Study guide
9.4 Axes, Stability, and Flight Controls
FAA Private Pilot — Airplane PAR
Track your progress as you read
Finished sections get a check mark.
1 Introduction & Exam Overview
1.1 Current Exam Facts 1.2 ACS Codes, the AKTR, and How to Use This Guide
2 Pilot Qualifications & Medicals
2.1 Eligibility, Training, and Knowledge-Test Authorization 2.2 Private Pilot Privileges and Limitations 2.3 Medical Certificates, Duration, and Disqualification 2.4 BasicMed (14 CFR 61.113(i) and Part 68)
3 Airworthiness, Documents & Currency
3.1 Required Pilot and Aircraft Documents 3.2 Inspections, Airworthiness Directives, and Preventive Maintenance 3.3 Inoperative Equipment and 91.213 3.4 Recent Flight Experience and the Flight Review
4 14 CFR Part 91 Operating Rules
4.1 Right-of-Way, Minimum Safe Altitudes, and Speed Limits 4.2 VFR Cruising Altitudes, Altimeter Settings, and Oxygen 4.3 Fuel Requirements, Transponder, ADS-B, and ELT 4.4 NOTAMs, TFRs, and Accident/Incident Duties
5 National Airspace System
5.1 Class A, B, and C Airspace 5.2 Class D, E, and G Airspace and VFR Weather Minimums 5.3 Special Use Airspace 5.4 Other Airspace, TFRs, TRSA, ADIZ, and SFRA
6 Aviation Weather Theory
6.1 Atmosphere, Pressure, Temperature, and Density 6.2 Stability, Clouds, and Moisture 6.3 Air Masses and Fronts 6.4 Wind, Jet Stream, and Local Wind Systems
7 Weather Hazards
7.1 Thunderstorms and Convective Weather 7.2 Structural Icing, Frost, and Carburetor Ice 7.3 Fog, Low Ceilings, and Visibility 7.4 Wind Shear, Microbursts, Turbulence, and Mountain Waves
8 Weather Products & Briefings
8.1 METAR Decoding 8.2 TAF and Graphical Forecast Products 8.3 PIREPs, AIRMET, SIGMET, Convective SIGMET, and Winds Aloft 8.4 Briefings and Go/No-Go Decisions
9 Principles of Flight
9.1 Four Forces and Lift Production 9.2 Angle of Attack, Critical AoA, and Stalls 9.3 Drag, L/D, and Ground Effect 9.4 Axes, Stability, and Flight Controls
10 Maneuvering Flight, Stalls & Spins
10.1 Load Factor, Bank Angle, and Stall Speed 10.2 Left-Turning Tendencies 10.3 Slow Flight, Power-On/Off Stalls, and Spin Awareness 10.4 Steep Turns and Ground-Reference Maneuvers
11 Powerplant, Fuel & Electrical Systems
11.1 Reciprocating Engines, Mixture, Detonation, and Preignition 11.2 Ignition, Magnetos, Carburetor vs Fuel Injection 11.3 Fuel Grades, Contamination, and Fuel-System Management 11.4 Electrical System and Alternator Failure
12 Flight Instruments & Avionics
12.1 Pitot-Static Instruments and Blockage Errors 12.2 Gyroscopic Instruments, Vacuum Failure, and Magnetic Compass Errors 12.3 Engine Instruments, Transponder Modes, and Basic Avionics
13 Aircraft Performance
13.1 Pressure Altitude, Density Altitude, and Performance Effects 13.2 Takeoff and Climb Performance 13.3 Cruise, Descent, and Landing Performance 13.4 Wind, Gradient, Surface, and Crosswind Component
14 Weight and Balance
14.1 Weight-and-Balance Principles 14.2 Moment, CG, and Sample Computations 14.3 Forward and Aft CG Effects 14.4 V-Speeds, Markings, and Limitation Placards
15 Charts, Pilotage & Dead Reckoning
15.1 Sectional Chart Symbology and Airspace Depiction 15.2 Pilotage and Dead Reckoning 15.3 Variation, Deviation, Wind Triangle, and E6B 15.4 VFR Cross-Country and Fuel Planning
16 Radio Navigation, Lost Procedures & Airport Operations
16.1 VOR Navigation 16.2 GPS, RAIM, and Radar Services 16.3 Lost Procedures and Diversion 16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns
17 Aeromedical Factors
17.1 Hypoxia, Hyperventilation, and Carbon Monoxide 17.2 Spatial Disorientation, Illusions, and Vision 17.3 Scuba-to-Flight, Alcohol/Drugs, and IMSAFE
18 ADM, Night Operations & Emergencies
18.1 ADM, Hazardous Attitudes, PAVE, and DECIDE 18.2 Night Operations and Night Illusions 18.3 Emergency Descent, Engine Failure, and System Malfunctions 18.4 Survival Gear, ELT, and Forced-Landing Considerations
19 Preflight Procedures & Airport Ground Operations
