Study guide
2.3 Required Aircraft Inspections & Maintenance Records
FAA Instrument Rating - Airplane IRA
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: Introduction & Instrument Rating Requirements
1.1 About the FAA Instrument Rating Knowledge Test 1.2 Aeronautical Experience & Certification Requirements 1.3 Instrument Recency & Currency Requirements
2 Chapter 2: IFR Preflight & Aircraft Equipment Requirements
2.1 14 CFR 91.205 Required IFR Instruments & Equipment 2.2 Inoperative Equipment, MELs & 14 CFR 91.213 2.3 Required Aircraft Inspections & Maintenance Records 2.4 VOR Equipment Accuracy Checks (14 CFR 91.171) 2.5 The Instrument Flight Deck Check & Flight Control Verification
3 Chapter 3: Pitot-Static, Gyroscopic & Magnetic Flight Instruments
3.1 Pitot-Static System Mechanics & Errors 3.2 Gyroscopic Instruments & Principles 3.3 Magnetic Compass Mechanics & Errors 3.4 Alternate Static Source & Instrument Malfunctions
4 Chapter 4: Electronic Flight Displays, AHRS & Automation
4.1 Electronic Flight Displays (PFD/MFD) & System Architecture 4.2 AHRS, ADC & Magnetometer Operation 4.3 Autopilot, Flight Director & Automation Management
5 Chapter 5: Attitude Instrument Flying & Partial-Panel Operations
5.1 Concept of Attitude Instrument Flying & Scanning Techniques 5.2 Pitch, Bank & Power Instrument Interpretation 5.3 Unusual Attitude Recoveries 5.4 Partial-Panel Instrument Flight & Systems Failures
6 Chapter 6: Aviation Meteorology & Atmospheric Hazards
6.1 Atmospheric Fundamentals, Pressure & Stability 6.2 Air Masses, Fronts & Frontal Weather 6.3 Structural & Induction Icing 6.4 Thunderstorms, Turbulence & Low-Level Wind Shear
7 Chapter 7: Aviation Weather Reports, Forecasts & Analysis Charts
7.1 Aviation Routine Weather Reports (METAR) & SPECI 7.2 Terminal Aerodrome Forecasts (TAF) & Aviation Forecasts 7.3 In-Flight Weather Advisories: AIRMETs, SIGMETs & PIREPs 7.4 Aviation Weather Charts & Graphic Products
8 Chapter 8: Ground-Based Navigation Systems
8.1 VOR Navigation Principles & Service Volumes 8.2 VOR Intercepting, Tracking & Radial Orientation 8.3 Distance Measuring Equipment (DME) Principles 8.4 Instrument Landing System (ILS) Ground Components
9 Chapter 9: Space-Based Navigation, GPS & RNAV Operations
9.1 Global Positioning System (GPS) Architecture & RAIM 9.2 Wide Area Augmentation System (WAAS) & SBAS 9.3 Area Navigation (RNAV) & Required Navigation Performance (RNP) 9.4 IFR Flight with GPS & Database Currency
10 Chapter 10: IFR En Route Charts, Airspace & Altitudes
10.1 IFR Low Altitude En Route Charts & Symbology 10.2 IFR Altitudes: MEA, MOCA, MAA, MRA, MCA & OROCA 10.3 Airspace Classification & IFR Operating Rules 10.4 IFR Cruising Altitudes & Oxygen Requirements
11 Chapter 11: ATC Clearances, Procedures & Lost Communications
11.1 IFR Flight Plan Filing & Activation 11.2 CRAFT Clearances & Departure Instructions 11.3 Mandatory IFR Position Reports & ATC Communications 11.4 14 CFR 91.185 Lost Communications Procedures 11.5 14 CFR 91.167 Fuel Requirements, Preferred Routes & Flight Planning Calculations
12 Chapter 12: IFR Departures, Arrival Procedures & Holding
12.1 Obstacle Departure Procedures (ODP) & Standard Instrument Departures (SID) 12.2 Standard Terminal Arrival Routes (STAR) 12.3 Holding Pattern Geometry, Speeds & Wind Drift Correction 12.4 Holding Pattern Entry Procedures: Direct, Teardrop & Parallel
13 Chapter 13: Instrument Approach Procedures & Navigation Profiles
13.1 Instrument Approach Plate Anatomy & Briefing 13.2 Precision Approaches: ILS Categories & Profiles 13.3 Non-Precision Approaches: VOR, LOC, RNAV (LNAV/LP) 13.4 APV Approaches: LPV, LNAV/VNAV & Baro-VNAV
14 Chapter 14: Approach Minimums, Landing Criteria & Missed Approaches
14.1 Visual Descent Point (VDP) & Circling Approaches 14.2 14 CFR 91.175 Landing Minimums & Visual References 14.3 Missed Approach Procedures & Rejected Landings 14.4 Engine-Inoperative Instrument Flight & Approaches (AMEL/AMES)
2.3 Required Aircraft Inspections & Maintenance Records
Key Takeaways Explain This Topic AI
The AVIATES inspection mnemonic summarizes the mandatory inspections required for IFR flight: Airworthiness Directives (ADs), VOR check (30 days), Inspections (Annual every 12 calendar months; 100-hour for hire), Altimeter/pitot-static system (24 calendar months), Transponder (24 calendar months), and ELT (12 calendar months / battery replacement).
