Study guide
1.1 About the NFPA CFI-I Exam & Certification
NFPA Certified Fire Inspector I CFI-I
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: Exam Overview & Test Strategy
1.1 About the NFPA CFI-I Exam & Certification 1.2 Reference Code Sets & Test Navigation Techniques
2 Chapter 2: Inspection Administration & Reports
2.1 Inspection Reports & Official Documentation 2.2 Permits and Plan Review Identification 2.3 Complaint Investigation Procedures
3 Chapter 3: Legal Authority, Enforcement & Court Procedures
3.1 Legal Authority, Code Adoption, and SRO Rules 3.2 Code Application, Retroactivity, and Appeals 3.3 Right of Entry, Warrants, and Court Testimony
4 Chapter 4: Water-Based Fire Suppression Systems
4.1 NFPA 13 Automatic Sprinkler System Types & Components 4.2 Sprinkler Heads, Spacing, and Clearances 4.3 NFPA 25 Inspection, Testing, and Maintenance
5 Chapter 5: Special Suppression Systems & Standpipes
5.1 Standpipe Systems & Fire Department Connections 5.2 Commercial Kitchen Exhaust & Wet Chemical Systems 5.3 Special Hazard Suppression & Clean Agents
6 Chapter 6: Fire Alarm Systems & Water Supplies
6.1 Fire Alarm Initiating Devices & Notification Appliances 6.2 Control Units, Power Supplies & System Monitoring 6.3 Water Supplies & Fire Flow Testing Calculations
7 Chapter 7: Portable Fire Extinguishers & System Plan Comparison
7.1 Portable Fire Extinguishers Selection, Placement & ITM 7.2 Comparing Approved Plans to Field Installations
8 Chapter 8: Hazardous Materials & Operational Hazards
8.1 Flammable and Combustible Liquids Storage & Handling 8.2 Compressed Gases & Liquefied Petroleum Gas 8.3 Hazardous Materials Identification, MAQs & Hazardous Processes
9 Chapter 9: Occupancy Classification, Construction & Sizing
9.1 Occupancy Classifications & Mixed Occupancies 9.2 Computing Occupant Load 9.3 Building Construction Types & Structural Fire Resistance
10 Chapter 10: Means of Egress Design & Illumination
10.1 Means of Egress Components & Capacity Sizing 10.2 Egress Arrangement, Travel Distance & Dead Ends 10.3 Emergency Lighting, Exit Signs & Interior Finishes
11 Chapter 11: Emergency Planning, Site Access & Inspection Procedures
11.1 Emergency Planning, Preparedness & Crowd Management 11.2 Emergency Vehicle Access & Site Infrastructure 11.3 Field Inspection Methodology & Compliance Determinations
1.1 About the NFPA CFI-I Exam & Certification
Key Takeaways Explain This Topic AI
The legacy NFPA CFI-I program is based on Chapter 4 of the 2014 edition of NFPA 1031 and uses four weighted domains: Administration 25%, Fire Protection Systems and Equipment 30%, Hazardous Substances and Materials 15%, and Occupancy Requirements 30%.
NFPA stopped accepting new CFI-I applications after June 30, 2026. Candidates whose applications were submitted on or before that date retain the normal 12-month period to finish, and the legacy exam remains available through June 30, 2027.
The exam is open book, contains 100 multiple-choice questions, allows four hours, and is delivered at Prometric test centers. NFPA reports pass/fail immediately but does not publish the passing score.
Certification requires 17 documented practicum activities: four administration activities and 13 field activities, completed and verified under the official workbook and proctor rules.
The newer NFPA Certified Fire Inspector program based on NFPA 1030 is a separate program with its own blueprint, references, exam, and practicum; it is not a renamed copy of the legacy CFI-I exam.
Last updated: October 2026
1.1 About the NFPA CFI-I Exam & Certification
Quick Summary: The legacy Certified Fire Inspector I (CFI-I) credential is based on the Fire Inspector I job performance requirements in Chapter 4 of the 2014 edition of NFPA 1031 . Its open-book Prometric exam contains 100 multiple-choice questions in four hours , and certification also requires 17 practicum activities . NFPA stopped accepting new CFI-I applications after June 30, 2026 ; previously accepted candidates receive their normal 12-month completion period, and the legacy exam remains available through June 30, 2027 . NFPA does not publish the score required to pass. Independent NFPA CFI-I prep by ExamFinch.
Program Status and Candidate Eligibility
The first task in responsible exam preparation is identifying the correct program. CFI-I is the legacy NFPA certification tied to NFPA 1031 (2014), Chapter 4 . It is not the newer Certified Fire Inspector (CFI) certification based on NFPA 1030, and it is not Certified Fire Inspector II.
NFPA's current CFI-I program page states that new applications were accepted only through June 30, 2026 . A person who submitted an application by that deadline has the standard 12-month candidacy period to complete the program. The CFI-I examination remains available at Prometric centers through June 30, 2027 . Existing credential holders may continue renewing on the normal three-year recertification cycle. A person who did not apply before the cutoff should investigate NFPA's current CFI or Certified First Responder Inspector programs and confirm which credential the employer or AHJ requires.
The official CFI-I program overview lists a high school diploma or equivalent as the education prerequisite. An approved candidate must follow the authorization and scheduling directions in the NFPA certification system; a study guide cannot create eligibility or extend an expired authorization.
