Study guide

4.3 GHS Labels, Signal Words & 9 GHS Pictograms

OSHA 511 Occupational Safety and Health Standards for General Industry Exam

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: OSH Act, Regulatory Framework & Inspection Procedures

1.1 OSH Act Purpose, Scope & General Duty Clause 1.2 OSHA Inspections, Priorities & Inspector Credentials 1.3 Citation Categories, Penalty Calculations & Contesting Procedures 1.4 Employer Rights, Employee Rights & Whistleblower Protections 1.5 Navigating 29 CFR: Standards Organization, Codification & Rulemaking 1.6 Safety & Health Programs, Cooperative Programs & Multi-Employer Worksites

2 Chapter 2: OSHA Recordkeeping & Reporting (29 CFR Part 1904)

2.1 Recording Criteria, Exclusions & First Aid vs. Medical Treatment 2.2 OSHA Recordkeeping Forms (Forms 300, 300A, 301) & Annual Summary Posting 2.3 Severe Injury Reporting Timelines, Privacy Cases & Electronic Submission

3 Chapter 3: Walking-Working Surfaces & Emergency Preparedness (Subparts D & E)

3.1 General Walking-Working Surface Requirements & Housekeeping (1910.22) 3.2 Ladders, Stairways, Scaffolds & Dockboards (1910.23-26) 3.3 Fall Protection Systems, Falling Object Protection & Training (1910.28-30) 3.4 Exit Routes, Emergency Action Plans (EAPs) & Fire Prevention Plans (1910.34-39) 3.5 Fire Protection (Subpart L): Extinguishers, Fixed Systems, Detection & Employee Alarms (1910.155-1910.165)

4 Chapter 4: Hazard Communication & GHS Standard (29 CFR 1910.1200)

4.1 Hazard Communication Standard Overview & Written HazCom Program 4.2 GHS Chemical Hazard Classification & Physical vs. Health Hazards 4.3 GHS Labels, Signal Words & 9 GHS Pictograms 4.4 Safety Data Sheets (16-Section SDS Format) & Employee Information/Training

5 Chapter 5: Personal Protective Equipment & Respiratory Protection (Subpart I)

5.1 Hierarchy of Controls & Hazard Assessment Certification (1910.132) 5.2 Eye, Face, Head, Foot & Hand Protection Standards (1910.133-138) 5.3 Respiratory Protection Program, Fit Testing & Medical Evaluations (1910.134) 5.4 Assigned Protection Factors (APFs), Maximum Use Concentrations & Respirator Selection

6 Chapter 6: Control of Hazardous Energy / Lockout/Tagout (29 CFR 1910.147)

6.1 Energy Control Program & Authorized vs. Affected Employee Roles 6.2 Lockout/Tagout Procedural Steps & Stored Energy Isolation 6.3 Special LOTO Situations: Group LOTO, Shift Changes & Outside Contractors 6.4 Periodic Annual Inspection, LOTO Hardware & Removal of Energy Controls

7 Chapter 7: Permit-Required Confined Spaces (29 CFR 1910.146)

7.1 Confined Space vs. Permit-Required Confined Space (PRCS) Identification 7.2 Atmospheric Testing Sequence, Testing Equipment & Acceptable Limits 7.3 PRCS Entry Roles: Entrant, Attendant, Entry Supervisor & Permit System 7.4 Non-Entry Rescue, Retrieval Systems & Emergency Response Services

8 Chapter 8: Electrical Safety & Safe Work Practices (Subpart S)

8.1 General Electrical Safety, NRTL Listing & Equipment Guarding (1910.303) 8.2 System Grounding, Ground-Fault Circuit Interrupters (GFCIs) & Wiring (1910.304-305) 8.3 Electrical Safe Work Practices, Qualified Persons & Approach Boundaries (1910.331-335) 8.4 Arc Flash Hazards, Personal Protective Equipment & Rubber Insulating Gloves

