Study guide
1.3 Admission Criteria, Coursework, Examinations & Reciprocity
New Jersey Water and Wastewater Operator Exam
Track your progress as you read
Finished sections get a check mark.
1 Chapter 1: NJDEP Regulatory Framework & Operator Licensing
1.1 NJDEP Licensing Framework & Operator License Types 1.2 System Classification: Point Ratings, Population Tiers & Class Levels 1.3 Admission Criteria, Coursework, Examinations & Reciprocity 1.4 Direct Responsible Charge, Staffing Requirements & Operator Duties 1.5 License Renewal, Training Contact Hours & Enforcement 1.6 New Jersey Water Statutes: WQAA, Lead Service Lines & PFAS
2 Chapter 2: Safe Drinking Water Act & NJPDES Discharge Compliance
2.1 Federal & State Drinking Water Regulations 2.2 NJPDES Discharge Standards & Wastewater Permitting 2.3 Monitoring, Public Notification & Violation Tiers
3 Chapter 3: Water Source Development, Coagulation & Flocculation
3.1 Surface Water Sources, Hydrology & Reservoir Dynamics 3.2 Groundwater, Wells & Source Water Protection 3.3 Coagulation Chemistry & Rapid Mixing 3.4 Flocculation & Solids Contact Clarification
4 Chapter 4: Sedimentation, Filtration & Advanced Water Treatment
4.1 Sedimentation Basin Hydraulics & Clarifier Design 4.2 Granular Media Filtration: Media, Underdrains, Operation & Backwash 4.3 Membrane Filtration: MF, UF, Nanofiltration & Reverse Osmosis 4.4 Specialty Treatment: Softening, Aeration & PFAS Remediation
5 Chapter 5: Water Disinfection, CT Calculations & Corrosion Control
5.1 Chlorination Chemistry & Alternative Disinfectants 5.2 Disinfection Kinetics & CT Compliance 5.3 Corrosion Control & Lead/Copper Stabilization
6 Chapter 6: Wastewater Preliminary & Primary Treatment
6.1 Raw Wastewater Characteristics & Preliminary Systems 6.2 Primary Clarification & Sedimentation 6.3 Flow Measurement & Equalization
7 Chapter 7: Secondary Biological Wastewater Treatment: Activated Sludge
7.1 Activated Sludge Fundamentals & Microbiology 7.2 Activated Sludge Process Control Parameters 7.3 Operational Troubleshooting & Aeration Modifications
8 Chapter 8: Fixed-Film Treatment, Biological Nutrient Removal & Effluent Disinfection
8.1 Trickling Filters: Media, Distribution, Ventilation & Troubleshooting 8.2 Rotating Biological Contactors & Hybrid Fixed-Film Systems 8.3 Biological Nutrient Removal: Nitrogen & Phosphorus 8.4 Wastewater Disinfection & Dechlorination
9 Chapter 9: Sludge Processing, Solids Handling & Biosolids Management
9.1 Sludge Thickening & Conditioning 9.2 Sludge Digestion (Aerobic & Anaerobic) 9.3 Dewatering & Biosolids Beneficial Reuse
10 Chapter 10: Water Distribution Networks & Hydraulics
10.1 Distribution System Design, Storage & Water Quality 10.2 Distribution Valves & Fire Hydrants 10.3 Water Main Installation, Testing, Disinfection & Repair 10.4 Cross-Connection Control & Backflow Prevention
11 Chapter 11: Wastewater Collection Systems, Pumping & Hydraulics
11.1 Gravity Sewer Design, Hydraulics & Manholes 11.2 Inflow, Infiltration, Overflows & Trenchless Rehabilitation 11.3 Wastewater Lift Stations & Wet Well Operations 11.4 Hydraulics, Flow & Head Calculations
12 Chapter 12: Pumps, Mechanical Equipment, SCADA & Electrical
12.1 Centrifugal Pumps: Principles, Components & Shaft Sealing 12.2 Positive Displacement Pumps, Priming & Ancillary Mechanical Equipment 12.3 Pump Hydraulics, Curves & Cavitation 12.4 Motors, Instrumentation & SCADA Systems
13 Chapter 13: Laboratory Analysis, Sampling & Water Quality Testing
13.1 Sampling Procedures, Chain of Custody & QA/QC 13.2 Drinking Water Laboratory Testing 13.3 Wastewater Laboratory Analysis
14 Chapter 14: Safety, Emergency Response & Utility Management
14.1 Confined Space Entry & Atmospheric Monitoring 14.2 Hazardous Chemicals & Chlorine Safety 14.3 Excavation, Lockout/Tagout, Electrical Safety & Work Zone Traffic Control 14.4 Emergency Response, Security & Utility Management
1.3 Admission Criteria, Coursework, Examinations & Reciprocity
Key Takeaways Explain This Topic AI
The 180-hour Introduction to Water and Wastewater Operations course is required for applicants with no degree above a high school diploma; the 90-hour advanced course is required for Class 2, 3, and 4.
