Study guide
17.5 Emergency Response Planning, Risk & Resilience & Security
California Water/Wastewater Operator Exam
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: California Water Regulatory Framework & Certification Ladders
1.1 State Water Board & Regional Boards Structure 1.2 Drinking Water Certification: T1-T5 & D1-D5 Requirements 1.3 Wastewater Certification: Grades I-V & OIT Requirements 1.4 Safe Drinking Water Standards, MCLs & Emerging Contaminants 1.5 California Waterworks Standards (Title 22, Chapter 16) 1.6 Public Water System Types, Permits & the Sanitary Survey
2 Chapter 2: California Water Rights, Title 22 & Environmental Policy
2.1 California Title 22 Recycled Water Standards 2.2 California Environmental Quality Act (CEQA) & Proposition 218 2.3 Water Rights & California Water Resources
3 Chapter 3: Drinking Water Source Quality & Coagulation/Flocculation
3.1 Source Water Quality & Watershed Management 3.2 Coagulation Chemistry & Flash Mixing 3.3 Flocculation & Jar Testing 3.4 Wells, Aquifers & Groundwater Hydraulics 3.5 Raw Water Storage, Clearwells & Reservoir Management
4 Chapter 4: Clarification & Granular Media Filtration
4.1 Sedimentation & Advanced Clarification 4.2 Granular Media Filtration Mechanics & Media Types 4.3 Filter Operation, Backwash Cycles & SWTR Compliance
5 Chapter 5: Disinfection, Oxidation & Advanced Water Treatment
5.1 Chlorination Chemistry & Breakpoint Curves 5.2 Disinfection Kinetics & CT Calculations 5.3 Alternative Disinfection: Ozone, UV & Chlorine Dioxide 5.4 Advanced Treatment: Membranes, AOP & PFAS Adsorption 5.5 Chloramination & Nitrification Control 5.6 Iron & Manganese Removal 5.7 Fluoridation Practice & Compliance 5.8 Corrosion Control Treatment & Water Stability 5.9 Taste & Odor Control and Algal Toxin Management
6 Chapter 6: Wastewater Preliminary & Primary Treatment
6.1 Preliminary Treatment: Screening & Grit Removal 6.2 Primary Clarification Operations 6.3 Primary Sludge Characteristics & Pumping 6.4 Stabilization Ponds, Lagoons & Small-Plant Processes
7 Chapter 7: Secondary Biological Treatment & Activated Sludge
7.1 Activated Sludge Process Fundamentals 7.2 Process Control Parameters: F/M, MCRT & SVI 7.3 Activated Sludge Microbiology & Troubleshooting 7.4 Fixed-Film & Hybrid Biological Processes
8 Chapter 8: Biological Nutrient Removal, Water Reuse & Solids Handling
8.1 Biological Nitrogen Removal: Nitrification & Denitrification 8.2 Biological Phosphorus Removal (EBPR) & Chemical Precipitation 8.3 Anaerobic & Aerobic Digestion 8.4 Sludge Thickening, Dewatering & Biosolids Disposal 8.5 Wastewater Disinfection: Chlorination, Dechlorination & UV
9 Chapter 9: Distribution Systems, Collection Networks & Hydraulics
9.1 Hydraulics, Pressure & Flow Dynamics 9.2 Centrifugal Pumps, Motors & VFDs 9.3 Distribution Network Infrastructure & Cross-Connection Control 9.4 Wastewater Collection Systems, SSMP & FOG Management
10 Chapter 10: Laboratory Analytics, Safety & Water Math
10.1 Water & Wastewater Laboratory Methods 10.2 Laboratory Quality Assurance & Regulatory Reporting 10.3 Chemical Safety, Hazardous Gases & Confined Space 10.4 Essential Water & Wastewater Math for Operators
11 Chapter 11: Federal & California Drinking Water Rules
11.1 The Revised Total Coliform Rule & Assessments 11.2 The Lead and Copper Rule and Service Line Replacement 11.3 Surface Water Treatment Rules & Log Removal Credit 11.4 Stage 1 & Stage 2 Disinfection Byproduct Rules 11.5 Secondary MCLs, Notification Levels & Response Levels 11.6 Public Notification, Consumer Confidence Reports & Recordkeeping
12 Chapter 12: Distribution System Design, Demand & Hydraulics
12.1 System Layout, Pressure Zones & Distribution Maps 12.2 Water Demand, Peaking Factors & Fire Flow 12.3 Distribution Storage: Types, Sizing & Turnover 12.4 Head Loss, C-Factor & Distribution Hydraulic Calculations 12.5 Water Hammer, Surge Control & Air Management
13 Chapter 13: Distribution Equipment Operation, Maintenance & Inspection
13.1 Valves: Types, Operation & Exercising Programs 13.2 Fire Hydrants: Types, Testing & Maintenance 13.3 Water Meters: Types, Accuracy & Meter Management 13.4 Instrumentation, In-Line Sensors, Telemetry & SCADA 13.5 Electrical Systems, Motors & Standby Generators 13.6 External Corrosion, Cathodic Protection & Asset Inspection