9 Chapter 9: Machine Guarding & Materials Handling (Subparts N & O)

9.1 General Machine Guarding Requirements & Safeguard Types (1910.212) 9.2 Mechanical Power Presses, Point of Operation & Power Transmission Guarding (1910.217, 1910.219) 9.3 Powered Industrial Trucks (Forklifts): Operator Training, Retraining & Safe Operation (1910.178) 9.4 Materials Handling, Storage, Slings & Overhead Cranes (1910.176, 1910.179, 1910.184) 9.5 Hand & Portable Powered Tools (Subpart P, 1910.241-1910.244)

10 Chapter 10: Occupational Health, Industrial Hygiene & Process Safety (Subparts G & Z)

10.1 Occupational Noise Exposure, Sound Levels & Hearing Conservation Program (1910.95) 10.2 Toxic & Hazardous Substances, Table Z-1 PELs & Industrial Hygiene Paradigm (1910.1000) 10.3 Specific Health Standards: Asbestos, Lead, Bloodborne Pathogens & Methylene Chloride 10.4 Process Safety Management (PSM) of Highly Hazardous Chemicals (1910.119 - 14 Elements) 10.5 Flammable Liquids (1910.106) & Welding, Cutting, and Brazing Safety (1910.252) 10.6 Hazardous Materials (Subpart H): Compressed Gases, Spray Finishing & HAZWOPER (1910.101, 1910.107, 1910.120) 10.7 General Environmental Controls & First Aid: Sanitation, Color Codes, Signs & Tags, Medical Services (Subparts J & K)

4.3 GHS Labels, Signal Words & 9 GHS Pictograms

Key Takeaways Explain This Topic AI

29 CFR 1910.1200(f) requires six mandatory label elements on all shipped containers of hazardous chemicals.

GHS standardizes signal words to two specific terms: 'Danger' for severe hazard categories and 'Warning' for less severe hazard categories.

OSHA recognizes nine GHS pictograms, eight of which are mandatory under OSHA enforcement; the Environment pictogram is non-mandatory as aquatic environmental hazard falls under EPA jurisdiction.

Employers may use alternative workplace labeling systems (such as NFPA 704 or HMIS) for in-plant secondary containers provided workers are fully trained and product identifiers and general hazard warnings are maintained.

Portable secondary containers intended solely for immediate use by the employee who performs the transfer within their workshift are exempt from labeling requirements under 29 CFR 1910.1200(f)(8).

Last updated: August 2026

  • 4.3 GHS Labels, Signal Words & 9 GHS Pictograms
  • The 6 Mandatory Shipped Container Label Elements

Under 29 CFR 1910.1200(f)(1) , chemical manufacturers, importers, and distributors must ensure that every container of hazardous chemicals leaving the facility is labeled, tagged, or marked with six mandatory GHS label elements :

Product Identifier : The unique chemical name, code number, or batch number matching the product identifier listed on the Safety Data Sheet (SDS) and the written chemical inventory list.

Signal Word : A standardized single word used to indicate the relative degree of hazard severity:

"Danger" : Reserved for severe hazard categories (e.g., Flammable Liquid Category 1, Acute Toxicity Category 1, Carcinogenicity Category 1A).

"Warning" : Reserved for less severe hazard categories (e.g., Flammable Liquid Category 3, Eye Irritation Category 2A).

Mandatory Priority Rule : If a chemical presents multiple hazards where one hazard warrants "Danger" and another warrants "Warning", only "Danger" appears on the container label.

Hazard Statement(s) : Standardized, assigned phrases describing the nature and degree of the hazard (e.g., "Fatal if swallowed" , "Highly flammable liquid and vapor" , "May cause cancer by inhalation" ).

Precautionary Statement(s) : Standardized phrases describing recommended measures to minimize or prevent adverse effects resulting from exposure, improper handling, or storage. These are grouped into four sub-categories: Prevention (e.g., "Keep away from heat/sparks/open flames" ), Response (e.g., "IF SWALLOWED: Immediately call a POISON CENTER" ), Storage (e.g., "Store locked up in a well-ventilated place" ), and Disposal (e.g., "Dispose of contents in accordance with local regulations" ).

Pictogram(s) : Graphic symbols depicting specific hazard classifications. GHS pictograms must feature a black hazard symbol set against a white background , enclosed within a red square set at a point (diamond) border.

