Study guide

13.5 Recordkeeping, Reporting & Administrative Duties

South Carolina Water/Wastewater Operator Study Guide Exam

Track your progress as you read

Finished sections get a check mark.

1 Chapter 1: South Carolina Regulations & Licensing Framework

1.1 SC Environmental Certification Board & Chapter 51 Regulations 1.2 Certification Levels & Experience Requirements 1.3 Facility Classifications & Operator-in-Charge Duties 1.4 Exam Logistics, Scoring & Study Resources

2 Chapter 2: Source Water Characteristics

2.1 Raw Water Sources & Pretreatment 2.2 Groundwater Sources, Wells & GWUDI Determinations 2.3 Watershed Protection & Source Water Contaminants

3 Chapter 3: Water Treatment: Coagulation, Flocculation & Sedimentation

3.1 Coagulation & Flocculation Process Control 3.2 Sedimentation Basins & Clarification

4 Chapter 4: Water Treatment: Filtration

4.1 Granular Media & Membrane Filtration 4.2 Filter Operation, Backwash & Troubleshooting

5 Chapter 5: Water Treatment: Disinfection & Chemical Conditioning

5.1 Chlorination & Chemical Disinfection 5.2 CT Calculations & Disinfection Byproducts Compliance 5.3 Chloramines, Chlorine Dioxide, Ozone & UV 5.4 Corrosion Control & the Lead and Copper Rule 5.5 Fluoridation & Water Softening 5.6 Iron, Manganese, Taste & Odor Control

6 Chapter 6: Water Distribution Systems

6.1 Water Distribution Network Operations & Maintenance 6.2 Cross-Connection Control & Backflow Prevention 6.3 Distribution Hydraulics & Pressure Management 6.4 Pipes, Valves, Hydrants & Appurtenances 6.5 Storage Tanks & Reservoirs 6.6 Water Quality in Distribution: Flushing & Residual Management 6.7 Main Disinfection, Breaks & Repair

7 Chapter 7: Wastewater Collection & Preliminary Treatment

7.1 Wastewater Collection & Preliminary Operations 7.2 Sanitary Sewer Collection System Maintenance 7.3 Lift Station Pumps, Controls & Hydraulics

8 Chapter 8: Wastewater Treatment: Primary & Secondary

8.1 Wastewater Characteristics & Plant Loadings 8.2 Primary Sedimentation & Clarifier Operations 8.3 Activated Sludge Process Control & Operations 8.4 Activated Sludge Troubleshooting 8.5 Aeration Systems & Dissolved Oxygen Control 8.6 Fixed-Film & Lagoon Treatment Systems 8.7 Biological Nutrient Removal & Tertiary Treatment

9 Chapter 9: Wastewater Disinfection, Effluent & Industrial Treatment

9.1 Wastewater Disinfection & Dechlorination 9.2 Effluent Disposal, Reuse & Land Application 9.3 Physical/Chemical Industrial Wastewater Treatment 9.4 Industrial Pretreatment Programs

10 Chapter 10: Solids, Biosolids & Regulatory Permitting

10.1 Sludge Thickening, Digestion & Dewatering 10.2 Biosolids Stabilization & Part 503 Land Application 10.3 Clean Water Act & NPDES Permit Compliance 10.4 Safe Drinking Water Act Compliance & Public Notification

11 Chapter 11: Laboratory Analysis & Quality Control

11.1 Sampling, Preservation & Chain of Custody 11.2 Physical & Chemical Water Quality Analysis 11.3 Wastewater Process Testing & Analytical Methods 11.4 Microbiological Testing & Quality Assurance 11.5 Data Validation, Reporting & Laboratory Certification

12 Chapter 12: Equipment Operation & Maintenance

12.1 Pumps: Types, Curves & Cavitation 12.2 Motors, Drives & Electrical Fundamentals 12.3 Bearings, Seals, Couplings & Lubrication 12.4 Flow Measurement & Process Instrumentation 12.5 Chemical Feed Equipment & Calibration 12.6 SCADA, Controls & Preventive Maintenance Programs

