Study guide

14.4 V-Speeds, Markings, and Limitation Placards

FAA Private Pilot — Airplane PAR

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 Current Exam Facts 1.2 ACS Codes, the AKTR, and How to Use This Guide

2 Pilot Qualifications & Medicals

2.1 Eligibility, Training, and Knowledge-Test Authorization 2.2 Private Pilot Privileges and Limitations 2.3 Medical Certificates, Duration, and Disqualification 2.4 BasicMed (14 CFR 61.113(i) and Part 68)

3 Airworthiness, Documents & Currency

3.1 Required Pilot and Aircraft Documents 3.2 Inspections, Airworthiness Directives, and Preventive Maintenance 3.3 Inoperative Equipment and 91.213 3.4 Recent Flight Experience and the Flight Review

4 14 CFR Part 91 Operating Rules

4.1 Right-of-Way, Minimum Safe Altitudes, and Speed Limits 4.2 VFR Cruising Altitudes, Altimeter Settings, and Oxygen 4.3 Fuel Requirements, Transponder, ADS-B, and ELT 4.4 NOTAMs, TFRs, and Accident/Incident Duties

5 National Airspace System

5.1 Class A, B, and C Airspace 5.2 Class D, E, and G Airspace and VFR Weather Minimums 5.3 Special Use Airspace 5.4 Other Airspace, TFRs, TRSA, ADIZ, and SFRA

6 Aviation Weather Theory

6.1 Atmosphere, Pressure, Temperature, and Density 6.2 Stability, Clouds, and Moisture 6.3 Air Masses and Fronts 6.4 Wind, Jet Stream, and Local Wind Systems

7 Weather Hazards

7.1 Thunderstorms and Convective Weather 7.2 Structural Icing, Frost, and Carburetor Ice 7.3 Fog, Low Ceilings, and Visibility 7.4 Wind Shear, Microbursts, Turbulence, and Mountain Waves

8 Weather Products & Briefings

8.1 METAR Decoding 8.2 TAF and Graphical Forecast Products 8.3 PIREPs, AIRMET, SIGMET, Convective SIGMET, and Winds Aloft 8.4 Briefings and Go/No-Go Decisions

9 Principles of Flight

9.1 Four Forces and Lift Production 9.2 Angle of Attack, Critical AoA, and Stalls 9.3 Drag, L/D, and Ground Effect 9.4 Axes, Stability, and Flight Controls

10 Maneuvering Flight, Stalls & Spins

10.1 Load Factor, Bank Angle, and Stall Speed 10.2 Left-Turning Tendencies 10.3 Slow Flight, Power-On/Off Stalls, and Spin Awareness 10.4 Steep Turns and Ground-Reference Maneuvers

11 Powerplant, Fuel & Electrical Systems

11.1 Reciprocating Engines, Mixture, Detonation, and Preignition 11.2 Ignition, Magnetos, Carburetor vs Fuel Injection 11.3 Fuel Grades, Contamination, and Fuel-System Management 11.4 Electrical System and Alternator Failure

12 Flight Instruments & Avionics

12.1 Pitot-Static Instruments and Blockage Errors 12.2 Gyroscopic Instruments, Vacuum Failure, and Magnetic Compass Errors 12.3 Engine Instruments, Transponder Modes, and Basic Avionics

13 Aircraft Performance

13.1 Pressure Altitude, Density Altitude, and Performance Effects 13.2 Takeoff and Climb Performance 13.3 Cruise, Descent, and Landing Performance 13.4 Wind, Gradient, Surface, and Crosswind Component

14 Weight and Balance

14.1 Weight-and-Balance Principles 14.2 Moment, CG, and Sample Computations 14.3 Forward and Aft CG Effects 14.4 V-Speeds, Markings, and Limitation Placards

15 Charts, Pilotage & Dead Reckoning

15.1 Sectional Chart Symbology and Airspace Depiction 15.2 Pilotage and Dead Reckoning 15.3 Variation, Deviation, Wind Triangle, and E6B 15.4 VFR Cross-Country and Fuel Planning

16 Radio Navigation, Lost Procedures & Airport Operations

16.1 VOR Navigation 16.2 GPS, RAIM, and Radar Services 16.3 Lost Procedures and Diversion 16.4 Communications, Light-Gun Signals, Lighting, and Traffic Patterns

17 Aeromedical Factors

17.1 Hypoxia, Hyperventilation, and Carbon Monoxide 17.2 Spatial Disorientation, Illusions, and Vision 17.3 Scuba-to-Flight, Alcohol/Drugs, and IMSAFE