Prohibition : OSHA strictly prohibits shipped container labels from displaying blank red diamonds without a black symbol.

Supplier Identification : The name, full street address, and U.S. telephone number of the chemical manufacturer, importer, or responsible party.

Detailed Breakdown of the 9 GHS Pictograms

OSHA recognizes 9 standard GHS pictograms. Under 29 CFR 1910.1200, 8 pictograms are mandatory under federal OSHA enforcement. The Environment pictogram is non-mandatory because aquatic toxicity falls under EPA statutory authority.

Pictogram Name Icon Appearance & Description Hazard Classes & Categories Represented

Health Hazard Human torso showing internal star/explosion Carcinogenicity (Cat 1A, 1B, 2), Germ Cell Mutagenicity, Reproductive Toxicity, Respiratory Sensitizer, STOT Single Exposure (Cat 1, 2), STOT Repeated Exposure, Aspiration Hazard.

Flame Burning flame above a fuel line Flammable Liquids, Flammable Gases, Flammable Aerosols, Flammable Solids, Pyrophorics, Self-Heating, Emits Flammable Gas, Self-Reactives, Organic Peroxides.

Exclamation Mark Bold exclamation point Acute Toxicity (Harmful - Cat 4), Skin Irritation (Cat 2), Eye Irritation (Cat 2A), Skin Sensitizer, STOT Single Exposure (Cat 3 narcotic effects / respiratory tract irritation), Hazardous to Ozone Layer (non-mandatory).

Gas Cylinder High-pressure compressed gas canister Gases Under Pressure (Compressed, Liquefied, Refrigerated Liquefied, Dissolved).

Corrosion Chemical dripping onto metal plate & corroding human hand Skin Corrosion (Cat 1A, 1B, 1C), Serious Eye Damage (Cat 1), Corrosive to Metals.

Exploding Bomb Exploding bomb fragment burst Unstable Explosives, Self-Reactives (Type A & B), Organic Peroxides (Type A & B).

Flame Over Circle Flame sitting atop an "O" ring Oxidizing Gases, Oxidizing Liquids, Oxidizing Solids.

Skull & Crossbones Skull positioned over crossed bones Acute Toxicity (Fatal or Toxic - Categories 1, 2, and 3 via oral, dermal, or inhalation exposure).

Environment (Non-Mandatory) Dead tree next to belly-up fish Aquatic Environmental Toxicity (Acute Cat 1 & Chronic Cat 1, 2, 3, 4). Non-mandatory for OSHA, but permitted on GHS labels.

Workplace / Secondary Container Labeling (29 CFR 1910.1200(f)(6))

When chemicals are transferred from original manufacturer-shipped containers into workplace secondary containers (such as spray bottles, dip tanks, day tanks, or squeeze bottles), employers are responsible for container labeling. Under 29 CFR 1910.1200(f)(6), employers may choose one of two compliant options:

Full GHS Label Replication : Affix a secondary label containing all 6 mandatory GHS shipped container elements.

Alternative Workplace Labeling System : Utilize an alternative system (such as NFPA 704 diamond placards, HMIS color bars, or customized company labels) PROVIDED that:

The product identifier matches the SDS and chemical inventory list.

The label provides words, pictures, symbols, or a combination thereof that supply at least general physical and health hazard warnings .

Employees are fully trained on the specific hazard warnings and symbols used in the alternative system.

Immediate-Use Secondary Container Exemption (29 CFR 1910.1200(f)(8))

Under 29 CFR 1910.1200(f)(8) , employers are NOT required to label portable secondary containers into which hazardous chemicals are transferred from labeled containers, provided all three of the following statutory conditions are met:

  • The portable container is intended ONLY for the immediate use of the employee who performs the transfer;
  • The chemical is used exclusively within that employee's work shift ; AND

The container remains under the exclusive control of the transferring employee at all times.

EXAM ALERT : If the employee leaves the work area, leaves the portable container unattended, hands the container to a co-worker, or fails to consume all chemical contents before the shift ends, the immediate-use exemption is forfeited , and a compliant secondary container label must be attached immediately.