Study guide
6.1 Inspecting Tank Vehicles: Leaks, Valves, Covers, Vents & Emergency Equipment
CDL Tanker N
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: Overview & Regulatory Requirements
1.1 Federal Tank Vehicle Definition & When the N Endorsement Applies 1.2 Endorsement Codes, Knowledge Testing & Licensing Rules (N, H, X) 1.3 Product Density, Legal Weight Limits & How Much to Load
2 Chapter 2: Tank Construction & Cargo Surge
2.1 Liquid Surge: Causes, Effects & Prevention 2.2 Baffled vs. Smooth Bore (Unbaffled) Tanks 2.3 Bulkheads, Multi-Compartment Tanks & Weight Distribution
3 Chapter 3: Outage, Center of Gravity & Loading Operations
3.1 Outage (Ullage) & Thermal Expansion 3.2 High Center of Gravity & Rollover 3.3 Loading & Unloading: Valves, Bonding, Vapor Recovery & Attendance
4 Chapter 4: Driving, Braking & Speed Management
4.1 Curves, Ramps, Grades & Intersection Turns 4.2 Braking & Stopping Distance: Empty, Full & Partial Loads 4.3 Following Distance, Smooth Driving & Bad Weather
5 Chapter 5: Skids, Emergency Maneuvers & Emergency Systems
5.1 Skids, Jackknife Prevention & Recovery 5.2 Emergency Steering, Leaving the Road & Returning Safely 5.3 Emergency Systems: Internal Valves, Remote Shut-offs & Crash Protection
6 Chapter 6: Inspection, Retests & Emergency Response
6.1 Inspecting Tank Vehicles: Leaks, Valves, Covers, Vents & Emergency Equipment 6.2 DOT Specification Cargo Tanks, Nameplates & Retest Markings 6.3 Leaks, Spills, Vapor Hazards & Tank Vehicle Fires
6.1 Inspecting Tank Vehicles: Leaks, Valves, Covers, Vents & Emergency Equipment
Key Takeaways Explain This Topic AI
The AAMVA manual says the most important item to check on all tank vehicles is leaks.
Carrying liquids or gases in a leaking tank is a crime: you will be cited, stopped from driving further, and may be liable for cleanup.
Check the shell for dents or leaks; intake, discharge, and cut-off valves; pipes, connections, and hoses; and manhole covers with gaskets and clear vents.
Never drive a tank vehicle with open valves or manhole covers.
A power unit hauling placarded hazmat needs a fire extinguisher rated 10 B:C or more, plus three reflective triangles or permitted alternatives.
Last updated: September 2026
The AAMVA manual opens the tank vehicle section with inspection: before loading, unloading, or driving a tanker, inspect the vehicle , so it is safe to carry the liquid or gas and safe to drive. Tank vehicles come in many types and sizes, so the manual also says to check the vehicle's operator manual to learn how to inspect your specific tank.
- The Manual's Tank Checklist (8.1)
- Leaks: the most important item
On all tank vehicles, the most important item to check for is leaks . Check under and around the vehicle for signs of any leaking. Don't carry liquids or gases in a leaking tank. To do so is a crime. You will be cited and prevented from driving further. You may also be liable for the clean-up of any spill.
In general, check:
- Item What to look for
- Tank body or shell Dents or leaks
- Intake, discharge, and cut-off valves Valves in the correct position before loading, unloading, or moving
- Pipes, connections, and hoses Leaks, especially around joints
- Manhole covers and vents Covers have gaskets and close correctly; vents are clear so they work correctly
- Special purpose equipment (8.1.2)
If the vehicle has any of these, make sure it works:
- Vapor recovery kits
- Grounding and bonding cables
- Emergency shut-off systems
- Built-in fire extinguisher
Never drive a tank vehicle with open valves or manhole covers.
Emergency equipment (8.1.3)
Check the emergency equipment required for your vehicle. Find out what you are required to carry, and make sure you have it and it works.