Under 14 CFR 91.411, no person may operate an aircraft in controlled airspace under IFR unless the static pressure system, each altimeter, and each automatic pressure altitude reporting system has been tested and inspected within the preceding 24 calendar months.
Under 14 CFR 91.413, ATC transponders must be tested and inspected every 24 calendar months for operations in airspace requiring a transponder.
An annual inspection expires on the last day of the 12th calendar month following the month of the previous inspection (14 CFR 91.409(a)); a 100-hour inspection may only be exceeded by up to 10 hours for the purpose of flying to an inspection facility (91.409(b)), and excess hours are subtracted from the next 100-hour interval.
ELT batteries must be replaced or recharged when the transmitter has been in use for more than 1 cumulative hour or when 50% of their useful life has expired as established by the manufacturer (14 CFR 91.207(c)).
Last updated: August 2026
Required Aircraft Inspections & Maintenance Records
Airworthiness is not an assumption—it is a verifiable legal status documented in the aircraft maintenance logbooks. Under 14 CFR § 91.403 and § 91.405 , the owner or operator is primarily responsible for maintaining the aircraft in an airworthy condition, but the Pilot-in-Command (PIC) is solely responsible for determining whether the aircraft is in condition for safe flight prior to each departure (14 CFR § 91.7).
To conduct an IFR flight in controlled airspace, the pilot must review the aircraft records to confirm compliance with all mandatory periodic inspections.
1. The AVIATES Maintenance Framework
The standard aviation mnemonic AVIATES captures the mandatory periodic inspection cycles required for IFR flight: +-----------------------------------------------------------------------------+
- | AVIATES INSPECTION FRAMEWORK |
- | |
- | [A] Airworthiness Directives (ADs) ---> 14 CFR Part 39 (One-time/Recurring)|
- | [V] VOR Equipment Check ---> 14 CFR 91.171 (Preceding 30 Days) |
- | [I] Inspections (Annual / 100-Hr) ---> 14 CFR 91.409 (12 Cal Mos / 100 Hr)|
- | [A] Altimeter & Pitot-Static ---> 14 CFR 91.411 (24 Cal Mos for IFR) |
- | [T] Transponder Check ---> 14 CFR 91.413 (24 Cal Mos) |
- | [E] Emergency Locator Transmitter ---> 14 CFR 91.207 (12 Cal Mos / Batt) |
- | [S] Supplemental / Static System ---> Part 23 / ICA Life Limits |
- +-----------------------------------------------------------------------------+
- 2. Airworthiness Directives (14 CFR Part 39)
Airworthiness Directives (ADs) are legally enforceable federal regulations issued by the FAA under 14 CFR Part 39 to correct an unsafe condition found in an aircraft, engine, propeller, or appliance.
Types of ADs
One-Time ADs: Require a single specific modification, inspection, or part replacement. Once completed, no further action is required unless specified.
Recurring ADs: Require repetitive inspections or maintenance actions at fixed intervals (e.g., every 50 hours of time-in-service, every 100 hours, or every 12 calendar months).
Emergency ADs: Issued immediately when an urgent safety hazard requires immediate grounding or inspection prior to further flight.
Service Bulletins (SBs) vs. ADs
Service Bulletins (SBs): Issued by aircraft or component manufacturers. SBs are advisory recommendations for Part 91 general aviation operators and are not mandatory unless explicitly incorporated by reference into an FAA Airworthiness Directive.
3. Annual and 100-Hour Inspections (14 CFR 91.409)
Federal aviation regulations establish two distinct airframe and powerplant inspection cycles based on operational use.
The Annual Inspection (14 CFR 91.409(a))
Scope: Required for all civil aircraft operated under Part 91.
Interval: Every 12 calendar months , expiring on the last day of the 12th calendar month following the month of the previous inspection.
Calculation Example: If an annual inspection is signed off on May 12, 2025 , it remains valid through May 31, 2026 .
Sign-off Authority: Must be performed and approved for return to service by an Airframe & Powerplant (A&P) mechanic holding an Inspection Authorization (IA) , an approved Part 145 repair station, or the aircraft manufacturer.
