Study guide

2.3 Transmitter Power Limits, 60-Meter Band Rules & Prohibited Transmissions

FCC Amateur Radio General License Exam

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: Introduction & Exam Strategy

1.1 General Class License Overview, Exam Format & Question Pool Structure 1.2 Core Study Strategies, Formula Quick Reference & Test-Taking Tactics

2 Chapter 2: Subelement G1 – Commission's Rules

2.1 General Class Band Privileges & ITU Regions 2.2 Antenna Structure Limits, Beacons & Security Rules 2.3 Transmitter Power Limits, 60-Meter Band Rules & Prohibited Transmissions 2.4 Volunteer Examiner Accreditation, Exam Administration & Remote Testing 2.5 Control Operator Categories, Repeaters, Third-Party Traffic & Station Identification

3 Chapter 3: Subelement G2 – Operating Procedures

3.1 HF Phone Operating Procedures, SSB Tuning & Phonetic Alphabet 3.2 CW Operating Procedures, Q-Signals, RIT/XIT & Split Operation 3.3 Digital Operating Procedures: FT8, JS8Call, PSK31 & RTTY 3.4 Emergency Communications, Traffic Nets, RACES, ARES & Distress Priority 3.5 Volunteer Monitor Program, HF Direction Finding & Azimuthal Maps

4 Chapter 4: Subelement G3 – Radio Wave Propagation

4.1 Solar Activity, Sunspots, Solar Flux Index & Geomagnetic Indices 4.2 Maximum Usable Frequency (MUF), Lowest Usable Frequency (LUF) & Ionospheric Layers 4.3 Skywave Propagation, NVIS, HF Scatter & Tropospheric Ducting

5 Chapter 5: Subelement G4 – Amateur Radio Practices

5.1 Station Setup, Speech Processors & Audio DSP Filters 5.2 Test Equipment: RF Wattmeters, SWR Bridges, Dummy Loads & Oscilloscopes 5.3 Radio Frequency Interference (RFI), TVI, Harmonics & Core Filtering 5.4 Station Grounding, Bonding & Lightning Protection 5.5 Mobile and Portable HF Operations, Vehicle Noise & Battery Systems

6 Chapter 6: Subelement G5 – Electrical Principles

6.1 Reactance, Impedance, Resonance & Quality Factor (Q) 6.2 Decibels, Power Calculations & RMS/Peak AC Voltage Conversions 6.3 Power Factor, Transformer Ratios & Resistive Voltage Dividers

7 Chapter 7: Subelement G6 – Circuit Components

7.1 Inductors, Toroid Cores, Crystals & Semiconductor Diodes 7.2 Transistors (BJT, FET), Voltage Regulators & Vacuum Tube Amplifiers

8 Chapter 8: Subelement G7 – Practical Circuits

8.1 Linear Power Supplies, Rectifier Circuits & Filter Capacitors 8.2 RF Filters, Oscillators (Colpitts, Hartley, Pierce) & Mixers 8.3 Superheterodyne Receivers, Direct Sampling SDRs & Transceiver Architecture

9 Chapter 9: Subelement G8 – Signals and Emissions

9.1 SSB, CW, AM & FM Modulation Principles & Carrier Suppression 9.2 Frequency Mixing, Intermodulation Distortion (IMD) & Bandwidth Standards 9.3 Digital Emission Protocols, Baudot, PSK, FSK & Symbol Rates

10 Chapter 10: Subelement G9 – Antennas and Feed Lines

10.1 Half-Wave Dipoles, Quarter-Wave Verticals & Radiation Patterns 10.2 Directional Antennas: Yagi-Uda, Cubical Quad & Phased Arrays 10.3 Transmission Lines, Characteristic Impedance, Attenuation & SWR 10.4 Antenna Tuners, Impedance Matching Networks & Baluns

11 Chapter 11: Subelement G0 – Electrical and RF Safety

11.1 RF Exposure Evaluation, Maximum Permissible Exposure (MPE) & Safety Offsets 11.2 Tower Safety, Fall Arrest Gear, Antenna Installation & AC Power Hazards

2.3 Transmitter Power Limits, 60-Meter Band Rules & Prohibited Transmissions

Key Takeaways Explain This Topic AI

The general maximum power limit for General Class licensees on most amateur frequencies is 1500 Watts Peak Envelope Power (PEP), but stations must always use the minimum power necessary to carry out communications (Part 97.313).

On the 30-meter band (10.100–10.150 MHz), amateur power is strictly capped at 200 Watts PEP to prevent interference to primary fixed services.