Where Tank Checks Fit the Seven-Step Inspection
The general inspection method in the manual has seven steps. Tank items belong in several of them:
Step Name Tank-specific additions
1 Vehicle overview Look under and around for fresh product leaks and puddles; review the last inspection report
2 Check engine compartment Standard checks
3 Start engine and inspect inside the cab Emergency equipment present; in-cab controls for air-operated valves if equipped
4 Turn off engine and check lights Standard checks
5 Do walkaround inspection Shell, valves, piping, hoses, outlets and caps, manholes and vents (where accessible), remote shut-off, bonding cable, test markings
- 6 Check signal lights Standard checks
- 7 Start the engine and check (brakes) Standard checks
Federal rules also require the driver to be satisfied that the vehicle is in good operating condition and that required emergency equipment is in place before driving (49 CFR 392.7 and 396.13).
- Detailed Hardware Checks
- Shell and structure
Dents, cuts, gouges, and corrosion , especially at welds and where the tank attaches to the frame or running gear. Registered inspectors judge dents against limits in 49 CFR 180.411: for dents at welds, the maximum allowed depth is 1/2 inch , and any tank showing damage that might make it unsafe must be tested and inspected before further use (180.407(b)).
Wet spots, stains, or residue trailing from seams, fittings, or insulation jackets. Insulated tanks hide the inner shell, so look for product at jacket seams and drain points.
Manhole covers
The gasket is present, seated, and not cut, cracked, hardened, or swollen.
The cover closes correctly and all fasteners are tight. Federal design rules require fastenings that keep covers from opening due to vibration or a rollover.
The safety device works. Each manhole, fill, and washout cover must have a device that prevents the cover from opening fully when internal pressure is present (49 CFR 178.345-5). Never wire it open or bypass it.
Work on top of a tank only where you can do it safely, using the ladder, walkway, and fall protection provided.
Vents and relief devices
Vents are clear , with no product buildup, debris, ice, or covers left on them.
Pressure and vacuum relief devices are not damaged, painted over, or blocked . A blocked vacuum vent can let the tank collapse during unloading (Section 3.3).
Valves, piping, and outlets
Internal valves closed and the operating linkage or air controls in good condition.
External valves closed with handles secure.
Caps or plugs on every outlet , with gaskets, fastened tight. Piping beyond a stop valve must end in another valve or leak-tight closure.
Shear sections not bent, cracked, welded over, or reinforced.
No drips from valve stems, packing, or couplings.
Emergency shut-off system
Locate each remote closure control and confirm it is not damaged or obstructed.
Where your carrier's procedure calls for it, operate the control and confirm the valves close.
Make sure the thermal closure elements (fusible links or similar) are present and not painted over or bypassed.
Bonding and grounding
Cable present, not frayed, with a clean clamp and a good connection point.
Test and inspection markings
Retest markings are legible and not past due for the tank's service (Section 6.2). External visual inspections include checking that all required markings are legible.
Emergency Equipment Rules (49 CFR 393.95)
- Equipment Requirement
- Fire extinguisher, power unit hauling placarded hazardous materials UL rating of 10 B:C or more
- Fire extinguisher, power unit not hauling hazmat 5 B:C or more, or two extinguishers of 4 B:C each
- Extinguisher condition Securely mounted, readily accessible, filled, with a way to see that it is charged
- Warning devices Three bidirectional emergency reflective triangles , or at least six fusees
For cargo tanks used for flammable liquids or flammable gases, loaded or empty, flame-producing warning devices may not be used (49 CFR 392.25), so carry the triangles .
Inspecting During the Trip and After
The general inspection rules still apply. During a trip, watch gauges, use your senses, and check critical items when you stop. For a tank, also look again for leaks at every stop, especially after loading, unloading, or a hard bump. Report defects on your post-trip inspection report so the carrier can repair them.
Common Test Traps
"What is the most important item to check on a tank vehicle?" Leaks.
"Can you drive with a small leak to the next stop?" No. Carrying liquids in a leaking tank is a crime.
"Is it OK to drive with a manhole cover open on an empty tank?" No. Never drive with open valves or manhole covers.
"What special purpose equipment should you check?" Vapor recovery kits, grounding and bonding cables, emergency shut-off systems, and built-in fire extinguishers.