Study guide

14.3 Blow-Dry, Thermal Curling, Roller Placement, Perm Panel, Pin Curl Wave and Finger Wave

New York Cosmetology Exam

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: New York Licensing Law & Professional Requirements

1.1 GBL Article 27, Scope of Practice & Who Must Be Licensed 1.2 Qualifying for Licensure: Age, 1,000 Hours, Health Certificate & the Temporary Licence 1.3 The Written and Practical Examinations: Format, Fees, Admittance & Results 1.4 Licence Term, Renewal, Lapse, Fees & Out-of-State Applicants 1.5 State and Federal Payroll and New York Sales Tax Requirements 1.6 Professional Ethics, Conduct & the Domestic Violence and Sexual Assault Awareness Requirement 1.7 Career Opportunities, Placement, Professional Organizations & Trade Shows

2 Chapter 2: Safety and Health — New York Salon Regulation

2.1 Salon Facilities, Plumbing and Nail-Salon Ventilation Standards 2.2 Business Licensing, Bonds, Mandatory Postings, Inspections and Penalties 2.3 OSHA Hazard Communication, Safety Data Sheets, Chemical Storage & Labelling 2.4 Hygienic Practices, Sanitary Dress, Towels and Linens

3 Chapter 3: Infection Control

3.1 Types, Classification, Growth and Reproduction of Infectious Organisms 3.2 Viruses, Fungi, Parasites and Modes of Transmission 3.3 Immunity and Body Defenses 3.4 Decontamination Levels, Physical and Chemical Agents 3.5 New York Implement Reprocessing and Prohibited Items (§§ 160.17, 160.18) 3.6 Blood, Body Fluids and Client Contact Procedures (§ 160.19)

4 Chapter 4: Anatomy, Physiology & Nutrition

4.1 Cells, Tissues, Organs and the Body Systems 4.2 Bones of the Head, Face, Neck, Arms, Hands, Legs and Feet 4.3 Muscles of the Head, Face, Neck, Arms and Legs 4.4 The Circulatory System and Blood Supply of the Head, Face and Neck 4.5 The Nervous System and the Cranial Nerves 4.6 Basic Principles of Nutrition

5 Chapter 5: Chemistry as Applied to Cosmetology

5.1 Matter, Elements, Compounds, Mixtures and Chemical Reactions 5.2 Solutions, Suspensions, Emulsions and Oxidation-Reduction Reactions 5.3 The pH Scale and FDA Law Governing Hair Care Products

6 Chapter 6: Hair Analysis, Scalp and Hair Disorders

6.1 Hair Structure: Root, Shaft and the Three Layers 6.2 Chemical Composition, Side Bonds and Hair Pigment 6.3 Growth Cycles, Growth Patterns and Wave Patterns 6.4 Hair Analysis: Texture and Density 6.5 Porosity, Elasticity and Other Diagnostic Factors 6.6 Dandruff, Alopecia and Hair Shaft Disorders 6.7 Fungal Infections, Infestations and Bacterial Infections

7 Chapter 7: Shampoos, Rinses, Conditioners & Treatments

7.1 Client Preparation, Draping, Analysis and Consultation 7.2 Hair Analysis Instruments and Equipment 7.3 Shampoo, Rinse and Conditioner Products, Composition and Procedures 7.4 The Scalp, Manipulations and Treatments for Hair and Scalp Disorders

8 Chapter 8: Hair Cutting and Shaping

8.1 Fundamentals of Design: Reference Points, Lines and Sections 8.2 Elevation, Guidelines and Overdirection 8.3 Scissor Haircutting: Nomenclature, Care of Shears and Grip 8.4 Razor Haircutting, Clippers, Combs and Ergonomics 8.5 Scissor Techniques: Blunt, Graduated, Uniform and Long-Layered Cuts 8.6 Texturising, Clipper Cutting and Cross-Checking 8.7 Contemporary and Specialised Haircutting: Female, Male and Children's Styles 8.8 Shaving, Mustache and Beard Shaping

