Study guide
7.3 Alternative Disinfectants (Chloramines, ClO2, Ozone, UV)
Florida Water/Wastewater Operator Study Guide Exam
Track your progress as you read
Finished sections get a check mark.
1 Introduction & FDEP Certification Framework
1.1 Current Exam Facts & PSI Logistics 1.2 License Families, Classes A–D & Distribution Levels 1.3 Examination Eligibility, Approved Courses & Linear Progression 1.4 Licensure Experience, Fees, Renewal & CEUs
2 Florida Regulations & Water Law
2.1 Chapter 62-602 Operator Certification Rules 2.2 FAC 62-550 Drinking Water Standards & SDWA Primacy 2.3 FAC 62-600 Wastewater & AWT 5-5-3-1 Standards 2.4 FAC 62-610 Reclaimed Water Reuse Rules
3 Source Water & Florida Hydrogeology
3.1 Characteristics of Source Water & Contaminants 3.2 Floridan Aquifer, Wells & Saltwater Intrusion 3.3 Reservoir, Wellfield Management & Water Management Districts
4 Coagulation, Flocculation & Sedimentation
4.1 Coagulation Chemistry & Jar Testing 4.2 Flocculation Process Control 4.3 Clarification & Sedimentation
5 Filtration & Membrane Processes
5.1 Granular Media Filtration Theory 5.2 Filter Operation, Backwash & Troubleshooting 5.3 Membrane Filtration & Reverse Osmosis (Florida RO)
6 Softening, Iron/Manganese & Taste/Odor Control
6.1 Lime Softening & Ion Exchange 6.2 Iron and Manganese Control 6.3 Taste and Odor Control & Aeration
7 Disinfection & Disinfectant Byproducts
7.1 Chlorination Chemistry & Residual Control 7.2 CT Calculations & Pathogen Inactivation 7.3 Alternative Disinfectants (Chloramines, ClO2, Ozone, UV) 7.4 DBP Formation, Stage 1/2 Rules & Compliance
8 Corrosion Control & Chemical Treatment
8.1 Corrosion Control & Lead and Copper Rule 8.2 Chemical Treatment, Fluoridation & Feed Systems 8.3 Residuals Disposal & Waste Handling
9 Wastewater Collection, Preliminary & Primary Treatment
9.1 Collection Systems, Lift Stations & SSO Reporting 9.2 Preliminary Treatment: Screening & Grit 9.3 Primary Sedimentation 9.4 Wastewater Characteristics & Plant Loadings
10 Secondary Treatment & Activated Sludge
10.1 Secondary Process Fundamentals 10.2 Activated Sludge Process Control 10.3 Activated Sludge Troubleshooting 10.4 Fixed-Film, Package Plants & Lagoons
11 Nutrient Removal, AWT & Reuse
11.1 Biological Nutrient Removal (N & P) 11.2 Florida AWT 5-5-3-1 Standards 11.3 Effluent Disposal Options 11.4 Reclaimed Water Systems & FAC 62-610 Practice
12 Solids Handling & Biosolids
12.1 Sludge Thickening & Digestion 12.2 Dewatering & Residuals Disposal 12.3 Biosolids Stabilization & Land Application Basics
13 Distribution Systems & Hydraulics
13.1 Distribution Network Design & Operations 13.2 Pipes, Valves, Hydrants & Appurtenances 13.3 Hydraulics, Pressure & Pumping 13.4 Main Disinfection, Breaks & Repair
14 Cross-Connection, Storage & Distribution Water Quality
14.1 Cross-Connection Control & Backflow Prevention 14.2 Storage Tanks & Reservoirs 14.3 Distribution Water Quality, Flushing & Residual Management
15 Laboratory Testing & Sampling
15.1 Sampling, Preservation & Chain of Custody 15.2 Physical & Chemical Water Analysis 15.3 Wastewater Process Lab Testing 15.4 Microbiological Testing & QA/QC
16 Operator Math
16.1 Math Fundamentals, Conversions & Formula Sheets 16.2 Dosage, Chemical Feed & Detention Time 16.3 Flows, Loadings, Removal Efficiency & Solids Math 16.4 Pump Hydraulics & Horsepower
17 Safety, Security & Emergency Preparedness
17.1 Confined Space, LOTO, PPE & Chemical Safety 17.2 Chlorine Gas Safety & Emergency Response 17.3 Security, Hurricane Preparedness & Contingency Planning (Florida)
18 Equipment, O&M & Administration
18.1 Operate & Maintain Plant Equipment 18.2 Process Control Instrumentation & SCADA Basics 18.3 Records, Reporting & Administrative Duties
7.3 Alternative Disinfectants (Chloramines, ClO2, Ozone, UV)
Key Takeaways Explain This Topic AI
Chloramines provide a persistent secondary residual and typically lower THM/HAA formation than free chlorine, with nitrification as a key warm-climate risk.
