Study guide
16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns
FAA Private Pilot — Airplane PAR
Track your progress as you read
Finished sections get a check mark.
1 Introduction & Exam Overview
1.1 Current Exam Facts 1.2 ACS Codes, the AKTR, and How to Use This Guide
2 Pilot Qualifications & Medicals
2.1 Eligibility, Training, and Knowledge-Test Authorization 2.2 Private Pilot Privileges and Limitations 2.3 Medical Certificates, Duration, and Disqualification 2.4 BasicMed (14 CFR 61.113(i) and Part 68)
3 Airworthiness, Documents & Currency
3.1 Required Pilot and Aircraft Documents 3.2 Inspections, Airworthiness Directives, and Preventive Maintenance 3.3 Inoperative Equipment and 91.213 3.4 Recent Flight Experience and the Flight Review
4 14 CFR Part 91 Operating Rules
4.1 Right-of-Way, Minimum Safe Altitudes, and Speed Limits 4.2 VFR Cruising Altitudes, Altimeter Settings, and Oxygen 4.3 Fuel Requirements, Transponder, ADS-B, and ELT 4.4 NOTAMs, TFRs, and Accident/Incident Duties
5 National Airspace System
5.1 Class A, B, and C Airspace 5.2 Class D, E, and G Airspace and VFR Weather Minimums 5.3 Special Use Airspace 5.4 Other Airspace, TFRs, TRSA, ADIZ, and SFRA
6 Aviation Weather Theory
6.1 Atmosphere, Pressure, Temperature, and Density 6.2 Stability, Clouds, and Moisture 6.3 Air Masses and Fronts 6.4 Wind, Jet Stream, and Local Wind Systems
7 Weather Hazards
7.1 Thunderstorms and Convective Weather 7.2 Structural Icing, Frost, and Carburetor Ice 7.3 Fog, Low Ceilings, and Visibility 7.4 Wind Shear, Microbursts, Turbulence, and Mountain Waves
8 Weather Products & Briefings
8.1 METAR Decoding 8.2 TAF and Graphical Forecast Products 8.3 PIREPs, AIRMET, SIGMET, Convective SIGMET, and Winds Aloft 8.4 Briefings and Go/No-Go Decisions
9 Principles of Flight
9.1 Four Forces and Lift Production 9.2 Angle of Attack, Critical AoA, and Stalls 9.3 Drag, L/D, and Ground Effect 9.4 Axes, Stability, and Flight Controls
10 Maneuvering Flight, Stalls & Spins
10.1 Load Factor, Bank Angle, and Stall Speed 10.2 Left-Turning Tendencies 10.3 Slow Flight, Power-On/Off Stalls, and Spin Awareness 10.4 Steep Turns and Ground-Reference Maneuvers
11 Powerplant, Fuel & Electrical Systems
11.1 Reciprocating Engines, Mixture, Detonation, and Preignition 11.2 Ignition, Magnetos, Carburetor vs Fuel Injection 11.3 Fuel Grades, Contamination, and Fuel-System Management 11.4 Electrical System and Alternator Failure
12 Flight Instruments & Avionics
12.1 Pitot-Static Instruments and Blockage Errors 12.2 Gyroscopic Instruments, Vacuum Failure, and Magnetic Compass Errors 12.3 Engine Instruments, Transponder Modes, and Basic Avionics
13 Aircraft Performance
13.1 Pressure Altitude, Density Altitude, and Performance Effects 13.2 Takeoff and Climb Performance 13.3 Cruise, Descent, and Landing Performance 13.4 Wind, Gradient, Surface, and Crosswind Component
14 Weight and Balance
14.1 Weight-and-Balance Principles 14.2 Moment, CG, and Sample Computations 14.3 Forward and Aft CG Effects 14.4 V-Speeds, Markings, and Limitation Placards
15 Charts, Pilotage & Dead Reckoning
15.1 Sectional Chart Symbology and Airspace Depiction 15.2 Pilotage and Dead Reckoning 15.3 Variation, Deviation, Wind Triangle, and E6B 15.4 VFR Cross-Country and Fuel Planning
16 Radio Navigation, Lost Procedures & Airport Operations
16.1 VOR Navigation 16.2 GPS, RAIM, and Radar Services 16.3 Lost Procedures and Diversion 16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns
17 Aeromedical Factors
17.1 Hypoxia, Hyperventilation, and Carbon Monoxide 17.2 Spatial Disorientation, Illusions, and Vision 17.3 Scuba-to-Flight, Alcohol/Drugs, and IMSAFE
18 ADM, Night Operations & Emergencies
