Study guide

11.4 Electrical System and Alternator Failure

FAA Private Pilot — Airplane PAR

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 Current Exam Facts 1.2 ACS Codes, the AKTR, and How to Use This Guide

2 Pilot Qualifications & Medicals

2.1 Eligibility, Training, and Knowledge-Test Authorization 2.2 Private Pilot Privileges and Limitations 2.3 Medical Certificates, Duration, and Disqualification 2.4 BasicMed (14 CFR 61.113(i) and Part 68)

3 Airworthiness, Documents & Currency

3.1 Required Pilot and Aircraft Documents 3.2 Inspections, Airworthiness Directives, and Preventive Maintenance 3.3 Inoperative Equipment and 91.213 3.4 Recent Flight Experience and the Flight Review

4 14 CFR Part 91 Operating Rules

4.1 Right-of-Way, Minimum Safe Altitudes, and Speed Limits 4.2 VFR Cruising Altitudes, Altimeter Settings, and Oxygen 4.3 Fuel Requirements, Transponder, ADS-B, and ELT 4.4 NOTAMs, TFRs, and Accident/Incident Duties

5 National Airspace System

5.1 Class A, B, and C Airspace 5.2 Class D, E, and G Airspace and VFR Weather Minimums 5.3 Special Use Airspace 5.4 Other Airspace, TFRs, TRSA, ADIZ, and SFRA

6 Aviation Weather Theory

6.1 Atmosphere, Pressure, Temperature, and Density 6.2 Stability, Clouds, and Moisture 6.3 Air Masses and Fronts 6.4 Wind, Jet Stream, and Local Wind Systems

7 Weather Hazards

7.1 Thunderstorms and Convective Weather 7.2 Structural Icing, Frost, and Carburetor Ice 7.3 Fog, Low Ceilings, and Visibility 7.4 Wind Shear, Microbursts, Turbulence, and Mountain Waves

8 Weather Products & Briefings

8.1 METAR Decoding 8.2 TAF and Graphical Forecast Products 8.3 PIREPs, AIRMET, SIGMET, Convective SIGMET, and Winds Aloft 8.4 Briefings and Go/No-Go Decisions

9 Principles of Flight

9.1 Four Forces and Lift Production 9.2 Angle of Attack, Critical AoA, and Stalls 9.3 Drag, L/D, and Ground Effect 9.4 Axes, Stability, and Flight Controls

10 Maneuvering Flight, Stalls & Spins

10.1 Load Factor, Bank Angle, and Stall Speed 10.2 Left-Turning Tendencies 10.3 Slow Flight, Power-On/Off Stalls, and Spin Awareness 10.4 Steep Turns and Ground-Reference Maneuvers

11 Powerplant, Fuel & Electrical Systems

11.1 Reciprocating Engines, Mixture, Detonation, and Preignition 11.2 Ignition, Magnetos, Carburetor vs Fuel Injection 11.3 Fuel Grades, Contamination, and Fuel-System Management 11.4 Electrical System and Alternator Failure

12 Flight Instruments & Avionics

12.1 Pitot-Static Instruments and Blockage Errors 12.2 Gyroscopic Instruments, Vacuum Failure, and Magnetic Compass Errors 12.3 Engine Instruments, Transponder Modes, and Basic Avionics

13 Aircraft Performance

13.1 Pressure Altitude, Density Altitude, and Performance Effects 13.2 Takeoff and Climb Performance 13.3 Cruise, Descent, and Landing Performance 13.4 Wind, Gradient, Surface, and Crosswind Component

14 Weight and Balance

14.1 Weight-and-Balance Principles 14.2 Moment, CG, and Sample Computations 14.3 Forward and Aft CG Effects 14.4 V-Speeds, Markings, and Limitation Placards

15 Charts, Pilotage & Dead Reckoning

15.1 Sectional Chart Symbology and Airspace Depiction 15.2 Pilotage and Dead Reckoning 15.3 Variation, Deviation, Wind Triangle, and E6B 15.4 VFR Cross-Country and Fuel Planning

