Study guide

14.2 Work Area Setup, Mannequin Preparation and the Haircutting Procedure

New York Cosmetology Exam

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: New York Licensing Law & Professional Requirements

1.1 GBL Article 27, Scope of Practice & Who Must Be Licensed 1.2 Qualifying for Licensure: Age, 1,000 Hours, Health Certificate & the Temporary Licence 1.3 The Written and Practical Examinations: Format, Fees, Admittance & Results 1.4 Licence Term, Renewal, Lapse, Fees & Out-of-State Applicants 1.5 State and Federal Payroll and New York Sales Tax Requirements 1.6 Professional Ethics, Conduct & the Domestic Violence and Sexual Assault Awareness Requirement 1.7 Career Opportunities, Placement, Professional Organizations & Trade Shows

2 Chapter 2: Safety and Health — New York Salon Regulation

2.1 Salon Facilities, Plumbing and Nail-Salon Ventilation Standards 2.2 Business Licensing, Bonds, Mandatory Postings, Inspections and Penalties 2.3 OSHA Hazard Communication, Safety Data Sheets, Chemical Storage & Labelling 2.4 Hygienic Practices, Sanitary Dress, Towels and Linens

3 Chapter 3: Infection Control

3.1 Types, Classification, Growth and Reproduction of Infectious Organisms 3.2 Viruses, Fungi, Parasites and Modes of Transmission 3.3 Immunity and Body Defenses 3.4 Decontamination Levels, Physical and Chemical Agents 3.5 New York Implement Reprocessing and Prohibited Items (§§ 160.17, 160.18) 3.6 Blood, Body Fluids and Client Contact Procedures (§ 160.19)

4 Chapter 4: Anatomy, Physiology & Nutrition

4.1 Cells, Tissues, Organs and the Body Systems 4.2 Bones of the Head, Face, Neck, Arms, Hands, Legs and Feet 4.3 Muscles of the Head, Face, Neck, Arms and Legs 4.4 The Circulatory System and Blood Supply of the Head, Face and Neck 4.5 The Nervous System and the Cranial Nerves 4.6 Basic Principles of Nutrition

5 Chapter 5: Chemistry as Applied to Cosmetology

5.1 Matter, Elements, Compounds, Mixtures and Chemical Reactions 5.2 Solutions, Suspensions, Emulsions and Oxidation-Reduction Reactions 5.3 The pH Scale and FDA Law Governing Hair Care Products

6 Chapter 6: Hair Analysis, Scalp and Hair Disorders

6.1 Hair Structure: Root, Shaft and the Three Layers 6.2 Chemical Composition, Side Bonds and Hair Pigment 6.3 Growth Cycles, Growth Patterns and Wave Patterns 6.4 Hair Analysis: Texture and Density 6.5 Porosity, Elasticity and Other Diagnostic Factors 6.6 Dandruff, Alopecia and Hair Shaft Disorders 6.7 Fungal Infections, Infestations and Bacterial Infections

7 Chapter 7: Shampoos, Rinses, Conditioners & Treatments

7.1 Client Preparation, Draping, Analysis and Consultation 7.2 Hair Analysis Instruments and Equipment 7.3 Shampoo, Rinse and Conditioner Products, Composition and Procedures 7.4 The Scalp, Manipulations and Treatments for Hair and Scalp Disorders

8 Chapter 8: Hair Cutting and Shaping

8.1 Fundamentals of Design: Reference Points, Lines and Sections 8.2 Elevation, Guidelines and Overdirection 8.3 Scissor Haircutting: Nomenclature, Care of Shears and Grip 8.4 Razor Haircutting, Clippers, Combs and Ergonomics 8.5 Scissor Techniques: Blunt, Graduated, Uniform and Long-Layered Cuts 8.6 Texturising, Clipper Cutting and Cross-Checking 8.7 Contemporary and Specialised Haircutting: Female, Male and Children's Styles 8.8 Shaving, Mustache and Beard Shaping

