Study guide

9.3 Confined Spaces: The 2010 ICOP, Hazardous Atmospheres, Roles, Permits and Rescue

NIOSH Site Safety Supervisor SSS

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: The SSS Role & Malaysian OSH Legislation

1.1 The Site Safety Supervisor: Legal Appointment, DOSH Registration & Core Duties 1.2 OSHA 1994 as Amended by Act A1648: Structure, Duties, Rights & Penalties 1.3 Regulations Under OSHA 1994 That a Site Safety Supervisor Applies 1.4 CDM Regulations 2024: Duty Holders, Notification, Plans and Site Requirements

2 Chapter 2: OSH Management Systems, Human Factors & Risk Management

2.1 OSH Management Systems: Planning, OSH Policy, Site Organisation & Safety Committees 2.2 Human and Behavioural Factors in Construction Safety 2.3 HIRARC and the General Principles of Prevention 2.4 Safe Work Procedures and Permit-to-Work Systems 2.5 Monitoring, Accident Investigation, NADOPOD Reporting, Record Keeping & Audit

3 Chapter 3: Site Planning, General Control, Welfare & Communication

3.1 Site Initial Planning, Hoarding, Access and Vehicle & Plant Movement 3.2 General Control and Welfare: Housekeeping, Storage, Site Security, Welfare Facilities and First Aid 3.3 Safety Communication: Site Induction, Toolbox Meetings, Signs and Safety Promotion

4 Chapter 4: Working at Height & Fall Protection

4.1 Working at Height: Legal Basis, Fall Physics and the Fall-Control Hierarchy 4.2 Collective Fall Protection: Guardrails, Floor Openings, Nets and Catch Platforms 4.3 Personal Fall Protection, Ladders, MEWPs and Rescue from Height

5 Chapter 5: Scaffolding: Components, Design, Erection & Inspection

5.1 Scaffolding Types, Components, Foundations, Bracing and Tower Scaffolds 5.2 Scaffold Design, Loading, Competent Scaffolders and Safe Erection & Dismantling 5.3 Scaffold Inspection, Tagging Systems and Records

6 Chapter 6: Excavation, Shoring & Underground Services

6.1 Excavation Hazards, Soil Behaviour and Pre-Excavation Investigation 6.2 Protecting Excavation Sides: Battering, Benching, Shoring and Trench Support Systems 6.3 Deep Excavations, Retaining Systems, Cofferdams & Caissons, Monitoring and Rescue 6.4 Excavation Access, Edge Protection, Inspection Reports, Underground Services, Water and Air

7 Chapter 7: Piling, Formwork & Falsework, Concrete Work & Demolition

7.1 Piling Operations: Rigs, Working Platforms, Driven and Bored Piles 7.2 Formwork and Falsework: Temporary Works Design, Erection, Inspection and Loading 7.3 Concrete Work: Pre-Pour Checks, Pumping and Placing, Cement Health Hazards and Striking 7.4 Demolition and Dismantling: Surveys, Written Arrangements, Methods, Debris and Asbestos

8 Chapter 8: Lifting Operations, Work Equipment & Mobile Plant

8.1 Cranes and Hoists: Certificates of Fitness, Competent Operators, Ground and Crane Safety 8.2 Lifting Tackle and Rigging: Slings, Shackles, Hooks, Inspection and Discard 8.3 Lift Planning, Load Charts, Sling Angles and Crane Signalling 8.4 Work Equipment and Mobile Plant: Earthmoving Machines, Hand and Power Tools, Compressors and Guarding

9 Chapter 9: Electrical Safety, Fire & Hot Work, and Confined Spaces

9.1 Electrical Safety on Construction Sites: Temporary Supply, RCDs, Competent Persons and Safe Isolation 9.2 Fire Safety, Emergency Arrangements, Hot Work and Welding 9.3 Confined Spaces: The 2010 ICOP, Hazardous Atmospheres, Roles, Permits and Rescue

10 Chapter 10: Occupational Health Hazards & Controls

10.1 Physical Hazards: Noise, Vibration, Heat Stress, Radiation and Lighting 10.2 Musculoskeletal Hazards: Manual Handling and Ergonomics on Construction Sites 10.3 Chemical and Biological Hazards: USECHH, CLASS, Silica, Asbestos, Lead and Site Infections 10.4 Psychological Health: Psychosocial Hazards, Stress, Fatigue, Violence and Substance Misuse 10.5 Personal Protective Equipment and Site Emergency Response

