Study guide

1.3 Search and Rescue Transponders (SART) & AIS-SART

RYA Marine Radio Short Range Certificate SRC/VHF

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: GMDSS Framework & Safety Equipment

1.1 GMDSS Architecture & Sea Areas (A1, A2, A3, A4) 1.2 Satellite EPIRBs (406 MHz / 121.5 MHz & COSPAS-SARSAT) 1.3 Search and Rescue Transponders (SART) & AIS-SART 1.4 NAVTEX System & Maritime Safety Information (MSI) 1.5 Digital Selective Calling (DSC) Fundamentals & MMSI Numbers

2 Chapter 2: VHF Radio Technical Operation & Channel Plan

2.1 Marine VHF Radio Controls, Power (1W vs 25W), & Squelch 2.2 VHF Range Calculations, Antenna Height, & Line-of-Sight Propagation 2.3 Simplex vs. Duplex Operating Modes & Channel Architecture 2.4 Specific VHF Channel Allocations (Ch 16, 70, 06, 13, 67, 80) 2.5 Routine DSC Calls & Working Channel Selection

3 Chapter 3: Emergency Communications & Distress Protocols

3.1 Voice Mayday Call & Distress Message Structure 3.2 DSC Distress Alerts & Automatic Acknowledgement Rules 3.3 Cancellation of False DSC Alerts & Accidental Transmissions 3.4 Mayday Relay Protocols & Coast Guard Coordination 3.5 Pan-Pan Urgency Calls & Medical Transmissions (Pan-Pan Medico) 3.6 Securite Safety Messages & Navigational Warnings 3.7 Radio Silence Control (Seelonce Mayday, Seelonce Distress, Prudonce, Seelonce Feenee)

4 Chapter 4: UK Regulations, Ofcom Licensing & Radio Governance

4.1 Ofcom Ship Radio Licensing & Ship Portable Licenses (10-Year Validation) 4.2 RYA Personal Operator Certificate (SRC) & Master's Authority 4.3 Secrecy of Communications, Illegal Transmissions, & Hoax Penalties 4.4 Radio Logbooks, Watchkeeping Requirements, & Routine Maintenance

5 Chapter 5: Phonetics, Terminology & Standard Marine Vocabulary

5.1 ITU Phonetic Alphabet (Alfa to Zulu) & Pronunciation Standards 5.2 Maritime Phonetic Numbering System & Position Reporting Formats 5.3 Standard Marine Procedural Words (Prowords: Over, Out, Roger, Say Again, Read Back)

1.3 Search and Rescue Transponders (SART) & AIS-SART

Key Takeaways Explain This Topic AI

Radar SARTs operate on 9 GHz X-band marine radar (9.2–9.5 GHz) and do not respond to 3 GHz S-band radars.

When interrogated by a searching vessel's X-band radar, a Radar SART displays 12 distinct blips extending 8 nautical miles along the bearing radial.

As the rescue vessel approaches within 1 nautical mile of the SART, the 12 dots expand into 12 concentric arcs and eventual wide circles.

AIS-SARTs broadcast position updates on AIS 1 (161.975 MHz) and AIS 2 (162.025 MHz), generating a dedicated symbol on ship ECDIS/AIS displays.

SARTs must be mounted at least 1 meter above sea level inside or attached to a survival craft to maximize line-of-sight radar detection range.

Last updated: July 2026

1.3 Search and Rescue Transponders (SART) & AIS-SART

Quick Answer: A Search and Rescue Transponder (SART) is a battery-powered survival craft homing device designed to guide rescue vessels directly to survivors in poor visibility, darkness, or rough seas. Traditional Radar SARTs respond to interrogation sweeps from 9 GHz X-band ship radars by generating a distinctive 12-dot radial line on the radar display. Modern AIS-SARTs utilize Automatic Identification System frequencies ( AIS 1 & AIS 2 ) and built-in GPS to broadcast high-precision position data directly onto navigation displays (ECDIS) as a specialized distress target.

Technical Principles of the 9 GHz Radar SART

A Radar SART remains in a low-power standby mode until it receives a radar pulse from a searching vessel or aircraft operating on the 9 GHz X-band radar frequency (9.2 to 9.5 GHz / 3 cm wavelength) .

CRITICAL EXAM FACT: Radar SARTs respond ONLY to 9 GHz X-band marine radar. They do NOT react to or display on 3 GHz S-band marine radar (10 cm wavelength) used for long-range precipitation penetration.

The Radar Display Response Sequence

When an X-band radar beam sweeps across a active SART, the transponder immediately triggers and sweeps back across the 9.2–9.5 GHz band. This transmission creates a unique graphic display on the searching vessel's radar PPI (Plan Position Indicator) screen:

Long Range (>1 Nautical Mile): The SART presents a series of 12 equally spaced dots (blips) aligned along a straight line extending 8 nautical miles outwards from the SART's location away from the center of the radar screen. The first dot closest to the radar center represents the actual position of the survival craft.

