Study guide

2.6 Gait, Assistive Devices, Weight-Bearing Status

National Physical Therapy Examination for Physical Therapist Assistants NPTE-PTA

Track your progress as you read

Finished sections get a check mark.

1 Introduction & NPTE-PTA Orientation

1.1 NPTE-PTA Exam Overview 1.2 Content Outline & Domain Weights 1.3 PT vs PTA Scope of Practice (Critical) 1.4 Study Plan & How to Use This Guide

2 Chapter 2: Musculoskeletal System

2.1 Upper Extremity Conditions & PTA Interventions 2.2 Lower Extremity Conditions & Post-Op Protocols 2.3 Spinal Conditions 2.4 Manual Muscle Testing & ROM Goniometry for PTAs 2.5 Therapeutic Exercise Principles 2.6 Gait, Assistive Devices, Weight-Bearing Status

3 Chapter 3: Neuromuscular & Nervous System

3.1 Stroke (CVA) Rehabilitation 3.2 Spinal Cord Injury (SCI) 3.3 Traumatic Brain Injury & the Rancho Los Amigos Scale 3.4 Parkinson's Disease, MS, ALS, & GBS 3.5 Peripheral Neuropathies & Upper vs Lower Motor Neuron Signs 3.6 Balance, Coordination, & Vestibular Basics

4 Cardiovascular & Pulmonary Systems

4.1 Cardiac Anatomy & Physiology Refresher 4.2 Cardiac Rehabilitation Phases 4.3 Pulmonary Conditions & Airway Clearance 4.4 Monitoring During Exercise (PTA Critical) 4.5 Lab Values PTAs Must Recognize

5 Integumentary & Other Systems

5.1 Wound Classification & Staging 5.2 Burn Classification & PT Considerations 5.3 Lymphedema & Compression Therapy 5.4 Other Systems Quick-Hit (Endocrine, GI, GU, Hematology)

6 Equipment, Devices, & Therapeutic Modalities

6.1 Therapeutic Ultrasound 6.2 Electrical Stimulation Modalities 6.3 Superficial & Deep Heat / Cold 6.4 Mechanical Modalities: Traction, CPM, Compression Pumps 6.5 Assistive Devices & Orthotics Refresher

7 Safety, Professional Responsibilities, & Research

7.1 Supervision Standards (Critical for NPTE-PTA) 7.2 Infection Control & Standard Precautions 7.3 Patient Safety, Emergency Response & Documentation 7.4 Ethics & Professional Behavior 7.5 Evidence-Based Practice for PTAs

8 Exam-Day Strategy & Final Review

8.1 NPTE-PTA Test-Taking Strategy 8.2 Targeted Final Review by Domain 8.3 Exam Day Logistics & After the Exam

2.6 Gait, Assistive Devices, Weight-Bearing Status

Key Takeaways Explain This Topic AI

Weight-bearing statuses: non-weight-bearing (NWB) 0%; toe-touch weight-bearing (TTWB) ~10-15% body weight for balance only; partial weight-bearing (PWB) 30-50%; weight-bearing as tolerated (WBAT) patient-limited; full weight-bearing (FWB) 100%.

Axillary crutch fit: tip 2 inches lateral and 6 inches anterior to the shoe, axillary pad 2-3 fingerbreadths (~5 cm) below the axilla, elbow flexed 20-30 degrees; weight is borne on the hands, never the axilla.

A single-point cane is held in the hand OPPOSITE the affected lower extremity; the cane and the affected leg advance together to reduce hip abductor demand.

Walker height is set so the top reaches the wrist crease with arms hanging at the sides, producing 20-30 degrees of elbow flexion when grasped.

The Rancho Los Amigos gait cycle divides stance into initial contact, loading response, midstance, terminal stance, and pre-swing, and swing into initial, mid, and terminal swing.

Last updated: June 2026

Weight-Bearing Statuses

The surgeon or physical therapist (PT) sets the weight-bearing status; the PTA implements it and collects adherence data. Standard categories across U.S. PT practice:

  • Status Abbreviation Percent Body Weight Practical Description
  • Non-weight-bearing NWB 0% Surgical limb cannot touch the floor
  • Toe-touch weight-bearing TTWB / TDWB ~10-15% Toe rests on floor for balance only
  • Partial weight-bearing PWB 30-50% (often specified, e.g., 50%) A defined percentage applied through the limb
  • Weight-bearing as tolerated WBAT Variable Patient bears as much weight as is comfortable
  • Full weight-bearing FWB 100% No restriction

A bathroom scale at the parallel bars is a PTA-friendly way to teach a patient what an assigned percentage feels like before ambulating. Confusing TTWB with PWB is a classic trap: a toe-touch patient should never load 50% through the limb.

