Study guide
4.4 Takeoffs, Landings, Slow Flight & Emergency Procedures
FAA Advanced Ground Instructor AGI
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: Ground Instructor Privileges & Pilot Certification
1.1 Ground Instructor Eligibility, Privileges & Currency 1.2 Pilot Certification Requirements & Aeronautical Experience 1.3 ATP Certification & Flight Instructor Prerequisites
2 Chapter 2: Operating Rules, Endorsements & Commercial Regulations
2.1 Pilot Logbooks & Special Aircraft Endorsements 2.2 Flight Reviews, Recency & Medical Certification 2.3 General Operating & Flight Rules (14 CFR Part 91) 2.4 Commercial Air Operations & Operator Certification 2.5 Aircraft Documents, Maintenance Records & NTSB Part 830 Reporting
3 Chapter 3: Aerodynamics & Principles of Flight
3.1 Aerodynamic Forces, Airfoils & Lift/Drag Generation 3.2 Aircraft Stability, Axes of Motion & Control Surfaces 3.3 Load Factor, Stalls & Maneuvering Speed 3.4 Ground Effect, Wingtip Vortices & Wake Turbulence
4 Chapter 4: Advanced Aerodynamics & Commercial Flight Maneuvers
4.1 High-Altitude & High-Speed Aerodynamics 4.2 Commercial Performance Maneuvers 4.3 Ground Reference Maneuvers & Eights-on-Pylons 4.4 Takeoffs, Landings, Slow Flight & Emergency Procedures
5 Chapter 5: Advanced Aircraft Systems & Pressurization
5.1 Reciprocating Engines & Constant-Speed Propellers 5.2 Turbochargers, Superchargers & Induction Systems 5.3 Pressurization Systems & Supplemental Oxygen Requirements 5.4 Flight Instruments, Pitot-Static & Advanced Avionics
6 Chapter 6: Weight, Balance & Aircraft Performance Calculations
6.1 Principles of Weight and Balance & Center of Gravity 6.2 Weight Shift & Payload Calculations 6.3 Atmospheric Physics & Density Altitude 6.4 Takeoff, Landing & Cruise Performance Charts
7 Chapter 7: Aviation Weather Principles & Hazardous Weather
7.1 Atmospheric Physics, Pressure Systems & Fronts 7.2 Thunderstorms, Microbursts & Low-Level Wind Shear 7.3 Aircraft Icing: Structural & Induction Hazards 7.4 Fog Formation, Visibility Obstructions & Atmospheric Stability
8 Chapter 8: Aviation Weather Reports, Forecasts & Charts
8.1 Surface Weather Observations: METAR & SPECI Decoding 8.2 Terminal Aerodrome Forecasts (TAF) & Graphical Forecasts (GFA) 8.3 In-Flight Weather Advisories & Convective Products
9 Chapter 9: Navigation Systems & National Airspace System
9.1 Pilotage, Dead Reckoning & E6B Computations 9.2 Ground-Based Navigation: VOR, DME & Receiver Checks 9.3 Satellite Navigation: GPS, RNAV, WAAS & RAIM 9.4 Airspace Classification, Special Use Airspace & TFRs 9.5 Airport Markings, Signs & Lighting 9.6 Radio Communications, Traffic Patterns & ATC Services
10 Chapter 10: Rotorcraft, Gliders, Light-Sport & Lighter-Than-Air Aircraft
10.1 Rotorcraft Principles: Helicopters & Gyroplanes 10.2 Gliders, Powered Parachutes & Weight-Shift-Control Aircraft 10.3 Lighter-Than-Air: Balloons & Airships
11 Chapter 11: Fundamentals of Instructing: Learning & Communication
11.1 Human Behavior, Maslow's Hierarchy & Defense Mechanisms 11.2 Learning Theory, Principles of Learning & Domains 11.3 The Teaching Process & Instructional Methods 11.4 Assessment, Critique & Evaluation Techniques
12 Chapter 12: Instructional Planning, Risk Management & Aeromedical Factors
12.1 Lesson Planning, Syllabus Organization & Scenario-Based Training 12.2 Aeronautical Decision-Making & Risk Models 12.3 Aeromedical Factors & Altitude Physiology 12.4 Vision, Spatial Disorientation & Fitness for Flight
4.4 Takeoffs, Landings, Slow Flight & Emergency Procedures
Key Takeaways Explain This Topic AI
In cruise, a pilot corrects for crosswind by establishing a wind correction heading (crab) with coordinated controls, not by holding rudder in a slip.
The wing-low (sideslip) crosswind landing uses aileron into the wind and opposite rudder so the longitudinal axis stays aligned with the runway at touchdown.
Excessive airspeed on final approach normally causes floating and a long landing, because the airplane must dissipate the extra energy in ground effect.
In a go-around from a full-flap approach, strong nose-up trim plus full power causes a pitch-up; apply power, pitch for climb, then retract flaps in stages.
After an engine failure shortly after takeoff at low altitude, the FAA teaches landing ahead with only small heading changes rather than attempting to turn back to the runway.
