Study guide
ASE T3 Drive Train (Medium/Heavy Truck) study guide
Read a lesson, then practice the ideas you want to remember.
Lessons
- Automated Manual Transmissions: Actuators, S
- Auxiliary Gearing: Range and Splitter Sectio
- Electronic Shift Controls and Diagnosis: In-
- Air Shift Systems: Roadranger Valves, Slave
- Transmission Electrical Circuits: Speed Sens
- Diagnosing Gear Jump-Out, Gear Clash, Hard S
- Diagnosing Slip, Chatter, Drag, and AMT Clut
- Manual vs. Self-Adjusting Clutches and Inter
- Flywheel Inspection, Resurfacing, Pilot Bear
- Clutch Brake Operation, Types, Clearance, an
- Clutch Release Linkages, Hydraulic Systems,
- Push-Type vs. Pull-Type Clutches and Two-Pla
- Release Bearings, Cross-Shafts, Clutch Safet
- Drive Axle Lubrication, Fill Procedures, Lea
- Full-Floating Axles, Wheel Bearings, Hub Sea
- Carrier Setup: Pinion Depth, Bearing Preload
- Ring and Pinion Tooth-Contact Pattern Diagno
- Wheel-End Systems: Preset and Unitized Hubs,
- Standard Differential Nest: Side Gears, Spid
- Drive Axle Configurations: Single-Reduction,
- Driver-Controlled Main Differential Locks: O
- Interaxle Differential Operation, Air Lockou
- Center Support Bearings, Slip Yokes, and Dri
- Driveline Operating Angles, Digital Inclinom
- Driveshaft Phasing, Spline Alignment, Runout
- Heavy-Duty Universal Joint Types, Inspection
- ASE T3 Exam Format, Scoring, and Technician
- Medium/Heavy Truck Drive Train Architecture
- Shift Bar Housings, Rails, Shift Forks, Dete
- Transfer Cases, PTO Controls, and PTO Drives
- Heavy-Duty Manual Transmission Layout: Twin
- Transmission Lubrication, Cooling, Filtratio
- Transmission Removal, Mounts, Leaks, and Ove
- Main Box Power Flow, Sliding Clutches, and G