Study guide
13.1 Diagnostic Fitting Set Decontamination, OSHA & Clinical Infection Control
ABO-NCLE Advanced Contact Lens Certification Exam
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: Corneal Topography, Tomography & Anterior Segment Imaging
1.1 Placido-Based Corneal Topography: Axial, Tangential & Elevation Maps 1.2 Corneal Tomography & Scheimpflug Imaging: Anterior/Posterior Elevation & Pachymetry 1.3 Topographic Indices, Asphericity & Cone Localization
2 Chapter 2: Complex Corneal Conditions & Surgical Alterations
2.1 Keratoconus, Pellucid Marginal Degeneration & Keratoglobus 2.2 Post-Keratoplasty (PKP/DALK) & Corneal Cross-Linking (CXL) 2.3 Post-Refractive Ectasia & Post-Refractive Surgery Corneas
3 Chapter 3: Prefit Ocular Surface Evaluation & Candidacy Assessment
3.1 Slit-Lamp Biomicroscopy & Ocular Surface Vital Staining 3.2 Tear Film Dynamics, Dry Eye & Severe Ocular Surface Disease 3.3 Patient History, Visual Needs Analysis & Specialty Lens Selection Strategy
4 Chapter 4: Scleral Lens Design Fundamentals & Sagittal Depth
4.1 Scleral Anatomy, Terminology & Sagittal Depth Principles 4.2 Central Corneal & Limbal Vault Clearance Optimization 4.3 Landing Zone Toricity, Quadrant-Specific Haptics & Edge Profiles
5 Chapter 5: Corneal RGP & Specialty Toric Designs for Irregular Corneas
5.1 Corneal RGP Fitting Philosophies: Apical Clearance vs Bearing vs Three-Point Touch 5.2 Bitoric & High-Toric RGP Calculations: SPE vs CPE & Induced Cylinder 5.3 Lens Materials, Hyper-Dk Polymers & Surface Coatings
6 Chapter 6: Hybrid & Piggyback Contact Lens Systems
6.1 Hybrid Lens Architecture: Rigid Center & Soft Hydrophilic Skirt Fitting 6.2 Hybrid Parameter Selection, Movement & Tear Exchange Optimization 6.3 Piggyback Systems: Carrier Selection, Power Calculations & Hypoxia Prevention
7 Chapter 7: Orthokeratology & Custom Prosthetic Lenses
7.1 Orthokeratology Reverse-Geometry Principles, Jessen Formula & Topographic Patterns 7.2 Prosthetic, Occlusive & Custom Soft Specialty Lenses for Irregular Corneas
8 Chapter 8: Specialty Lens Delivery, Application & Removal Techniques
8.1 Scleral Lens Application Protocols, Plungers & Bubble Prevention 8.2 Scleral, Hybrid & RGP Removal Techniques & Emergency Extraction 8.3 Patient Handling Training, Hygiene & Lens Inspection at Dispense
9 Chapter 9: Filling Solutions, Chemical Disinfection & Wearing Schedules
9.1 Preservative-Free Scleral Reservoir Filling Solutions & Fluid Dynamics 9.2 Disinfection Regimens, Conditioning Systems, Hydra-PEG Care & Adaptation Schedules
10 Chapter 10: Slit-Lamp Fit Evaluation & Optical Troubleshooting
10.1 Settling Time Dynamics & Slit-Lamp Evaluation of Vault Clearance 10.2 Midday Fogging, Tear Reservoir Debris & Lens Surface Wettability 10.3 Over-Refraction, Lenticular Astigmatism & Lens Flexure vs Warpage
11 Chapter 11: In-Office & Laboratory Specialty Lens Modifications
11.1 In-Office Corneal RGP Modifications: Edge Blending, Polishing & Power Changes 11.2 Scleral Parameter Adjustments: Sagittal Depth, Landing Zones & Micro-Vaults 11.3 Ortho-K & Hybrid Fit Problem Solving and Parameter Modifications
12 Chapter 12: Acute Complications, Corneal Pathology & Emergency Triage
12.1 Corneal Hypoxia, Neovascularization & Graft Rejection Recognition 12.2 Mechanical Staining Patterns, Dimple Veiling, Impingement & Conjunctival Prolapse 12.3 Infectious Keratitis, Infiltrative Events & Acute Triage Protocols
13 Chapter 13: Clinical Infection Control, Regulatory Standards & Practice Management
13.1 Diagnostic Fitting Set Decontamination, OSHA & Clinical Infection Control 13.2 FCLCA, Contact Lens Rule, FDA Regulatory Standards & SOAP Documentation
13.1 Diagnostic Fitting Set Decontamination, OSHA & Clinical Infection Control
Key Takeaways Explain This Topic AI
FDA has noted that no harmonized industry standard addresses all in-office trial-lens disinfection and storage, so practices must use a validated lens- and product-compatible protocol.
Cleaning precedes disinfection; saline alone does not disinfect, and consumer lens-care products are not automatically FDA-cleared high-level disinfectants for multi-patient devices.
Menicon Progent is a 30-minute intensive cleaner for compatible GP lenses and must be followed by labeled cleaning and disinfection; it is not a stand-alone high-level disinfection claim.
For epidemic keratoconjunctivitis, CDC states that 70% isopropyl alcohol is not effective against adenovirus; use compatible manufacturer-approved methods such as 5,000 ppm chlorine or 70% ethyl alcohol for tonometer tips.
