Study guide
11.3 Surface Water Treatment Rules & Log Removal Credit
California Water/Wastewater Operator Exam
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: California Water Regulatory Framework & Certification Ladders
1.1 State Water Board & Regional Boards Structure 1.2 Drinking Water Certification: T1-T5 & D1-D5 Requirements 1.3 Wastewater Certification: Grades I-V & OIT Requirements 1.4 Safe Drinking Water Standards, MCLs & Emerging Contaminants 1.5 California Waterworks Standards (Title 22, Chapter 16) 1.6 Public Water System Types, Permits & the Sanitary Survey
2 Chapter 2: California Water Rights, Title 22 & Environmental Policy
2.1 California Title 22 Recycled Water Standards 2.2 California Environmental Quality Act (CEQA) & Proposition 218 2.3 Water Rights & California Water Resources
3 Chapter 3: Drinking Water Source Quality & Coagulation/Flocculation
3.1 Source Water Quality & Watershed Management 3.2 Coagulation Chemistry & Flash Mixing 3.3 Flocculation & Jar Testing 3.4 Wells, Aquifers & Groundwater Hydraulics 3.5 Raw Water Storage, Clearwells & Reservoir Management
4 Chapter 4: Clarification & Granular Media Filtration
4.1 Sedimentation & Advanced Clarification 4.2 Granular Media Filtration Mechanics & Media Types 4.3 Filter Operation, Backwash Cycles & SWTR Compliance
5 Chapter 5: Disinfection, Oxidation & Advanced Water Treatment
5.1 Chlorination Chemistry & Breakpoint Curves 5.2 Disinfection Kinetics & CT Calculations 5.3 Alternative Disinfection: Ozone, UV & Chlorine Dioxide 5.4 Advanced Treatment: Membranes, AOP & PFAS Adsorption 5.5 Chloramination & Nitrification Control 5.6 Iron & Manganese Removal 5.7 Fluoridation Practice & Compliance 5.8 Corrosion Control Treatment & Water Stability 5.9 Taste & Odor Control and Algal Toxin Management
6 Chapter 6: Wastewater Preliminary & Primary Treatment
6.1 Preliminary Treatment: Screening & Grit Removal 6.2 Primary Clarification Operations 6.3 Primary Sludge Characteristics & Pumping 6.4 Stabilization Ponds, Lagoons & Small-Plant Processes
7 Chapter 7: Secondary Biological Treatment & Activated Sludge
7.1 Activated Sludge Process Fundamentals 7.2 Process Control Parameters: F/M, MCRT & SVI 7.3 Activated Sludge Microbiology & Troubleshooting 7.4 Fixed-Film & Hybrid Biological Processes
8 Chapter 8: Biological Nutrient Removal, Water Reuse & Solids Handling
8.1 Biological Nitrogen Removal: Nitrification & Denitrification 8.2 Biological Phosphorus Removal (EBPR) & Chemical Precipitation 8.3 Anaerobic & Aerobic Digestion 8.4 Sludge Thickening, Dewatering & Biosolids Disposal 8.5 Wastewater Disinfection: Chlorination, Dechlorination & UV
9 Chapter 9: Distribution Systems, Collection Networks & Hydraulics
9.1 Hydraulics, Pressure & Flow Dynamics 9.2 Centrifugal Pumps, Motors & VFDs 9.3 Distribution Network Infrastructure & Cross-Connection Control 9.4 Wastewater Collection Systems, SSMP & FOG Management
10 Chapter 10: Laboratory Analytics, Safety & Water Math
10.1 Water & Wastewater Laboratory Methods 10.2 Laboratory Quality Assurance & Regulatory Reporting 10.3 Chemical Safety, Hazardous Gases & Confined Space 10.4 Essential Water & Wastewater Math for Operators
11 Chapter 11: Federal & California Drinking Water Rules
11.1 The Revised Total Coliform Rule & Assessments 11.2 The Lead and Copper Rule and Service Line Replacement 11.3 Surface Water Treatment Rules & Log Removal Credit 11.4 Stage 1 & Stage 2 Disinfection Byproduct Rules 11.5 Secondary MCLs, Notification Levels & Response Levels 11.6 Public Notification, Consumer Confidence Reports & Recordkeeping
12 Chapter 12: Distribution System Design, Demand & Hydraulics
12.1 System Layout, Pressure Zones & Distribution Maps 12.2 Water Demand, Peaking Factors & Fire Flow 12.3 Distribution Storage: Types, Sizing & Turnover 12.4 Head Loss, C-Factor & Distribution Hydraulic Calculations 12.5 Water Hammer, Surge Control & Air Management
13 Chapter 13: Distribution Equipment Operation, Maintenance & Inspection