18.1 ADM, Hazardous Attitudes, PAVE, and DECIDE 18.2 Night Operations and Night Illusions 18.3 Emergency Descent, Engine Failure, and System Malfunctions 18.4 Survival Gear, ELT, and Forced-Landing Considerations
19 Preflight Procedures & Airport Ground Operations
19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection 19.2 Flight Deck Management, Passenger Briefings, and Engine Starting 19.3 Taxi Operations: Signs, Markings, Lighting, and Runway Incursion Avoidance 19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane
20 Class-Specific Knowledge: Seaplane & Multiengine
20.1 Seaplane and Water Operations Knowledge 20.2 Multiengine Knowledge: VMC, VYSE, and Engine-Out Fundamentals
16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns
Key Takeaways Explain This Topic AI
CTAF is the frequency for airport advisory practices when the tower is closed or does not exist. It may be UNICOM, MULTICOM 122.9, an FSS frequency, or the tower frequency. AIM 4-1-9: announce about 10 miles out, downwind, base, final, and clear of the runway.
Standard pattern is left traffic unless the chart shows RP, the segmented circle says otherwise, or the tower assigns right traffic. Recommended entry is 45° to midfield downwind at pattern altitude (AIM 4-3 / AC 90-66C); propeller airplanes typically 1,000 feet AGL unless a TPA is published.
Light-gun signals (14 CFR 91.125 / AIM TBL 4-3-1): flashing red in the air means airport unsafe — do not land; flashing red on the ground means taxi clear of the runway. Steady green is takeoff on the ground and land in the air.
Acknowledge a light signal by moving the ailerons or rudder by day, and by flashing landing or navigation lights at night (AIM 4-3-13).
VASI/PAPI: red over white is on glide path. Taxiway edge lights are blue. REIL are the two flashing threshold identifiers. Pilot-controlled lighting is keyed on the CTAF (commonly 3 / 5 / 7 clicks in 5 seconds).
Last updated: August 2026
ACS PA.III.A is communications, light signals, and runway lighting. PA.III.B is traffic patterns at towered and nontowered airports. AIM 4-1-9, 4-3, 2-1, and 14 CFR 91.125 / 91.126 are the exam pages. Lost-comm IFR (91.185) is not the private-pilot VFR answer; VFR lost comm is stay visual, land as soon as practicable, and use this section’s light gun.
Who you are talking to
CTAF (common traffic advisory frequency) is the frequency designated for airport advisory practices when there is no operating control tower . AIM 4-1-9: it may be a UNICOM, MULTICOM, FSS, or the tower frequency itself. Read the sectional data block and the Chart Supplement; do not guess 122.8 for every grass strip.
UNICOM is a nongovernment advisory station — fuel, wind if someone answers, not ATC separation. Common UNICOM CTAFs include 122.7, 122.8, 122.725, 122.975, and 123.0. If no one answers, self-announce on the same frequency .
MULTICOM 122.9 is the self-announce frequency when there is no tower, FSS, or UNICOM .
Tower owns the Class D (or C/B) surface area while open. Initial call about 15 miles out (AIM 4-3-2), with ATIS. Ground owns the movement area except the runway; do not taxi onto a runway without the local controller. When the tower is closed, the CTAF is usually the tower frequency and the airspace often reverts — confirm the Chart Supplement.
ATIS is the recorded tower-airport briefing (weather, duty runway, NOTAMs). ASOS/AWOS are automated weather. Get one-minute weather before you call, and say you have it.
AIM 4-1-9 recommended calls at a field without an operating tower: before taxi , before taking the runway , 10 miles out , entering downwind, base, and final , and clear of the runway . Phraseology is position and intention, not a novel: “Podunk traffic, Skyhawk 345, 10 south, inbound for left downwind 27, Podunk.”