13 Chapter 13: Safety, Security & Administrative Procedures

13.1 Confined Space Entry & Atmospheric Hazards 13.2 Chlorine Gas Safety & Emergency Response 13.3 Lockout/Tagout, PPE, Hazard Communication & Excavation 13.4 Security, Vulnerability Assessment & Emergency Response Planning 13.5 Recordkeeping, Reporting & Administrative Duties

14 Chapter 14: Process Calculations & Hydraulic Math

14.1 Basic Water & Wastewater Math Fundamentals 14.2 Chemical Feed Rate & Dosage Calculations 14.3 Detention Time & Volumetric Flow Calculations 14.4 Removal Efficiency & Process Loading Rates 14.5 Pump Hydraulics & Horsepower Calculations 14.6 Activated Sludge Process Control Math

13.5 Recordkeeping, Reporting & Administrative Duties

Key Takeaways Explain This Topic AI

Operational logs must be recorded contemporaneously in ink, with errors corrected by a single line-through, initials, and date, never erased or obliterated.

Monthly operating reports and Discharge Monitoring Reports are signed under penalty of law and falsifying them carries criminal exposure.

Asset management links condition and criticality to a funded capital replacement plan rather than deferring maintenance until failure.

Operator staffing must ensure a properly licensed operator-in-charge covers the facility as required by its group classification.

Documentation of training, safety meetings, and equipment history is what demonstrates a functioning program during an inspection.

Last updated: August 2026

13.5 Recordkeeping, Reporting & Administrative Duties

The standardized exams place administrative procedures alongside safety and security in a single content area worth 12 to 15 questions out of 100. That is the smallest of the content areas, but it is still more than a tenth of the exam, and the questions are cheap points because the answers are rules rather than judgment calls: an operator who runs a perfect process and cannot document it has not met the standard.

1. The Operational Log

The daily log is simultaneously a process control tool , a shift communication device , and a legal record .

What goes in it

  • Category Entries
  • Flows Raw, finished, backwash, waste, recycle; totals and instantaneous rates

Water quality Turbidity, disinfectant residual, pH, alkalinity, temperature; for wastewater, DO, MLSS, settleability, blanket depth

  • Chemical Dose setpoints, tank levels, deliveries received, feed rates verified
  • Equipment Units in and out of service, runtime hours, alarms, failures, work performed
  • Process changes Every adjustment, with the reason for it — this is what makes a log useful weeks later
  • Sampling Sample times, locations, collectors, results received
  • Unusual events Odor, color, spills, complaints, visitors, inspections, weather
  • Shift handover Conditions passed to the next operator
  • How to record it

Contemporaneously. Record when it happens, not at end of shift from memory.

In permanent ink , or in an electronic system with an audit trail .

Corrections by a single line-through , with the correct value, initials, and date . Never erase, white out, scribble over, or obliterate an entry.

Sign and date each shift.

No blanks — record "not run," "N/A," or "no reading" rather than leaving a space that looks like a missed observation.

Record the reason , not just the number. "Increased alum to 32 mg/L" is data; "increased alum to 32 mg/L, raw turbidity up to 45 NTU after overnight rain, jar test confirmed" is a record that teaches the next operator.

Why the correction rule matters: an obliterated entry looks like concealment. A clean line-through with initials looks like a professional correcting an error. Both may reflect the same honest mistake, and only one survives scrutiny.

2. Reports and Retention

  • Report To whom Timing
  • Monthly Operating Report (MOR) SC DES Monthly
  • Discharge Monitoring Report (DMR) SC DES (NPDES) Monthly per permit
  • Drinking water monitoring results SC DES Within 10 days after the end of the monitoring period
  • Violation notification SC DES 48 hours ; 24 hours for acute
  • Noncompliance that may endanger health or environment SC DES Oral 24 hours, written 5 days (Section 1.3)
  • Consumer Confidence Report Customers July 1 (Section 10.4)
  • Biosolids annual report Permitting authority Typically February 19 (Section 10.2)
  • Continuing education documentation Retained by the licensee for Board audit Per cycle (Section 1.1)

Retention requirements were covered in Section 1.3 for drinking water. On the NPDES side, monitoring records, calibration and maintenance records, and copies of all reports are retained for at least 3 years , extended by the permitting authority or automatically during unresolved litigation or enforcement.

