Study guide

19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection

FAA Private Pilot — Airplane PAR

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 Current Exam Facts 1.2 ACS Codes, the AKTR, and How to Use This Guide

2 Pilot Qualifications & Medicals

2.1 Eligibility, Training, and Knowledge-Test Authorization 2.2 Private Pilot Privileges and Limitations 2.3 Medical Certificates, Duration, and Disqualification 2.4 BasicMed (14 CFR 61.113(i) and Part 68)

3 Airworthiness, Documents & Currency

3.1 Required Pilot and Aircraft Documents 3.2 Inspections, Airworthiness Directives, and Preventive Maintenance 3.3 Inoperative Equipment and 91.213 3.4 Recent Flight Experience and the Flight Review

4 14 CFR Part 91 Operating Rules

4.1 Right-of-Way, Minimum Safe Altitudes, and Speed Limits 4.2 VFR Cruising Altitudes, Altimeter Settings, and Oxygen 4.3 Fuel Requirements, Transponder, ADS-B, and ELT 4.4 NOTAMs, TFRs, and Accident/Incident Duties

5 National Airspace System

5.1 Class A, B, and C Airspace 5.2 Class D, E, and G Airspace and VFR Weather Minimums 5.3 Special Use Airspace 5.4 Other Airspace, TFRs, TRSA, ADIZ, and SFRA

6 Aviation Weather Theory

6.1 Atmosphere, Pressure, Temperature, and Density 6.2 Stability, Clouds, and Moisture 6.3 Air Masses and Fronts 6.4 Wind, Jet Stream, and Local Wind Systems

7 Weather Hazards

7.1 Thunderstorms and Convective Weather 7.2 Structural Icing, Frost, and Carburetor Ice 7.3 Fog, Low Ceilings, and Visibility 7.4 Wind Shear, Microbursts, Turbulence, and Mountain Waves

8 Weather Products & Briefings

8.1 METAR Decoding 8.2 TAF and Graphical Forecast Products 8.3 PIREPs, AIRMET, SIGMET, Convective SIGMET, and Winds Aloft 8.4 Briefings and Go/No-Go Decisions

9 Principles of Flight

9.1 Four Forces and Lift Production 9.2 Angle of Attack, Critical AoA, and Stalls 9.3 Drag, L/D, and Ground Effect 9.4 Axes, Stability, and Flight Controls

10 Maneuvering Flight, Stalls & Spins

10.1 Load Factor, Bank Angle, and Stall Speed 10.2 Left-Turning Tendencies 10.3 Slow Flight, Power-On/Off Stalls, and Spin Awareness 10.4 Steep Turns and Ground-Reference Maneuvers

11 Powerplant, Fuel & Electrical Systems

11.1 Reciprocating Engines, Mixture, Detonation, and Preignition 11.2 Ignition, Magnetos, Carburetor vs Fuel Injection 11.3 Fuel Grades, Contamination, and Fuel-System Management 11.4 Electrical System and Alternator Failure

12 Flight Instruments & Avionics

12.1 Pitot-Static Instruments and Blockage Errors 12.2 Gyroscopic Instruments, Vacuum Failure, and Magnetic Compass Errors 12.3 Engine Instruments, Transponder Modes, and Basic Avionics

13 Aircraft Performance

13.1 Pressure Altitude, Density Altitude, and Performance Effects 13.2 Takeoff and Climb Performance 13.3 Cruise, Descent, and Landing Performance 13.4 Wind, Gradient, Surface, and Crosswind Component

14 Weight and Balance

14.1 Weight-and-Balance Principles 14.2 Moment, CG, and Sample Computations 14.3 Forward and Aft CG Effects 14.4 V-Speeds, Markings, and Limitation Placards

15 Charts, Pilotage & Dead Reckoning

15.1 Sectional Chart Symbology and Airspace Depiction 15.2 Pilotage and Dead Reckoning 15.3 Variation, Deviation, Wind Triangle, and E6B 15.4 VFR Cross-Country and Fuel Planning