19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection 19.2 Flight Deck Management, Passenger Briefings, and Engine Starting 19.3 Taxi Operations: Signs, Markings, Lighting, and Runway Incursion Avoidance 19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane
20 Class-Specific Knowledge: Seaplane & Multiengine
20.1 Seaplane and Water Operations Knowledge 20.2 Multiengine Knowledge: VMC, VYSE, and Engine-Out Fundamentals
9.4 Axes, Stability, and Flight Controls
Key Takeaways Explain This Topic AI
Pitch is about the lateral axis (elevator/stabilator), roll about the longitudinal axis (ailerons), and yaw about the vertical axis (rudder). All three axes pass through the CG.
Static stability is the initial tendency after a disturbance; dynamic stability is what the motion does over time. Positive, neutral, and negative apply to both.
An aft CG reduces longitudinal stability, lowers stall speed slightly, and can make stall recovery impossible. A forward CG is more stable and stalls at a higher speed.
Primary controls are ailerons, elevator/stabilator, and rudder. Secondary controls include flaps, trim, spoilers, and leading-edge devices.
Adverse yaw is the nose yawing opposite the roll because the down-going aileron makes more lift and more induced drag. Rudder, differential ailerons, and Frise ailerons fight it.
Last updated: August 2026
ACS PA.I.G.K1a (primary flight controls) and PA.I.G.K1b (secondary flight controls) sit on the same three axes PHAK Chapter 5 uses to teach stability. If you cannot name which surface rotates the airplane about which axis, the rest of the systems oral is noise.
Three axes, three primary controls
The longitudinal , lateral , and vertical axes all pass through the CG . The airplane rotates about one or more of them whenever you change attitude.
- Motion Axis of rotation Name of that stability Primary control
- Pitch (nose up/down) Lateral axis (wingtip to wingtip) Longitudinal stability Elevator or stabilator
- Roll (bank) Longitudinal axis (nose to tail) Lateral stability Ailerons
- Yaw (nose left/right) Vertical axis Directional stability Rudder
The vocabulary trap is swapping the motion name with the axis name. Longitudinal stability is about pitch, but the rotation is about the lateral axis. Lateral stability is about roll, about the longitudinal axis. Say it twice.
Ailerons. Wheel or stick right: right aileron up , left aileron down . The left wing’s camber and AOA increase, lift increases, that wing rises.
Elevator. Aft yoke: trailing edge of the elevator up , the tail is pushed down , the nose pitches up , wing AOA rises. A stabilator is a one-piece slab that pivots as a whole; an anti-servo tab moves in the same direction as the slab to add feel and discourage over-control. A canard is a forward surface that produces up-lift , not the tail download of a conventional stabilizer.
Rudder. Left pedal: rudder trailing edge left, tail pushed right, nose yaws left. Rudder authority rises with speed and with propeller slipstream. It does not make the airplane turn by itself in the PAR picture; the horizontal component of lift in a bank makes the turn. Rudder keeps the nose aligned with the relative wind so the turn is coordinated.
Adverse yaw, and why the rudder is not optional
The down-going aileron is a high-lift device. More lift means more induced drag on the rising wing. The up-going aileron reduces lift and drag on the descending wing. The drag imbalance yaws the nose opposite the roll: that is adverse yaw . It is worst at low speed / high AOA , where aileron deflections are large and the surfaces are less effective. PHAK Chapter 6: apply rudder in the direction of the turn to cancel it. “Step on the ball” or “rudder toward the low wing” is the same sentence.
Designers also build the wing to help:
Differential ailerons. The up aileron travels farther than the down aileron. Extra drag on the descending wing offsets the induced-drag spike on the rising wing.