Last updated: September 2026
Takeoffs, Landings, Slow Flight & Emergency Procedures
The commercial pilot knowledge areas include "maneuvers, procedures, and emergency operations appropriate to the aircraft" (14 CFR 61.125(b)(13)), and the private areas include safe and efficient operation of aircraft (61.105(b)(7)). The FAA's published AGI sample questions reflect this: they ask how to correct for crosswind in cruise, why an airplane is hard to control in a full-flap go-around, what excessive speed on final causes, how short- and soft-field takeoffs differ, and how to teach slow flight. The primary reference is the Airplane Flying Handbook (FAA-H-8083-3C) , with performance standards in the Private and Commercial Pilot Airman Certification Standards (ACS) .
Crosswind Correction in Cruise and on the Runway
In cruise , a pilot compensates for wind drift by establishing a heading into the wind (a crab) with coordinated use of the controls. The airplane flies straight and coordinated; only its heading differs from the ground track. Holding rudder to point the nose down the track while banking the other way is a slip, which adds drag and is inappropriate for cruise.
For takeoff and landing , the aircraft's longitudinal axis must be aligned with the runway at touchdown or liftoff to avoid side loads on the landing gear. The Airplane Flying Handbook teaches two landing methods:
Method Technique Transition to Touchdown
Crab Heading into the wind on final, wings level Just before touchdown, rudder aligns the nose with the runway while aileron keeps the airplane from drifting; demands precise timing
Wing-low (sideslip) Upwind wing lowered with aileron to stop drift; opposite rudder keeps the nose aligned with the centerline Touch down on the upwind main wheel first, then the other main, then the nosewheel; increase aileron into the wind as the airplane slows
On the takeoff roll in a crosswind, the pilot starts with full aileron into the wind and reduces it as speed builds, uses rudder to track the centerline, and lifts off cleanly to avoid side-skipping.
Short-Field and Soft-Field Takeoffs
Short-field takeoff: Use the POH flap setting, start at the very beginning of the runway, apply full power (with brakes held if the POH recommends), rotate at the recommended speed, and climb at VX (best angle) until the obstacle is cleared, then accelerate to VY .
Soft-field takeoff: Keep the airplane moving on the soft surface, hold back-elevator pressure to lift the nosewheel early and transfer weight from the wheels to the wings , and lift off at the lowest possible airspeed . Then lower the nose slightly and accelerate in ground effect to VX or VY before climbing out of ground effect (see Section 3.4).
Soft-field landing: Touch down at the lowest possible airspeed with the nose held off, often with a little power, and keep the nosewheel off the surface as long as possible.
Approach Speed, Floating & Go-Arounds
An approach flown too fast leaves the airplane with excess energy . In the flare it enters ground effect, induced drag drops, and the airplane floats far down the runway, often ending in a long landing or an overrun. Forcing it onto the runway invites a bounce or a wheelbarrow. The cure is a stabilized approach at the POH or 1.3 VSO approach speed with gust corrections.
A go-around (rejected landing) should be initiated early , as soon as the pilot decides the approach or landing cannot be completed safely. The FAA teaches three elements: power, attitude, configuration .
Power: apply takeoff power smoothly and promptly.
Attitude: hold the pitch attitude that stops the descent and gives a climb; right rudder counters the left-turning tendencies.
Configuration: retract flaps in increments (first to an intermediate setting such as 20°), retract the gear after a positive rate of climb, and retract the remaining flaps at a safe altitude and airspeed.
A common trap: the approach was trimmed nose-up for full flaps and low speed. When full power is applied, the trim and the flaps create a strong nose-up pitching moment , so poor controllability in a full-flap go-around is usually caused by that trim setting. The pilot must use firm forward pressure and retrim.
Loading diagram... Go-Around Decision and Sequence
Slow Flight and Stall Recovery
The current ACS defines slow flight as flight at an airspeed at which any further increase in angle of attack, increase in load factor, or reduction in power would result in a stall warning (horn, buffet, or other cue). Instructors should cover it in both clean and landing configurations, in straight flight, turns, climbs, and descents, because this is where approaches, departures, and go-arounds happen. The student learns how control effectiveness decreases, how much power the airplane needs on the back side of the power curve, and how quickly a stall warning appears if the nose comes up.
The Airplane Flying Handbook's stall recovery sequence puts reducing angle of attack first :
Disconnect the autopilot or flight director if engaged.
Reduce the angle of attack (lower the nose) until the stall warning stops.
Roll the wings level.
Add power as needed.
Return to the desired flight path.
Emergency Operations
Emergency FAA-Taught Response
Engine failure after takeoff at low altitude Immediately lower the nose to the best glide attitude and land straight ahead , changing heading only slightly as needed to avoid obstacles. Turning back to the runway from low altitude risks a stall-spin.
Engine failure at altitude Airspeed (best glide), Best field (landing site within gliding range, considering wind and surface), Checklist (restart attempt, then securing the engine and communicating on 121.5 MHz or the current frequency, squawk 7700).
Electrical fire Master switch off, cabin vents as the POH directs, fire extinguisher if needed, land as soon as possible.
Engine fire in flight Mixture to idle cutoff, fuel selector off, and a descent to land immediately per the POH.
Partial power loss Maintain best glide or the speed for the power available, troubleshoot (carburetor heat, fuel selector, mixture, magnetos), and plan to land at the nearest suitable airport.
The Airplane Flying Handbook stresses that the pilot's first duty in any emergency is to maintain control of the airplane ; a controlled touchdown at the slowest safe speed into a poor landing site is far more survivable than a stall-spin while trying to reach a better one.