Study guide
4.4 VHF Channel Selection & Channel Assignments
FCC General Radiotelephone Operator License GROL
Track your progress as you read
Finished sections get a check mark.
1 Introduction & GROL Exam Overview
1.1 About the General Radiotelephone Operator License 1.2 Exam Format, COLEMs, FRN & Application Process
2 Element 1: Rules & Regulations
2.1 Equipment Requirements (Part 80) 2.2 License Requirements & Operator Authority 2.3 Watchkeeping & Logkeeping Duties 2.4 Log Entries & Required Records 2.5 Ship Station Control, Inspections & International Rules
3 Element 1: Communications Procedures
3.1 Bridge-to-Bridge Operations & VTS 3.2 Distress Communications & Alerting 3.3 Operating Procedures, Calling & Testing 3.4 Urgency (PAN PAN) & Safety (SECURITE) Traffic 3.5 The GMDSS Concept & Ship Responsibilities
4 Element 1: Equipment Operations
4.1 VHF Equipment Controls 4.2 MF/HF SSB Equipment Controls 4.3 DSC Operations & Equipment Faults 4.4 VHF Channel Selection & Channel Assignments 4.5 MF/HF Frequency & Emission Selection 4.6 Required Equipment Tests & On-Air Test Procedure
5 Element 1: Other Equipment & Antennas
5.1 Marine Antennas & Polarization 5.2 EPIRBs & Emergency Beacons 5.3 Power Sources, Reserve Power & Required Tests 5.4 Search and Rescue Transponders (SARTs) 5.5 Survival Craft Portable VHF (SCT) Requirements 5.6 NAVTEX & Maritime Safety Information
6 Element 3: Electrical Principles
6.1 Electrical Elements, Units & Power Types 6.2 Magnetism & Magnetic Circuits 6.3 Resistance, Capacitance & Inductance 6.4 Waveforms & Semiconductor Introduction 6.5 Materials, Corrosion & Skin Effect 6.6 AC Measurement & Conversion Factors 6.7 Conduction, Reactive Power & Maximum Power Transfer
7 Element 3: Electrical Math
7.1 Ohm's Law — Series & Parallel Circuits 7.2 Frequency, Period, Wavelength & Waveform Math 7.3 Power Relationships & Decibels 7.4 RC/RL Time Constants 7.5 Frequency Counter Accuracy, PPM & Harmonics 7.6 Impedance in Rectangular & Polar Coordinates 7.7 Regulation, Turns Ratio, Zener Bias & Conductance
8 Element 3: Circuit Components — Passives & Power Devices
8.1 Capacitors & Photoconductive Devices 8.2 Transformers, Voltage Regulators & Zener Diodes 8.3 Diodes, SCRs & Triacs
9 Element 3: Active Components — Transistors & Devices
9.1 Bipolar Junction Transistors 9.2 FETs, LEDs & Specialty Devices 9.3 Device Selection, Ratings & Thermal Design
10 Element 3: Practical Circuits — RLC, Op Amps & Schematics
10.1 R-L-C Resonant Circuits 10.2 Op Amps, PLLs, VCOs & Mixers 10.3 Reading Schematics & Signal Flow
11 Element 3: Digital Logic
11.1 Logic Gates & Boolean Functions 11.2 Flip-Flops & Sequential Elements 11.3 Multivibrators & Timing Circuits 11.4 Microprocessors & Bus Architecture 11.5 TTL Logic Families & Input Voltage Levels 11.6 Positive & Negative Logic and Truth Tables 11.7 Memory Types & Microprocessor Concepts 11.8 Counters, Prescalers, BCD & Data Converters
12 Element 3: Receivers
12.1 Receiver Theory & Superheterodyne Architecture 12.2 RF Amplifiers & Front-End Design 12.3 Filters & Detectors 12.4 Audio, Squelch & Receiver Performance Specs 12.5 Receiver Oscillators: Colpitts, Hartley & Pierce 12.6 Mixing, Image Frequencies & Spurious Products 12.7 IF Selectivity & Filter Bandwidth