Hand hygiene, no-water handling, environmental disinfection, parameter verification, and complete reprocessing documentation are part of a safe contact-lens environment.
Last updated: September 2026
13.1 Diagnostic Lens Reprocessing & Clinical Infection Control
A multi-patient diagnostic lens contacts the tear film and may contact compromised epithelium. Safe reuse requires a written, validated protocol for the exact lens material, coating, cleaner, disinfectant, storage method, and local regulation. A generic household or patient-care routine is not enough.
Start With Risk and Instructions
The Spaulding framework classifies devices by tissue contact. Items contacting mucous membranes are generally semicritical and ordinarily require at least high-level disinfection when compatible. Contact-lens materials can be damaged by heat and some chemical sterilants, however, and the FDA has noted the absence of a harmonized industry standard covering all in-office trial-lens disinfection and storage.
Therefore, the clinic should reconcile:
- the diagnostic-lens manufacturer’s reprocessing instructions;
- the cleaner and disinfectant labeling;
- material and coating compatibility;
- state-board, facility, and infection-prevention requirements;
validation for the organisms and contact time of concern.
If the clinic cannot validate safe reuse, use a single-patient lens or do not reuse the lens.
Cleaning Comes First
Remove mucus, lipid, cosmetics, and other soil using a compatible cleaner and mechanical action specified by the manufacturer. Soil can shield organisms and reduce disinfection efficacy. Rinse with the specified sterile or approved solution. Saline removes residue but does not disinfect.
Inspect under magnification. Discard a lens that is chipped, crazed, cracked, warped, deeply scratched, or otherwise impossible to clean reliably. Record the lens identifier so the correct parameters return to the correct set.
Do Not Misclassify Care Products
A one-step hydrogen-peroxide contact-lens system disinfects compatible patient lenses when used with its dedicated case for the full labeled cycle. That labeling does not automatically make the product a high-level disinfectant for multi-patient medical-device reprocessing.
Menicon Progent combines hypochlorite and bromide and is used for intensive cleaning and protein removal on compatible GP lenses. Menicon specifies a 30-minute treatment and then directs cleaning and disinfection with Unique pH or another preferred labeled solution. Progent is incompatible with Hydra-PEG. Do not claim that it alone is an FDA-cleared high-level disinfectant that eradicates every Acanthamoeba cyst, virus, fungus, and biofilm.
Autoclaving may deform common GP materials, but the governing rule is again the lens manufacturer’s validated instruction. “Never autoclave any rigid lens” is broader than the evidence and should not replace material-specific guidance.
Storage Is Protocol-Specific
Drying reduces microbial growth in many storage systems, but neither CDC nor the American Academy of Optometry universally mandates dry storage for every diagnostic GP or scleral set. Storage must follow the validated protocol and lens/coating instructions. For example, Hydra-PEG manufacturer guidance calls for storage in a compatible solution and warns that dry storage can damage the coating.
Whether storage is dry or wet, use a clean labeled container, prevent tap-water exposure, replace contaminated or damaged cases, control solution dates, and reprocess the lens again if storage integrity is uncertain.
Ophthalmic Equipment and EKC
Noncritical slit-lamp surfaces such as chinrests, forehead rests, handles, and controls should be cleaned and disinfected between patients with a compatible EPA-registered product and its required wet-contact time.
Goldmann tonometer tips contact the ocular surface and require the instrument manufacturer’s validated process. During epidemic keratoconjunctivitis control, CDC recommends cleaning and then disinfecting tonometer tips for 5 to 10 minutes with 5,000 ppm chlorine or 70% ethyl alcohol when compatible and manufacturer-approved, followed by thorough rinsing in water and air drying. CDC specifically notes that 70% isopropyl alcohol is not effective against adenovirus and should not be relied on for EKC control.
For room surfaces during EKC, use an EPA-registered disinfectant effective against adenovirus and observe the full contact time. Cohort suspected patients and avoid moving contaminated equipment between rooms.
Hand Hygiene and PPE
Wash with soap and water for at least 20 seconds when hands are visibly soiled or after relevant exposure. Otherwise use an appropriate alcohol-based hand rub consistent with facility policy, then allow hands to dry before lens handling. Avoid touching a lens with wet hands and never rinse it with tap water. Use gloves and other personal protective equipment when exposure to blood, secretions, nonintact skin, or hazardous chemicals is anticipated.
OSHA’s Bloodborne Pathogens Standard applies to occupational exposure to blood and other potentially infectious materials. Maintain an exposure-control plan, training, sharps safety, post-exposure procedures, and appropriate PPE. It does not turn every tear-film contact into a bloodborne-pathogen event.
A Defensible Reprocessing Workflow
Segregate the used lens from clean stock and record its identifier.
Perform hand hygiene and use indicated PPE.
Clean and rinse using material-compatible products.
Inspect for damage and discard if integrity is compromised.
Apply the validated disinfectant at the correct concentration and full contact time.
Rinse, neutralize, dry, and store exactly as the protocol requires.
Reverify lens identity and parameters before the next use.
Document date, operator, products, lot or expiry when required, contact time, and any deviation.
Exam Traps
Progent is not a substitute for its labeled post-treatment disinfection step.
Consumer saline does not disinfect.
“Dry storage always” and “wet storage always” are both unsafe shortcuts.
Isopropyl alcohol is not reliable against adenovirus in EKC control.
A disinfectant is effective only at its validated concentration, contact time, and compatible use.
When reprocessing cannot be validated, do not reuse the diagnostic lens.