9 Chapter 9: Hair Styling

9.1 Wet Styling Science, Finger Waving and Skip Waving 9.2 Pin Curling 9.3 Roller Styling and Patterns in Hairstyling 9.4 Finishing Techniques 9.5 Tools, Implements and Blow-Dry Styling 9.6 Thermal Curling and Flat Ironing 9.7 Hair Pressing 9.8 Twisting, Wrapping, Weaving, Extending, Locking and Braiding 9.9 Hair Pieces, Wigs and Extensions

10 Chapter 10: Chemical Restructuring

10.1 The Chemistry of Chemical Restructuring 10.2 Chemical Restructuring Products and Processing Dynamics 10.3 Client Consultation and Preliminary Procedures for Chemical Services 10.4 Permanent Waving: Rods, Wrapping Techniques and Procedures 10.5 Chemical Relaxers: Products and Application 10.6 Curl Re-formation and Corrective Chemical Restructuring

11 Chapter 11: Hair Coloring and Lightening

11.1 Colour Theory and the Law of Colour 11.2 Tone, Intensity, the Level System and Underlying Pigment 11.3 Classifications of Haircolour: Temporary Through Permanent 11.4 Developer Chemistry, Vegetable Dyes and Metallic Salts 11.5 Client Consultation and Preliminary Procedures for Colour 11.6 Hair Lightening, Decolorisation and Toning 11.7 Special Effects: Foiling, Balayage and Dimensional Placement 11.8 Corrective Colour Procedures

12 Chapter 12: Nail Care and Procedures

12.1 Nail Structure, Growth, and Nail Shape and Colour Analysis 12.2 Nail Disorders and Diseases 12.3 Manicuring, Pedicuring and Manipulations of the Hand, Arm, Leg and Foot 12.4 Foot Spa Sanitation and New York's Prohibited Implements 12.5 Nail Tips, Wraps, Liquid and Powder Extensions and Gels

13 Chapter 13: Skin Care and Procedures

13.1 Structure and Function of the Skin 13.2 Skin Conditions and Disorders 13.3 Facial Procedures, Skin Analysis, Exfoliation and Enhancement Products 13.4 Temporary Methods of Hair Removal 13.5 Make-Up Application, Eyebrow Contouring and Lash Services

14 Chapter 14: The New York Practical Examination

14.1 Practical Exam Format, Scheduling, Admittance and Results 14.2 Work Area Setup, Mannequin Preparation and the Haircutting Procedure 14.3 Blow-Dry, Thermal Curling, Roller Placement, Perm Panel, Pin Curl Wave and Finger Wave 14.4 Chemical Service Simulations: Foiling, Haircolour Retouch and Relaxer

14.3 Blow-Dry, Thermal Curling, Roller Placement, Perm Panel, Pin Curl Wave and Finger Wave

Key Takeaways Explain This Topic AI

The blow-dry procedure dries the top from crown to front hairline plus one side using a round bristle brush, with water only and no products.

Thermal curling requires three barrel curls on base on the top and three spiral curls on the dried side, using an electric marcel iron.

Roller placement requires three 1⅛-inch rollers on the top starting at the front hairline, rolled away from the face, placed on base, half off base and off base.

The permanent waving panel on the left side uses five or more full-length rods of a single colour, with protective cream, cotton coil, simulated lotion and a test curl.

The demonstration procedures are left in place until the examiner instructs a take-down after the finger wave.

Last updated: August 2026

Blow-Dry, Thermal Curling, Roller Placement, Perm Panel, Pin Curl Wave and Finger Wave

Exam Focus: These six procedures run back to back with tight transitions, and each one ends with an instruction to clear the surface and set out the next procedure's supplies. Learn the exact counts — three barrel curls, three spiral curls, three rollers, five or more perm rods, three or more ridge curls, three or more C-shaping curls, one wave with two ridges.

1. Blow-Dry Styling Techniques (15 minutes)

Specification: blow-dry out the top, from crown to front hairline , and one side section — any starting point is acceptable — using a round bristle brush of any size .

