Study guide

7.1 Helmets and Personal Protective Equipment

Ireland Driver Theory Test - Motorcycle and Moped Exam

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: Theory Test Logistics & Irish Licensing Framework

1.1 Category AM Theory Test Structure, Scoring & Testing Rules 1.2 Motorcycle Licence Categories & Progressive Access 1.3 Learner Permit Rules & Mandatory Initial Basic Training (IBT)

2 Chapter 2: Irish Rules of the Road, Signs & Traffic Controls

2.1 Regulatory, Warning and Information Signs 2.2 Road Markings, Yellow Box Junctions, Bus Lanes & Parking 2.3 Traffic Lights, Filter Arrows & Pedestrian Crossings

3 Chapter 3: Junctions, Roundabouts, Speed Limits & Motorways

3.1 Junction Navigation, Right of Way & Turning 3.2 Roundabouts: Approach, Lane Selection & Signalling 3.3 Speed Limits, Zones & Traffic Calming 3.4 Motorways, Dual Carriageways & Tunnels

4 Chapter 4: Safe Motorcycle Control, Positioning & Road Craft

4.1 Road Positioning & Space Cushions 4.2 Observation Routines, Mirrors & The Lifesaver Check 4.3 Cornering Dynamics, Counter-Steering & The Limit Point

5 Chapter 5: Braking, Stopping Distances & Overtaking

5.1 Braking Techniques, ABS & Stopping Distances 5.2 Overtaking Rules & Riding Between Lanes of Traffic

6 Chapter 6: Hazard Awareness, Road Surfaces & Environmental Conditions

6.1 Vulnerable Road Users & Sharing the Road 6.2 Road Surface Hazards & Low-Grip Traps 6.3 Adverse Weather Conditions & Night Riding

7 Chapter 7: Protective Equipment, Rider Conspicuity & Passenger Safety

7.1 Helmets and Personal Protective Equipment 7.2 High-Visibility Gear & Daytime Conspicuity 7.3 Pillion Passengers & Motorcycle Loading

8 Chapter 8: Motorcycle Roadworthiness & Pre-Ride Inspection

8.1 The POWDER Pre-Ride Inspection Routine 8.2 Tyres, Wheels and Suspension Integrity 8.3 Drive Chain, Controls and Fluid Maintenance

9 Chapter 9: Legal Responsibilities, Impairment & Emergency Procedures

9.1 Alcohol Limits, Drugs and Driver Impairment 9.2 Penalty Points, Novice (N) Period & Documentation 9.3 Eco-Riding, Collision Protocols & Scene Safety

7.1 Helmets and Personal Protective Equipment

Key Takeaways Explain This Topic AI

The RSA says it is the law that everyone on a motorcycle wears a properly fastened, approved crash helmet at all times, including a pillion passenger.

The Rules of the Road says an unsecured helmet is illegal, and riding without a helmet or carrying a passenger without one is a fixed-charge offence.

European helmets are approved under UN ECE Regulation 22 (22.05 or the newer 22.06), and a modular helmet may be ridden open only if its label shows P/J approval.

Use a clear visor and replace it if scratched: the Rules of the Road warns that a dark visor makes oil on a wet road almost impossible to see.

Never buy or lend a second-hand helmet, replace a damaged one, and choose CE-marked clothing, armour, gloves and boots that come above the ankle.

Last updated: September 2026

Helmets and Personal Protective Equipment

Motorcyclists are among the most vulnerable road users in Ireland. The Rules of the Road notes that motorcycles are fewer than 1 in 50 licensed vehicles, yet motorcycle users account for about 1 in 8 road deaths, and that in a crash motorcycle and moped users have less protection than drivers or passengers in vehicles. With no crumple zone, seatbelt or airbag, your helmet and protective clothing are the main barrier between you and the road.

The Helmet Law in Ireland

The RSA states that it's the law that everyone on a motorcycle wears a properly fastened, approved crash helmet at all times . For the rules on the use of crash helmets, the RSA points to S.I. No. 360 of 1978.

Rider and passenger: the rule covers everyone on the motorcycle, including a pillion passenger.