Chlorine dioxide does not form THMs like free chlorine but creates chlorite/chlorate monitoring concerns.
Ozone is a powerful primary oxidant/disinfectant with no lasting residual and possible bromate formation in bromide waters.
UV inactivates pathogens without chemical DBPs from the UV step but provides no distribution residual and requires lamp and UVT maintenance.
Florida systems often pair a strong primary barrier with chlorine or chloramines for distribution residual based on DBP and logistics tradeoffs.
Last updated: August 2026
7.3 Alternative Disinfectants (Chloramines, ClO2, Ozone, UV)
Quick Answer: Free chlorine is common, but many systems use chloramines , chlorine dioxide , ozone , or UV (often in combination) to hit pathogen goals while managing DBPs and distribution residuals. Chloramines persist and usually form fewer regulated THMs/HAAs from free chlorine pathways; ClO2 avoids THMs but creates chlorite/chlorate concerns; ozone and UV are powerful primary disinfectants with no lasting residual —a secondary disinfectant is still required in distribution.
Florida utilities choose disinfectants based on source water (groundwater vs surface vs RO permeate), DBP pressure, distribution length, and operational complexity. Exams test advantages, limitations, byproducts, and residual behavior —not vendor brand names.
Why Alternatives Exist
Free chlorine is excellent for primary disinfection but:
- Reacts with natural organic matter to form THMs and HAAs
- Decays relatively quickly in long, warm distribution systems
- Can cause taste/odor complaints at higher residuals
Alternatives (or free chlorine + alternative secondary residual) address those gaps. Many large systems use a primary/secondary pair (e.g., ozone or UV or free chlorine contact at the plant, then chloramines in the distribution system).
Chloramination (Combined Chlorine Residual)
Chloramines are formed by reacting free chlorine with ammonia in a controlled Cl2:N ratio (commonly targeting monochloramine). Typical operational ratios are discussed as chlorine-to-ammonia-nitrogen mass ratios near the range that favors monochloramine (operators follow plant-specific targets, often near 3:1 to 5:1 Cl2:NH3-N conceptual range—always use the facility SOP and avoid dichloramine/trichloramine zones).
Advantage Why it matters
Lower regulated THM/HAA formation (vs free chlorine residual) Helps Stage 1/2 DBPR compliance when precursors are high
- More persistent residual Better for long Florida distribution systems and storage tanks
- Milder taste/odor for many customers Fewer "swimming pool" complaints at moderate residuals
- Biofilm penetration (relative discussion) Often cited operational benefit vs free chlorine in some systems
Limitation / risk Operator response
Weaker primary disinfectant than HOCl Use adequate free-chlorine (or other) primary CT before ammonia addition when required
Nitrification in distribution (especially warm water) Monitor nitrite/nitrate, HPC, residual; flush; optimize residual and tank turnover
Dichloramine/trichloramine taste if ratio wrong Control Cl2:N ratio and mixing order
Lead/copper and corrosion chemistry shifts on conversion Coordinate corrosion control before switching residuals
Special sensitive users (kidney dialysis, some aquaria) Public notification and coordination on chloramine conversions
Florida angle: Warm temperatures increase nitrification risk in chloraminated systems. Residual loss with nitrite appearance is a classic red flag. Operational programs include targeted flushing, reservoir cycling, occasional free-chlorine "burns" where approved, and careful booster practices.
Chlorine Dioxide (ClO2)
Chlorine dioxide is a strong disinfectant and oxidant generated on-site (not shipped as a bulk compressed ClO2 product for typical drinking-water use). It is effective for pathogens and for oxidizing iron, manganese, and some taste-and-odor compounds.
- Topic Chlorine dioxide fact
- THM formation Does not form THMs the way free chlorine does with NOM
- Inorganic byproducts Chlorite and chlorate are key regulated/monitored concerns
- Residual Can provide residual but chemistry and quenching differ from free chlorine
- Generation On-site generators; precursor chemicals and yield control matter
- CT Has its own CT tables/credits; do not use free-chlorine tables
Operator watch-outs:
- Monitor chlorite per rule requirements; high chlorite can limit ClO2 dose
- Generator efficiency and purity affect byproducts
- ClO2 is useful when free-chlorine DBPs are problematic but organic precursors remain
- Ozone (O3)
Ozone is an extremely powerful oxidant/disinfectant generated on-site from air or oxygen. It provides excellent inactivation and can oxidize taste-and-odor compounds and some micropollutants.