16 Radio Navigation, Lost Procedures & Airport Operations

16.1 VOR Navigation 16.2 GPS, RAIM, and Radar Services 16.3 Lost Procedures and Diversion 16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns

17 Aeromedical Factors

17.1 Hypoxia, Hyperventilation, and Carbon Monoxide 17.2 Spatial Disorientation, Illusions, and Vision 17.3 Scuba-to-Flight, Alcohol/Drugs, and IMSAFE

18 ADM, Night Operations & Emergencies

18.1 ADM, Hazardous Attitudes, PAVE, and DECIDE 18.2 Night Operations and Night Illusions 18.3 Emergency Descent, Engine Failure, and System Malfunctions 18.4 Survival Gear, ELT, and Forced-Landing Considerations

19 Preflight Procedures & Airport Ground Operations

19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection 19.2 Flight Deck Management, Passenger Briefings, and Engine Starting 19.3 Taxi Operations: Signs, Markings, Lighting, and Runway Incursion Avoidance 19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane

20 Class-Specific Knowledge: Seaplane & Multiengine

20.1 Seaplane and Water Operations Knowledge 20.2 Multiengine Knowledge: VMC, VYSE, and Engine-Out Fundamentals

11.4 Electrical System and Alternator Failure

Key Takeaways Explain This Topic AI

Typical trainers are 14- or 28-volt DC: battery, alternator or generator, bus, voltage regulator, and either circuit breakers or fuses (PHAK Chapter 7).

Night VFR under 14 CFR 91.205(c)(6) requires one spare set of fuses, or three spare fuses of each kind, accessible in flight — on airplanes that use fuses.

An ammeter shows charge (+) or discharge (−). A loadmeter shows how much load the alternator is carrying from zero up. Full-scale minus suggests alternator failure; full-scale plus suggests a regulator/overvoltage problem.

After an alternator failure the magnetos still run the engine and an engine-driven vacuum pump still drives those gyros. Shed electrical load. A starter that stays engaged after start is a mixture-cutoff and master-off emergency.

Last updated: August 2026

ACS PA.I.G.K1f is the electrical system. PA.I.G.K2 is what you still have when it quits. PAR’s favorite wrong picture is a dark cockpit that must also be a silent engine. The magnetos were never on this bus.

Battery, alternator, bus

Most light airplanes use a 14- or 28-volt DC system. PHAK’s usual parts:

Battery — starts the engine and is the emergency reservoir if the alternator dies.

Alternator (or, on older airplanes, a generator ) — supplies the system in flight and recharges the battery. Alternators still make usable current at low RPM ; generators often do not, so idle taxi can drain the battery.

Voltage regulator — holds output a little above battery voltage so the battery stays charged without being cooked.

Bus bar — the distribution strip that feeds radios, lights, pumps, and instruments.

Master switch , often split : a BAT half that connects the battery to the bus, and an ALT (or GEN) half that brings the alternator online. Turning the alternator half off leaves the entire electrical load on the battery .

The master powers almost everything electrical except the ignition system : position and anti-collision lights, landing and taxi lights, cabin and instrument lights, radios, electric turn coordinator, fuel gauges, electric fuel pump, stall-warning electronics, pitot heat, and the starter. Magnetos are not on that list.

Many modern panels split the bus further in concept if not in name: an essential (or battery/emergency) bus for the few items you keep in an electrical emergency, and an avionics bus behind an avionics master so you can spin the engine without a voltage spike hitting the radios. Know which switch kills the glass and which switch still leaves you a transponder or a comm, from that AFM.

Breakers, fuses, and 91.205 at night

Circuit breakers and fuses protect wires and equipment from overload. A breaker can be reset — once , if the AFM allows, after a cooling pause — if the trip was nuisance. A fuse must be replaced. A breaker that trips again stays out; you just found a short.

