Study guide

19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane

FAA Private Pilot — Airplane PAR

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 Current Exam Facts 1.2 ACS Codes, the AKTR, and How to Use This Guide

2 Pilot Qualifications & Medicals

2.1 Eligibility, Training, and Knowledge-Test Authorization 2.2 Private Pilot Privileges and Limitations 2.3 Medical Certificates, Duration, and Disqualification 2.4 BasicMed (14 CFR 61.113(i) and Part 68)

3 Airworthiness, Documents & Currency

3.1 Required Pilot and Aircraft Documents 3.2 Inspections, Airworthiness Directives, and Preventive Maintenance 3.3 Inoperative Equipment and 91.213 3.4 Recent Flight Experience and the Flight Review

4 14 CFR Part 91 Operating Rules

4.1 Right-of-Way, Minimum Safe Altitudes, and Speed Limits 4.2 VFR Cruising Altitudes, Altimeter Settings, and Oxygen 4.3 Fuel Requirements, Transponder, ADS-B, and ELT 4.4 NOTAMs, TFRs, and Accident/Incident Duties

5 National Airspace System

5.1 Class A, B, and C Airspace 5.2 Class D, E, and G Airspace and VFR Weather Minimums 5.3 Special Use Airspace 5.4 Other Airspace, TFRs, TRSA, ADIZ, and SFRA

6 Aviation Weather Theory

6.1 Atmosphere, Pressure, Temperature, and Density 6.2 Stability, Clouds, and Moisture 6.3 Air Masses and Fronts 6.4 Wind, Jet Stream, and Local Wind Systems

7 Weather Hazards

7.1 Thunderstorms and Convective Weather 7.2 Structural Icing, Frost, and Carburetor Ice 7.3 Fog, Low Ceilings, and Visibility 7.4 Wind Shear, Microbursts, Turbulence, and Mountain Waves

8 Weather Products & Briefings

8.1 METAR Decoding 8.2 TAF and Graphical Forecast Products 8.3 PIREPs, AIRMET, SIGMET, Convective SIGMET, and Winds Aloft 8.4 Briefings and Go/No-Go Decisions

9 Principles of Flight

9.1 Four Forces and Lift Production 9.2 Angle of Attack, Critical AoA, and Stalls 9.3 Drag, L/D, and Ground Effect 9.4 Axes, Stability, and Flight Controls

10 Maneuvering Flight, Stalls & Spins

10.1 Load Factor, Bank Angle, and Stall Speed 10.2 Left-Turning Tendencies 10.3 Slow Flight, Power-On/Off Stalls, and Spin Awareness 10.4 Steep Turns and Ground-Reference Maneuvers

11 Powerplant, Fuel & Electrical Systems

11.1 Reciprocating Engines, Mixture, Detonation, and Preignition 11.2 Ignition, Magnetos, Carburetor vs Fuel Injection 11.3 Fuel Grades, Contamination, and Fuel-System Management 11.4 Electrical System and Alternator Failure

12 Flight Instruments & Avionics

12.1 Pitot-Static Instruments and Blockage Errors 12.2 Gyroscopic Instruments, Vacuum Failure, and Magnetic Compass Errors 12.3 Engine Instruments, Transponder Modes, and Basic Avionics

13 Aircraft Performance

13.1 Pressure Altitude, Density Altitude, and Performance Effects 13.2 Takeoff and Climb Performance 13.3 Cruise, Descent, and Landing Performance 13.4 Wind, Gradient, Surface, and Crosswind Component

14 Weight and Balance

14.1 Weight-and-Balance Principles 14.2 Moment, CG, and Sample Computations 14.3 Forward and Aft CG Effects 14.4 V-Speeds, Markings, and Limitation Placards

15 Charts, Pilotage & Dead Reckoning

15.1 Sectional Chart Symbology and Airspace Depiction 15.2 Pilotage and Dead Reckoning 15.3 Variation, Deviation, Wind Triangle, and E6B 15.4 VFR Cross-Country and Fuel Planning

16 Radio Navigation, Lost Procedures & Airport Operations

16.1 VOR Navigation 16.2 GPS, RAIM, and Radar Services 16.3 Lost Procedures and Diversion 16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns

17 Aeromedical Factors

17.1 Hypoxia, Hyperventilation, and Carbon Monoxide 17.2 Spatial Disorientation, Illusions, and Vision 17.3 Scuba-to-Flight, Alcohol/Drugs, and IMSAFE

18 ADM, Night Operations & Emergencies

18.1 ADM, Hazardous Attitudes, PAVE, and DECIDE 18.2 Night Operations and Night Illusions 18.3 Emergency Descent, Engine Failure, and System Malfunctions 18.4 Survival Gear, ELT, and Forced-Landing Considerations

19 Preflight Procedures & Airport Ground Operations

19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection 19.2 Flight Deck Management, Passenger Briefings, and Engine Starting 19.3 Taxi Operations: Signs, Markings, Lighting, and Runway Incursion Avoidance 19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane

20 Class-Specific Knowledge: Seaplane & Multiengine

20.1 Seaplane and Water Operations Knowledge 20.2 Multiengine Knowledge: VMC, VYSE, and Engine-Out Fundamentals

19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane

Key Takeaways Explain This Topic AI

The magneto check verifies that each ignition system fires independently; the AFM sets both the maximum RPM drop and the maximum allowable difference between the two magnetos.

