, Sea Breezes and Local Effects 10.2 Turbulence, Orographic Effects and Terrain 10.3 Thunderstorms, Fronts and Fog 10.4 Density Altitude, METAR/TAF and BoM Forecasts 10.5 Weather Observations: Reading the Sky and the Site

11 Human Factors

11.1 IMSAFE, Fatigue and Complacency 11.2 Situational Awareness, Fixation and External Pressure 11.3 Alcohol, Drugs and Crew Resource Management 11.4 Vision, Visual Limitations and Illusions 11.5 Stress and Stress Management 11.6 Threat and Error Management

12 Radio & AROC

12.1 Phonetic Alphabet, Phraseology and CTAF 12.2 The 121.5 MHz Emergency Frequency, Transponder Codes and the AROC

13 Risk & Operational Procedures

13.1 Job Safety Assessment, Risk Assessment and the Hierarchy of Controls 13.2 Site Survey, Bystander Management, Emergencies and Giving Way

14 Operations, Airworthiness & Reporting (RKOP)

14.1 Remote Pilot Responsibilities, Crew Briefing and Ground Operations 14.2 Operational, Remote Pilot and Technical Logs 14.3 Airworthiness, Serviceability and Defect Reporting 14.4 Role Equipment, Sensors and Payload Implications 14.5 Accident and Incident Reporting to the ATSB 14.6 Abnormal Operations, Fail-Safes and Flight Termination 14.7 Operating Near Aerodromes and Above 400 ft AGL

12.1 Phonetic Alphabet, Phraseology and CTAF

Key Takeaways Explain This Topic AI

The ICAO phonetic alphabet assigns a fixed word to each letter (Alpha through Zulu) so callsigns, waypoints and registrations survive a noisy VHF link; remote pilots must learn it verbatim.

The number 9 is spoken "Niner" because the English word "nine" can be confused with the German "nein" (meaning no) and with "five" on a poor link — a common exam trap.

Standard phraseology is a small fixed vocabulary: Roger means received and understood (not yes), Wilco means will comply, Say again means repeat, Stand by means wait, and Affirm/Negative replace yes/no.

Every routine call follows the four-part shape [Called station] [Calling station] [Message] Over/Out, and safety-critical instructions (clearances, runway, QNH, taxi, squawk, frequency changes) must be read back.

CTAF is the VHF frequency used at non-controlled (Class G) aerodromes for self-sequencing; an RPA pilot should monitor CTAF near the circuit and broadcast position and intent when the operation could affect other traffic.

Last updated: August 2026

ICAO Phonetic Alphabet and Numbers

When you transmit on an aeronautical Very High Frequency (VHF) radio, every letter and number must be unambiguous over a noisy link. The International Civil Aviation Organization (ICAO) phonetic alphabet assigns a fixed word to each letter of the English alphabet so that callsigns, waypoints and registrations survive interference and accents.

Remote pilots should learn the full set verbatim — you will hear it on every Common Traffic Advisory Frequency (CTAF) broadcast and read it back when confirming a clearance or callsign.

  • Letter Word Letter Word Letter Word
  • A Alpha J Juliet S Sierra
  • B Bravo K Kilo T Tango
  • C Charlie L Lima U Uniform
  • D Delta M Mike V Victor
  • E Echo N November W Whisky
  • F Foxtrot O Oscar X X-ray
  • G Golf P Papa Y Yankee
  • H Hotel Q Quebec Z Zulu
  • I India R Romeo

Numbers are spoken as single digits except where noted, with three pronunciation traps that catch new operators:

3 is spoken "Tree" (not "three") — the "th" sound is hard to distinguish on VHF.

5 is spoken "Fife" (not "five") — the trailing "v" is dropped.

9 is spoken "Niner" — the most important trap, because the English word "nine" can be confused with the German word "nein" (meaning "no") and with "five" on a poor link. Exam questions on this are common.