18 ADM, Night Operations & Emergencies

18.1 ADM, Hazardous Attitudes, PAVE, and DECIDE 18.2 Night Operations and Night Illusions 18.3 Emergency Descent, Engine Failure, and System Malfunctions 18.4 Survival Gear, ELT, and Forced-Landing Considerations

19 Preflight Procedures & Airport Ground Operations

19.1 Preflight Assessment, Airworthiness Determination, and the Preflight Inspection 19.2 Flight Deck Management, Passenger Briefings, and Engine Starting 19.3 Taxi Operations: Signs, Markings, Lighting, and Runway Incursion Avoidance 19.4 Before-Takeoff Check, After-Landing, and Securing the Airplane

20 Class-Specific Knowledge: Seaplane & Multiengine

20.1 Seaplane and Water Operations Knowledge 20.2 Multiengine Knowledge: VMC, VYSE, and Engine-Out Fundamentals

14.4 V-Speeds, Markings, and Limitation Placards

Key Takeaways Explain This Topic AI

14 CFR 1.2: Vso landing-config stall, Vs1 specified-config stall, Vr rotation, Vx best angle, Vy best rate, Va design maneuvering, Vfe max flap extended, Vno max structural cruise, Vne never exceed, Vlo gear operating, Vle gear extended.

ASI color code: white arc Vso–Vfe, green arc Vs1–Vno, yellow arc Vno–Vne (smooth air only), red radial Vne.

Va decreases as weight decreases: Va_light = Va_heavy × √(W_light / W_heavy). It is not a painted constant.

14 CFR 91.9: operate within the approved Airplane Flight Manual, markings, and placards. A modern POH contains that approved AFM; older airplanes may use approved markings and placards without a full AFM.

Last updated: August 2026

ACS PA.I.F is performance and limitations . The speeds painted on the airspeed indicator and printed in the AFM Limitations section are not conveniences. 14 CFR 91.9(a) says no person may operate a civil aircraft without complying with the operating limitations specified in the approved Airplane or Rotorcraft Flight Manual, markings, and placards. Exceeding Vne, extending full flaps above Vfe, or ignoring a baggage-compartment placard is the same class of rule as busting a weight limit in 14.2.

The V-speeds PAR actually uses

14 CFR 1.2 defines most of the letters. Best-glide is a PHAK / AFM speed usually written Vg in training materials; it is not itself a 1.2 abbreviation. Learn the meaning, then take this airplane’s knots from the AFM — never from a friend who flies a different model.

  • Speed 14 CFR 1.2 / training meaning Where you see it
  • Vso Stalling speed or minimum steady flight speed in the landing configuration Bottom of the white arc

Vs1 Stalling speed or minimum steady flight speed in a specified configuration (usually clean) Bottom of the green arc

  • Vr Rotation speed AFM takeoff procedure; not an ASI mark
  • Vx Speed for best angle of climb (most altitude per distance) AFM; not an ASI mark
  • Vy Speed for best rate of climb (most altitude per time) AFM; not an ASI mark
  • Vg Best glide (training abbreviation) AFM emergency / performance; not an ASI mark
  • Va Design maneuvering speed AFM and often a placard; not painted as an arc; falls when weight falls
  • Vfe Maximum flap extended speed Top of the white arc (full-flap value)
  • Vno Maximum structural cruising speed Top of the green / bottom of the yellow
  • Vne Never-exceed speed Red radial line
  • Vlo Maximum landing-gear operating speed (extending or retracting) AFM; retractable airplanes
  • Vle Maximum landing-gear extended speed (down and locked) AFM; usually ≥ Vlo

Vx versus Vy. Vx clears an obstacle in the shortest distance . Vy gets you to altitude in the least time . As altitude increases, published Vx usually rises and Vy falls until they meet at the absolute ceiling. That pair is a Chapter 13 performance item; the limitation item is “use the AFM number for this weight and altitude,” not a memorized 62 / 74 that belonged to a different year of the same type.

Vlo versus Vle. While the gear is in transit the mechanism and doors are more vulnerable, so Vlo is the lower “you may move it” speed. Once the gear is down and locked, Vle is the higher “you may leave it there” speed. Fixed-gear PAR trainers do not use either number in the airplane, but the knowledge test still asks which letter is which.

Vg is the speed that gives the maximum lift-to-drag ratio in the published glide configuration — the farthest glide for a given height in still air. It is not Vy, and it is not the bottom of the green arc.