No RPM drop at all during the magneto check suggests a broken or grounded P-lead, which leaves that magneto hot — the propeller must then be treated as live even with the switch off.

The carburetor heat check should produce an RPM drop, confirming that warm, unfiltered air is actually reaching the carburetor.

Do not begin after-landing checks until the airplane is completely clear of the runway, past the runway holding position marking.

Shut down with the mixture at idle cutoff so no combustible charge remains in the cylinders, and record every discrepancy in the maintenance record rather than passing it along verbally.

Last updated: August 2026

The run-up is a diagnostic, not a ritual

PA.II.F.K1 asks for the reasons for checking each item and for detecting malfunctions . Position the airplane clear of the runway and of other aircraft, on a firm surface so the propeller does not ingest gravel, and — where practical — nose into the wind for cooling.

Check What it is actually testing The malfunction it detects

Magneto check at the AFM RPM Each ignition system firing on its own, since the engine has two independent magnetos and two plugs per cylinder Excessive RPM drop (fouled plug, bad lead, mistimed magneto); excessive difference between magnetos; a rough run on one magneto

No drop at all on a magneto The P-lead grounding path A broken or grounded P-lead — that magneto is hot and the engine can fire even with the switch OFF

Carburetor heat That warm, unfiltered air is reaching the carburetor No RPM drop means the heat is not getting there — the anti-icing system is inoperative (Section 7.2)

Engine instruments Oil temperature and pressure in the green, ammeter charging, suction or vacuum in range, fuel flow normal A failing alternator, a failing vacuum pump before you need the gyros (Section 12.2), a cooling problem

Flight controls free and correct Full, unobstructed travel in the correct sense A jammed control, a control lock left in, a reversed cable after maintenance

Flight instruments set Altimeter to the current setting, heading indicator aligned to the magnetic compass, attitude indicator erect, VSI near zero A gyro that will not erect, an altimeter outside tolerance, precession beyond limits

Configuration Trim set for takeoff, flaps set, fuel selector on the proper tank, mixture set for the field elevation A trim setting or fuel selector that would produce a control or power surprise on the roll

Doors, belts, seats Latched, fastened, and locked A door that pops open on climb-out, a seat that slides aft on rotation

Finish with a departure briefing spoken out loud: the abort point on the runway, what you will do if the engine quits on the roll (throttle idle, brakes, stop straight ahead) versus after liftoff at low altitude (lower the nose, land more or less straight ahead, small turns only to avoid obstacles — Section 18.3), the initial heading and altitude, and the first frequency. Deciding this on the ground is the whole point.

After landing — clear the runway first

The rule that matters: do not begin after-landing checks until the airplane is completely clear of the runway , meaning past the runway holding position marking. Heads-down time on an active runway is how incursions and collisions happen. At a towered airport, stay on the tower frequency until instructed to change.

Once clear: flaps up, carburetor heat cold, trim reset, landing light and strobes as appropriate, transponder per local procedure, and then the taxi clearance.

Shutdown, securing, and the postflight inspection

Task XII.A covers airplane shutdown, securing, and postflight inspection, plus documenting discrepancies.

Mixture to idle cutoff stops the engine by starving it of fuel, so no combustible charge is left in the cylinders. Shutting down with the magneto switch instead leaves raw fuel where it can fire on a later propeller movement.

Magnetos off after the propeller stops , then master off, then the key removed. Treat the propeller as live regardless — especially if the magneto check showed no drop.

Secure the airplane: control lock installed, chocks and a three-point tie-down (both wings and the tail) if it will sit outside, pitot cover on, cowl plugs in, fuel selector per the AFM, and the doors and windows latched. Park into the wind where the ramp layout allows.

Postflight inspection is a walk-around with fresh eyes: new oil streaks, a fuel stain, a nicked propeller, a flat-spotted tire, a hangar-rash dent. The discrepancy you find on the ramp is the one the next pilot does not discover at 1,000 feet.

Documenting discrepancies (PA.XII.A.K2) means writing them into the squawk sheet or maintenance record — not mentioning them to whoever is behind the desk. A verbal report leaves no record, does not reach the mechanic reliably, and does not discharge your responsibility. If an item is deferred, the 91.213(d) path requires it to be removed or deactivated and placarded "Inoperative" (Section 3.3).

Refueling after the flight reduces overnight condensation in the tanks, which is the practical answer to water in the sumps — but check that the resulting fuel load still leaves a legal weight and CG for the next flight (Chapter 14).