Table IIIA requires 1 year total experience for Class 1, and for a high school credentialed applicant 6 years total for Class 3 and 10 years total for Class 4.
Direct responsible charge experience must be gained while holding a license no more than one grade lower than the license sought, at a system no more than one classification lower.
Candidates pay a non-refundable $70 NJDEP application fee and a $102 per-exam fee directly to PSI; renewal is $50, late renewal $20, and duplicate certificates $15.
New Jersey administers WPI (formerly ABC) standardized exams of 100 scored multiple-choice questions plus up to 10 unscored pre-test items, three hours long, passed with a score of 70 or greater.
Last updated: September 2026
- 1.3 Admission Criteria, Coursework, Examinations & Reciprocity
- Mandatory Coursework (N.J.A.C. 7:10A-1.15)
New Jersey ties examination admission to a high school credential, an approved course, and documented experience.
Introductory course. Any applicant holding no degree higher than a high school diploma, or not holding an associates degree , must successfully complete a Department-approved introductory course in the subject matter pertaining to the license being sought before applying to test. In practice this is the 180-hour "Introduction to Water and Wastewater Operations" course. NJDEP waives it for applicants holding, at a minimum, an associates degree in engineering or a related science field , or a bachelors degree in an unrelated field .
Advanced course. Any applicant for a Class 2, 3, or 4 license must complete a Department-approved advanced course in the subject matter of the license sought — the 90-hour "Advanced Water Operations" course for T and W licenses, or the corresponding advanced wastewater course for S, C, and N licenses.
VSWS course. VSWS applicants complete the 12-hour VSWS training course .
Industrial (N) course. Applicants for an industrial wastewater treatment system license must have completed a Department-approved industrial waste course before applying.
Waiver for equivalent training. Any of these course requirements may be waived if the applicant submits satisfactory proof of equivalent training — transcripts and course descriptions, including textbooks used.
Exam Trap Alert : The advanced course threshold is Class 2 , not Class 3. Candidates who memorize "advanced course for Class 3 and 4" will miss the Class 2 case, which is the single most common admission question on this topic.
Table IIIA — Experience Requirements for VSWS, S, T, C, and W
Classification Education Operating experience (years) Direct responsible charge experience (years) Total experience (years)
- VSWS HS diploma or equivalency 6 months 0 6 months
- Associates degree 6 months 0 6 months
- Bachelors degree 6 months 0 6 months
- Class 1 HS diploma or equivalency 1 0 1
- Associates degree 1 0 1
- Bachelors degree 1 0 1
- Class 2 HS diploma or equivalency 3 0 3
- Associates degree 2 0 2
- Bachelors degree 1.5 0 1.5
- Class 3 HS diploma or equivalency 3 plus 3 6
- Associates degree 2 plus 2 4
- Bachelors degree 1.5 plus 1.5 3
- Class 4 HS diploma or equivalency 6 plus 4 10
- Associates degree 4 plus 3 7
- Bachelors degree 3 plus 2 5
Associates and bachelors degrees in this table mean degrees from an accredited college resulting in an engineering or related science degree.
The Two Kinds of Experience
Operating experience is time spent in the satisfactory performance of operational duties at a system acceptable to the Board of Examiners: process control decisions, chemical dosing, sampling and testing, equipment operation, and routine maintenance.
Direct responsible charge (DRC) experience is active, daily, on-site supervision , including operation and maintenance responsibilities, at a system no more than one classification lower than the license sought — and it must be gained while holding a license no more than one grade lower than the license sought.
Exam Trap Alert : DRC experience is not merely "supervisory time." A T-2 licensee accumulating DRC hours at a T-1 plant is building qualifying time toward T-3. An unlicensed lead operator accumulates operating experience only, no matter how much crew supervision the job involves. This is why Class 3 and Class 4 ladders take a decade for a high-school-credentialed candidate: the DRC clock cannot start until the previous license is in hand.
