Study guide
7.1 Straight-Razor Shaving: Prep, Technique & Safety
Georgia Barber License Barber II
Track your progress as you read
Finished sections get a check mark.
1 Introduction & Georgia Barber II Exam Overview
1.1 What Is the Georgia Barber II License? 1.2 Exam Format, Fees & Scheduling 1.3 Eligibility, Training Hours & Applying for Your License
2 Georgia Barber Law & Board Regulations
2.1 Board Authority & OCGA Title 43 Chapter 10 2.2 School vs Apprenticeship & Hour Requirements 2.3 Examination, Renewal & Continuing Education 2.4 Unlawful Practice, Shop Licensing & Violations
3 Infection Control & Safety
3.1 Pathogens & Infection-Control Principles 3.2 Cleaning, Disinfecting & Sterilizing Implements 3.3 Bloodborne Pathogens, OSHA & Exposure Incidents 3.4 Shop Safety & Product/Chemical Handling
4 Hair, Scalp & Skin Science
4.1 Hair Structure, Composition & Growth Cycle 4.2 Scalp & Skin Disorders and Contraindications 4.3 Basic Chemistry: pH, Water & Product Types 4.4 Anatomy Essentials: Head, Face & Neck
5 Implements, Equipment & Client Consultation
5.1 Implements & Equipment: ID, Function & Care 5.2 Draping, Consultation, Contraindications & Records 5.3 Electrical Tools & Equipment Safety
6 Haircutting & Hair Design Services
6.1 Haircutting Fundamentals: Sectioning, Elevation & Tools 6.2 Clipper Cutting, Fades & Tapers 6.3 Scissor-Over-Comb, Texturizing & Finishing 6.4 Shampooing, Scalp Treatments & Basic Styling 6.5 Hairpieces, Wigs & Attachments
7 Shaving & Facial Hair Services
7.1 Straight-Razor Shaving: Prep, Technique & Safety 7.2 Beard & Mustache Design and Trimming 7.3 Facial Treatments & Waxing Within Barber II Scope
8 Professional Practice, Ethics & Barbershop Business
8.1 Ethics, Client Communication & Scope Boundaries 8.2 Shop Operations, Employment & Career Paths
7.1 Straight-Razor Shaving: Prep, Technique & Safety
Key Takeaways Explain This Topic AI
Georgia Rule 240-14-.03 requires Barber II schools to teach straight-razor handling through the fourteen-stroke process and proper sharps disposal (Shaving — 25 hours)
Client prep includes consultation, skin analysis, grain mapping, draping, steam towels, and warm lather before any blade contact
The four stroke families are freehand, backhand, reverse freehand, and reverse backhand; first time over is always with the grain
Cover and disinfect the headrest each client; stop for blood, glove up, use single-use styptic, then disinfect and discard contaminated materials
- Used blades go immediately into a puncture-resistant sharps container — never regular trash
- Last updated: July 2026
7.1 Straight-Razor Shaving: Prep, Technique & Safety
Quick Answer: Georgia Barber II curriculum (Rule 240-14-.03) requires 25 hours of shaving instruction , including proper straight-razor handling through the fourteen-stroke process and sharps disposal . Soften and lather first, shave the 14 areas with the grain on the first pass using freehand / backhand / reverse strokes, keep the headrest covered and disinfected, and treat every used blade as a contaminated sharp.
Straight-razor shaving is a signature Barber II service and a high-stakes safety skill. NIC Barber 1 (No Chemical Services) weights Facial Hair Services at about 10% of theory; Georgia school rules make the fourteen-stroke process and blade disposal explicit training requirements, so expect both technique and infection-control items on the PSI written and practical.
Client Prep Before the Blade
Every shave starts with a short consultation and skin analysis , not with lather.
Ask about sensitivity, prior razor burn or ingrown hairs, blood thinners, topical retinoids/acids, and whether the client wants a once-over or a closer second pass.
Inspect the face and neck under good light for contagious or compromised conditions — tinea barbae , active herpes , impetigo , weeping folliculitis, inflamed acne, sunburn, or open sores. Contagious lesions mean stop and refer ; never shave through infection.