The 60-meter band (5.3 MHz) is a secondary allocation operating on five specific discrete channels with a maximum Effective Radiated Power (ERP) of 100 Watts referenced to a half-wave dipole.

Permissible modes on 60 meters include Upper Sideband (USB voice), CW, and digital data, with emissions restricted to a maximum bandwidth of 2.8 kHz and digital signals centered on the channel center frequency.

FCC Part 97.113 strictly prohibits transmissions for pecuniary interest, broadcasting, music, and commercial activity, with a narrow exception allowing paid classroom teachers to operate amateur stations as an incidental part of instruction.

Last updated: August 2026

Transmitter Power Limits, 60-Meter Band Rules & Prohibited Transmissions

Radio frequency power management is one of the foundational technical responsibilities of an amateur licensee. Transmitting excessive power creates unnecessary RF exposure hazards, increases harmonic distortion, and generates inter-station interference across congested HF frequencies. FCC Part 97.313 defines legal power limits across amateur spectrum while enforcing the overarching operating philosophy: amateurs must always use the minimum power necessary to sustain communications .

In addition, operating on specialized secondary allocations like the 60-meter (5 MHz) band requires strict adherence to channelized frequency boundaries, custom emission types, and effective radiated power calculations referenced to a dipole antenna.

  • 1. Amateur Station Transmitter Power Standards (Part 97.313)
  • The 1500-Watt PEP Baseline Rule

Except where lower limits are specifically designated by rule or international agreement, the maximum allowable transmitter power output for General Class (and higher) licensees is 1500 Watts Peak Envelope Power (PEP) . +-----------------------------------------------------------------------------------------+

  • | AMATEUR HF TRANSMITTER POWER LIMITS |
  • | |
  • | Band / Allocation Maximum Power Limit Reference / Basis |
  • | ------------------------------------------------------------------------------------- |
  • | General HF Bands (160m, 80m, etc.) 1500 Watts PEP Transmitter Output (PEP) |
  • | 30-Meter Band (10.100 - 10.150 MHz) 200 Watts PEP Transmitter Output (PEP) |
  • | 60-Meter Band (5.3 MHz Channels) 100 Watts ERP Referenced to 0 dBd Dipole|
  • | Novice / Tech HF CW Subbands 200 Watts PEP Transmitter Output (PEP) |
  • | Beacon Stations (Part 97.203) 100 Watts PEP Transmitter Output (PEP) |
  • | 2200-Meter Band (135.7 kHz) 1 Watt EIRP Isotropic Radiated Power |
  • | 630-Meter Band (472 kHz) 5 Watts EIRP Isotropic Radiated Power |
  • +-----------------------------------------------------------------------------------------+
  • The Fundamental Power Standard: Minimum Power Necessary

Under 47 C.F.R. § 97.313(a) , regardless of the maximum theoretical limit of your license class or linear amplifier, an amateur station must use the minimum transmitter power necessary to carry out the desired communications at all times. If a solid contact can be maintained with 50 Watts, operating at 1500 Watts violates federal regulations.

Key Exceptions to the 1500 W PEP Limit:

30-Meter Band (10.100 – 10.150 MHz): Maximum transmitter power output is strictly limited to 200 Watts PEP . This restriction protects commercial, diplomatic, and military fixed-service stations that share this band as primary users.

60-Meter Band (5.3 MHz): Maximum power is 100 Watts Effective Radiated Power (ERP) .

Novice / Technician HF Subbands: On 80m, 40m, and 15m CW (and 10m phone/data), maximum power is 200 Watts PEP .

2. The 60-Meter Band Plan & Operating Protocols

The 60-meter (5.3 MHz) amateur allocation is structured completely differently from traditional amateur HF bands. Rather than a continuous band, the FCC allocates five discrete channels on a secondary basis to the Federal Government (NTIA). +-----------------------------------------------------------------------------------------+

  • | 60-METER (5.3 MHz) CHANNEL PLAN |
  • | |
  • | Channel USB Dial / Suppressed Carrier Channel Center Frequency Max Bandwidth |
  • | --------------------------------------------------------------------------------------- |
  • | Channel 1 5330.5 kHz 5332.0 kHz 2.8 kHz |
  • | Channel 2 5346.5 kHz 5348.0 kHz 2.8 kHz |
  • | Channel 3 5357.0 kHz 5358.5 kHz 2.8 kHz |
  • | Channel 4 5371.5 kHz 5373.0 kHz 2.8 kHz |
  • | Channel 5 5403.5 kHz 5405.0 kHz 2.8 kHz |
  • +-----------------------------------------------------------------------------------------+
  • Dial Frequency vs. Center Frequency in USB Voice

On standard modern transceivers operating in Upper Sideband (USB) voice, the radio display indicates the suppressed carrier frequency (the "dial frequency"). Because USB voice audio extends upward from the carrier by roughly 300 Hz to 2.8 kHz, the energy of a voice transmission is centered approximately 1.5 kHz above the dial frequency .

