Study guide
NAAQS, Criteria Pollutants, HAPs & AQI
FE Environmental Study Guide Exam
Track your progress as you read
Finished sections get a check mark.
1 Introduction, Mathematics & Ethics
Exam Format, NCEES CBT Logistics & Blueprint Map Calculus & Differential Equations Probability, Statistics & Regression Numerical Methods & Engineering Math Mathematics Applications for Environmental FE
2 Ethics, Economics & Materials
NCEES Model Rules & Engineering Ethics Professional Practice, Liability & Public Safety Engineering Economics: Time Value of Money Benefit-Cost, Replacement & Inflation Analysis Materials: Concrete, Corrosion & Polymers
3 Environmental Science & Chemistry
Geosynthetics & Environmental Materials Environmental Chemistry & Stoichiometry Water Chemistry: pH, Alkalinity & Hardness Microbiology, BOD Kinetics & Monod Growth Henry's Law & Phase Equilibrium for Air Quality
4 Risk Assessment & Water Resources
Environmental Science Applications EPA Four-Step Risk Assessment Paradigm Exposure, Dose, Hazard Quotient & Cancer Risk Hydrology & Rainfall-Runoff Analysis Open-Channel Flow & Manning Equation
5 Groundwater & Water Treatment
Groundwater: Darcy, Theis & Cooper-Jacob Streeter-Phelps & Water-Quality Modeling Water Treatment: Sedimentation & Filtration Disinfection, CT Rule & Chlorination Wastewater: Activated Sludge & BOD Removal
6 Advanced Treatment & Air Quality
Advanced Treatment: MBR, GAC & RO Sludge Handling & Water Reuse NAAQS, Criteria Pollutants, HAPs & AQI Gaussian Plume, Pasquill Stability & Effective Stack Height AP-42 Factors & Air Pollution Control Technologies
7 Air Permitting & Solid/Hazardous Waste
PSD, NSR, BACT, LAER, Title V & Offsets RCRA Lists, Characteristics & Generator Categories Subtitle D Landfill Design, Liners & Leachate CERCLA, UST, TCLP & Land Disposal Restrictions MSW Collection, Transfer, Composting, WTE & Recycling
8 Sustainability, EHS & Exam Day
LCA Stages, Carbon Footprint & Scope 1/2/3 Emissions LEED Credits, ISO 14001 EMS & Triple Bottom Line PELs, TLVs, Hierarchy of Controls & Confined Spaces EPCRA Reporting, TRI Form R, DOT Hazmat & RCRA Manifests Exam Format, NCEES CBT Logistics & Blueprint Map
NAAQS, Criteria Pollutants, HAPs & AQI
Key Takeaways Explain This Topic AI
Six criteria pollutants have National Ambient Air Quality Standards: PM2.5, PM10, ozone, CO, SO2, and NO2.
Primary NAAQS protect public health; secondary NAAQS protect welfare (crops, visibility, materials).
Hazardous air pollutants (HAPs) are regulated under CAA Section 112 with MACT for major sources.
The Air Quality Index (AQI) translates ambient concentrations into color-coded health categories for the public.
Attainment status by county drives whether PSD or nonattainment NSR applies to new major sources.
Last updated: July 2026
Quick Answer: Know the six criteria pollutants , the difference between primary and secondary NAAQS , HAP major-source thresholds (≥10 tpy single or ≥25 tpy total HAPs), and how AQI categories communicate health risk from ambient monitoring data.
Air quality engineering on the FE Environmental exam begins with the Clean Air Act (CAA) pollutant framework. Before sizing control devices or running dispersion models, you must classify pollutants, identify applicable standards, and understand how ambient data are reported to the public.
Criteria Pollutants and NAAQS
EPA designates criteria pollutants because ambient levels, sources, and health effects justify national standards:
- Pollutant Typical form Example standard type
- PM2.5 Annual & 24-hr mass Annual arithmetic mean; 24-hr (98th percentile)
- PM10 24-hr mass 24-hr (99th percentile)
- Ozone (O3) 8-hr average Primary & secondary 8-hr NAAQS
- CO 8-hr & 1-hr Ambient CO for carboxyhemoglobin risk
- SO2 1-hr & 3-hr Acid deposition precursor
- NO2 Annual & 1-hr Respiratory effects; ozone precursor
National Ambient Air Quality Standards (NAAQS) include:
Primary standards — protect public health with adequate margin for sensitive groups (asthmatics, children, elderly).
Secondary standards — protect welfare : visibility, vegetation, materials, climate-related effects.