Rule Detail

Re-wetting Permitted, but wet sparingly so the hair can be thoroughly dried in the time. Only water may be used — no products

  • Control Must show control of the procedure ; sectioning clips should be used . Random drying is not acceptable
  • Concentrator May be used; not required
  • Direction Dry the top and one side in a uniform manner, under or up

Steps: set up supplies if not already done and wait to be instructed; prepare the hair, re-wetting only if necessary and removing tangles; thoroughly dry the top and one side uniformly with the round bristle brush; remove implements no longer needed; plug in and turn on the marcel iron and set out thermal supplies.

2. Thermal Curling / Curling Iron Techniques (15 minutes)

Specification: a total of six curls — three barrel curls on base and three spiral curls — using an electric marcel iron . No stoves or spring grips will be allowed.

Element Requirement

Barrel curls Three, on base , on the top of the head, made scalp to end with manipulation of the iron, then clipped and left to cool

  • Spiral curls Three , on the dried side of the head, scalp to end , vertical and not clipped
  • Examiner presence One of each type demonstrated in the examiner's direct presence
  • Products None may be used

Finish: remove implements no longer needed; unplug the marcel iron , wrap it in a towel or cover it and pack it away; set out supplies for roller placement.

3. Demonstration of Techniques — Four Separate Operations

DOS groups the next four procedures together and adds a critical instruction: "You will leave in all procedures performed during this portion of the exam until instructed to take down by your examiner (this will be after the finger wave). You must perform each procedure on the designated section of the head."

Roller Placement — Top of Head (10 minutes)

Three full-size 1⅛-inch diameter rollers — they may be beige — on the top section , starting at the front hairline , all rolled away from the face . Only water — no products.

Set up supplies if not already done; wait to be instructed.

Place the first roller on base and secure.

Place the second roller ½ off base (½ on base) and secure.

Place the third roller off base and secure.

Remove implements no longer needed; set out supplies for permanent waving.

Chemical Restructuring: Permanent Waving — Left Side of Head (10 minutes)

Element Requirement

Draping Drape the mannequin for chemical procedures first. This draping remains for the duration of the examination

Rods Five or more full-length perm rods — all grey, all white, or all purple — completing the panel on the left side

Protection Protective cream (gel) and cotton coil , applied to the face area of the section or the entire block — either is permissible

  • Lotion Water from an applicator bottle simulates the waving lotion; applied when prompted
  • Test curl Performed in the examiner's direct presence
  • Gloves Must be worn while applying lotion and performing the test curl

Finish: remove implements no longer needed; set out supplies for the pin curl wave and C-shaping.

Diagonal Pin Curl Wave / C-Shaping — Right Side of Head (10 minutes)

Set up supplies; wait to be instructed.

Wet the hair if necessary and subsection.

First panel: form a diagonal ridge at the front hairline, then three or more overlapping clockwise ridge curls , approximately one inch in diameter , carved out of the ridge from the open end of the shaping .

Second panel: carve curls from a diagonal c-shaping behind the ridge curls — three or more overlapping counterclockwise carved pin curls .

Remove implements no longer needed; set out supplies for finger waving.

Product: hair styling gel, finger wave lotion or water may be used.

Finger Waving — Back of Head (10 minutes)

One wave — two ridges — starting at the open end of the molding on the back of the head . The wave may be horizontal, vertical or diagonal . Gel or finger waving lotion is optional ; water may be used instead of or in addition to them.

Set up supplies; wait to be instructed.

Wet the hair if necessary and comb smooth.

Form one wave with evenly spaced, defined ridges.

Remove implements no longer needed; set out supplies for foiling.

4. The Transitions Are Graded Too

Every procedure above ends with the same two-part instruction: remove supplies and implements from the work surface that are no longer needed , and set out supplies for the next procedure . Candidates who treat these as housekeeping rather than as part of the examination lose time on the following procedure and present a cluttered, non-compliant workstation while sanitation is being assessed throughout.

Build the transition into your practice runs. A rehearsed candidate finishes each procedure with the next one's kit already laid out and the previous one's implements bagged or stored.