The 100-Hour Inspection (14 CFR 91.409(b))
Scope: Required for aircraft operated for hire, carrying passengers for hire, or provided by a flight instructor for hire in flight training.
Interval: Every 100 hours of time-in-service .
Sign-off Authority: Can be performed and returned to service by any certificated A&P mechanic (IA is not required).
The 10-Hour Overfly Rule (91.409(b))
The 100-hour limit may be exceeded by a maximum of 10 hours solely for the purpose of flying the aircraft to a location where the inspection can be performed.
Mandatory Subtraction: Any excess time used must be subtracted from the next 100-hour interval.
Example: If a 100-hour inspection was due at 1,200.0 hours tachometer time, and the aircraft is flown to 1,208.0 hours to reach the maintenance base, the inspection is performed at 1,208.0 hours. The subsequent 100-hour inspection is due at 1,300.0 hours (1,200 + 100), NOT 1,308.0 hours.
Substitution Relationship
An Annual inspection can substitute for a 100-hour inspection .
A 100-hour inspection can NEVER substitute for an Annual inspection .
4. Altimeter & Pitot-Static System (14 CFR 91.411)
Under 14 CFR § 91.411 , specialized testing of the barometric pressure system is mandated for instrument flight:
Requirement: No person may operate an airplane in controlled airspace under IFR unless within the preceding 24 calendar months , each static pressure system, each altimeter instrument, and each automatic pressure altitude reporting system (altitude encoder / blind encoder) has been tested and inspected in accordance with 14 CFR Part 43, Appendix E .
Scope: Applies to any IFR operation in controlled airspace, even if flying in visual meteorological conditions (VMC).
Expiration: Valid until the last day of the 24th calendar month.
Example: Tested on August 15, 2024 → \rightarrow → Valid through August 31, 2026 .
5. ATC Transponder Inspection (14 CFR 91.413)
Under 14 CFR § 91.413 , any transponder operated in civil aircraft must be inspected:
Requirement: Tested and inspected within the preceding 24 calendar months in accordance with 14 CFR Part 43, Appendix F .
Scope: Applies to all aircraft operating in airspace where a transponder is required by 14 CFR 91.215 (Class A, Class B, Class C, within 30 NM Mode C Veil, and above 10,000 feet MSL).
Authorization: Must be conducted by an authorized Part 145 repair station, avionics technician, or manufacturer.
6. Emergency Locator Transmitter (14 CFR 91.207)
Under 14 CFR § 91.207 , the Emergency Locator Transmitter (ELT) is subject to both calendar inspection and battery replacement rules:
Annual ELT Inspection (91.207(d))
Inspected every 12 calendar months for:
- Proper installation and antenna integrity
- Battery corrosion
- Operation of the crash-impact inertial switch (G-switch)
- Sufficient radiated RF signal from its antenna
- ELT Battery Replacement / Recharge (91.207(c))
ELT batteries must be replaced (or recharged, if rechargeable) when:
The transmitter has been in use for more than 1 cumulative hour of operating time; OR
50% of the battery's useful life (or useful charge) has expired, as established by the manufacturer and stamped on the exterior of the battery casing.
Tip
ELT Operational Testing Rules: Airborne or ground operational testing of 121.5 MHz analog ELTs must only be conducted during the first 5 minutes past any hour , and is restricted to no more than 3 audio sweeps . Digital 406 MHz ELTs contain internal self-test circuits and should never be triggered over the air without following manufacturer self-test button sequences.
7. Comprehensive Inspection Summary Table
Inspection Item Regulation Calendar / Hourly Interval Performed / Approved By Applicable Scope
Airworthiness Directives 14 CFR Part 39 Per AD text (One-time/Recurring) A&P Mechanic / IA All applicable aircraft
- VOR Equipment Check 14 CFR 91.171 Preceding 30 days Pilot (or Mechanic) Required for IFR flights
- Annual Inspection 14 CFR 91.409(a) 12 Calendar Months A&P with IA / Repair Station All Part 91 aircraft
- 100-Hour Inspection 14 CFR 91.409(b) 100 Hours Time-in-Service A&P Mechanic Aircraft for hire / instruction
- Altimeter & Pitot-Static 14 CFR 91.411 24 Calendar Months Part 145 Repair Station IFR in controlled airspace
- Transponder Check 14 CFR 91.413 24 Calendar Months Part 145 Repair Station Airspace requiring transponder
- ELT Inspection 14 CFR 91.207(d) 12 Calendar Months A&P Mechanic All civil aircraft (with exceptions)
ELT Battery Replacement 14 CFR 91.207(c) 50% Life / 1 Hr Cumulative A&P / Pilot (if simple) As stamped on battery