Study guide
6.1 The Safe System of Work and Its Hierarchy
Personal Track Safety PTS
Track your progress as you read
Finished sections get a check mark.
1 Introduction
About the PTS Qualification & Assessment
2 Chapter 1: Railway Infrastructure & Track Layout
1.1 Track Layout, Track Components & Permanent Way Terminology 1.2 Points, Crossings, Switch Blades & Associated Hazards 1.3 Limited Clearances, Refuges & Trackside Structures
3 Chapter 2: Sentinel Scheme, Fitness for Work & PPE
2.1 The Sentinel Scheme, Card System & Sponsorship 2.2 Medical Fitness, Drugs & Alcohol Policy & Fatigue Management 2.3 Trackside Personal Protective Equipment Standards
4 Chapter 3: Walking and Working On or Near the Line
3.1 On or Near the Line, the Lineside & Going onto the Railway 3.2 Positions of Safety, Walking Alone & Crossing the Line 3.3 Procedures When a Train Approaches
5 Chapter 4: AC Electrification & Overhead Line Safety
4.1 AC Overhead Line Equipment Principles & Components 4.2 AC Clearances, Live Equipment, Bonds & Overhead Line Permits 4.3 Overhead Line Emergencies, Emergency Switch-Off & Rescue
6 Chapter 5: DC Conductor Rail & Electrification Safety
5.1 DC Electrification Infrastructure & Operating Voltages 5.2 DC Working Distances, Safe Stepping & Bridging Risks 5.3 Flooding, Weather & DC Emergency Switch-Off
7 Chapter 6: Safe Systems of Work & Trackside Safety Roles
6.1 The Safe System of Work and Its Hierarchy 6.2 Trackside Safety Roles and How to Recognise Them 6.3 Briefings, During the Work & the Worksafe Procedure
8 Chapter 7: Safety-Critical Communications & Trackside Signage
7.1 Communicating Clearly: Safety-Critical Communications 7.2 Signals, Trackside Signs & Whistle Boards 7.3 Railway Telephones, Radio & Mobile Phones
9 Chapter 8: Railway Emergency Procedures & Stopping Trains
8.1 Emergencies: Danger to Trains and Emergency Calls 8.2 Stopping Trains and Protecting the Line 8.3 Reporting Your Concerns: Close Calls, CIRAS & Statutory Reporting
6.1 The Safe System of Work and Its Hierarchy
Key Takeaways Explain This Topic AI
The safe system of work is planned to use the safest method possible, and a line blockage with no train movements (safeguarded) is the preferred option.
A rigid safety barrier must be at least 1.25 metres from the nearest open line; barrier tape or plastic netting may be at 1.25 metres only where the open line speed is 40 mph or less, otherwise at least 2 metres.
A site warden working area needs at least 2 metres between the site and the nearest open line, a site warden when there are more than two people, and 3 metres if there are more than two people and no site warden.
Lookout warning requires all HB7 section 6.8 conditions, including director authorisation, no alternative system, 25 mph/25 m/45 s limits, and no darkness, poor visibility or tunnel use.
Whatever the system, the warning must let everyone reach the position of safety at least 10 seconds before a train arrives.
Last updated: October 2026
6.1 The Safe System of Work and Its Hierarchy
Every job on or near the line needs a safe system of work that stops people being put in danger by trains or electrification. Network Rail's standard NR/L2/OHS/019, Safety of people at work on or near the line , sets out how safe systems of work are planned, checked and authorised. Its simplified issues introduced the Safe Work Pack (SWP) and set out the roles of the Planner, the Responsible Manager and the Person in Charge (PIC) , so that no single person plans, verifies and authorises a safe work pack on their own.
The PTS handbook (RT3170, section 5.3) lists the systems the COSS or person in charge may set up, and says that work will be planned to use the safest method possible . A line blockage with no train movements is the preferred option, but this is not always possible, which is why other safe systems exist. SAFEST 1. Safeguarded - lines blocked, no trains on the site
- | 2. Fenced - a fence separates the group from trains
- | 3. Separated - a site warden keeps the group in a safe area
- | 4. Track warning systems - ATWS, SATWS, TAWS / TOWS
- LEAST 5. Lookout warning - all current HB7 restrictions apply
- 1. Safeguarded
With a safeguarded site of work, all the lines at your site are blocked to trains. This is achieved by a line blockage arranged with the signaller (Rule Book Handbook 8 covers an IWA, COSS or protection controller blocking a line) or by working inside an engineering possession controlled by the person in charge of the possession (PICOP), with worksites managed by engineering supervisors.
Inside a possession worksite, engineering trains and on-track plant may move through a safeguarded area, but only at no more than walking pace ; the person in charge or COSS will brief you if this is to happen. The same arrangement can apply to fenced and site warden areas, but only within a possession worksite.
Remember that a blocked line next to an open line is not a safe area for the open line. If the adjacent line is still open, you must stay within the limits you were briefed.