Strength Limitation
Very strong pathogen inactivation (including significant Crypto credit potential depending on design) No lasting residual for distribution
Can reduce some precursors or change NOM character Can form bromate in bromide-containing waters (Florida coastal/brackish influence is relevant)
Improves some subsequent processes Capital, energy, and complex O&M (generators, contactor, off-gas destruct)
Critical exam point: Ozone disinfection in the plant does not replace a secondary residual (usually chlorine or chloramines) in the distribution system. Design is primary ozonation + residual disinfectant leaving the plant.
Bromide in source water (coastal groundwater, saltwater intrusion influence, some surface waters) raises bromate risk—an ozone-specific DBP concern distinct from THMs/HAAs.
Ultraviolet (UV) Disinfection
UV light (commonly low-pressure or medium-pressure lamps in validated reactors) inactivates pathogens by damaging nucleic acids. UV is a physical disinfectant—not a chemical residual.
- Advantage Limitation
- Excellent for Crypto/Giardia inactivation credit when validated No residual for distribution
- No chlorine DBPs from the UV step itself Lamp aging, sleeve fouling, UVT (transmittance) reduce dose
- Compact footprint for many plants Power quality, sensor calibration, and redundancy required
Works well with membranes or as multi-barrier add-on Does not oxidize chemicals; may need separate oxidant for T&O/Fe/Mn
Dose concept: UV dose ≈ intensity × time (mJ/cm2). Validated reactors use sensors and UVT monitoring. Operators track:
- Lamp hours and replacement schedules
- Sleeve cleaning (mechanical/chemical wipers)
- UVT of the water (high color/turbidity/iron hurts transmittance)
- Alarm setpoints and redundancy (N+1 lamps/trains)
Florida groundwater with iron, color, or organics may need pretreatment so UVT stays in the validated range.
Selection Tradeoffs for Florida Systems
- Disinfectant Residual in distribution? DBP / byproduct theme Good fit when… Watch closely for…
- Free chlorine Yes THMs, HAAs Simple trains, strong primary CT needs Warm-system residual loss; Stage 2 sites
Chloramines Yes (persistent) Lower THM/HAA; nitrification Long distribution, DBP pressure Nitrite, residual decay, ratio control
ClO2 Possible / specialized Chlorite, chlorate; low THMs DBP or oxidation needs without free Cl2 THMs Generator yield; chlorite MCL strategy
Ozone No Bromate; no Cl-DBPs from O3 itself Strong primary; T&O; multi-barrier Energy, bromate, still need secondary residual
- UV No None from UV step Crypto credit; multi-barrier with free Cl2 residual UVT, lamps, no residual alone
- Common Florida train patterns (conceptual)
- Groundwater free chlorine — Aeration/iron removal → free chlorine → clearwell → distribution free residual
Surface / enhanced treatment — Coag/floc/sed/filter → free chlorine contact → possibly ammonia to chloramines for citywide residual
RO/membrane — Permeate may have low precursors but still needs disinfection residual strategy and corrosion control
- UV or ozone primary — High-level inactivation → chlorine/chloramines for pipeline residual
- Decision factors operators should cite on exams
- Pathogen credit needed (Giardia/virus/Crypto)
- TOC and bromide (DBP and bromate risk)
- Distribution residence time and temperature
- Staffing skill and O&M budget
- Customer sensitivity and conversion public outreach
- Regulatory MCLs and monitoring complexity
- Integrating Alternatives with Residual Rules
Whatever primary disinfectant is used:
Distribution residual requirements still apply when the system uses a chemical residual disinfectant
Switching from free chlorine to chloramines is a major operational change—flush, public notice themes, dialysis coordination, and corrosion control review
Measuring the correct residual species (free vs total vs ClO2) is mandatory for both process control and compliance
Operator Exam Focus
Expect to match disinfectant → residual yes/no → signature byproduct → main advantage. Example flash associations:
- Chloramines → persistent residual, fewer THMs, nitrification risk
- ClO2 → no THMs from ClO2 pathway, chlorite concern
- Ozone → powerful, no residual, bromate risk
- UV → powerful for protozoa, no residual, lamp/UVT maintenance
If you can fill that table from memory, Section 7.3 exam items become straightforward.