  • Assistive Device Fitting
  • Axillary Crutches

Tip placed about 2 inches lateral and 6 inches anterior to the shoe.

Axillary pad 2-3 fingerbreadths (~5 cm / 2 inches) below the axilla .

Hand grip set for 20-30 degrees of elbow flexion .

Weight borne through the hands, never the axilla — sustained axillary pressure can compress the radial nerve and brachial plexus ("crutch palsy").

Forearm (Lofstrand) Crutches

Cuff sits 1-1.5 inches below the olecranon.

Hand grip set for 20-30 degrees of elbow flexion.

Suited to patients with adequate upper-extremity strength who need a long-term aid.

Cane (Single-Point or Quad)

Held in the hand opposite the affected lower extremity.

Height equals the floor-to-wrist-crease distance (ulnar styloid level) with the arm relaxed; elbow flexed 20-30 degrees when grasped.

The cane and affected leg advance together to share load and reduce hip abductor demand, lowering the joint reaction force at the affected hip.

Walker

Top reaches the wrist crease with arms relaxed; 20-30 degrees elbow flexion when grasping.

Sequence: advance the walker first, then the affected leg, then the stronger leg.

A rolling walker fits a patient who cannot safely lift and advance a standard walker.

Common Gait Patterns

  • Pattern When Used
  • Two-point One crutch/cane and opposite leg advance together; mild bilateral involvement

Three-point Both crutches and the affected leg advance, uninvolved leg follows; NWB or restricted weight-bearing

  • Modified three-point Like three-point but the affected leg bears partial weight; PWB or WBAT
  • Four-point Reciprocal — right crutch, left leg, left crutch, right leg; most stable, bilateral involvement

Swing-to / Swing-through Both crutches advance, then both legs swing to or past them; spinal cord injury, bilateral LE weakness

Rancho Los Amigos Gait Cycle

The modern terminology used on the NPTE-PTA divides one cycle into eight phases:

Stance (~60%):

  • Initial contact (heel strike)
  • Loading response (foot flat)
  • Midstance
  • Terminal stance (heel off)
  • Pre-swing (toe off)

Swing (~40%):

  • Initial swing (acceleration)
  • Midswing
  • Terminal swing (deceleration)

Double-limb support occurs twice per cycle (loading response and pre-swing) and disappears at faster speeds, which is the kinematic boundary between walking and running.

Common Gait Deviations a PTA Documents

  • Deviation Common Cause
  • Trendelenburg gait (pelvic drop on swing-leg side) Weak hip abductors (gluteus medius) on the stance side
  • Antalgic gait (shortened stance time on painful side) Pain in the loaded limb
  • Foot drop / steppage gait Weak dorsiflexors, often peroneal nerve or L4-L5 involvement
  • Circumduction Functional leg-length discrepancy, weak hip flexors, or a knee that cannot flex
  • Knee hyperextension in midstance Quadriceps weakness, plantarflexion contracture
  • Forward trunk lean in stance Quadriceps weakness, hip flexor contracture, anterior knee pain

When a PTA observes a Trendelenburg sign during gait training, the appropriate action is to collect and document the finding and report it to the supervising PT, who decides whether to revise the plan of care — the PTA does not independently change the diagnosis or program.

Matching Device, Pattern, and Stairs to the Scenario

Device-selection items reward matching the level of support to the patient's weight-bearing order, balance, and upper-extremity strength, then applying the correct gait pattern and stair sequence.

Device by Stability Need (Most to Least Support)

  • Device Relative Support Typical Candidate
  • Standard / rolling walker Greatest Marked balance deficit, NWB/PWB lower extremity, deconditioning
  • Axillary crutches High Temporary NWB/PWB with good upper-extremity strength
  • Forearm crutches Moderate Long-term users, better UE function
  • Quad cane Low-moderate Hemiparesis, needs a wider base than a single cane
  • Single-point cane Least Mild balance or single-joint off-loading
  • Stair Sequence (Memorize)
  • Going UP: the uninvolved (stronger) leg leads , then the involved leg and device follow — "up with the good."
  • Going DOWN: the involved (weaker) leg and device lead , then the uninvolved leg follows — "down with the bad."

This sequence keeps the stronger leg doing the work of lifting and lowering the body, protecting the surgical limb and reducing fall risk. A PTA who reverses it forces the weak limb to control the descent or power the ascent.

Guarding and Safety

The PTA guards on the involved side and slightly behind the patient, using a gait belt, and clears the path before training. If a patient begins to fall, the PTA controls the descent toward the floor while protecting the head rather than trying to hold the patient fully upright. These safety behaviors and the device-fitting standards are PTA-implemented; reassigning the weight-bearing status or prescribing a different device class is a PT decision the PTA requests, not makes.