9 Chapter 9: Hair Styling

9.1 Wet Styling Science, Finger Waving and Skip Waving 9.2 Pin Curling 9.3 Roller Styling and Patterns in Hairstyling 9.4 Finishing Techniques 9.5 Tools, Implements and Blow-Dry Styling 9.6 Thermal Curling and Flat Ironing 9.7 Hair Pressing 9.8 Twisting, Wrapping, Weaving, Extending, Locking and Braiding 9.9 Hair Pieces, Wigs and Extensions

10 Chapter 10: Chemical Restructuring

10.1 The Chemistry of Chemical Restructuring 10.2 Chemical Restructuring Products and Processing Dynamics 10.3 Client Consultation and Preliminary Procedures for Chemical Services 10.4 Permanent Waving: Rods, Wrapping Techniques and Procedures 10.5 Chemical Relaxers: Products and Application 10.6 Curl Re-formation and Corrective Chemical Restructuring

11 Chapter 11: Hair Coloring and Lightening

11.1 Colour Theory and the Law of Colour 11.2 Tone, Intensity, the Level System and Underlying Pigment 11.3 Classifications of Haircolour: Temporary Through Permanent 11.4 Developer Chemistry, Vegetable Dyes and Metallic Salts 11.5 Client Consultation and Preliminary Procedures for Colour 11.6 Hair Lightening, Decolorisation and Toning 11.7 Special Effects: Foiling, Balayage and Dimensional Placement 11.8 Corrective Colour Procedures

12 Chapter 12: Nail Care and Procedures

12.1 Nail Structure, Growth, and Nail Shape and Colour Analysis 12.2 Nail Disorders and Diseases 12.3 Manicuring, Pedicuring and Manipulations of the Hand, Arm, Leg and Foot 12.4 Foot Spa Sanitation and New York's Prohibited Implements 12.5 Nail Tips, Wraps, Liquid and Powder Extensions and Gels

13 Chapter 13: Skin Care and Procedures

13.1 Structure and Function of the Skin 13.2 Skin Conditions and Disorders 13.3 Facial Procedures, Skin Analysis, Exfoliation and Enhancement Products 13.4 Temporary Methods of Hair Removal 13.5 Make-Up Application, Eyebrow Contouring and Lash Services

14 Chapter 14: The New York Practical Examination

14.1 Practical Exam Format, Scheduling, Admittance and Results 14.2 Work Area Setup, Mannequin Preparation and the Haircutting Procedure 14.3 Blow-Dry, Thermal Curling, Roller Placement, Perm Panel, Pin Curl Wave and Finger Wave 14.4 Chemical Service Simulations: Foiling, Haircolour Retouch and Relaxer

14.2 Work Area Setup, Mannequin Preparation and the Haircutting Procedure

Key Takeaways Explain This Topic AI

Setup begins by removing pre-mixed surface sanitising solution from the kit and sanitising the assigned work surface.

A plastic bag for disposables and a container for blood contamination must both be set out during initial setup.

Hands are sanitised and the mannequin secured with a counter-top clamp and draped before further instructions.

The haircut establishes a zero-degree perimeter with an angled front, then a 90-degree layered cut using vertical partings.

A hanging length of six inches minimum and seven inches maximum must remain for the procedures that follow.

Last updated: August 2026

Work Area Setup, Mannequin Preparation and the Haircutting Procedure

Exam Focus: The haircut is the longest single procedure at fifty minutes, and it constrains everything after it: cut too short and the perm rods, rollers, foils and relaxer sections will not work. Learn the six-to-seven-inch remaining-length rule, the four or five allowable sections, and the prohibition on point cutting.

1. Preparation of Work Area and Client (10 minutes)

Begin immediately on assignment to your work area, without waiting to be told.

Step 1 — Sanitise the work surface. Remove the pre-mixed surface sanitising solution and related supplies from your kit and sanitise your assigned work surface following required procedures. Attach a plastic bag for disposables to your workstation at this time.