To transmit USB phone on Channel 1 (Center: 5332.0 kHz) , set your transceiver dial to 5330.5 kHz .

To transmit USB phone on Channel 2 (Center: 5348.0 kHz) , set your transceiver dial to 5346.5 kHz .

To transmit USB phone on Channel 3 (Center: 5358.5 kHz) , set your transceiver dial to 5357.0 kHz .

To transmit USB phone on Channel 4 (Center: 5373.0 kHz) , set your transceiver dial to 5371.5 kHz .

To transmit USB phone on Channel 5 (Center: 5405.0 kHz) , set your transceiver dial to 5403.5 kHz .

Important

CW and Digital Data Positioning on 60 Meters: For CW and digital modes (e.g., PSK31, FT8), the actual transmitted RF signal must be positioned precisely on the channel center frequency (e.g., exactly 5332.0 kHz, 5348.0 kHz, etc.). The total emission bandwidth for any mode on 60 meters must never exceed 2.8 kHz .

Effective Radiated Power (ERP) on 60 Meters

The power limit on 60 meters is 100 Watts ERP relative to a half-wave dipole (0 dBd) .

If you use a simple half-wave dipole (gain = 0 dBd), your transmitter power output can be up to 100 Watts PEP (minus feedline losses).

If you use a directional gain antenna (such as a multi-element beam or phased array), you must reduce transmitter power so that the radiated field strength does not exceed that of a 100 W dipole.

Example Calculation: If your antenna has a gain of 6 dBd (a power gain of 4 × 4\times 4 × ), your maximum allowable transmitter output power is: Power Out = 100 W 4 = 25 Watts PEP \text{Power Out} = \frac{100\text{ W}}{4} = 25\text{ Watts PEP} Power Out = 4 100 W ​ = 25 Watts PEP

3. Statutory Prohibitions on Amateur Transmissions (Part 97.113)

FCC Part 97.113 defines transmission types and content that are strictly prohibited in the Amateur Radio Service. Violating these prohibitions can result in civil monetary penalties, license revocation, or equipment seizure. +-----------------------------------------------------------------------------------------+

  • | PART 97.113 PROHIBITED TRANSMISSIONS |
  • | |
  • | Prohibited Category Rule / Description |
  • | ------------------------------------------------------------------------------------- |
  • | Pecuniary Interest / Hire No compensation (paid or promised) for operating |
  • | Broadcasting No one-way dispatches intended for the general public |
  • | Music / Entertainment Audio No playing recorded music or singing over the air |
  • | Commercial Activity No buying/selling goods (except personal amateur gear) |
  • | Obscenity / Indecency No profane, obscene, or indecent language |
  • | False Distress Signals No unauthorized MAYDAY, SOS, or fraudulent ID |
  • +-----------------------------------------------------------------------------------------+
  • 1. Pecuniary Interest and Commercial Prohibition

Amateur radio stations may never be used for hire or for material compensation , direct or indirect, paid or promised. You cannot accept payment to handle messages, provide communications for commercial businesses, or operate on behalf of an employer.

Exception for Classroom Teachers (Part 97.113(e)): An amateur who is a paid classroom teacher in an educational institution may direct and operate a school amateur station as an incidental part of teaching classroom curriculum, provided the teacher receives no extra compensation beyond their normal teaching salary.

Club Station Officers: Station trustees and club officers cannot receive salaries for managing amateur club stations.

2. Buying and Selling Gear (The Swap Net Exception)

Amateurs may buy, sell, or trade personal amateur radio apparatus and associated peripheral equipment on the air during designated "swap nets," provided such activity is non-commercial, occurs occasionally, and is not conducted on a regular commercial business basis.

3. Broadcasting

Broadcasting is defined as transmitting transmissions intended for direct reception by the general public. Amateur stations are prohibited from broadcasting news, political commentary, podcast audio, or sports to the public.

Permitted One-Way Bulletins: Transmitting official amateur news bulletins and Morse code practice sessions (such as those transmitted by W1AW) is specifically permitted because these bulletins relate exclusively to amateur radio and are directed at licensed operators.

4. Music and Audio Retransmission

Transmitting music (live, recorded, or background audio) is strictly prohibited. The only historical exception was incidental music transmitted during retransmissions of NASA space shuttle / space station audio authorized under special temporary authority.

Loading diagram... Transmitter Power Compliance and 60-Meter Operational Flowchart