2. Fenced
A temporary fence is put up between the site and the nearest open line. There are three types: a rigid safety barrier , plastic netting or barrier tape .
- Fence type Minimum distance from the nearest running rail of the open line
- Rigid safety barrier 1.25 metres (4 feet)
Barrier tape or plastic netting 1.25 metres (4 feet) if the open line's maximum speed is no greater than 40 mph (65 km/h); otherwise at least 2 metres (6 feet 6 inches), with no restriction on speed
If the person in charge or COSS told you at the briefing that a fence marks the safe working limit, you must stay on the safe side of the fence, not lean on or over it, and not lean objects against it. HB1 section 5.3 says you must not lean against a safety barrier or rest tools or equipment against it.
3. Separated (Site Warden Warning)
With a site warden area, a space is provided between the site and the nearest open line:
- the space must be at least 2 metres (6 feet 6 inches) ;
- a site warden is appointed if there are more than two people in the group;
- site wardens are only used for static sites of work, never when walking to a site;
if the group is just you and the person in charge or COSS, a site warden is not required, but the space must still be at least 2 metres;
if there are more than two people and no site warden , the space must be at least 3 metres (10 feet) .
The site warden wears a white armlet or badge with "SITE WARDEN" in blue letters and watches the group, not the trains. If someone strays outside the safe area towards an open line, the site warden shouts "get back!" . If the person does not move back immediately, the site warden gives a series of short sharp blasts on a whistle or horn. Never distract a site warden, and if you think you might not hear their warning, tell the person in charge or COSS.
4. Track Warning Systems
With a track warning system , you are warned when a train is coming, and the COSS or person in charge makes sure the warning gives you enough time to reach the position of safety at least 10 seconds before the train passes. The PTS handbook lists three methods in order of preference :
Automatic Track Warning System (ATWS) : approaching trains are detected by the signalling system or by equipment attached to the running rails, and the warning is given by trackside flashing lights and sirens and/or a personal warning device. It is independent of human operation.
Semi-Automatic Track Warning System (SATWS) : works the same way as ATWS, except that an operator cancels the warning tone and lights at the site of work.
Train Activated Warning System (TAWS) and Train Operated Warning System (TOWS) : approaching trains are detected by the signalling system and the warning is given by trackside sirens. When the system is switched on an intermittent tone is heard; as a train gets closer the tone and frequency change.
5. LOWS and Lookout Warning
Keep equipment-warning rules distinct from human-lookout conditions. HB7 section 6.7 covers ATWS, SATWS, TOWS and LOWS: competent users, adequate warning, everyone safe at least ten seconds before arrival, audibility and tested warnings are required. Follow any additional company approval requirements. Director approval alone does not satisfy the separate human-lookout conditions.
Current limits on lookout warning
HB7 Issue 10 section 6.8 permits lookout warning only when all its conditions are satisfied. No alternative safe system may be available, and the arrangement must be planned in advance and authorised at director level. The COSS must not act as lookout. The permissible speed of approaching trains must be no more than 25 mph , nobody may need to cross an open line to safety, and the group must not need to walk more than 25 metres along the line to reach safety. Required warning time must be no more than 45 seconds , while allowing everyone to reach safety at least 10 seconds before arrival.
Trains may approach only on the working line or an adjacent line; a train must not be able to route onto the relevant line after the lookout has seen it. Competent lookouts must be positioned for the required sighting and warnings in every applicable direction. They must have no other duties, take no part in the actual work and not be distracted. The warning must be heard by everyone, and tested before work. The system cannot be used if sighting, required staffing or the 45-second limit cannot be met. Do not use lookouts during darkness, poor visibility, or in or near a tunnel.
Working out warning time
The COSS considers stopping work, placing tools down and reaching safety, adds five seconds for each additional direction the site lookout watches , then adds at least ten seconds in the position of safety. Use HB7’s sighting chart and the applicable method; its warning-time aid also includes a five-second allowance when working alone. Chart speeds above 25 mph may be relevant to equipment warning ; they do not authorise a human-lookout system at those speeds.
For an illustrative group needing 15 seconds to stop and reach safety, with a lookout watching one additional direction, the subtotal is 15 + 5 + 10 = 30 seconds . That arithmetic alone authorises nothing: every condition above, sufficient sighting and the planned safe system must also be satisfied. A 90 mph human-lookout example does not comply with the current 25 mph restriction.
Why the Hierarchy Matters
Warning systems depend on people seeing, hearing and reacting correctly every time; protection systems remove the train or put a barrier in the way. The Rail Accident Investigation Branch investigated the accident at Margam on 3 July 2019, in which two track workers were struck and killed by a train while working on an open line, and reducing reliance on lookout warning has been a major focus of track worker safety improvement since then, as the PTS handbook's note that lookout working is being reduced reflects. As a PTS holder, you do not choose the system, but you must understand it, follow it exactly and speak up if it is not what was briefed.