14 Chapter 14: Water Mains, Piping & Field Construction
14.1 Pipe Materials & Pipe Selection 14.2 Joints, Fittings, Thrust Restraint & Bedding 14.3 Main Installation, Tapping & Service Line Installation 14.4 Leak Detection, Water Loss Auditing & Main Repair 14.5 Main Cleaning & Maintenance: Flushing, Pigging & Lining 14.6 Excavation, Trench Safety & Utility Locating
15 Chapter 15: Disinfecting Distribution Facilities & Maintaining Water Quality
15.1 Water Main Disinfection (AWWA C651) 15.2 Disinfecting Storage Reservoirs (C652) & Wells (C654) 15.3 Maintaining Distribution Water Quality: Residual, Biofilm & Discolored Water 15.4 Cross-Connection Control Program Administration & Device Testing
16 Chapter 16: Plant Equipment, Chemical Feed & Maintenance
16.1 Chemical Feed Systems: Metering Pumps, Dry Feeders & Calibration 16.2 Gas Chlorination Equipment & Hypochlorite Systems 16.3 Blowers, Compressors & Aeration Equipment 16.4 Flow Measurement Devices: Meters, Weirs & Flumes 16.5 Preventive Maintenance, CMMS & Asset Management
17 Chapter 17: Utility Management, Administration & Emergency Response
17.1 Planning, Organizing, Directing & Controlling a Utility Work Group 17.2 Budgets, Water Rates & Financial Management 17.3 Operator Training, Staffing & Safety Program Development 17.4 Energy Management & Optimization 17.5 Emergency Response Planning, Risk & Resilience & Security 17.6 Water Conservation Planning & Drought Response
18 Chapter 18: Applied Operator Mathematics Workshop
18.1 The Exam Conversion Sheet, Units & Dimensional Analysis 18.2 Distribution & Hydraulic Math Workshop 18.3 Treatment & Wastewater Process Math Workshop
17.5 Emergency Response Planning, Risk & Resilience & Security
Key Takeaways Explain This Topic AI
Emergency Response Planning and Safety Plan are named sub-topics in the SWRCB distribution Expected Range of Knowledge, and the T5 oral exam devotes two of six questions to management and emergency situations.
The America's Water Infrastructure Act requires community water systems serving more than 3,300 people to complete risk and resilience assessments and emergency response plans and to recertify them every five years.
An emergency response plan must be prepared within six months of certifying the corresponding risk and resilience assessment.
California hazards that drive water utility planning include earthquake, wildfire, drought, flood, power shutoff, and cyber intrusion.
A precautionary boil water notice is lifted on the basis of coliform-negative sample results plus restored pressure and residual, not on completion of the repair.
Last updated: September 2026
The Statutory Framework
The America's Water Infrastructure Act (AWIA) of 2018 requires every community water system serving more than 3,300 people to:
- Conduct a Risk and Resilience Assessment (RRA) and certify its completion to EPA
- Prepare or revise an Emergency Response Plan (ERP) within six months of certifying the RRA
- Review and recertify both every five years
The RRA must evaluate risk from malevolent acts and natural hazards to: the physical barriers; the source water; the pipes, conveyances, storage, treatment, and distribution facilities; the electronic, computer, and other automated systems including the use of those systems (this is the cybersecurity hook); the monitoring practices ; the financial infrastructure ; the chemical storage and handling ; and the operation and maintenance of the system.
The ERP must include strategies and resources to improve resilience , plans and procedures for responses including alternative source water, relocation of intakes, and flushing, actions and equipment to lessen the impact including automated shutoffs and backup power, and strategies for detecting malevolent acts and natural hazards .
Important
The RRA and ERP are not documents you write and file. The recertification cycle exists because systems, staffing, hazards, and technology change. A plan whose callout list has three retired people on it and whose SCADA section describes a system replaced four years ago is worse than no plan, because it creates false confidence.