Whole hundreds are spoken as "Hundred" and thousands as "Thousand" (for example, altitude "Two Thousand Five Hundred"). The decimal point is spoken "Decimal" — used for frequencies such as "One Two One Decimal Five" for 121.5 MHz.

Standard Phraseology

Aviation radio uses a small, fixed vocabulary so that meaning does not depend on tone, idiom or fluency in English. Master these words before you key the microphone:

Roger — "I have received and understood your last transmission." It does not mean "yes" or "I will comply."

Wilco — "Will comply." Use it when you accept an instruction you will carry out.

Say again — "Repeat your last transmission." Never use "repeat" — in military contexts "repeat" can mean "fire again."

Stand by — "Wait, I will call you back." It is not a refusal, just a pause.

Affirm / Negative — Yes / No. "Affirmative" is discouraged because it can be confused with "negative" on a poor link.

  • Confirm — "I am checking — is this what you said or intend?"
  • Over — "My transmission is ended and I expect a reply."

Out — "My transmission is ended and I expect no reply." Never combine as "over and out" — they contradict each other.

Standard Call Format

Every routine call follows the same four-part shape so the called station knows who is being asked and who is asking:

  • Called station first — for example, "Brisbane Tower."
  • Calling station second — for example, "Remote Pilot Alpha Bravo Charlie Delta."

Message — position, intention or request.

"Over" if you expect a reply, or "Out" if you do not.

Putting the called station first lets the receiver know the call is for them before they hear a stranger's callsign.

Read-Back of Safety-Critical Instructions

Controllers and other pilots expect you to read back any safety-critical instruction so they can catch a misunderstanding before it becomes an incident. For a remote pilot, the items that must be read back include:

  • ATC clearances (for example, "cleared to enter controlled airspace")
  • Runway instructions (cleared to land, take-off, cross, backtrack)
  • QNH altimeter settings
  • Taxi instructions
  • Squawk codes (transponder codes)
  • Frequency changes

A read-back is not a parrot echo — it is a confirmation. If the read-back does not match what was said, the controller will correct you with "Negative, I said…"

CTAF at Non-Controlled Aerodromes

The Common Traffic Advisory Frequency (CTAF) is the VHF frequency used at non-controlled (Class G) aerodromes for pilots to self-sequence their traffic. There is no tower controller issuing instructions; instead, each pilot broadcasts position and intent so everyone can build a mental traffic picture and deconflict.

For a Remote Pilot Aircraft (RPA) operator, the rules are:

Monitor the CTAF whenever you are operating within the vicinity of a non-controlled aerodrome (generally within about 5 NM and below the circuit height), even if you do not intend to transmit.

Broadcast on CTAF when your operation could affect other traffic — for example launching or recovering near the circuit, crossing the approach path, or operating on the aerodrome. If you hold an Aeronautical Radio Operator Certificate (AROC) you may transmit; without one you may only monitor.

Keep calls short, standard and in the same format towered calls use — position first, then intention.

Standard CTAF calls for a manned aircraft are made at inbound 5 NM , joining downwind, base, final, and clear of the runway. A remote pilot launching near the circuit should mirror this discipline: call before launch, state position and intent, and call again when clear.

Sample CTAF Call

A sample inbound call from a manned aircraft, which a remote pilot should emulate:

"Cashmore Traffic, Cessna Foxtrot Sierra Golf, inbound five nautical miles, estimating circuit at time two five, runway Two One, Cashmore Traffic."

Note the structure: [location] Traffic (CTAF calls are addressed to all traffic at that aerodrome), [callsign] , [position] , [intent] , and close with the location again so listeners know the call is finished and who it referred to.

For an RPA, an equivalent launch call might be:

"Cashmore Traffic, Remote Pilot Alpha Bravo Charlie Delta, operating remotely one nautical mile north of the field, below 400 feet, runway Two One, Cashmore Traffic."