13.1 Valves: Types, Operation & Exercising Programs 13.2 Fire Hydrants: Types, Testing & Maintenance 13.3 Water Meters: Types, Accuracy & Meter Management 13.4 Instrumentation, In-Line Sensors, Telemetry & SCADA 13.5 Electrical Systems, Motors & Standby Generators 13.6 External Corrosion, Cathodic Protection & Asset Inspection
14 Chapter 14: Water Mains, Piping & Field Construction
14.1 Pipe Materials & Pipe Selection 14.2 Joints, Fittings, Thrust Restraint & Bedding 14.3 Main Installation, Tapping & Service Line Installation 14.4 Leak Detection, Water Loss Auditing & Main Repair 14.5 Main Cleaning & Maintenance: Flushing, Pigging & Lining 14.6 Excavation, Trench Safety & Utility Locating
15 Chapter 15: Disinfecting Distribution Facilities & Maintaining Water Quality
15.1 Water Main Disinfection (AWWA C651) 15.2 Disinfecting Storage Reservoirs (C652) & Wells (C654) 15.3 Maintaining Distribution Water Quality: Residual, Biofilm & Discolored Water 15.4 Cross-Connection Control Program Administration & Device Testing
16 Chapter 16: Plant Equipment, Chemical Feed & Maintenance
16.1 Chemical Feed Systems: Metering Pumps, Dry Feeders & Calibration 16.2 Gas Chlorination Equipment & Hypochlorite Systems 16.3 Blowers, Compressors & Aeration Equipment 16.4 Flow Measurement Devices: Meters, Weirs & Flumes 16.5 Preventive Maintenance, CMMS & Asset Management
17 Chapter 17: Utility Management, Administration & Emergency Response
17.1 Planning, Organizing, Directing & Controlling a Utility Work Group 17.2 Budgets, Water Rates & Financial Management 17.3 Operator Training, Staffing & Safety Program Development 17.4 Energy Management & Optimization 17.5 Emergency Response Planning, Risk & Resilience & Security 17.6 Water Conservation Planning & Drought Response
18 Chapter 18: Applied Operator Mathematics Workshop
18.1 The Exam Conversion Sheet, Units & Dimensional Analysis 18.2 Distribution & Hydraulic Math Workshop 18.3 Treatment & Wastewater Process Math Workshop
11.3 Surface Water Treatment Rules & Log Removal Credit
Key Takeaways Explain This Topic AI
Surface Water Treatment Rule and Amendments is a named sub-topic in the SWRCB treatment Expected Range of Knowledge.
The SWTR requires an overall 3-log Giardia and 4-log virus removal or inactivation for all surface water and GWUDI systems.
Conventional filtration receives 2.5-log Giardia and 2.0-log virus removal credit, so disinfection must supply the remaining 0.5-log Giardia and 2.0-log virus.
Direct filtration receives only 2.0-log Giardia and 1.0-log virus credit, so it carries a much larger disinfection burden than conventional treatment.
The Interim Enhanced SWTR requires combined filter effluent turbidity at or below 0.3 NTU in 95 percent of monthly measurements and never above 1.0 NTU, plus individual filter effluent monitoring.
Last updated: September 2026
A Layered Set of Rules
The Surface Water Treatment Rule and Amendments is listed by name in the treatment blueprint. It is not one rule but a stack, each layer adding a requirement without repealing the one below:
Rule Year Applies to What it added
SWTR 1989 All surface water and GWUDI systems 3-log Giardia and 4-log virus removal/inactivation; filtration and disinfection required; disinfectant residual entering and in the distribution system
IESWTR 1998 Systems serving ≥ 10,000 2-log Cryptosporidium removal; tightened turbidity to 0.3 NTU ; individual filter effluent (IFE) monitoring ; sanitary survey requirements
LT1ESWTR 2002 Systems serving < 10,000 Extended IESWTR requirements to small systems
LT2ESWTR 2006 All surface water and GWUDI systems Source water Cryptosporidium monitoring , bin classification , additional treatment for higher bins, uncovered finished reservoir requirements
Two universal SWTR residual requirements operators must know:
A detectable disinfectant residual must be maintained in the distribution system, or an HPC of ≤ 500 CFU/mL may be used in lieu of a detectable residual.
The residual entering the distribution system may not be undetectable for more than 4 hours .