Step 2 — Set out supplies. Set out the general supplies you will use throughout the examination, plus the items needed for the haircutting procedure. Set out your container for blood contamination at this time. This satisfies 19 NYCRR § 160.19(c), which requires plastic bags and sealable rigid containers to be available at all times when services are performed, and whose absence is presumptive evidence of non-compliance.

Step 3 — Sanitise hands, clamp and drape. Sanitise your hands. Secure the mannequin to the workstation with a counter-top clamp . Drape the mannequin and wait for further instructions .

After the examiner has checked your workstation, you begin each procedure only when directed to do so .

What is being assessed here

Professional appearance — smock, closed-toe shoes covering the top of the foot, no bulky jewellery.

Correct hand sanitising with a product containing 60% or more alcohol .

Correct draping — the neck-strip-before-cape rule from 19 NYCRR § 160.20(d) applies to the mannequin as it would to a client.

A properly separated waste stream: plastic bag for disposables, rigid container for blood contamination .

Organised supply layout — implements accessible, sharp implements stored so as not to be exposed, per § 160.20(f).

Simulated products handled as if they were the actual product. DOS states this explicitly; treat gel standing in for relaxer with the same care as relaxer.

2. Hair Cutting Techniques (50 minutes)

You will use scissors to demonstrate ninety-degree layered haircutting techniques .

The specification

  • Element Requirement
  • Perimeter Established using a zero-degree guideline ; the front will be angled
  • Layers A layered cut, without bangs , using vertical partings to establish 90-degree elevation
  • Razor When prompted, demonstrate one or two sections using a razor , in the examiner's direct presence

Bulk removal Demonstrate removal of excess bulk using your choice of implement — thinning shears, razor or scissors — in the examiner's direct presence

  • Sections Four or five sections are allowable
  • Remaining length Six inches minimum, seven inches maximum hanging length must remain
  • Prohibited Point cutting is not allowed on this examination
  • The nine steps

Set up all supplies and implements needed if not already done. Wait until instructed before moving forward.

Part the hair into sections — four or five.

Establish the perimeter using a zero-elevation guideline , starting at the nape and continuing in either direction.

Establish layered length using the guideline from the perimeter. You may cut from the crown down or from the nape up .

Establish a ninety-degree elevation using vertical partings.

When prompted, and in the examiner's direct presence, use a razor to continue the ninety-degree layered cut.

Demonstrate the removal of excess bulk — thinning shears, razor or scissors — in the examiner's direct presence .

Remove hair clippings from skin, cape and work area; sweep the floor surrounding your work area ; re-sanitise your hands after cleanup .

Remove supplies and implements no longer needed from the work surface and set out supplies for blow-drying .

Where candidates lose marks

Error Consequence

Cutting too short Six inches minimum must remain. Too short and the perm rods, rollers, foils, colour retouch and relaxer sections that follow cannot be executed

Point cutting Expressly prohibited on this examination

Missing the razor or bulk-removal demonstration in the examiner's presence Both are specified as direct-presence demonstrations

  • Inconsistent elevation Vertical partings held at anything other than 90 degrees produce an uneven layer length
  • Skipping the clean-up step Step 8 is graded: clippings removed, floor swept, hands re-sanitised
  • Failing to re-sanitise hands after cleanup Explicitly required at step 8

Leaving unnecessary implements out Step 9 requires clearing the surface and setting out the next procedure's supplies

  • Handling razors carelessly Sanitation and safety are graded throughout every procedure
  • Practising to the specification

Practise on a mannequin identical to the one you will bring — uncut, unprocessed, solid-colour human hair, minimum eight inches from the nape — and time yourself. Fifty minutes is generous for the cut itself and tight once the setup, the two direct-presence demonstrations, the clean-up and the transition to blow-dry supplies are included. Rehearse the whole sequence, not just the cutting.