11 Chapter 11: The SSS Examination: Paper 1, Site Assessment & Presentation

11.1 The SSS Examination: Entry Rules, Format, Retakes and Paper 1 Technique 11.2 Paper 2: Site Visit Practice, the Site Assessment and the Online HIRARC Presentation

9.3 Confined Spaces: The 2010 ICOP, Hazardous Atmospheres, Roles, Permits and Rescue

Key Takeaways Explain This Topic AI

Under the confined space ICOP 2010, a confined space is an enclosed or partially enclosed space at atmospheric pressure, not intended mainly as a place of work, that could hold harmful contaminants, have too little or too much oxygen, or cause engulfment, and that could have restricted entry or exit.

The ICOP defines a hazardous atmosphere as oxygen below 19.5% or above 23.5%, flammable gas above 10% of its lower explosive limit, toxic gas at or above its permissible exposure limit, or any other condition immediately dangerous to life or health.

Authorised entrants and standby persons must pass a course run by NIOSH or a DOSH-registered training provider, authorised gas testers and entry supervisors must also be registered with the Director General, and all four roles take a refresher course every two years.

Under the ICOP, an occupational health doctor issues a health fitness certificate valid for two years, and each authorised entrant declares in writing that they are fit before each entry.

The ICOP requires retrieval systems for non-entry rescue, with a mechanical device available to retrieve people from vertical confined spaces more than 1.5 metres deep.

Last updated: October 2026

Why confined spaces kill

Many confined space deaths follow the same pattern. One worker is overcome by gas or lack of oxygen, and co-workers who go in to help without breathing apparatus collapse too. DOSH's ICOP notes that deaths often follow inhaling toxic gases. The hazards are often invisible and odourless , and a space that was safe yesterday can be deadly today.

The Industry Code of Practice for Safe Working in a Confined Space 2010 is an approved industry code of practice under section 37 of OSHA 1994. Section 38 allows it to be used in proceedings, so departing from it without an equally safe method is hard to defend.

Recognising a confined space

The ICOP defines a confined space as an enclosed or partially enclosed space that:

  • is at atmospheric pressure during occupancy
  • is not intended or designed primarily as a place of work

is liable at any time to (i) have harmful levels of contaminants, (ii) have an oxygen deficiency or excess, or (iii) cause engulfment

could have restricted means for entry and exit

A person whose head or upper body is inside the space is treated as having entered it (paragraph 1.2.3). The ICOP does not apply to underground mining or to spaces not at atmospheric pressure.

The ICOP's examples include storage tanks, boilers and silos with manholes; open-topped spaces such as pits ; and pipes, sewers, tunnels, shafts and ducts . Construction examples:

  • manholes and sewers
  • sumps and wet wells
  • lift pits
  • box culverts
  • water tanks
  • basement tanks and pump rooms
  • deep narrow shafts and caissons
  • ducts and service tunnels
  • the inside of large precast units

Whether a trench or pit is a confined space depends on the assessment , not on a fixed depth.

Hazardous atmosphere

Under the ICOP a hazardous atmosphere is one that may expose workers to death, incapacitation, inability to self-rescue, injury or acute illness from:

  • Condition Limit
  • Oxygen Below 19.5% or above 23.5% by volume at sea level
  • Flammable or explosive gas More than 10% of its lower explosive limit (LEL)
  • Toxic gas At or above its permissible exposure limit (PEL)
  • Other Any atmosphere immediately dangerous to life or health (IDLH)

Typical construction sources:

  • hydrogen sulphide and methane in sewers and wet wells
  • carbon monoxide from petrol engines and generators
  • carbon dioxide and nitrogen that displace oxygen
  • solvent vapours from coatings and adhesives
  • oxygen used up by rusting steel or rotting matter
  • oxygen enrichment from leaking cutting gas

Other confined space hazards include engulfment in water, silt or granular materials; heat; machinery; and poor lighting and access.