14 CFR 91.205(c)(6) adds a night-VFR item: one spare set of fuses, or three spare fuses of each kind required , accessible to the pilot in flight . That rule is about airplanes that use fuses . A breaker-only panel does not require a pocket of spare fuses for circuits that have no fuses. Day VFR (91.205(b)) does not add the spare-fuse line. The FLAPS memory aid (Fuses, Landing light, Anti-collision, Position lights, Source of electrical power) is a study handle for 91.205(c), not a substitute for the regulation.

Ammeter versus loadmeter

You cannot manage a failure you cannot read.

Instrument Scale What a normal reading means What a sick reading means

Ammeter Minus / zero / plus Plus (+) — the alternator is charging the battery. A small plus after start is normal while the starter debt is repaid Minus (−) — the battery is net discharging. Full-scale minus — treat as alternator/generator failure . Full-scale plus — treat as a regulator / overvoltage problem

Loadmeter Zero upward Shows the load the alternator is carrying right now A sudden drop toward zero with a dying bus is an alternator that stopped supplying

They are not the same gauge. An ammeter talks about battery charge direction . A loadmeter talks about alternator output demand .

Overvoltage (a failed regulator, often that full-scale plus) can cook the battery and the avionics. The systems move is to shed the alternator — ALT half of the master OFF — then treat the rest of the flight as a battery-only electrical problem.

Alternator failure: shed load, know what still works

When the ammeter goes full minus, the low-voltage light comes on, or the loadmeter collapses, assume the alternator is no longer feeding the bus . AFM flows differ in button order; the knowledge is stable:

Confirm the ALT side is on and the breaker is in (a popped alternator breaker is a cheap save).

If it will not come back, ALT off so a sick alternator cannot put junk on the bus.

Shed electrical load immediately: pitot heat if you do not need it, extra lights, unused radios, electric fuel pump if the engine-driven pump is doing the job, cabin power. You are spending a finite battery.

Plan a landing with enough battery for a radio call, a transponder squawk, and lighting if it is night.

What still works after a total electrical (battery + alternator) failure, on a typical trainer:

  • Engine — dual magnetos, independent of the bus
  • Engine-driven fuel pump

Vacuum attitude and heading gyros , if they are driven by an engine-driven vacuum pump rather than by electricity

Pitot-static airspeed, altimeter, and VSI (those instruments do not eat bus voltage)

What stops : radios and audio, transponder and ADS-B out, GPS and glass screens, electric turn coordinator, electric flaps, fuel gauges, interior and exterior lights, pitot heat, electric boost pump, stall-warning electronics. Night, IMC, or a busy Class B arrival on a dying battery is a land soon problem, not a “the engine will quit in four minutes” problem.

Starter still engaged, and the split master

After start, listen. A starter that remains engaged (grind, scream, or a starter annunciator) is trying to motor an already-running engine. It will overheat , can weld or fling the starter drive , and is a firewall fire candidate. This is not a “taxi in and write it up” item. Typical immediate action: mixture idle cutoff , master OFF , and get the engine stopped before the starter becomes a torch. Do not keep the master on “so the radios still work.”

The split master is also how you isolate a failed alternator without killing the battery bus, and how you crank on battery alone with the ALT side off if the AFM wants that for start. Know which half you are holding.

Scenario: Jordan’s midnight ammeter

Jordan is on a night VFR hop when the ammeter slams to full minus and the low-voltage light comes on. He does not lean or fuss with the mags — those were never on this bus. He checks the alternator breaker, then turns the ALT half off, kills pitot heat and the second radio, and points at a lighted airport 15 miles ahead while the battery still runs one comm and the lights. The vacuum attitude indicator is still up. The engine never noticed. In the same airplane, a full-scale plus would have been the opposite story: regulator/overvoltage, ALT off for a different reason. And if this airframe used fuses , 91.205(c) already required the spare set within reach — not in the hangar.

Loading diagram... Alternator failure sheds the bus, not the magnetos