Study guide
5.1 Equipment, Devices & Technologies
NPTE Physical Therapy Exam Exam
Track your progress as you read
Finished sections get a check mark.
1 Introduction: NPTE Exam Overview
NPTE Physical Therapy Exam Overview NPTE Licensure Process Study Strategies & Test-Taking Tips Content Domains & Weight Distribution
2 Chapter 1: Musculoskeletal System
1.1 Musculoskeletal Anatomy & Kinesiology 1.2 Musculoskeletal Examination & Evaluation 1.3 Musculoskeletal Interventions 1.4 Common MSK Conditions & Management
3 Chapter 2: Neuromuscular & Nervous Systems
2.1 Neuroanatomy & Neurophysiology 2.2 Neurological Examination 2.3 Neurological Conditions 2.4 Neurological Interventions
4 Chapter 3: Cardiovascular & Pulmonary Systems
3.1 Cardiopulmonary Anatomy & Physiology 3.2 Cardiopulmonary Examination 3.3 Cardiopulmonary Interventions
5 Chapter 4: Integumentary & Other Body Systems
4.1 Integumentary System: Wound Care & Burns 4.2 Other Body Systems 4.3 Multi-System Conditions
6 Chapter 5: Non-Systems (Equipment, Safety & Professional Practice)
5.1 Equipment, Devices & Technologies 5.2 Therapeutic Modalities 5.3 Safety & Protection 5.4 Professional Practice & Ethics
5.1 Equipment, Devices & Technologies
Key Takeaways Explain This Topic AI
Assistive device progression (least to most support): cane → forearm crutch → axillary crutch → standard walker → rolling walker → platform walker
Cane fitting: elbow flexion 20-30 degrees when holding the cane; top of cane at greater trochanter or wrist crease
Canes are held on the OPPOSITE side of the affected lower extremity to reduce joint forces and improve gait pattern
Axillary crutch fitting: 2-3 finger widths below the axilla; weight borne on handgrips, NOT on axillary pads (axillary nerve/brachial plexus compression risk)
Walker types: standard (pick-up), front-wheeled, four-wheeled (rollator); rollators allow fastest gait but least stability
Weight-bearing status: NWB (0%), TDWB (toe touch only), PWB (up to 25-50%), WBAT (as tolerated), FWB (100%)
Wheelchair measurements: seat width = widest point of hips + 2 inches; seat depth = posterior buttock to popliteal fossa - 2 inches; footrest clearance = minimum 2 inches from ground
TENS (Transcutaneous Electrical Nerve Stimulation) uses the gate control theory of pain; conventional TENS uses high frequency (50-150 Hz), low intensity for pain modulation
Last updated: June 2026
The non-systems domain covers equipment selection, fitting, and training that spans across all clinical settings. This section focuses on assistive devices, wheelchairs, and electrotherapy modalities.
- Assistive Devices
- Canes
Fitting:
- Top of cane at the level of the greater trochanter or wrist crease when standing upright
- Elbow flexion of 20-30 degrees when holding the cane
- Held on the OPPOSITE side of the affected lower extremity
Why opposite side? Holding the cane contralateral to the affected leg reduces the compressive force on the affected hip joint by creating a counterbalancing moment arm. This also promotes a more normal reciprocal gait pattern.
Cane Types:
- Type Support Level Indications
- Single-point (straight) cane Minimal support Mild balance deficit, slight weight-bearing assist
- Small-base quad cane (SBQC) Moderate support Moderate balance deficit; freestanding
- Large-base quad cane (LBQC) Greater support Significant balance deficit; provides most stability
- Hemi-walker Maximum support (cane category) Hemiplegia, maximal stability needed from one-hand device
- Crutches
Axillary Crutch Fitting:
- 2-3 finger widths (approximately 2 inches) below the axilla
- Handgrips positioned for 20-30 degrees of elbow flexion
Critical safety point: Weight must be borne on the handgrips , NOT the axillary pads. Leaning on axillary pads compresses the axillary nerve and brachial plexus, potentially causing "crutch palsy" (radial/axillary nerve injury)
Forearm (Lofstrand) Crutches:
- Cuff encircles the forearm below the elbow
- Allows hand release without dropping the crutch
- Preferred for long-term crutch users (better energy efficiency)
- Common in patients with lower extremity paralysis, bilateral involvement
- Crutch Gait Patterns
- Pattern Description Weight-Bearing Status
- 2-point Right crutch + left foot, then left crutch + right foot PWB to FWB bilateral
- 3-point Both crutches + affected leg, then unaffected leg NWB, TDWB, PWB on one leg
- 4-point Right crutch, left foot, left crutch, right foot (one at a time) PWB bilateral, slowest/most stable
- Swing-to Both crutches forward, swing feet to crutches NWB bilateral, paraplegia
- Swing-through Both crutches forward, swing feet past crutches NWB bilateral, fastest, most energy
- Walkers
Type Characteristics Best For
Standard (pick-up) walker Must be lifted with each step; most stable Maximum support, poor balance, limited endurance for crutches
Front-wheeled walker Two front wheels, two rear tips; push forward Patients who cannot lift standard walker (weakness, coordination)