For pseudofolliculitis barbae (PFB) (ingrown hairs after close shaving of curly hair), soften thoroughly and keep the first pass with the grain only — avoid chasing an ultra-close finish.
Map grain direction by stroking dry growth: smooth = with the grain; resistance = against. Cheeks usually grow down; necks often grow up or in whorls.
Draping and chair setup: Place a clean neck strip or towel against skin, then the cape so fabric never contacts bare skin. Recline the chair so the head is supported, raise the seat to near elbow height, and stand to the client’s right (right-handed barber) rather than reaching across the face.
Headrest rule: Fit a clean cover or towel on the headrest for every client . Between clients, clean and disinfect the headrest surface with an EPA-registered disinfectant for the full label contact time. An uncovered, shared headrest is an infection-control failure examiners notice.
Steam, Lather, and Skin Stretch
Step Purpose Exam cue
Steam / hot towel Softens keratin, opens pores, relaxes tissue Test temperature on your wrist first; leave nostrils clear
Warm lather Hydrates hair, lifts shafts, emulsifies oil Work with brush or fingers in circular motions; keep lather moist
Skin stretch Creates a flat cutting plane Non-dominant hand stretches opposite the stroke, about 1–2 inches behind the edge
Hold the razor at roughly a 30-degree angle on flat facial surfaces. Too steep digs; too flat skips. Keep strokes short and controlled — long, rushed strokes cause nicks.
The Fourteen-Stroke Process
Georgia’s Barber II curriculum language is specific: schools must teach "proper handling technique of [the] straight razor learning the fourteen (14) stroke process." Memorize the 14 numbered areas and the stroke family for each (right-handed convention):
- Area Location (summary) Typical stroke
- 1 Right sideburn toward mouth / jaw Freehand
- 2 Right mouth angle to chin point Backhand
- 3 Under nostrils / right upper lip Freehand
- 4 Right neck below jaw to grain change Freehand
- 5 Remainder of right neck (upward with grain) Reverse freehand
- 6 Left upper lip Backhand
- 7 Left hairline toward mouth / jaw Backhand
- 8 Left mouth angle to chin point Freehand
- 9 Left chin point to neck grain change Backhand
- 10 Left lower neck upward Reverse freehand
- 11 Across upper chin below jaw Freehand
- 12 Just below chin, arcing to grain change Freehand
- 13 Center lower neck upward (stretch off Adam’s apple) Reverse freehand
- 14 Up from chin cleft toward lower lip Reverse freehand
Stroke concepts:
Freehand: Primary downward stroke on much of the right side (areas commonly 1, 3, 4, 8, 11, 12).
Backhand: Covers the left side without reaching across the nose (commonly 2, 6, 7, 9).
Reverse freehand: Upward stroke where hair grows up — neck/under-jaw areas 5, 10, 13, 14 .
Reverse backhand: Used mainly for outline / sideburn / behind-ear work with the client upright — not a standard facial-pass stroke.
First time over is always with the grain . A closer second time over (across or against the grain) is optional after re-lathering and only if skin can tolerate it.
Blood Exposure Readiness and Sharps Disposal
Rule 240-14-.03 pairs stroke training with proper disposal of razor blades in sharps containers . Shop practice mirrors bloodborne-pathogen standards:
Prefer a changeable-blade (shavette) razor with a new disposable blade per client .
Carry an open razor with the edge away from bodies; pass handle first .
If you nick the client: STOP → glove → gentle pressure with clean gauze → single-use styptic/alum powder on a disposable applicator (never a shared stick) → bag contaminated disposables → disinfect the station and tools → wash hands and document.
Drop every used blade immediately into a puncture-resistant, leak-proof sharps container . Never trash, pocket, or leave blades on the station.
Finish with a cool towel, astringent or aftershave as appropriate, and moisturizer. Replace linens, cover the headrest fresh, and reset the station before the next guest.
Georgia Barber II candidates who can explain prep → fourteen strokes → headrest care → nick protocol → sharps have covered the core of this domain for both theory and practical scoring.