13 Element 3: Transmitters
13.1 RF Amplifier Classes & Efficiency 13.2 Oscillators, Modulators & Tuning Networks 13.3 SSB Transmitters & Modern Transmitter Technology
14 Element 3: Signals, Emissions & Modulation
14.1 Amplitude & Frequency Modulation 14.2 Single-Sideband Modulation 14.3 Pulse Modulation & Emission Types
15 Element 3: Power Sources
15.1 Batteries & Energy Storage 15.2 Motors, Generators & Power Supplies
16 Element 3: Antennas & Feed Lines
16.1 Antenna Theory, Types & Patterns 16.2 Voltage, Current & Impedance on Antennas 16.3 Transmission Lines, Velocity Factor & SWR 16.4 Effective Radiated Power & Antenna Bandwidth
17 Element 3 Background: Propagation & Radio Practice
17.1 Radio Wave Propagation Modes 17.2 Multipath, Fading & Doppler Effects 17.3 Radio Practice, Interference & Good Engineering
18 Element 3: Aircraft Radio Navigation Systems
18.1 DME & VOR 18.2 ILS, ADF & ATC Transponders 18.3 Aircraft Antennas, Frequencies & Equipment Functions
19 Element 3: Installation, Maintenance & Repair
19.1 Indicating Meters & Meter Movements 19.2 Oscilloscopes & Waveform Measurement 19.3 Measurement Procedures 19.4 Installation Codes & Bonding Procedures 19.5 Frequency Standards, SINAD Meters & EMI Hunting 19.6 Spectrum Analyzers, TDRs & Service Monitors 19.7 Bench Repair Practices, ESD & Rework Tools 19.8 Systematic Troubleshooting & Field Fault Diagnosis
20 Element 3: Communications Technology & Marine Systems
20.1 Transmission Types, Coding & Multiplexing 20.2 Signal Processing, Software & Codes 20.3 Marine VHF, MF/HF & SSB-SITOR 20.4 Survival Craft Electronics, FAX & NAVTEX 20.5 NMEA 0183 & NMEA 2000 Data Networks
21 Element 3: RADAR & Satellite Systems
21.1 RADAR Theory & Pulse Fundamentals 21.2 Range, Pulse Width & PRF 21.3 Radar Antennas & Waveguides 21.4 INMARSAT Satellite Communications 21.5 RADAR Components: Magnetron, Duplexer, ATR & Synchro 21.6 RADAR Equipment, ARPA & Radiation Safety 21.7 Low Earth Orbit Systems: Iridium & COSPAS-SARSAT 21.8 GPS Satellite Navigation & DGPS
22 Element 3: RF & Electrical Safety
22.1 RF Radiation Exposure Limits 22.2 Electrical Safety Practices for Radio Technicians
23 Study Strategy & Exam Day
23.1 Study Strategy, Practice Plan & Exam Day
4.4 VHF Channel Selection & Channel Assignments
Key Takeaways Explain This Topic AI
Channel 16 is the VHF-FM channel that must be monitored at all times when a VHF-equipped vessel is at sea
Channel 70 is used only for digital selective calling and never for voice
Channel 13 carries the required bridge-to-bridge navigational watch in most areas of the continental United States
Channel 08 is a typical routine ship-to-ship voice working channel, and Channel 28 a typical public-correspondence channel for shore telephone calls
- The aircraft distress frequency is 121.500 MHz using A3E emission, not an FM marine channel
- Last updated: August 2026
4.4 VHF Channel Selection & Channel Assignments
Quick Answer: Ch-16 — monitored at all times at sea. Ch-70 — digital selective calling only , never voice. Ch-13 — required bridge-to-bridge watch in most of the continental US. Ch-08 — routine ship-to-ship working traffic. Ch-28 — call to a shore telephone . 121.500 MHz, A3E — aircraft distress.