Fastened, not just worn: the Rules of the Road says an unsecured helmet is illegal and useless in a crash, because it can come off before your head hits the road.

Fixed-charge offences: using a motorcycle without wearing a crash helmet, and permitting a passenger to ride on a motorcycle without wearing one, are both fixed-charge offences.

Rider responsibility: if you carry a passenger, the Rules of the Road says you must make certain they are wearing a properly fitted crash helmet. +-------------------------------------------------------------------------+

  • | IRISH CRASH HELMET ESSENTIALS |
  • | |
  • | [ Approved helmet ] ----> Meets recognised safety standards |
  • | [ Securely fastened ] ----> An unsecured helmet is illegal |
  • | [ Rider AND passenger ] ----> Everyone on the motorcycle |
  • +-------------------------------------------------------------------------+
  • Recognised Helmet Standards

The RSA advises choosing a helmet that meets proper safety standards, and the Rules of the Road says to ensure all equipment meets EU standards. In Europe, motorcycle helmets are approved under UN ECE Regulation 22 :

ECE 22.05

The long-established European helmet standard. An approved helmet carries a label with a circled "E" and a number showing the country that granted the approval; E24 is Ireland.

ECE 22.06

The newer version of the regulation. It adds tests such as rotational (oblique) impacts and impacts at more than one speed, and it tests approved accessories such as internal sun visors with the helmet, so it represents a higher level of testing than 22.05.

Warning

A label from outside Europe on its own, such as a US "DOT" sticker, is not a European ECE approval, and novelty or decorative helmets give little protection. Choose a helmet with a genuine ECE approval label, buy from a reputable dealer, and never buy or use a second-hand helmet.

Helmet Types and Protection Profiles

Helmet Type Structural Design Facial & Chin Protection Best Use Case

Full-Face One-piece shell with integrated chin bar Highest : covers chin, jaw and face All road riding, especially at speed

Modular / Flip-Front Hinged chin bar that locks down Full protection only with the chin bar locked closed, unless the helmet is P/J approved Touring and commuting

Open-Face / Jet Shell covers the top, sides and back; no chin bar None for the chin and jaw Low-speed riding; eye protection required

Half Helmet Shallow skull cap Leaves the temples, lower head and face exposed Unlikely to carry ECE approval; avoid

Why the chin bar matters

Helmet crash research consistently finds that the chin and face area is often struck in a crash. An open-face helmet leaves the jaw, teeth and facial bones exposed to impact and abrasion. The Rules of the Road adds that if you wear an open-face helmet, you must wear eye protection.

Modular helmets and P/J approval

ECE approval labels show how a modular helmet may be used:

'P' (Protective): approved as a full-face helmet only, with the chin bar closed and locked.

'J' (Jet): approved as an open-face helmet.

'P/J': approved for use both closed and open, usually with a lock that holds the chin bar in the raised position.

Important

Ride with the chin bar raised only if the helmet's approval label shows P/J and the chin bar is locked open. A 'P'-only helmet is not approved for use with the chin bar raised.

Visors and Eye Protection

At 100 km/h you travel about 28 metres every second, so an insect or piece of grit hitting an unprotected eye can instantly cause a loss of control.

The Rules of the Road's helmet advice includes:

Use a helmet with a clear visor. If you use a dark visor, it will be almost impossible for you to see oil on a wet road.

Replace the visor if it is scratched. Scratches scatter the light from oncoming headlights into glare.

Clean your visor gently with warm soapy water. Solvents and abrasive cleaners can damage it.

Wear eye protection with an open-face helmet.

Tinted visors are labelled by their makers for daytime use only. In darkness, at dusk, and in rain or fog, use a clear visor. A Pinlock -style anti-fog insert helps stop the inside of the visor misting up in cold, damp weather.

Helmet Fit, Care and Replacement

The Rules of the Road tells you to buy from reputable dealers, try several different sizes and makes, and make sure the dealer knows how to assess fit.

The fitment checklist

Snug all round: firm, even contact around the crown, forehead and cheeks, with no gaps.

Skin movement test: with the strap undone, gently turn the helmet; your skin should move with the lining rather than the helmet sliding over your head.