Close Range (<1 Nautical Mile): As the searching vessel closes to within approximately 1 nautical mile, radar receiver saturation and delay response cause the 12 dots to widen into 12 concentric arcs . When extremely close, these arcs expand into full concentric circles surrounding the searching vessel, confirming immediate proximity to the life raft. Radar SART Display States:

  • Distance > 1 nm: [Survival Craft] ● ● ● ● ● ● ● ● ● ● ● ● (12 Dots extending 8 nm outward)
  • Distance < 1 nm: [Survival Craft] ( ( ( ( ( ( ( ( ( ( ( ( (12 Concentric Arcs / Rings)
  • Radar SART vs. AIS-SART: Technical Comparison

With the expansion of digital marine electronics, the IMO authorized AIS-SARTs as an acceptable alternative to traditional 9 GHz Radar SARTs under SOLAS regulations.

  • Operational Feature 9 GHz Radar SART AIS-SART
  • Operating Frequency 9.2 – 9.5 GHz (X-band Radar) AIS 1 (161.975 MHz) & AIS 2 (162.025 MHz)
  • Primary Display Medium Marine X-band Radar PPI screen Chart Plotter / ECDIS / AIS display
  • Graphic Symbol 12-dot radial line -> Arcs -> Circles Circle containing an 'X' symbol ( MOB/SART )
  • Position Source Radar bearing & distance measurement Internal GPS/GNSS receiver (lat/long)
  • Update Rate Depends on radar antenna rotation speed 8 transmissions per minute (Message 1 & 14)
  • MMSI Numbering None (RF transponder sweep) Unique 9-digit MMSI starting with 970XXXXXX
  • Signal Propagation Microwave line-of-sight VHF line-of-sight (bends slightly around obstacles)
  • The Impact of Antenna Mounting Height on Detection Range

Because both X-band radar and VHF AIS signals travel via line-of-sight, the maximum range at which a searching vessel can detect a SART depends heavily on the mounting height of the SART above the water and the height of the searching radar or VHF antenna.

Mathematical Horizon Range Calculation D = 1.23 × ( h r a d a r / v h f + h s a r t ) D = 1.23 \times (\sqrt{h_{radar/vhf}} + \sqrt{h_{sart}}) D = 1.23 × ( h r a d a r / v h f ​ ​ + h s a r t ​ ​ )

Where:

  • (D) = Maximum detection range in nautical miles
  • h r a d a r / v h f h_{radar/vhf} h r a d a r / v h f ​ = Search vessel antenna height in feet
  • h s a r t h_{sart} h s a r t ​ = SART mounting height in feet
  • Worked Exam Scenario: SART Mounting Height Comparison

Case A (Correct Mounting): A survivor inside a life raft extends the telescopic support pole, securing the SART at a height of 3.3 feet (1 meter) above sea level. The searching vessel has a radar scanner mounted 49 feet high. D = 1.23 × ( 49 + 3.3 ) = 1.23 × ( 7 + 1.81 ) = 1.23 × 8.81 = 10.83 nm D = 1.23 \times (\sqrt{49} + \sqrt{3.3}) = 1.23 \times (7 + 1.81) = 1.23 \times 8.81 = 10.83\text{ nm} D = 1.23 × ( 49 ​ + 3.3 ​ ) = 1.23 × ( 7 + 1.81 ) = 1.23 × 8.81 = 10.83 nm

Case B (Incorrect Mounting): The survivor leaves the SART floating in the water attached by a lanyard, resulting in an effective height of only 0.33 feet (0.1 meter) . D = 1.23 × ( 49 + 0.33 ) = 1.23 × ( 7 + 0.57 ) = 1.23 × 7.57 = 9.31 nm D = 1.23 \times (\sqrt{49} + \sqrt{0.33}) = 1.23 \times (7 + 0.57) = 1.23 \times 7.57 = 9.31\text{ nm} D = 1.23 × ( 49 ​ + 0.33 ​ ) = 1.23 × ( 7 + 0.57 ) = 1.23 × 7.57 = 9.31 nm

Furthermore, sea swell and wave attenuation can block a low-floating SART completely, reducing detection range to under 2 nautical miles! This demonstrates why SART poles must be erected immediately upon entering a survival craft.

  • Battery Requirements, Operational Testing & Audible Indicators
  • Battery Performance Specs

GMDSS regulations mandate that all SART batteries must maintain sufficient capacity to operate in:

Standby Mode: Minimum of 96 hours (monitoring for interrogation pulses).

Active Transmitting Mode: Minimum of 8 hours continuous interrogation response while being painted by a radar.

Battery Expiration: Lithium battery packs have a operational shelf life of 5 years and must be replaced prior to the printed expiration date.

Operational Testing Procedure

To perform a routine inspection without causing false distress alarms to nearby ships:

Switch the SART selector switch to the TEST position.

Observe the visual indicator LED and listen for the built-in audible beeper .

Check the vessel's own 9 GHz X-band radar screen (set to 6 nm or 12 nm range scale). The radar screen should display concentric test rings or concentric dots.

Release the switch back to OFF or STANDBY immediately upon verification.

Visual and Audible Feedback in Survival Mode

When deployed in a real emergency, a SART provides feedback to survivors inside the life raft. When interrogated by a passing ship's radar, the SART flashes an LED light and emits an audible tone . This alerts survivors that a searching vessel is nearby and painted the transponder, boosting morale and alerting crew to prepare pyrotechnics.

Theoretical SART Detection Range vs. SART Antenna Height (Ship Radar Antenna at 49 ft)