Four-wheeled (rollator) All four wheels, brakes, often with seat Community ambulation, endurance training, patients who need periodic rest
Wheelchair Fitting
- Measurement Guideline
- Seat width Widest part of hips/thighs + 2 inches
- Seat depth Posterior buttock to popliteal fossa - 2 inches (prevents pressure on posterior knee)
- Seat height Allows 2+ inches clearance between footrests and ground
- Back height Below the inferior angle of the scapula (standard); higher for trunk support if needed
- Armrest height Shoulders relaxed, elbows flexed 90 degrees
- Common Wheelchair Problems
- Problem Likely Cause
- Pressure on posterior knees Seat depth too long
- Difficulty reaching wheels for propulsion Seat width too wide
- Trunk lean to one side Seat too wide, scoliosis, weak trunk muscles
- Skin breakdown at ischial tuberosities Inadequate pressure relief, poor cushion
- Electrotherapy Modalities
- TENS (Transcutaneous Electrical Nerve Stimulation)
Mode Frequency Intensity Duration Mechanism
Conventional High (50-150 Hz) Low (sensory level) 30-60 min; can use continuously Gate control theory (large fiber activation blocks pain signals)
Acupuncture-like Low (1-10 Hz) High (motor level, visible contraction) 20-30 min Endorphin release (endogenous opioid system)
- Brief-intense High (100-150 Hz) High (highest tolerable) 15 min Gate control + counterirritant
- NMES (Neuromuscular Electrical Stimulation)
- Used to produce muscle contraction for strengthening, motor relearning, or preventing atrophy
- Frequency: 35-80 Hz
- On:Off ratio: 1:3 to 1:5 (to prevent fatigue), progressing to 1:1
Common applications: Quad strengthening post-TKA, dorsiflexor activation for foot drop, shoulder subluxation post-stroke
Interferential Current (IFC)
Uses two medium-frequency currents (e.g., 4000 Hz and 4100 Hz) that interfere to produce a low-frequency (100 Hz) current at depth
- Deeper penetration than conventional TENS
- Used for deep pain, edema, and muscle spasm
- Ultrasound (Therapeutic)
- Parameter Thermal Effects Non-Thermal Effects
- Frequency 1 MHz (deep, 3-5 cm) or 3 MHz (superficial, 1-2 cm) Same
- Duty cycle Continuous (100%) Pulsed (20% typical)
- Intensity 1.0-2.0 W/cm2 0.5-1.0 W/cm2
- Effects Increases tissue temperature, extensibility, blood flow Cavitation, acoustic streaming, tissue healing
- Indications Joint contracture, chronic inflammation Acute inflammation, wound healing
- Weight-Bearing Status and Device Selection
Selecting and progressing devices requires fluency with weight-bearing (WB) terminology , which is physician-ordered and dictates the appropriate device and gait pattern:
- Status Definition
- NWB (non-weight bearing) 0% — no contact of the limb with the floor
- TTWB / TDWB (toe-touch) Foot rests for balance only (~10-15% or "as if on eggshells")
- PWB (partial weight bearing) A defined percentage, commonly 25-50%
- WBAT (as tolerated) Patient self-limits by comfort
- FWB (full weight bearing) 100% as tolerated
NWB and TTWB statuses generally require a 3-point gait with axillary or forearm crutches (a walker can also be used). As the patient progresses to FWB and improved balance, the device is downgraded from walker to crutches to cane, and finally to no device — always advancing the cane on the side opposite the involved limb.
NMES, FES, and Biofeedback
Neuromuscular electrical stimulation (NMES) elicits a muscle contraction for strengthening and atrophy prevention; functional electrical stimulation (FES) times stimulation to a functional task, such as stimulating the dorsiflexors during the swing phase of gait for foot drop. A 1:5 on:off ratio limits early fatigue and is progressed toward 1:1.
Russian current (a 2500 Hz medium-frequency burst) targets strengthening of healthy muscle, while high-volt pulsed current (HVPC) is used for edema and wound healing. EMG biofeedback converts muscle electrical activity into visual or auditory signals, helping patients up-train weak muscles (e.g., quadriceps post-TKA) or down-train overactive muscles (e.g., upper trapezius, pelvic floor).
Robotics, Body-Weight Support, and Emerging Technology
Contemporary rehabilitation technology appears on the exam in concept. Body-weight-supported treadmill training (BWSTT) unloads a percentage of body weight via a harness to enable task-specific gait practice in patients with stroke, spinal cord injury, or Parkinson disease. Robotic exoskeletons and end-effector devices provide repetitive, high-dose movement practice consistent with motor-learning principles.
Tilt tables progressively reintroduce upright tolerance for patients with orthostatic intolerance after prolonged bed rest, and continuous passive motion (CPM) machines maintain joint range after surgery such as total knee arthroplasty. In every case, technology is an adjunct that should reinforce active, task-specific practice rather than replace it.