Patterns — left unless marked
14 CFR 91.126 / 91.127: at nontowered airports, make all turns to the left unless the airport displays approved light signals or visual markings indicating right turns, or ATC says otherwise. AIM 4-3-3: RP plus a runway number in the data block means right traffic for that runway. The segmented circle and its L-shaped traffic-pattern indicators show the same thing on the ground. A tetrahedron, if installed, shows landing direction (small end points the way you land); do not use it as a wind sock.
AIM 4-3-3 recommended pattern altitudes unless the Chart Supplement publishes another TPA: propeller-driven airplanes 1,000 feet AGL ; large/turbine not less than 1,500 feet AGL or 500 above the established TPA. AC 90-66C and AIM figures: the standard recommended entry is a 45° entry to the downwind , at pattern altitude, abeam midfield. Straight-in and midfield-crosswind entries exist; they are not an excuse to cut off someone already on downwind. At a towered field, fly what the tower assigns — “make right traffic, report midfield” wins over the RP note.
Pattern parts (AIM 4-3-2): departure / upwind, crosswind, downwind, base, final. Wind correction on downwind is the same ground-reference skill as Chapter 10: crab so the ground track is parallel to the runway. 91.113: the lower aircraft on approach has the right-of-way, but do not cut in front of someone already on final.
Light-gun signals — exact (91.125 / AIM TBL 4-3-1)
If the radio fails in the pattern at a tower, squawk 7600 , enter the pattern, and watch the tower. AIM 4-3-13: by day, acknowledge by moving the ailerons or rudder; at night, flash the landing or navigation lights.
- Color and type of signal Aircraft on the ground Aircraft in flight
- Steady green Cleared for takeoff Cleared to land
- Flashing green Cleared to taxi Return for landing (to be followed by steady green at the proper time)
- Steady red Stop Give way to other aircraft and continue circling
- Flashing red Taxi clear of runway in use Airport unsafe — do not land
- Flashing white Return to starting point on airport Not applicable
- Alternating red and green Exercise extreme caution Exercise extreme caution
Memorize the flashing-red trap . In the air, flashing red is airport unsafe, do not land — go somewhere else. On the ground, flashing red is taxi clear of the runway . Steady red in the air is not “go away”; it is give way and keep circling until you get a green. Flashing white does nothing for an airplane in flight. Alternating red/green is caution in both states; it is not a clearance and not a wave-off by itself.
Lighting, PCL, beacons
VASI and PAPI both use red/white glide-path cues. Memory that matches AIM 2-1-2: red over white, you’re all right. Two-bar VASI: both white = too high; both red = too low. PAPI (usually four lights): two white / two red on path; more white = high; more red = low. REIL are the two synchronized flashing lights at the threshold that say “this is the runway.” ALS is the approach lighting system off the arrival end. Runway edge lights are white (often amber on the last 2,000 feet, or last half, of some runways); threshold appears green when landing, runway end red. Taxiway edge lights are blue ; taxiway centerline lights are green.
Pilot-controlled lighting (PCL) is keyed on the CTAF or a published lighting frequency. AIM 2-1-8 typical intensity steps: 3, 5, or 7 microphone clicks within 5 seconds for low / medium / high (confirm the Chart Supplement). Lights usually stay up about 15 minutes; click again on final if they die. A starred L on the sectional means lighting limitations — hours, intensity, or PCL — and you open the Supplement.
Rotating beacons (AIM 2-1-10), night and often IMC day: white and green = civilian land airport; white and yellow = water airport; white-white-green (dual-peaked white) = military; white, yellow, and green = heliport. A beacon on in daylight can mean the ground visibility is less than 3 SM or the ceiling is less than 1,000 feet — treat it as a weather clue, not a clearance to scud-run.
PAR scenario: Towered Class D, radio dead after you already have ATIS. Squawk 7600, enter left traffic unless the data block said RP, rock the ailerons when the gun hits you. Flashing green in the air means return for landing and wait for steady green to actually land. Flashing red in the air means leave — the airport is unsafe. After landing, flashing red means get off the runway; flashing white means go back to where you started (the ramp, not another circuit). At the nontowered alternate, CTAF is 122.9 because there is no UNICOM, enter 45° to left downwind at 1,000 AGL, and click the mic seven times so the REIL and MIRL come up.