Application, Fees, and Examination Administration
Apply to NJDEP. File the application with the Examinations & Licensing Unit with documentary evidence of education and experience, the appropriate signatory (usually the licensed operator in charge at the system, sometimes the owner or administrator), and the non-refundable $70.00 application fee . Applications submitted without the required documentation or fee are returned without substantive review. Applicants are advised at least two weeks in advance regarding admission to examinations.
Schedule with PSI. After the Board of Examiners approves the application, the candidate receives an Authorization to Test and schedules a computer-based examination at a PSI testing center, paying the $102 per-exam testing fee directly to PSI . PSI — not the Department — handles all exam scheduling.
Fee Schedule
- Service Cost
- Application fee (non-refundable) $70
- Initial license fee $50
- Renewal license fee (annual) $50
- Late fee for renewals $20
- Duplicate wall certificate $15
Application and initial license fees are currently waived for VSWS licenses .
Examination Format
New Jersey administers Water Professionals International (WPI, formerly ABC) standardized operator examinations at PSI testing centers. Each standardized exam is:
100 scored multiple-choice questions , plus up to 10 unscored pre-test questions scattered through the exam that WPI uses to develop future forms;
- three hours in length;
- passed with a score of 70 or greater ;
supported by an on-screen calculator and a formula/conversion table (hard-copy formula tables are also provided; personal calculators must be basic, with no graphing or alphanumeric functions);
written in US Standard units with metric equivalents in parentheses , each item solvable in either unit system.
N.J.A.C. 7:10A-1.4 requires the Department to offer examinations at least twice annually , and permits written questions, oral questions, or a combination. Roughly 15 to 16 percent of items on the standardized water and wastewater exams are calculation items.
WPI Content Areas by License Discipline (Class IV)
Discipline Content areas and scored-question counts
Water Treatment (T) Treatment Process 35 ; Equipment Operation and Maintenance 20 ; Laboratory Analysis 17 ; Source Water Characteristics 14 ; Security, Safety, and Administrative Procedures 14
Water Distribution (W) Water Quality Monitoring, Evaluation, Adjustment, and Laboratory Analysis/Interpretation 30 ; Security, Safety, Administrative Procedures, and Public Interactions 26 ; Distribution System Components 23 ; Equipment Installation, Operation, Maintenance, and Repair 21
Wastewater Treatment (S) Treatment Process Evaluation and Adjustment 42 ; Equipment Evaluation, Maintenance, and/or Operation 28 ; Laboratory Analysis 15 ; Security, Safety, and Administrative Procedures 15
Wastewater Collection (C) Equipment Operation, Evaluation, and Maintenance 23 ; Collection System Operation, Maintenance, and Restoration 23 ; Collection System Monitoring, Evaluation, and Adjustment 20 ; Security, Safety, and Administrative Procedures 18 ; Lift Station Operation and Maintenance 16
Use these weights to allocate study time. A wastewater treatment candidate who neglects process evaluation and adjustment is walking away from 42 percent of the exam; a distribution candidate who dismisses "administrative" material is walking away from 26.
Results, Retakes, and Three-Time Failure
Candidates are notified approximately four to six weeks after testing. Every examinee receives an analysis showing the number of correct and incorrect responses in each content area — the single most useful retake-planning document available, because it identifies which WPI content area failed. Actual examinations are never released for review.
An applicant who fails the same examination three times may not sit a fourth time until submitting proof of having retaken and satisfactorily completed the appropriate Department-approved training course for that license. The $70 application fee is due again for the initial exam and each time a three-time-failure refresher completion certificate is submitted for reexamination eligibility.
Reciprocity with Other States (N.J.A.C. 7:10A-1.11)
The Department may issue licenses to persons meeting the requirements of N.J.S.A. 58:11-69 . An out-of-state licensee applying for a New Jersey license must:
Meet the minimum New Jersey education and experience requirements for the license sought — the same Table IIIA ladder applies;
Have passed an examination deemed equivalent to a New Jersey examination ; and
Hold a license from a state that grants reciprocity to New Jersey licensees (New Jersey may grant reciprocity only on a mutual basis).
Exam Trap Alert : Reciprocity is not a transfer. It is a discretionary Department action that still requires the New Jersey education and experience minimums to be satisfied independently. A Class 4 license from a state with no reciprocity agreement buys nothing in New Jersey.