Color arcs — what the ASI is allowed to teach you

PHAK’s airspeed-indicator marking scheme, matching certification practice:

White arc: Vso to Vfe. Flap-operating range in the landing-flap sense. You may fly this slow only with flaps down as the AFM allows, and you may not have full flaps out above the top of the white.

Green arc: Vs1 to Vno. Normal operating range, flaps up (the specified clean stall at the bottom).

Yellow arc: Vno to Vne. Caution range. Smooth air only. Structural margin against gusts is gone. If it gets rough, slow into the green.

Red radial line: Vne. Never exceed, smooth air included. Flutter and structural failure live past that mark.

The ASI does not paint Vr, Vx, Vy, Vg, Va, Vlo, or Vle. Those live in the AFM and on placards. “Anywhere in the green is a safe maneuvering speed” is false; Va is usually below Vno and moves with weight.

Flap operating versus flap extended

Vfe is the maximum speed with the flaps in a given extended position. You also must be at or below that speed to operate (move) the flaps to that position. Light trainers usually publish one Vfe, and that number is the top of the white arc — typically the full-flap limit.

Many AFMs also publish a higher speed for a first notch of approach flaps than for landing flaps. The white arc does not grow to that higher number. Extending 10° above the top of the white can be legal if that AFM lists a higher partial-flap Vfe ; extending full flaps there is not. Read the limitations table, not just the paint. Jets sometimes split flap- operating and flap- extended speeds more finely. PAR’s job is: white arc = full-flap window; any other flap speed is an AFM number.

Va decreases with weight — the painted-constant trap

Design maneuvering speed (Va) is the speed at which, in smooth air , one abrupt full deflection of a single flight control will stall the wing before the structure reaches limit load. Chapter 10 already used that sentence. The limitation half is the weight correction.

A lighter airplane stalls slower. At the gross-weight Va it is farther from the stall, so the same full elevator can build a load factor above limit before the wing quits. Therefore Va is reduced when the airplane is light :

Va_actual = Va_published × √(W_actual ÷ W_published)

Use the Example 1 airplane. Published Va is 99 KIAS at 2,550 lb . At the 2,130-lb two-up loading:

  • √(2,130 ÷ 2,550) = √0.8353 ≈ 0.914
  • 99 × 0.914 ≈ 90 KIAS

Using 99 KIAS because “that is what the placard says” is the miss. The placard is the heavy number unless the AFM prints a table of Va versus weight. Va is not Vno, not the top of the green, and not a speed you hold while yanking more than one control in a gust.

91.9, the AFM, the POH, and the stickers

14 CFR 91.9(a) — comply with the operating limitations in the approved flight manual, the markings, and the placards.

91.9(b) — if 14 CFR 21.5 requires an Airplane Flight Manual (airplanes that had no flight time before March 1, 1979 and were not already certificated with an AFM, which in practice is the modern fleet), a current, approved AFM must be available in the aircraft . If 21.5 does not require an AFM, the airplane may be operated with the approved combination of manual material, markings, and placards that does exist — still 91.9(a).

AFM versus POH. The Airplane Flight Manual is the FAA-approved document. The Pilot’s Operating Handbook is the GAMA-standard format most manufacturers use. On a modern trainer the POH contains the AFM: Section 2 Limitations (and usually the approved parts of Emergency and Performance) is regulatory. Other POH pages can be manufacturer information that is not itself a 91.9 limitation. When in doubt, the Limitations section, the instrument markings, and the required placards win.

Placards that 91.9 will actually bite you on: maximum baggage weights and “solo from front seat only,” published Va, flap-speed reminders, “day-VFR only” if that is how the airplane is equipped, occupant-warning placards, and any operating-limitation sticker the TCDS or AFM requires to be in view. A missing required placard is an airworthiness problem (Chapter 3) and a 91.9 problem.

Scenario: Alex’s yellow-arc descent

Alex is light — the 2,130-lb Example 1 airplane — descending through smooth air at the top of the yellow because “redline is the only real limit.” Vno is already behind him; Vne is the red line he has not hit yet . A ridge-wave bump at that speed is a structural event, and the Va he should have been near in the first ripple is about 90 KIAS , not the 99 on the gross-weight placard. He slows into the green, then toward that reduced Va, and he treats the color code and 91.9 as the same sentence.

Loading diagram... ASI paint versus AFM speeds — Va is a weight-dependent limit, not an arc