Study guide

11.2 Reducing Environmental Impact & Environmental Management Systems

IOSH Managing Safely Exam

Track your progress as you read

Finished sections get a check mark.

1 Introduction & Exam Overview

1.1 What Is IOSH Managing Safely? 1.2 Exam Format & Dual Assessment 1.3 Certificate Validity & Study Plan

2 Chapter 1: Introducing Managing Safely

2.1 Moral, Legal & Financial Reasons 2.2 The Accident Cost Iceberg 2.3 Responsibility & Accountability

3 Chapter 2: Assessing Risks

3.1 Hazard, Hazardous Event & Risk 3.2 Five Steps of Risk Assessment 3.3 The 5×5 Likelihood × Consequence Matrix 3.4 Residual Risk, Suitable & Sufficient, Review

4 Chapter 3: Controlling Risks

4.1 ERICPD Hierarchy of Control 4.2 Reasonably Practicable 4.3 Safe Systems of Work (SSoW) 4.4 Permits to Work

5 Chapter 4: Understanding Responsibilities

5.1 Criminal vs Civil Law 5.2 Employer & Employee Duties 5.3 Enforcement, Improvement & Prohibition Notices 5.4 Knowledge Tests & Management Systems (HSG65 / ISO 45001)

6 Chapter 5: Hazard Categories, Noise, Vibration & Substances

6.1 Six Hazard Categories 6.2 Noise Hazards & Action Values 6.3 Hand-Arm & Whole-Body Vibration 6.4 Hazardous Substances, Asbestos & LEV

7 Chapter 6: Work at Height, Manual Handling, Fire & Electricity

7.1 Work at Height 7.2 Manual Handling, Slips & Trips 7.3 Fire Safety Basics 7.4 Electricity Hazards

8 Chapter 7: Stress, Work Equipment & Other Hazards

8.1 Work-Related Stress & Psychosocial Hazards 8.2 Work Equipment & Machinery 8.3 Confined Spaces, Workplace Transport & Welfare

9 Chapter 8: Investigating Incidents

9.1 Accidents, Incidents & Near Misses 9.2 Immediate, Underlying & Root Causes 9.3 Four-Step Investigation Process 9.4 RIDDOR Reporting Overview

10 Chapter 9: Measuring Performance

10.1 Active (Proactive) vs Reactive Indicators 10.2 KPIs & Characteristics of Good Metrics 10.3 Auditing the Safety Management System 10.4 Calculating Injury Incidence & Frequency Rates 10.5 Inspections & Benchmarking

11 Chapter 10: Protecting the Environment

11.1 Environmental Basics: Pollution, Waste & Duty of Care 11.2 Reducing Environmental Impact & Environmental Management Systems

12 Chapter 11: Risk Assessment Project & Exam Day

12.1 Project Requirements & Marking 12.2 Worked Example: Four-Hazard Assessment 12.3 Written Assessment Strategy & High-Yield Review

11.2 Reducing Environmental Impact & Environmental Management Systems

Key Takeaways Explain This Topic AI

The waste hierarchy in priority order is prevention, preparing for re-use, recycling, other recovery, then disposal as the last resort.

Regulation 12 of the Waste (England and Wales) Regulations 2011 makes applying the hierarchy a legal duty, declared on the waste transfer note.

ISO 14001 is the international environmental management system standard; ISO 45001 covers occupational health and safety, and both follow Plan–Do–Check–Act.

Environmental aspects and impacts are the environmental equivalent of hazard and risk, ranked by significance and controlled in priority order.

EMS benefits include compliance confidence, cost savings on waste and energy, fewer incidents, supply-chain credibility and continual improvement.

Last updated: August 2026

11.2 Reducing Environmental Impact & Environmental Management Systems

Quick Answer: The waste hierarchy is a legal priority order under regulation 12 of the Waste (England and Wales) Regulations 2011 : prevention, preparing for re-use, recycling, other recovery (for example energy recovery), disposal . Businesses must take all reasonable measures to apply it and declare that they have on the transfer note. An environmental management system (EMS) — ISO 14001 is the international standard — organises that effort using the same Plan–Do–Check–Act cycle as HSG65 and ISO 45001. Benefits: compliance confidence, lower cost, tender credibility and fewer incidents.

Section 11.1 covered what can go wrong and the legal minimum. This section covers the improvement half of the environment element: how a manager actually reduces pollution and waste, and how organisations hold that improvement in place with a system rather than good intentions.