States implement State Implementation Plans (SIPs) showing how attainment and maintenance will occur. Designations classify counties as attainment , nonattainment , or unclassifiable for each criteria pollutant.
Exam trap: ground-level vs. stratospheric ozone
Tropospheric ozone is a criteria pollutant formed by NOx + VOC + sunlight . Stratospheric ozone depletion (Montreal Protocol, CFCs) is a separate issue. Exam references to "ozone nonattainment" always mean ground-level smog .
Hazardous Air Pollutants (HAPs)
Section 112 lists 187 HAPs (benzene, formaldehyde, mercury, etc.). Source categories:
- Category Threshold Typical control
- Major HAP source ≥10 tpy any single HAP OR ≥25 tpy combined MACT
- Area source Below major thresholds Residual risk, GACT, consumer rules
MACT (Maximum Achievable Control Technology) sets emission limits based on performance of the best-controlled similar sources. After MACT, EPA may address residual risk if lifetime cancer risk to the maximum exposed individual exceeds policy thresholds (~1 in 10,000 in rulemaking context).
Air Quality Index (AQI)
The AQI converts monitored pollutant concentrations into a uniform 0–500 scale for public communication:
- AQI range Category Health message (simplified)
- 0–50 Good Little concern
- 51–100 Moderate Acceptable; unusually sensitive people consider limits
- 101–150 Unhealthy for sensitive groups Sensitive groups reduce exertion
- 151–200 Unhealthy Everyone may experience effects
- 201–300 Very unhealthy Health alert
- 301+ Hazardous Emergency conditions
AQI = max sub-index among criteria pollutants reported. Sub-indices use piecewise linear breakpoints tied to NAAQS levels. PM2.5 and ozone drive many high-AQI days in urban areas.
Lead and Other Historical Notes
Lead was a criteria pollutant; ambient lead NAAQS remain though mobile-source lead phased out. Some exam stems still reference lead smelters or aviation gasoline. Greenhouse gases are regulated under separate authority (not criteria NAAQS in the traditional six-pollutant list on older stems — know exam context).
Monitoring and Design Values
Federal Reference Methods (FRM) and Federal Equivalent Methods (FEM) define how ambient data are collected. Design values (e.g., 3-year average of annual 98th percentile PM2.5) compare against NAAQS for attainment determinations.
Prevention of Significant Deterioration (PSD) increments limit how much a pristine area can degrade — separate from NAAQS but part of air planning.
Worked Classification Scenario
A county is in moderate ozone nonattainment . A proposed factory emits 120 tpy NOx as potential to emit (PTE) .
NAAQS context: ozone nonattainment → stricter new-source review than attainment areas.
Title V: major source threshold often 100 tpy criteria pollutant → likely Title V operating permit required.
HAPs: if benzene is 2 tpy, not a major HAP source by itself; evaluate combined HAP total separately.
Mobile, Area, and Point Sources
- Source type Examples Inventory role
- Point Stacks, vents Permitted, stack-tested
- Area Dry cleaners, small boilers Gridded emissions
- Mobile Cars, trucks, aircraft Fleet models, fuels
Emission inventories sum mass per time by source category before modeling or permitting.
FE Exam Focus
Memorize criteria pollutant names, primary vs. secondary NAAQS purpose, HAP major thresholds, AQI category breakpoints conceptually, and attainment vs. nonattainment consequences for permitting. Handbook tables supply specific numbers — practice locating pollutant-specific Significant Emission Rates (SER) for modifications.
Exam trap: Confusing emission standards (source limits in lb/MMBtu or tpy) with ambient NAAQS (µg/m³ or ppm in outside air). A source can meet its permit while a region remains in nonattainment.
Solid pollutant taxonomy and AQI literacy unlock every subsequent air chapter topic — dispersion, controls, and permitting.
State Implementation and SIP Basics
Each state adopts State Implementation Plans (SIPs) showing how attainment and maintenance of NAAQS will occur. SIPs include emission inventories, control measures, and monitoring networks. When EPA disapproves a SIP element, federal implementation plans may apply. Transportation conformity requires that federally funded highway and transit projects not worsen air quality in nonattainment areas — linking NAAQS status to infrastructure funding.
Exceptional events (wildfires, dust storms) may be excluded from attainment determinations if documented — policy context for interpreting monitored exceedances on exam scenarios.
Regional Haze and Secondary Standards
Regional Haze rules protect Class I area visibility — related to secondary NAAQS welfare protection. While detailed haze modeling is beyond FE scope, know that secondary standards address welfare effects (vegetation, materials, visibility) distinct from primary health-based limits. Exam items may ask whether a standard is primary or secondary when discussing crop damage versus respiratory hospital admissions.