California-Specific Hazards
Hazard Water system consequence Planning response
Earthquake Main breaks by the hundreds, tank failures, source loss, power loss, treatment plant damage, fire following earthquake with no water to fight it Seismic-resistant pipe (restrained joint or HDPE) in fault and liquefaction zones, flexible tank connections, automatic seismic shutoff valves on tanks to preserve storage, emergency interties, portable pumps and generators, staged repair materials, potable water distribution points
Wildfire Loss of power and pumping, structures burning cause simultaneous open services that collapse system pressure , benzene and VOC contamination of melted plastic pipe and service lines in burn areas , watershed damage causing post-fire turbidity and debris flow Isolation valves to segment burned areas, pressure monitoring, post-fire flushing and VOC sampling protocol , source turbidity contingency, watershed sanitary survey updates
Drought Source loss, water quality degradation in low reservoirs, groundwater level decline, revenue loss Water Shortage Contingency Plan, alternate sources, interties, conservation stages
Flood Well and vault inundation, treatment plant flooding, turbidity spikes, sewer overflow Elevate or seal wellheads, watertight vaults, sandbag plans, backup power above flood elevation
Public Safety Power Shutoff (PSPS) Planned multi-day utility power outage Backup generation at every critical facility , fuel contracts, portable generator quick-connects, staffing plan for extended manual operation
Cyber intrusion Loss of SCADA, manipulated setpoints, ransomware on the historian and business systems Network segmentation, MFA, offline backups, documented ability to operate in local/manual mode , incident reporting
Contamination / malevolent act Intentional introduction, cross-connection, vandalism Site security, intrusion alarms, sampling capability, customer complaint surveillance
Sanitary sewer overflow On the wastewater side, a reportable spill with public health and enforcement consequences SSMP, spill response kit, CIWQS reporting
Incident Command
California operates under the Standardized Emergency Management System (SEMS) and the National Incident Management System (NIMS) , both built on the Incident Command System (ICS) . Operators should know the structure well enough to plug into it:
- ICS function Role
- Incident Commander Overall authority; sets objectives
- Operations Executes the tactical response - where most utility field staff work
- Planning Situation status, resource tracking, the incident action plan
- Logistics Materials, equipment, fuel, food, contractors
Finance/Administration Cost tracking - critical for FEMA and Cal OES reimbursement , which requires documented labor, equipment, and material costs from hour one
- Public Information Officer Single voice to the public and press
- Safety Officer Authority to stop unsafe operations
Unity of command, span of control, and a single incident action plan are the concepts most likely to appear on an exam.
Boil Water Notices
The decision that most often falls to an operator at 2 a.m.
When to consider one:
- Loss of pressure below 20 psi in a portion of the distribution system
- A confirmed or suspected backflow event of a health hazard
- Loss of disinfection at the plant, or an extended period with no detectable residual
- E. coli-positive results
- A treatment failure delivering inadequately treated surface water
- Physical evidence of contamination - a flooded well, a broken main in a sewage-saturated trench
The process:
Consult the Division of Drinking Water as early as possible; DDW may direct the notice.
Define the affected area precisely using the hydraulic model and valve records - notifying too broadly destroys credibility, and too narrowly is a public health failure.
Issue the notice with the required content and by a Tier 1 method if it accompanies an acute violation - broadcast media, hand delivery, posting, phone or text, all within 24 hours .
Notify special populations directly - hospitals, dialysis centers, schools, food service, day care, and large employers.
Correct the cause , flush, disinfect per AWWA C651, and restore pressure and residual.
Sample - typically two consecutive sets of coliform-negative samples 24 hours apart from the affected area.
Lift the notice only with DDW concurrence , and communicate the lift by the same channels used to issue it, with instructions for customers to flush their plumbing and ice makers.
Warning
The notice is not lifted because the repair is done. It is lifted on coliform-negative results plus restored pressure and residual , with regulator concurrence. Lifting early and then having to re-issue is the fastest way for a utility to lose the public trust it will need in the next event.
Mutual Aid
CalWARN - the California Water/Wastewater Agency Response Network - is the mutual aid framework through which California utilities share personnel, equipment, and materials during emergencies, under a pre-executed agreement that handles liability, reimbursement, and workers' compensation. Joining before an emergency is the entire point; a utility that tries to arrange aid during the event has already lost days.
Practical pre-staging: emergency interties with neighboring systems (with backflow protection and metering), agreements with bottled water suppliers and bulk hauling , contracts with generator and pump rental vendors, stocked repair clamps and pipe in the common sizes, and fuel supply agreements .
Security
- Layer Measures
- Deter Fencing, lighting, signage, visible patrols
Detect Intrusion alarms on tanks, wells, vaults, and chemical storage; camera coverage; SCADA alarms on abnormal conditions
- Delay Locks, hatch security, ladder guards, bollards
- Respond Alarm callout with confirmed receipt, law enforcement coordination, documented response procedures
Chemical storage deserves specific attention: chlorine, ammonia, and sulfur dioxide are both operational hazards and potential targets, and facilities holding threshold quantities carry CalARP and Risk Management Plan obligations plus a Hazardous Materials Business Plan filed with the local CUPA.
Cybersecurity is now an explicit RRA element. The baseline expectations are the ones in Section 13.4: no internet-exposed remote access with default or shared credentials, multifactor authentication, network segmentation, patching, offline tested backups, and a demonstrated ability to run the plant in local/manual mode without SCADA - which is not only a security control but a resilience control, since it is also the answer to a failed communications link or a lightning-damaged PLC.