Frise-type ailerons. The up-going aileron pivots on an offset hinge so its leading edge protrudes below the wing into the relative wind, adding form drag on the descending wing. A slot often helps the down-going aileron stay attached.
Coupled aileron–rudder interconnects (with a spring you can override to slip) and flaperons appear on some types.
You still need your feet. Differential and Frise reduce adverse yaw; they do not repeal it.
Secondary controls: flaps, trim, spoilers
Secondary systems make the airplane easier to fly or change the wing’s lift/drag for a phase of flight. They are not required to rotate the airplane about an axis the way the primary three are.
Flaps (plain, split, slotted, Fowler) increase camber and, for Fowler, area. Lift and induced drag both rise. Used to lower stall speed and steepen the approach. Leading-edge slots, slats, flaps, and cuffs delay tip or leading-edge separation so the wing can reach a higher AOA before it stalls.
Trim (tabs, balance tabs, anti-servo tabs, ground-adjustable tabs, movable stabilizer) relieves continuous control force. Trim to an attitude and power setting; do not fly the airplane with the trim wheel. Aft CG and a sensitive stabilator make trim a safety item, not a convenience.
Spoilers dump lift and add drag. On a glider they control glide path; on a jet they also help roll and put weight on the wheels after touchdown. Few PAR trainers have them, but the ACS still expects the name.
Static versus dynamic stability
Stability is the airplane’s inherent tendency to return toward the original flight path after a disturbance. Maneuverability is how readily it can be flown into a new path and take the stress. Controllability is how it responds to the pilot. Those are three different words on the test.
Static stability is the initial tendency, the first moment after you let go:
Positive static: nose (or bank, or heading) starts back toward the original condition.
Neutral static: it stays at the new condition.
Negative static: it starts farther away .
Dynamic stability is what the motion does over time after that initial tendency:
Positive dynamic: oscillations dampen .
Neutral dynamic: they continue at the same amplitude.
Negative dynamic: they diverge .
The desirable combination is positive static and positive dynamic . Positive static plus negative dynamic is a divergent oscillation — the airplane starts home and then overshoots worse each cycle. Longitudinal phugoid (slow speed/altitude wander at nearly constant AOA) is usually easy to trim out. A short-period pitch oscillation is not something you “ride.”
Longitudinal (pitch) stability depends on CG location relative to the wing and tail, tail volume, and downwash on the stabilizer. Reduce power and downwash, and a stable airplane pitches down toward a new trim speed — the PHAK speed-stability story.
Lateral (roll) stability is built with dihedral (the low wing in a sideslip sees a higher AOA and lifts itself), sweepback , high-wing keel effect , and weight distribution. Directional stability is the vertical tail acting as a weathervane . Too much directional stability and too little dihedral produces spiral instability (the graveyard-spiral tendency). The opposite mix produces Dutch roll . Trainers are usually a little spiral-unstable and easy to keep level.
CG rewrites stability and the stall
Because the tail’s restoring moment is force × arm , sliding the CG aft :
- shortens the tail arm,
- reduces longitudinal stability (lighter stick, easier to over-rotate, more willing to depart),
- lowers stall speed slightly (less tail download, so the wing carries less than weight + download),
can leave you without enough elevator to pitch the nose down in a stall.
Sliding the CG forward does the opposite: more stable, higher stall speed, heavier elevator, and a firm nose-down break. Forward-CG landings can run out of elevator in the flare. Both ends of the envelope are AFM limits, not preferences. The weight-and-balance chapter will make you compute the number; this chapter asks you what the number does .
Scenario: Maya’s first steep turn
Maya rolls left with her feet on the floor. The left aileron goes down, the left wing makes more lift and more induced drag, and the nose yaws right — adverse yaw — while the ball skids. The turn is uncoordinated at high load factor, which is the accelerated-stall / spin-entry picture from 9.2. She adds left rudder as she adds left aileron (and right rudder as she rolls out, because adverse yaw reverses). After the maneuver she retrims; she does not hold 10 pounds of back-pressure with her fist. If she had loaded the baggage compartment past the aft CG, the same pull would have felt lighter, the nose would have been happier to keep rising, and the stall recovery in the next lesson would have been the one PHAK warns you may not finish.