Section 4.1 covered what the knobs on a marine VHF do. Official sub-topic 1-C-14 (VHF Channel Selection) is about which channel , and it is almost entirely a recall exercise. Six pool items, six numbers. There is no reasoning shortcut—learn the table.
The core channel table
Channel Assignment The trap
16 Distress, safety and calling. Monitored at all times by VHF-FM-equipped vessels at sea Confusing "calling" with "working"—you call on 16 and then shift
70 Digital selective calling only Answering "70" for a voice question, or transmitting voice on 70
13 Bridge-to-bridge navigational safety , the required bridge-to-bridge watch in most areas of the continental US Assuming 13 is a survival-craft or general channel
- 06 Intership safety Confusing with 08
- 08 Routine ship-to-ship voice traffic Confusing with 06
28 Public correspondence —placing a call to a shore telephone Assuming any duplex channel works for phone calls
Channel 16 — the continuous watch
What channel must VHF-FM-equipped vessels monitor at all times when at sea? Channel 16. This is the single most repeated fact in Element 1 and it appears in the watchkeeping sub-topic as well. Channel 16 is simultaneously the distress channel, the safety channel, and the calling channel—which is exactly why traffic must move off it immediately once contact is established.
Channel 70 — DSC only
Which VHF channel is used only for digital selective calling? Channel 70. Note the word only . Channel 70 is not a voice channel that also carries DSC; it is a data channel reserved for DSC alerting and acknowledgement. Modern radios physically prevent voice transmission on 70, and a set that lets you key voice onto it is faulty or misconfigured.
The relationship between 16 and 70 is the heart of modern GMDSS VHF working:
- DSC alert goes out on Ch-70 — digital, addressed, carries your MMSI and position
- Voice follow-up happens on Ch-16 — the radio typically switches automatically after the alert
- Channel 13 — bridge-to-bridge
Which channel is used for the required bridge-to-bridge watch? VHF-FM on Ch-13 in most areas of the continental United States. Section 3.1 covered the bridge-to-bridge rules themselves; here the point is just the number, and the qualifier "in most areas of the continental United States" matters because some regions designate an alternative. Channel 13 is a low-power, short-range navigational-safety channel—the channel two vessels use to agree a passing arrangement, not a general chat channel.
Recall from section 5.5 that Ch-13 is specifically not a required survival-craft portable VHF capability. The pool likes to place Ch-13 as a distractor in survival-craft questions precisely because candidates learn it as an important number.
Channels 06, 08 and 28 — the working channels
These three are the "routine traffic" answers:
- Ch-06 — intership safety communications
- Ch-08 — the pool's answer for routine ship-to-ship voice traffic
Ch-28 — the pool's answer for placing a call to a shore telephone (public correspondence through a coast station)
Ch-28 is a duplex public-correspondence channel, which is where the USA–INT control (section 20.3) becomes relevant: that control changes some channels that are normally duplex into simplex, reflecting differences between the international and US domestic channel plans.
The aviation outlier: 121.500 MHz, A3E
One item in this maritime-flavoured sub-topic is about aircraft: the aircraft frequency and emission used for distress communications is 121.500 MHz, A3E.
Two halves, both testable:
- Half Value Why
- Frequency 121.500 MHz The international aeronautical emergency frequency, in the VHF air band
- Emission A3E Double-sideband full-carrier AM telephony—aviation VHF uses AM, not FM
That emission designator is the giveaway. Marine VHF is FM (G3E); aviation VHF is AM (A3E). Aviation kept AM partly because overlapping AM transmissions produce an audible heterodyne that alerts controllers to a blocked call, whereas FM capture effect would silently hide the weaker station. You will meet 121.5 MHz again in section 5.2 as a legacy EPIRB homing frequency alongside the 406 MHz satellite alert.
Drill list
Cover the right column and recite:
- Monitored at all times at sea → 16
- DSC only → 70
- Required bridge-to-bridge watch → 13
- Routine ship-to-ship voice → 08
- Call to a shore telephone → 28
- Aircraft distress → 121.500 MHz, A3E