16 Radio Navigation, Lost Procedures & Airport Operations

16.1 VOR Navigation 16.2 GPS, RAIM, and Radar Services 16.3 Lost Procedures and Diversion 16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns

17 Aeromedical Factors

17.1 Hypoxia, Hyperventilation, and Carbon Monoxide 17.2 Spatial Disorientation, Illusions, and Vision 17.3 Scuba-to-Flight, Alcohol/Drugs, and IMSAFE

18 ADM, Night Operations & Emergencies

18.1 ADM, Hazardous Attitudes, PAVE, and DECIDE 18.2 Night Operations and Night Illusions 18.3 Emergency Descent, Engine Failure, and System Malfunctions 18.4 Survival Gear, ELT, and Forced-Landing Considerations

19 Preflight Procedures & Airport Ground Operations

19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection 19.2 Flight Deck Management, Passenger Briefings, and Engine Starting 19.3 Taxi Operations: Signs, Markings, Lighting, and Runway Incursion Avoidance 19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane

20 Class-Specific Knowledge: Seaplane & Multiengine

20.1 Seaplane and Water Operations Knowledge 20.2 Multiengine Knowledge: VMC, VYSE, and Engine-Out Fundamentals

19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection

Key Takeaways Explain This Topic AI

91.7(a) prohibits operating a civil aircraft unless it is in an airworthy condition; 91.7(b) makes the pilot in command responsible for determining that the aircraft is in condition for safe flight.

Airworthy has two halves: the aircraft conforms to its type certificate (including STCs and complied-with ADs), and it is in condition for safe operation. Both must be true.

91.103 requires the PIC to become familiar with all available information concerning the flight, and specifically requires weather reports and forecasts, fuel requirements, alternatives, known traffic delays, runway lengths at airports of intended use, and takeoff and landing distance data.

The preflight inspection is flown from the AFM/POH checklist for that make and model, not from a generic walk-around card; ACS II.A asks which items you check, why you check them, and how you would detect a defect.

Visually verify fuel quantity and grade at the filler and sump every tank and drain — fuel gauges are required equipment but are not a legal or practical substitute for looking.

Last updated: August 2026

Everything in this chapter comes from ACS Area of Operation II, Preflight Procedures , the block the knowledge test uses for "before you release the brakes" questions. Section 19.1 covers Task II.A, Preflight Assessment. The ACS splits the task into three questions, and the test asks all three: is the pilot fit, is the airplane appropriate and airworthy, and has the required preflight action been completed?

Pilot self-assessment comes first

PA.II.A.K1 is pilot self-assessment. That is the IMSAFE checklist and the personal-minimums habit from Section 17.3, plus the P in the PAVE model from Section 18.1. On the written test, self-assessment questions are usually dressed as a scenario — a pilot with a head cold, a pilot 5 hours into a 20-hour duty day, a pilot who took an over-the-counter antihistamine — and the correct answer is almost always the one that cancels or delays. 61.53 is the regulation with teeth here: you may not act as pilot in command while you know, or have reason to know, of a medical condition or medication that makes you unable to meet the standards of your medical certificate or BasicMed.

"Appropriate and airworthy" — two different determinations

PA.II.A.K2 asks you to determine that the airplane to be used is appropriate and airworthy . They are separate findings.

Appropriate means the airplane matches the mission and matches your certificate. Do you hold the category and class rating? Does it need a high-performance, complex, tailwheel, or high-altitude endorsement? Will it carry the load to the destination with legal reserves at a legal CG? Is it legal for the operation — day VFR only, or equipped for night under 91.205(c)?

Airworthy is the 91.7 term, and it has two halves that both have to be true:

The aircraft conforms to its type certificate — including supplemental type certificates and any alterations properly recorded — and all applicable Airworthiness Directives have been complied with .

The aircraft is in condition for safe operation .