The waste hierarchy — a legal priority order, not a poster

Under regulation 12 of the Waste (England and Wales) Regulations 2011, any business that produces, collects, transports, recovers or disposes of waste must take all reasonable measures to apply this order when transferring waste:

Rank Stage What it means Workplace examples

1 Prevention Do not create the waste at all Redesign packaging; buy the right quantity; fix leaks; reduce over-ordering; digital rather than printed documentation

2 Preparing for re-use Check, clean or repair items so they can be used again Repair pallets and totes; refurbish IT equipment; refill containers; donate surplus materials

3 Recycling Reprocess into a new material or product Segregated cardboard, metal, plastic, glass, wood

4 Other recovery Extract value, typically energy Energy-from-waste; anaerobic digestion where the output is not a quality-protocol product

5 Disposal Last resort Landfill; incineration without energy recovery

Two points examiners and auditors both care about:

Prevention sits at the top, disposal at the bottom. A site that recycles enthusiastically but still generates avoidable waste is working at level 3 when level 1 was available.

The duty is a legal one. Waste transfer notes carry a declaration confirming the hierarchy has been applied, and a business may only depart from the order where life-cycle thinking justifies a better overall environmental outcome.

Where a manager actually cuts impact

Lever Practical action Environmental and business gain

Purchasing and design Specify less hazardous substances, less packaging, longer-life equipment, returnable containers Removes waste and COSHH risk together

Segregation at source Clearly labelled, conveniently placed bins; keep paper, metal, plastic and glass separate Higher recycling value; lower disposal cost

Leak and spill prevention Planned maintenance on tanks, hoses, couplings and bunds Prevents the incident rather than cleaning it up

Energy and water Switch off routines, compressed-air leak surveys, lighting controls, temperature setpoints Direct cost reduction, visible to finance

Transport and logistics Fewer, fuller loads; route planning; idling policies Fuel, emissions and cost together

Contractor control Environmental requirements in the induction and the contract, not just the safety ones Contractor spills become your incident too

People Explain why , publish results, act on suggestions The same engagement that improves safety culture

Notice the pattern: almost every environmental control is an operational decision a line manager already owns. That is exactly why IOSH puts environmental basics in a management course.

Environmental management systems

An EMS is the structured way an organisation manages its environmental responsibilities — the environmental twin of the safety management system in Section 5.4.

ISO 14001 is the international standard for environmental management systems. It shares the same architecture as ISO 45001 (occupational health and safety) and the same Plan–Do–Check–Act logic as HSG65 , which is why organisations frequently run one integrated system rather than three separate binders.

PDCA stage Safety system (HSG65 / ISO 45001) Environmental system (ISO 14001)

Plan Policy, risk assessment, objectives, legal duties Environmental policy; identify environmental aspects and impacts ; register of legal requirements; objectives

Do Controls, competence, communication, emergency arrangements Operational control (storage, waste, drains, contractors); training; spill and incident response plans

Check Active and reactive monitoring, audit Monitoring emissions, waste and energy data; compliance checks; internal audit

Act Management review, corrective action, improvement Management review; corrective action on non-conformities; revised objectives

Aspects and impacts — the environmental risk assessment

The environmental equivalent of hazard and risk is aspect and impact :

An aspect is an element of your activity that can interact with the environment — storing diesel, running a boiler, generating solvent waste.

An impact is the change that results — contaminated groundwater, emissions to air, landfill burden.

You rank them by significance in much the same way you rank risk, then apply controls to the significant ones first. A manager who can run a 5×5 risk assessment already has the mental model.

Benefits of an EMS

  • Benefit Why it matters to the business
  • Legal compliance confidence Duties are identified, assigned and checked rather than remembered
  • Cost reduction Waste, energy, water and raw material savings are real cash
  • Fewer incidents Controls are designed and audited, not improvised during a spill
  • Market access Clients, tenders and supply-chain questionnaires increasingly require certification
  • Reputation Demonstrable performance rather than claims
  • Continual improvement Objectives and reviews stop the system decaying after year one
  • Employee engagement Visible progress on something people care about

Certification is not compulsory. A small business can run an effective, uncertified EMS; the value comes from the cycle — plan, do, check, act — not from the certificate on the wall.

Common exam traps

  • Trap Correction
  • "Recycling is the top of the waste hierarchy" Prevention is top; recycling is third of five

"The waste hierarchy is voluntary good practice" Regulation 12 makes applying it a legal duty, declared on the transfer note

"ISO 45001 covers the environment" ISO 45001 is occupational health and safety; ISO 14001 is the environmental standard

"An EMS is only for large certified companies" Any organisation can apply the PDCA cycle; certification is optional

  • "Environmental improvement always costs money" Prevention, energy and materials savings routinely reduce cost
  • Manager checklist

Can I recite the five stages of the waste hierarchy in order ?

Where in my area is waste being created that could have been prevented ?

Is segregation easy enough that people actually do it?

Do we know our significant environmental aspects and impacts ?

Does our system genuinely run Plan–Do–Check–Act , or does it stop after "Do"?

Are environmental requirements written into contractor inductions alongside safety ones?

Environment is the shortest element of Managing Safely, and it is the one most often skimmed. Learn the hierarchy order, the ISO 14001 label and the PDCA parallel, and you have the marks — and a set of decisions that quietly reduce cost as well as harm.