Roles and training (ICOP section 12)

Role Duties Training and registration

Authorised entrant Enters and works in the space; knows the hazards; communicates with the standby person; leaves when ordered or when alarms or symptoms occur Course for authorised entrants and standby persons, run by NIOSH or a DOSH-registered training provider, with an examination

Standby person Stays outside throughout; keeps an accurate count of entrants matching the permit; communicates; orders evacuation on any prohibited condition, behavioural effects, outside danger or alarm; summons rescue ; performs non-entry rescue ; does no other duties that interfere Same course as entrants

Authorised gas tester (AGT) Tests the atmosphere Course for authorised gas testers and entry supervisors with an examination; registered with the Director General

Entry supervisor Accepts and signs the permit; checks conditions; organises the entry; terminates entry and cancels the permit if conditions change; closes the permit Same course as gas testers; registered with the Director General

Permit issuer Issues the permit after checking preparations Trained as both an entry supervisor and an AGT, and not the same person who supervises the entry

All four trained categories take a refresher course every two years , using a DOSH-approved module. The employer keeps training records.

Health fitness

An occupational health doctor issues a health fitness certificate valid for two years , after health surveillance using the ICOP's checklist (paragraph 11.3).

Each authorised entrant declares in writing that they are fit before each entry (paragraph 11.4).

Preparing the space

Assess first. Decide whether entry can be avoided, for example with remote cameras, long-reach tools or outside cleaning.

Isolate (ICOP section 7):

Positive isolation of pipes, ducts, drains and conveyors, by blanking or disconnecting. Closing a valve is not positive isolation.

De-energise and lock out or tag out machinery such as mixers and agitators, and deal with stored energy.

Clean, purge or ventilate to remove contaminants.

Ventilate. With continuous forced ventilation:

  • no entry until the ventilation has removed any hazardous atmosphere
  • air directed to where people work, from a clean source , and kept running until everyone is out
  • periodic retesting (paragraph 8.7.2)
  • never "sweeten" the air with oxygen

Test the atmosphere. The authorised gas tester tests from outside before anyone enters , in this order:

  • oxygen first
  • then flammable gases and vapours
  • then toxic gases and vapours

Test at several levels and record the results on the permit. Continue monitoring during entry, with personal gas detectors for entrants.

Equip. Provide lighting suitable for the atmosphere, communication equipment, means of entry and exit (ladders, a winch and tripod), PPE, and emergency and rescue equipment.

Sign-post. Post confined space warning signs while permitted work is in progress (paragraph 4.2.7).

The permit to work (ICOP sections 5 and 6)

The permit is issued by the permit issuer and accepted and signed by the entry supervisor, and posted at the entry portal .

Contents:

  • the space
  • the purpose of entry
  • the date and authorised duration
  • the names of the authorised entrants
  • the permit issuer, entry supervisor and standby person
  • the hazards
  • the isolation, purging and ventilation measures
  • acceptable entry conditions and test results
  • communication and rescue arrangements
  • equipment
  • other permits, such as hot work

Duration: no longer than the task or 8 hours , whichever is shorter. It can be extended once for up to 4 hours by the entry supervisor if conditions are unchanged.

The entry supervisor cancels the permit if a prohibited condition arises, and closes it when work is complete, followed by a debrief.

The confined space permit is the overriding permit over other permits, such as hot work.

Rescue

Retrieval systems for non-entry rescue are used whenever an authorised entrant enters, unless they would increase the overall risk or would not help the rescue (paragraph 10.8):

  • each entrant wears a chest or full-body harness with a retrieval line
  • the line is attached outside the space to a mechanical device or fixed point , so rescue can begin at once
  • a mechanical device must be available for vertical spaces more than 1.5 m deep

Rescue procedures must be planned in advance: who rescues, with what breathing apparatus, how the casualty is lifted, how the emergency services are called, and first aid and resuscitation.

Untrained, unprotected entry to rescue is forbidden. The standby person summons rescue and attempts non-entry rescue only.

Scenario: the sewer manhole

A pipe-laying crew needs to connect to an existing sewer through a 4 m deep manhole. The foreman suggests "just a quick look" without testing. The SSS stops the entry and arranges:

A permit issued by a trained permit issuer, with a separate registered entry supervisor.

Isolation of upstream flows by plugging, with the sewer operator's agreement.

Forced ventilation from a clean source, and pre-entry tests from the top in the order oxygen, then flammables, then H2S and CO. All readings must be within limits before entry.

A tripod and winch with full-body harness and retrieval line, because the space is vertical and more than 1.5 m deep.

A trained standby person at the opening with a radio, and a rescue plan with breathing apparatus.

Checks that the entrants hold current training certificates and two-year fitness certificates, and that each has signed the fitness declaration.