Examination Format and Scoring
The official program overview specifies:
- Feature Legacy CFI-I requirement
- Delivery Computer-based testing at Prometric test centers
- Length 100 multiple-choice questions
- Time 4 hours
- Reference policy Open book, using the authorized editions for the candidate's selected code set
- Result Pass/fail result provided after completion
- Passing score Not published by NFPA
- Language English and Arabic listed in the program overview
Four hours for 100 items yields an average of 2.4 minutes per item, but this is a pacing calculation—not a statement about item weighting or the passing standard. The NFPA Certification Candidate Handbook expressly says NFPA does not publish the score required to pass. Do not build a plan around an assumed 70 percent cut score, a supposed curve, or an unofficial claim about the scoring method.
Prometric supplies an on-screen scientific calculator . Only reference materials authorized for this examination may enter the testing room. Candidates should use the exact NFPA program overview and current Candidate Handbook for rules governing printed books, permanent tabs, highlighting, personal items, and test-center procedures. Electronic references are not allowed unless NFPA expressly identifies an exception. Test-center staff control the examination environment and any supplied note materials.
Official Four-Domain Blueprint
The blueprint is weighted by domain, so study time should follow the same proportions:
Domain Weight 2014 NFPA 1031 JPRs and tested work
I. Administration 25% 4.2.1 report; 4.2.2 recognize permit need; 4.2.3 recognize plan-review need; 4.2.4 complaint; 4.2.5 applicable code or standard; 4.2.6 participation in legal proceedings
II. Fire Protection Systems and Equipment 30% 4.3.5 fixed fire suppression; 4.3.6 fire alarm; 4.3.7 portable extinguishers; 4.3.9 approved plan versus installation; 4.3.16 fire-flow verification
III. Storage, Handling, and Use of Hazardous Substances and Materials 15% 4.3.8 hazardous equipment, processes, and operations; 4.3.12 flammable and combustible liquids and gases; 4.3.13 hazardous materials
IV. Occupancy Requirements 30% 4.3.1 occupancy classification; 4.3.2 occupant load; 4.3.3 means of egress; 4.3.4 construction, alteration, and addition; 4.3.10 emergency planning; 4.3.11 emergency access; 4.3.14 hazardous fire-growth conditions; 4.3.15 code-compliance inspection
The blueprint contains 22 JPR topics . A JPR describes a field outcome, not merely a code-book chapter. For example, JPR 4.2.2 asks the inspector to recognize when a permit is required and communicate that requirement under adopted policy; it does not turn a Fire Inspector I into the official who approves every permit. Likewise, JPR 4.3.9 requires comparing an installed system with approved plans and documenting discrepancies, not redesigning the system in the field.
Authorized Reference Sets
The 2025 CFI-I program overview lists two authorized reference sets. The 2021 set uses NFPA 1 (2021), NFPA 13 (2019), NFPA 25 (2020), NFPA 72 (2019), and NFPA 101 (2021). The 2018 set uses NFPA 1 (2018), NFPA 13 (2016), NFPA 25 (2017), NFPA 72 (2016), and NFPA 101 (2018). Both sets also use the edition of the IFSTA Fire Inspection and Code Enforcement manual identified by NFPA. Candidates must prepare from the set connected to their exam authorization because section numbering and some technical values differ by edition.
The Exact 17-Activity Practicum
The official workbook contains four administration activities and 13 field-inspection activities. The required activities are:
Recognize the need for a permit (JPR 4.2.2).
Recognize the need for a plan review (JPR 4.2.3).
Investigate a fire-code complaint (JPR 4.2.4).
Participate in legal proceedings (JPR 4.2.6).
Inspect means of egress (JPR 4.3.3).
Inspect a building addition or remodeling project (JPR 4.3.4).
Inspect an existing water-based sprinkler system (JPR 4.3.5).
Inspect a fire alarm system (JPR 4.3.6).
Inspect portable fire extinguishers (JPR 4.3.7).
Inspect a commercial kitchen (JPR 4.3.8).
Compare an installed system with approved plans (JPR 4.3.9).
Verify emergency planning and preparedness (JPR 4.3.10).
Inspect emergency access for an existing site (JPR 4.3.11).
Inspect flammable and combustible liquid storage (JPR 4.3.12).
Inspect hazardous-material storage, handling, and use (JPR 4.3.13).
Identify hazardous fire-growth conditions (JPR 4.3.14).
Verify required fire flows (JPR 4.3.16).
The workbook requires the activities to cover at least three different buildings and to be evaluated under the official proctor criteria. The candidate and proctor should use the current workbook and affidavit rather than an unofficial checklist. All certification requirements must be completed during the candidate's 12-month eligibility period.
Retesting, Recertification, and the New CFI Program
The current legacy CFI-I page lists a $249 retest fee and a $225 recertification fee . Fees can change, so the certification system is controlling. The Candidate Handbook permits up to two additional examination attempts within the 12-month eligibility period, subject to its scheduling and fee rules. Certified individuals renew on a three-year cycle under the current recertification requirements.
NFPA 1031 has been consolidated into NFPA 1030, but the newer NFPA Certified Fire Inspector (CFI) credential is a separate certification program. Its program overview identifies a different examination length, blueprint, reference list, and practicum. Candidates should not assume that an old CFI-I authorization transfers to the new program or that the two blueprints are identical.
Independent NFPA CFI-I prep by ExamFinch.