The certification statement

As noted in Section 11.5, regulatory submissions are signed under a statement certifying under penalty of law that the information is true, accurate, and complete , with acknowledgment of significant penalties including fine and imprisonment for false information.

This is where the ethics material in Section 1.1 becomes concrete. Report the exceedance. A reported violation is a compliance matter with a defined path — corrective action, possibly a penalty, and resolution. A concealed one is falsification: grounds for license revocation under Chapter 51, and a criminal matter under state and federal environmental law.

3. Staffing and the Operator-in-Charge

Every facility must be covered by an operator-in-charge holding a license equal to or higher than the class designated for the facility's group (Section 1.3). Practical management duties that follow:

Maintain a current designation of the primary operator-in-charge with the state.

Verify licenses are current — renewal is biennial, ending June 30 of odd-numbered years , with a $200 late fee and nonrenewable status after 365 days .

Track continuing education for every licensed operator — 12 clock hours per cycle, or pass the state examination .

Cross-train , so a single absence does not leave the facility without qualified coverage.

Notify the Board within 15 days when an operator changes employers into a position requiring a certification they do not hold (R.51-3.D).

Document training — safety topics, confined space, LOTO, hazard communication, chlorine handling, with dates, topics, and attendee signatures.

4. Budgeting and Asset Management

Operators are increasingly expected to participate in the financial side, because they hold the information that drives it.

  • Budget type Content
  • Operating (O&M) Labor, chemicals, power, parts, contracted services, laboratory, training
  • Capital (CIP) Equipment replacement, rehabilitation, expansion — multi-year
  • The five core asset management questions
  • What do I own? — a complete, current asset inventory (Section 12.6)
  • What is it worth? — replacement value

What is its condition and remaining useful life? — condition assessment from inspection and predictive monitoring

  • What is its criticality? — consequence of failure, not just likelihood
  • What is my best O&M and CIP strategy, and how do I fund it? — a funded replacement plan

Why this matters operationally: the alternative to asset management is deferred maintenance, and deferred maintenance is simply borrowing against a future emergency at a very high interest rate. A pump replaced on schedule costs the planned amount; the same pump replaced after a catastrophic failure costs overtime, emergency procurement, possibly a permit violation, and sometimes a boil water advisory.

The operator's contribution is the data : runtime hours, failure history, repair costs, and condition observations. A documented equipment history from the CMMS is what converts "this pump keeps breaking" into a funded line item.

5. Inspections and Audits

Inspection Focus

Sanitary survey (drinking water) Source, treatment, distribution, storage, pumps, monitoring, management, and operator certification — conducted on a recurring cycle by SC DES

  • NPDES compliance inspection Effluent monitoring, laboratory practices, records, permit conditions
  • Pretreatment audit Local limits, SIU permitting, monitoring, enforcement (Section 9.4)
  • Laboratory certification audit Methods, QC records, analyst competency (Section 11.5)
  • SC OSHA inspection Safety programs and records (Section 13.3)
  • Board continuing education audit CE documentation for licensees (Section 1.1)
  • How to be ready

The honest answer is that you cannot prepare for an inspection in the week before it . What an inspector reviews — logs, calibration records, training documentation, maintenance history, sample records — is created daily over the preceding years or it does not exist. Systems that pass inspections cleanly are systems where the recordkeeping described in this section is simply how the plant runs.

During an inspection: be present and cooperative, answer what is asked accurately, say "I don't know, let me find out" rather than guessing , take your own notes, request a closing conference, and address findings with a documented corrective action plan and a completion date.