Log Removal, Log Inactivation, and Total Log Reduction Total Log Reduction = Log Removal (physical) + Log Inactivation (disinfection) \text{Total Log Reduction} = \text{Log Removal (physical)} + \text{Log Inactivation (disinfection)} Total Log Reduction = Log Removal (physical) + Log Inactivation (disinfection)
Log removal is credit for physically taking organisms out - coagulation, sedimentation, filtration, membranes. Log inactivation is credit for killing or disabling them - chlorine, ozone, chlorine dioxide, UV. A log is a factor of ten:
- Log reduction Percent reduction
- 0.5-log 68.4%
- 1-log 90%
- 2-log 99%
- 2.5-log 99.68%
- 3-log 99.9%
- 4-log 99.99%
- Filtration Removal Credits
- Filtration technology Giardia Virus Cryptosporidium
- Conventional (coagulation, flocculation, sedimentation, filtration) 2.5-log 2.0-log 2.0-log
- Direct filtration (no sedimentation) 2.0-log 1.0-log 2.0-log
- Slow sand filtration 2.0-log 2.0-log 2.0-log
- Diatomaceous earth filtration 2.0-log 1.0-log 2.0-log
- What Disinfection Must Then Supply
- Plant type Required total Filtration credit Disinfection must provide
- Conventional 3-log Giardia / 4-log virus 2.5 / 2.0 0.5-log Giardia and 2.0-log virus
- Direct filtration 3-log Giardia / 4-log virus 2.0 / 1.0 1.0-log Giardia and 3.0-log virus
- Slow sand 3-log Giardia / 4-log virus 2.0 / 2.0 1.0-log Giardia and 2.0-log virus
Important
This is the single most useful table in the whole SWTR topic. A direct filtration plant needs twice the Giardia inactivation and much more virus inactivation than a conventional plant treating the same water, because it gets less physical credit. That is why so many California direct filtration plants run higher chlorine residuals or added ozone or UV. When a question compares two plants with identical CT, the direct filtration plant is the one closer to non-compliance.
Turbidity Performance Standards
Turbidity is the day-to-day proxy for physical removal, and the standards are performance-based rather than health-based:
Measurement Conventional and direct filtration Slow sand and DE
Combined filter effluent (CFE) ≤ 0.3 NTU in at least 95 percent of the measurements taken each month ≤ 1.0 NTU in 95 percent
- CFE maximum Never above 1.0 NTU Never above 5.0 NTU
- Measurement frequency Every 4 hours minimum for CFE Same
- Individual Filter Effluent (IFE) Monitoring
Under IESWTR/LT1, each individual filter must be monitored continuously, with readings recorded at least every 15 minutes . Reporting triggers:
IFE turbidity > 1.0 NTU in two consecutive 15-minute readings - report and, if it recurs in three consecutive months, conduct a filter self-assessment
IFE turbidity > 0.5 NTU in two consecutive readings at the end of the first four hours after the filter returns to service
IFE turbidity > 2.0 NTU in two consecutive readings , in two consecutive months - a comprehensive performance evaluation (CPE) by the State or a third party
Tip
The rule targets filter ripening deliberately. The 0.5 NTU four-hour trigger exists because the worst water a filter produces is in the first minutes after backwash, which is also when Cryptosporidium is most likely to pass. Filter-to-waste during ripening is the standard operational answer.
LT2 and Bin Classification
LT2 required systems to monitor source water for Cryptosporidium (large systems by direct measurement; small systems by E. coli screening first) and then be assigned to a bin :
- Bin Source water Cryptosporidium (oocysts/L) Additional treatment required beyond conventional
- Bin 1 < 0.075 None
- Bin 2 0.075 to < 1.0 1.0-log
- Bin 3 1.0 to < 3.0 2.0-log
- Bin 4 ≥ 3.0 2.5-log
Additional credit is earned from the microbial toolbox : watershed control, bank filtration, second-stage filtration, membranes, bag/cartridge filters, combined filter performance, presedimentation, roughing filters, ozone , chlorine dioxide , and UV - which is the most common answer because UV delivers large Cryptosporidium credit at low dose.
LT2 also addressed uncovered finished water reservoirs : systems had to cover them or treat the discharge to achieve 4-log virus, 3-log Giardia, and 2-log Cryptosporidium inactivation. This is why California utilities spent the 2010s covering or replacing open finished-water reservoirs.
Putting It Together
A conventional plant treats a Bin 2 source.
Giardia: 3-log required; filtration gives 2.5-log; disinfection must supply 0.5-log .
Virus: 4-log required; filtration gives 2.0-log; disinfection must supply 2.0-log .
Cryptosporidium: 2-log from conventional filtration plus 1.0-log additional for Bin 2 = 3.0-log total . Chlorine provides essentially no Cryptosporidium credit at practical CT, so the plant must add UV or ozone to earn the extra log.
That single scenario explains most California plant upgrades of the past two decades: UV was added not for Giardia or viruses, but for Cryptosporidium bin credit.