No pressure points: wear it for a while in the shop; a red mark or headache means the shell shape does not suit your head.

Roll-off test: fasten the strap firmly, then try to roll the helmet forward off your head. If it comes off, the size or fit is wrong. +-------------------------------------------------------------------------+

  • | HELMET FITMENT VERIFICATION |
  • | |
  • | 1. Snug crown and cheeks ----> No gaps, firm contact all round |
  • | 2. Skin movement test ----> Skin moves with the liner |
  • | 3. Pressure check ----> No painful hot spots |
  • | 4. Roll-off test ----> Cannot be pulled forward off the head|
  • +-------------------------------------------------------------------------+
  • Care and replacement

The Rules of the Road's helmet rules are clear:

Never buy or use second-hand helmets , and never lend your helmet to someone else.

If your helmet is damaged, replace it. The foam liner absorbs an impact by crushing, and crushed foam does not recover, even if the shell looks fine after a drop or a crash.

Read the manual for your helmet and follow the care instructions, including the manufacturer's advice on when to replace it.

Do your research before you buy , and make sure all your equipment meets EU standards.

Protective Clothing

The RSA recommends that motorcyclists, and pillion passengers, wear approved motorcycle personal protective equipment (PPE), including a jacket and trousers, protective gloves and motorcycle boots. The Rules of the Road says:

Jackets and trousers should give you enough protection from impact, abrasion, cold and weather .

Use body armour on exposed areas such as the back, knees, elbows, shoulders, hips and shins, adjusted so it fits snugly and does not move in a crash.

Wear a good reflective jacket to make you more visible on the road.

Wear protective gloves , and footwear that comes above the ankle at least.

Use ear protection on long journeys, and do not use a personal entertainment system while riding.

Under Regulation (EU) 2016/425, motorcycle clothing sold as protective equipment must carry a CE mark showing that it meets the relevant European standard.

Garments: EN 17092

The European standard for motorcycle jackets, trousers and one-piece suits uses five classes:

  • Class What it means
  • AAA The highest protection class for abrasion, tear and seam strength
  • AA Medium protection, common for touring and everyday riding
  • A Lighter protection for urban riding
  • B Abrasion protection like Class A, but without impact protectors
  • C Garments designed to hold impact protectors in place, not to resist abrasion

Ordinary denim and fashion jackets are not designed to survive a slide along the road and can tear through very quickly.

Impact armour: EN 1621

EN 1621-1 covers limb protectors for the shoulders, elbows, hips and knees.

EN 1621-2 covers back protectors.

Protectors are rated Level 1 or Level 2 ; a Level 2 protector must pass on less force in testing, so it offers more protection.

Boots: EN 13634

Motorcycle boots certified to EN 13634 are tested for boot height, impact abrasion resistance, impact cut resistance and transverse rigidity (resistance to crushing). The RSA adds that boots should be free of laces , so they cannot get caught in the chain. Trainers and casual shoes give almost no protection when a motorcycle falls on your foot.

Gloves: EN 13594

Motorcycle gloves are certified to EN 13594 at Level 1 or Level 2 , and a KP marking shows knuckle protection. In a fall the hands usually hit the ground first, so look for palm sliders, knuckle protection and a wrist strap that stops the glove being pulled off.

Summary of PPE Standards

Equipment European Standard What to Look For Key Protective Function

Crash Helmet UN ECE Regulation 22.05 or 22.06 ECE label; P/J if you want to ride a modular helmet open Head impact protection

Visor Approved with the helmet Clear, unscratched visor for night and poor light Eye protection and clear vision

  • Riding Garment EN 17092 CE mark and class (AAA, AA, A, B or C) Abrasion and tear resistance
  • Limb Armour EN 1621-1 Level 1 or Level 2 Absorbs impacts at the joints
  • Back Protector EN 1621-2 Level 1 or Level 2 Protects the spine
  • Riding Boots EN 13634 CE mark; above the ankle; no laces Crush and abrasion protection
  • Riding Gloves EN 13594 Level 1 or 2; KP for knuckle protection Hand and wrist protection