91.7(a) says no person may operate a civil aircraft unless it is in an airworthy condition. 91.7(b) puts the determination on the pilot in command , and requires the PIC to discontinue the flight when unairworthy mechanical, electrical, or structural conditions occur. The mechanic signs the inspection; you make the airworthiness determination on the day you fly.

The paperwork side of that determination is Chapter 3: the ARROW documents aboard (Section 3.1), the inspections current (Section 3.2), and any inoperative equipment resolved through 91.213 (Section 3.3).

91.103 — preflight action

PA.II.A.K3d points at the associated regulations, and 91.103 is the one the test loves. Read what it actually says, because the specific list is the answer:

General duty. Each PIC shall, before beginning a flight, become familiar with all available information concerning that flight .

For a flight not in the vicinity of an airport, and for any flight under IFR: weather reports and forecasts, fuel requirements, alternatives available if the planned flight cannot be completed , and any known traffic delays advised by ATC.

For any flight: runway lengths at airports of intended use, and the takeoff and landing distance data in the approved AFM — or, if that data is not published, other reliable information appropriate to the aircraft, using airport elevation and runway slope, aircraft gross weight, and wind and temperature.

Two traps. First, the weather-and-alternates paragraph applies to flights not in the vicinity of an airport , so a local pattern flight is not excused from the runway-length and distance-data paragraph, which applies to any flight. Second, "all available information" is not satisfied by a phone glance at one radar image; NOTAMs, TFRs, and the Chart Supplement are available information (Sections 4.4 and 8.4).

The preflight inspection — what, why, and how you would spot it

PA.II.A.K3 breaks the inspection into which items to inspect, the reasons for checking each item , how to detect possible defects, and the associated regulations. Most candidates can recite a sequence; the ACS wants the reason. Use the AFM/POH checklist for that make and model , not a generic card, because the manufacturer's list reflects that airplane's known failure points.

Item Why you check it What a defect looks like

Fuel quantity, visually at the filler Gauges are required by 91.205 but are only required to be accurate at empty; fuel exhaustion and starvation remain leading causes of engine-failure accidents Level well below the tab or last known fueling; a fuel receipt that does not match the tank

Fuel sumps — every drain, every tank, plus the gascolator Water settles to the low point; the wrong grade or jet fuel will destroy the engine Clear beads or a separate layer at the bottom; wrong color for the grade (100LL is blue); a sweaty, kerosene smell

Oil quantity against the AFM minimum for flight Below minimum, cooling and lubrication margins disappear on a hot climb Level below the marked minimum; oil streaks aft of the cowling or on the belly

Control surfaces, hinges, and linkage A jammed or disconnected control is unrecoverable in flight Excess play, missing cotter pins or safety wire, cracked hinge brackets, dented skins

Pitot cover removed; pitot and static ports clear A blocked pitot or static port gives false airspeed and altitude (Section 12.1) Cover still installed, insect nest, tape or wax over the static port

Fuel vents clear A blocked vent creates a vacuum and starves the engine in cruise Insect nests, crushed vent tube

Stall warning Your only aerodynamic warning before the buffet (Section 9.2) No horn or light with suction applied and master on

Propeller and spinner Nicks are stress risers that grow into fatigue cracks Nicks, gouges, cracks in the spinner or its backplate, oil at the hub

Tires, brakes, struts Directional control on the roll and the ability to stop Cord showing, flat spots, hydraulic wetness at the caliper, a flat strut

Tie-downs, chocks, gust locks, cowl plugs Every one of them has caused a departure accident when left in place Anything still attached to the airplane

Antennas, static wicks, windscreen Communication, navigation, and the ability to see Bent or missing antennas, crazed or oil-filmed windscreen

How to detect a defect (PA.II.A.K3c) is a discipline, not a list: compare against how the airplane looked last time, follow oil and hydraulic streaks upstream to their source, press and wiggle anything meant to be rigid, and treat anything you cannot explain as a discrepancy until a mechanic explains it. Frost, snow, or ice on the lifting surfaces is a stop item — Section 7.2 explains why even a thin layer of frost can cost enough lift to prevent a safe takeoff.